• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.8
• /
• pp.148-155
• /
• 2014

In this research a signal processing system is designed for detecting the ultrasonic signal envelope using Xilinx's Zynq SoC(system on chip). As a design tool, Vivado IDE(integrated design environment) is used to hierarchically design the whole signal processing system. The proposed system consists of a Zynq-internal ADC, an FIR(finite impulse response) BPF(band pass filter), an absolute value calculator, an FIR LPF(lpw pass filter), and the Kalman filter. Under this configuration, two design schemes, HW design scheme with LPF as a final stage and HW/SW co-design scheme with a Kalman filter as a final stage, are compared in terms of the performance and efficiency. As a result, envelope detecting performances of the two schemes are proved to be almost same, but the HW/SW co-design is verified to be much more efficient than the HW design considering the much smaller time consumption during system design.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.8 no.4
• /
• pp.233-239
• /
• 2003

For the quantitative analysis of an unknown sample a calibration curve should be obtained, as analytical instruments give relative, rather than absolute measurements. Therefore, researchers should make standard samples with various known concentrations, measure each standard and the unknown sample, and then determine the concentration of the unknown by comparing the measured value to those of the standards. These procedures are tedious and time-consuming. Therefore, we developed a polymer based microfluidic device from polydimethylsiloxane, which integrates serial dilution and capillary electrophoresis functions in a single device. The integrated microchip can provide a one-step analytical tool, and thus replace the complex experimental procedures. Two plastic syringes, one containing a buffer solution and the other a standard solution, were connected to two inlet holes on a microchip, and pushed by a hydrodynamic force. The standard sample is serially diluted to various concentrations through the microfluidic networks. The diluted samples are sequentially introduced through microchannels by electro-osmotic force, and their laser-induced fluorescence signals measured by capillary electrophoresis. We demonstrate the integrated microchip performance by measuring the fluorescence signals of fluorescein at various concentrations. The calibration curve obtained from the electropherograms showed the expected linearity.

• Korean Journal of Clinical Laboratory Science
• /
• v.36 no.1
• /
• pp.27-32
• /
• 2004

Bone marrow transplantation(BMT) is widely used as curative means of various malignant and nonmalignant hematologic disorders, and early and accurate determination of engraftment is very important for critical management decisions. Reticulocyte counts performed by automated flow cytometric methods is a good indicator of erythropoietic activity and its evaluation has been proposed as an early predictor of bone marrow regeneration. Some reports highlighted the usefulness of the percentage of highly fluorescent reticulocytes and the sum of highly and medium fluorescent reticulocytes(immature reticulocyte fraction, IRF). In Asan Medical Center, the criteria for engraftment following BMT or PBSCT was defined as the first day of a 3-day trend of absolute neutrophil count(ANC)${\geq}500/uL$ and platelet count${\geq}30{\times}10^3/uL$. In 1999, Grotto et al proposed an indidator of bone marrow recovery as the first day on which the IRF was twice the minimum value after bone marrow transplantation. To compare the both criterias, we got consecutive datas of immature reticulocyte fraction, absolute neutrophil count(ANC), WBC count, platelet count and reticulocyte count by XE-2100 automated hematology analyzer(Sysmex Co. Japan) from 33 patients daily after BMT. When compared to standard neutrophil engraftment(10-30 days, $16.2{\pm}4.6days$), IRF engraftment (5-21 days, $11.0{\pm}3.9days$) occured significantly earlier in 87.9% of patients(P<0.05). The mean engraftment day for WBC count(11-29 days, $16.4{\pm}4.3days$) was similar to ANC, but platelet count and reticulocyte count revealed more delayed data (10-49 days, $19.1{\pm}7.4days$ vs 17-64 days, $31.4{\pm}14.1days$). In conclusion, our results confirm that an increase in the immature reticulocyte population is the earliest sign of the hematopoietic recovery after BMT and that automated reticulocyte quantification including immature fraction may be integrated into clinical protocols to evaluate bone marrow reconstitution.

• Journal of Korean Society on Water Environment
• /
• v.37 no.3
• /
• pp.217-228
• /
• 2021

This paper discusses a methodology where an integrated modelling framework is used to quantify the risk derived from anthropic activities on habitats and species. To achieve this purpose, a tool comprising the Delft3D and HABITAT model, was applied in the Yeongsan river. Delft3D effectively simulated the operational condition and flow of weirs in river. In accuracy evaluation of the Delft3D-FLOW, the Bias, Pbias, Mean Absolute Error (MAE), Nash-Sutcliffe Efficiency (NSE), and Index of Agreement (IOA) were used, and the result was evaluated as grade above 'Satisfactory'. The HABITAT calculated Habitat Suitability Value (HSV) for the following eight species: mammal, fish, aquatic plant, and benthic macroinvertebrate. An Area was defined as a suitable habitat if the HSV was larger than 0.5. HABITAT was judged accurately by measuring the Correct Classification rate (CCR) and the area under the ROC curve (AUC). For benthic macroinvertebrate, the CCR and AUC were 77% and 0.834, respectively, at thresholds of 0.017 and 4 inds/m² for HSV and individuals per unit area. This meant that the HABITAT model accurately predicted the appearance of the benthic macroinvertebrates by approximately 77% and that the probability of false alarms was also very low. As a result of evaluating the suitability of habitats, in the Yeongsan river, if the annual "lowest level" (Seungchon weir: 2.5 EL.m/ Juksan weir: -1.35 EL.m) was maintained, the average habitat improvement effect of 6.5%P compared to the 'reference' scenario was predicted. Consequently, it was demonstrated that the integrated modelling framework for habitat suitability assessment is able to support the remedy aquatic ecological management.

• The Journal of Korean Society for Radiation Therapy
• /
• v.18 no.1
• /
• pp.1-5
• /
• 2006

Purpose: IMRT quality assurance(Q.A) is consist of the absolute dosimetry using ionization chamber and relative dosimetry using the film. We have in general used 0.015 cc ionization chamber, because small size and measure the point dose. But this ionization chamber is too small to give an accurate measurement value. In this study, we have examined the degree of calculated to measured dose difference in intensity modulated radiotherapy(IMRT) based on the observed/expected ratio using various kinds of ion chambers, which were used for absolute dosimetry. Materials and Methods: we peformed the 6 cases of IMRT sliding-window method for head and neck cases. Radiation was delivered by using a Clinac 21EX unit(Varian, USA) generating a 6 MV x-ray beam, which is equipped with an integrated multileaf collimator. The dose rate for IMRT treatment is set to 300 MU/min. The ion chamber was located 5cm below the surface of phantom giving 100cm as a source-axis distance(SAD). The various types of ion chambers were used including 0.015cc(pin point type 31014, PTW. Germany), 0.125 cc(micro type 31002, PTW, Germany) and 0.6 cc(famer type 30002, PTW, Germany). The measurement point was carefully chosen to be located at low-gradient area. Results: The experimental results show that the average differences between plan value and measured value are ${\pm}0.91%$ for 0.015 cc pin point chamber, ${\pm}0.52%$ for 0.125 cc micro type chamber and ${\pm}0.76%$ for farmer type 0.6cc chamber. The 0.125 cc micro type chamber is appropriate size for dose measure in IMRT. Conclusion: IMRT Q.A is the important procedure. Based on the various types of ion chamber measurements, we have demonstrated that the dose discrepancy between calculated dose distribution and measured dose distribution for IMRT plans is dependent on the size of ion chambers. The reason is small size ionization chamber have the high signal-to-noise ratio and big size ionization chamber is not located accurate measurement point. Therefore our results suggest the 0.125 cc farmer type chamber is appropriate size for dose measure in IMRT.

• Journal of Korean Society of Transportation
• /
• v.30 no.5
• /
• pp.61-69
• /
• 2012

It is important for highway maintenance and safety assessment to get the accurate highway geometric information. However, it is difficult to acquire good highway geometric information due to missing blueprints or deteriorated highway sections. This research, to get highway geometric information rapidly, has developed a highway geometric analysis algorithm that uses data from vehicles with GPS-IMU integrated system. In conclusion, the result shows that 3.38% of error-ratio for the horizontal alignment and 0.083 absolute value difference for vertical grade comparing with highway drawings. Therefore, the result suggest that the developed method can be applied to the road safety inspection or road safety audit.

• Journal of the Korean Institute of Gas
• /
• v.23 no.5
• /
• pp.52-58
• /
• 2019

In this study, we have developed a forecasting model for city- gas acceptance. City-gas corporations have to report about city-gas sale volume next year to KOGAS. So it is a important thing to them. Factors influenced city-gas have differences corresponding to usage classification, however, in city-gas acceptence, it is hard to classificate. So we have considered tha outside temperature as factor that influence regardless of usage classification and the model development was carried out. ARIMA, one of the traditional time series analysis, and LSTM, a deep running technique, were used to construct forecasting models, and various Ensemble techniques were used to minimize the disadvantages of these two methods.Experiments and validation were conducted using data from JB Corp. from 2008 to 2018 for 11 years.The average of the error rate of the daily forecast was 0.48% for Ensemble LSTM, the average of the error rate of the monthly forecast was 2.46% for Ensemble LSTM, And the absolute value of the error rate is 5.24% for Ensemble LSTM.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.37 no.5
• /
• pp.379-388
• /
• 2019

Recently, a technique for acquiring spatial information data using UAV (Unmanned Aerial Vehicle) has been greatly developed. It is a very crucial issue of the GIS (Geographic Information System) mapping system that passes way point in the unmanned airframe and finally measures the accurate image and stable localization to the desired destination. Though positioning using DGPS (Differential Global Navigation System) or RTK-GPS (Real Time Kinematic-GPS) guarantee highly accurate, they are more expensive than the construction of a single positioning system using a single GPS. In the case of a low-priced single GPS system, the stability of the positioning data deteriorates. Therefore, it is necessary to supplement the uncertainty of the absolute position data of the UAV and to improve the accuracy of the current position data economically in the operating state of the UAV. The aim of this study was to present an algorithm enhancing the stability of position data in a single GPS mode of UAV with multiple GPS. First, the arrangement of multiple GPS receivers through the center of gravity of the UAV were examined. Next, MD (Mahalanobis Distance) is applied to detect instantaneous errors of GPS data in advance and eliminate outliers to increase the accuracy of previously collected multiple GPS data. Processing procedure for multiple GPS reception data by applying the center of the triangular method were presented to improve the position accuracy. Second, UAV navigation systems integrated multiple GPS through configuration of the UAV specifications were implemented. Using the unmanned airframe equipped with multiple GPS receivers, GPS data is measured with the TCM (Triangular Center Method). In addition, UAV equipped with multiple GPS were operated in study area and locational accuracy of multiple GPS of UAV with VRS (Virtual Reference Station) GNSS surveying were compared. The result showed that the error factors are compensated, and the error range are reduced, resulting in the reliability of the corrected value. In conclusion, the result in this paper is expected to realize high-precision position estimation at low cost in UAV using multiple low-cost GPS receivers.

• Journal of Arbitration Studies
• /
• v.32 no.2
• /
• pp.135-157
• /
• 2022

Religion has a very close relationship with our everyday lives. In particular, religion maintains an absolute and ultimate value system and is deeply associated with all sectors of society such as politics, economy, thought, arts, culture, and science. The original meaning of religion in Buddhism means the teachings that become fundamentals. There are numerous religions around the world, and each religion has its own object of faith, different system, and unique rites and lifestyles. Therefore, evaluating or denouncing other regions based on the doctrines or conventions of a specific religion can lead to conflicts and disputes. The Buddhist Vinaya Pitaka related to alternative dispute resolution (ADR) is a method regarding the operation of a community. Vinaya Pitaka contains Buddha's teachings about individual and organizational ethics and on community life and activities. It is the Buddhist dispute resolution (BDR) of the Vinayata Pitaka that contains knowledge on howto remedy disputes among the four types of disputes that can occur. Vinaya Pitaka contains the principles and systems of BDR, and it is sufficient background for succeeding in the development of harmony today. The messages of laws, ethics, and Buddhist teachings are clear in these characteristics. The systems, progress, and procedures for various rites, events, and disputes as well as for everyday life, etc. display a rational operating system through karma. In particular, when disputes occur, the cause of the dispute is resolved as much as possible through transparent fairness and being unanimous using the seven remedies for disputes. Buddhist priests pursue private autonomy of ADR through karma, repentance, acceptance, etc. to maintain and continue the integrated functions of Buddhist priest harmony.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.1
• /
• pp.74-80
• /
• 2006

Benefit transfer is a method, which obtains an estimate for the economic valuation of non-marketed commodities at a given site through the analysis of studies that have been previously carried out to value similar commodities at a different location. The objective of this study was to estimate benefit transfer values for the construction of the integrated sewerage system in the catchment area of dams in Korea. For pooled data analysis, five models were suggested in this study. Among five models, model 2 showed only 6 to 7% errors when the willingness-to-pay(WTP) predicted in the policy-site, Dam Soyang was compared with that estimated using contingent valuation method(CVM) in the study-sites, Dams Namgang, Hapcheon, and Daecheong. However, the WTP estimate predicted by model 1 showed the absolute errors of 42 to 47% when it was compared with WTP estimated using CVM in Dams Andong and Imha. It seemed that residents of Dams Andong and Imha have feeling of being victimized since two dams were constructed very adjacently, the upstream area was designated as drinking water source protection zone, and thereafter their developmental economical actions have been significantly restricted.