• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.567-570
• /
• 2002

The LVDS (Low Voltage Differential Signaling) I/O cells, fully compatible with ANSI TIA/ EIA-644 LVDS standard, are designed using a 0.35${\mu}m$ standard CMOS technology. With a single 3V supply, the core cells operate at 1.34Gbps and power consumption of the output driver and the input receiver is 10. 5mW and 4.2mW, respectively. In the output driver, we employ the DCMFB (Dynamic Common-Mode FeedBack) circuit which can control the DC offset voltage of differential output signals. The SPICE simulation result of the proposed output driver shows that the variation of the DC offset voltage is 15.6% within a permissible range. In the input receiver, the proposed dual input stage with a positive feedback latch covers rail-to-rail input common-mode range and enables a high-speed, low-power operation. 5-channels of the proposed LVDS I/O pair can handle display data up to 8-bit gray scale and UXGA resolution.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.6
• /
• pp.507-515
• /
• 2012

DC-DC converter which composed of LLC resonant converter, operated by fixed switching frequency with fixed duty cycle (50%), and flyback converter to provide constant output voltage($400V_{DC}$) with variation of input voltage($30-60V_{DC}$) is proposed in this paper. To obtain constant output voltage($400V_{DC}$), flyback converter is not operated in case of above the maximum input voltage($60V_{DC}$) and operated as the input voltage decreases to below 60VDC. Therefore, flyback converter can be designed to the 50% power rating of the maximum power in the proposed DC-DC converter. Operation modes and voltage gain characteristics were analyzed and a 360W prototype converter was tested to verify the proposed converter.

• Journal of Power Electronics
• /
• v.6 no.4
• /
• pp.330-339
• /
• 2006

This paper deals with novel electronic ballast based on single-stage power processing topology using a symmetrical half-bridge inverter and current injection circuit. The half-bridge inverter drives the output parallel resonant circuit and injects current through the power factor correction (PFC) circuit. Because of high frequency current injection and high frequency modulated voltage, the proposed circuit maintains the unity power factor (UPF) with low THD even under wide variation in ac input voltage. This circuit needs minimum and lower sized components to achieve the UPF and high efficiency. This leads to an increase in reliability of ballast at low cost. Furthermore, to reduce cost, the electronic ballast is designed for two series-connected fluorescent lamps (FL). The analysis and experimental results are presented for ($2{\times}36$ Watt) fluorescent lamps operating at 50 kHz switching frequency and input line voltage (230 V, 50 Hz).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.6
• /
• pp.543-549
• /
• 2003

It is important to consider the nonlinear effects of the HPA(High Power Amplifier) in the OFDM communication systems and other digital communication systems as well. In this paper, we investigate a new performance figure-of$.$merit(D) that reflects both power and spectrum efficiencies. The performance figure-of-merit is expressed to include the spectrum and power efficiencies that depend on the magnitude of IBO(Input Backoff) and the number of subcarriers. So, we analyze the variation characteristics of the power efficiency and spectrum efficiency which has the tradeoff relationship.

• Proceedings of the KIPE Conference
• /
• 2000.07a
• /
• pp.299-304
• /
• 2000

In this paper we investigate accurately the input-output characteristic of single-phase diode rectifier. The diode rectifier has some advantages of simplicity cost and high-efficiency. But it has some defects which THD of input current low PF and voltage drop of output side. In order to compensate it we analyzed using the parameter variation and introduced capacitor insertion method for reducing the distortion and increasing the PF.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.1
• /
• pp.197-203
• /
• 2013

Optical power optimization of 10 Gbps 40 wavelength division multiplexing channels was analyzed at the 3000 km long-haul transmission distance when the link span distance was changed between 40 km and 140 km. The signal performance of the transmission was obtained as a Q value and it was compared when input power into SSMF and input power into DCF on the transmission link were changed. The optimized input power into SSMF increased linearly to link span distance with 1 dB/km. The optimized power into DCF increased linearly with 0.5 dB/km up to 100 km link span, but it had no variation at longer link span than 100 km.

• Proceedings of the KIEE Conference
• /
• 2002.07b
• /
• pp.1120-1122
• /
• 2002

Switching power supply are widely used in many industrial field. Power factor improvement and harmonic reduction technique is very important in switching power supply. The power factor correction (PFC) circuit using boost converter used in input of power source is studied in this paper. It is analyzed distortional situations and harmonics of input currents that presented at continuous conduction mode(CCM) of boost PFC circuit. It is done simulations of harmonics distribution according to load variation by using PSPICE and MATLAB. From the actual experiment of boost PFC circuit the validity of the analysis is confirmed.

• Proceedings of the KIEE Conference
• /
• 2004.07e
• /
• pp.27-29
• /
• 2004

This paper presents improved teaching and learning Gill for easily analysis tool of load flow of power system. This GUI includes not only contingency analysis function, but also calculating power loss from transmission line flow. The Gill is friendly for study for power system operation and control because picture provide a better visualizing of relationships between input parameters and effect than a tabula type result. This Gill enables topology and the output data of load flow for line outages to be shown on same picture page. Users can input the system data for power flow on the the picture and can easily see the the result diagram of bus voltage, bus power, line flow. It is also observe the effects of different types of variation of tap, shunt capacitor, loads level, line outages. Proposed Gill has been studied on the Ward-Hale 6-Bus system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.10C
• /
• pp.798-804
• /
• 2008

This paper proposes a low-power circuit for detecting and correcting L2 cache errors during microprocessor data image processing. A simplescalar-ARM is used to analyze input and output data by accessing the microprocessor's L2 cache during image processing in terms of the data input and output frequency as well as the variation of each bit for 32-bit processing. The circuit is implemented based on an H-matrix capable of achieving low power consumption by extracting bits with small and large amounts of variation and allocating bits with similarities in variation. Simulation is performed using H-spice to compare power consumption of the proposed circuit to the odd-weight-column code used in a conventional microprocessor. The experimental results indicated that the proposed circuit reduced power consumption by 17% compared to the odd-weight-column code.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.38 no.7
• /
• pp.557-568
• /
• 1989

Using Power Spectrum Analysis, conditions of parameter convergence for a Model Reference Adaptive Control (MRAC) system are described. The general Persistent Excitation (PE) condition given in time domain can be transformed to the positiveness of auto-correlation matrix which is represented in frequency domain by the spectra of reference input signal. For an MRAC system designed with relative degree one, the existence and the uniqueness of parameter nominal values due to the variation of input spectra can be analyzed by the PE condition in frequency domain. If the input signal has 2n spectra or more, it can be shown that the nominal values exist independent of adaptive gain, input amplitudes, and magnitudes or numbers of their spectra.