• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 1999.04a
• /
• pp.275-277
• /
• 1999

• Journal of KIISE:Information Networking
• /
• v.29 no.2
• /
• pp.181-187
• /
• 2002

Connection admission control(CAC), which decides whether or not to accept a new call request, is one of the most Important preventive congestion control techniques in asynchronous transfer mode(ATM) networks. To develop a practical CAC scheme, first we propose a "Modified Cell Loss Probability MP${\nu}"$, which is based on "Virtual Cell Loss Probability P${\nu}"$, taking into account mean burst duration of input traffic source and buffer size in ATM networks. MP${\nu}"$ computes more accurate cell loss probability than P${\nu}"$ without increasing computational complexity, since P${\nu}"$ is formulated simply form the maximum and the average cell rate of input traffic. P${\nu}"$ is overestimated as compared to the real cell loss probability when the mean burst duration is relatively small to the buffer capacity. Then, we Propose a CAC scheme, based on "Modified Virtual Bandwidth(MVB)" method, which may individualize the cell loss probabilities in heterogeneous traffic environments. For the proposed approach, we define the interference intensity to identify interferences between heterogeneous traffic sources and use it as well as MP${\nu}"$ to compute MVB. Our approach is well suitable for ATM networks since it provides high bandwidth utilization and guarantees simple and real time CAC computation for heterogeneous traffic environments.heterogeneous traffic environments.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.11
• /
• pp.7-14
• /
• 2019

The compacted bentonite buffer is one of the major components of an engineered barrier system (EBS) for the disposal of high-level radioactive waste (HLW), and it is considered the best candidate for the buffer material. The buffer is located between disposal canisters and near-field rock mass, and it interrupts the release of radionuclide from disposal canisters and protect them from the penetration of groundwater. At initial disposal condition, degree of saturation of the compacted bentonite buffer decreases because of high thermal quantities released from the disposal canisters. However, the degree of saturation of the compacted bentonite buffer gradually increases caused by inflow of groundwater. The saturated and unsaturated behavior of the buffer is a very important input data since it can determine the safety performance of EBS. Therefore, this paper investigated water retention capacity (WRC) for the Korean compacted bentonite buffer. The WRC of the compacted bentonite buffer was derived by measuring volumetric water content and water suction when temperature variation was between 24℃~125℃ considering decrease of degree of saturation with respect to temperature increase. The WRC was also derived with the same volumetric water content under the room temperature condition, and it showed 1~15% larger water suction than high temperature condition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12A
• /
• pp.1910-1916
• /
• 1999

This paper suggested to solve ATM switch performance and service rate which was input buffer managed scheme in ATM network with burst traffic characteristics, For this purpose, ATM multiplexer is prepared before sending for handling burst random input traffic to multiplex and then sort based on cell inter-arrival time and cell processing due time which had been marked after that. The server looks for cell header with the most shortest due time and sends it, thus it is satisfied that real time traffic for instance CBR and rt-VBR was guaranteed cell processing time to send fast than non real time traffic. For analysis of ATM switch performance with cell processing due time and priority, each output port has divided into four different virtual buffer and each buffer has assigned different cell inter-arrival time and processing due time according to ATM Forum for example CBT/rt-VBR, nrt-VBR, ABR and UBR and showed it’s optimal service parameters then analyzed service rate behaviors according to each traffic characteristics.

• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.531-542
• /
• 2002

An input and output buffering ATM switch conventionally operates in either Queueloss mode or Backpressure mode. Recently, a new mode, which is called Hybrid mode, was proposed to overcome the drawbacks of Queueloss mode and Backpressure mode. In Hybrid mode, when both the destined output buffer and the originfted input buffer are full, a cell is dropped. This thesis analyzes the cell loss rate and the cell delay of Queueloss, Backpressure and Hybrid modes in a switch adopting output-port expansion scheme under uniform traffic. Output-port expansion scheme allows only one cell from an input buffer to be switched during one time slot. If several cells switch to a same destined output port, the number of maximum transfer cells is restricted to K (Output-port expansion ratio). The simulation results show that if an offered load is less than 0.9, Hybrid mode has lower cell loss rate than the other modes; otherwise, Queueloss mode illustrates the lowest cell loss rate, which is a different result from previous researches. However, the difference between Hybrid and Queueloss modes is comparably small. As expected, the average cell delay in Backpressure mode is lower than those of Queueloss mode and Hybrid mode, since the cell delay due to the retransmission of higher number of dropped cells in Backpressure mode is not considered.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.17 no.3
• /
• pp.329-338
• /
• 2019

Suction of unsaturated bentonite buffers is a very important input parameter for hydro-mechanical performance assessment and design of an engineered barrier system. This study analyzed suction measurement techniques and constitutive models of unsaturated porous media reported in the literature, and suggested suction measurement techniques and constitutive models suitable for bentonite buffer in an HLW repository. The literature review showed the suction of bentonite buffer to be much higher than that of soil, as measured by total suction including matric suction and osmotic suction. The measurement methods (RH-Cell, RH-Cell/Sensor) using a relative humidity sensor were suitable for suction measurement of the bentonite buffer; the RH-Cell /Sensor method was more preferred in consideration of the temperature change due to radioactive decay heat and measurement time. Various water retention models of bentonite buffers have been proposed through experiments, but the van Genuchten model is mainly used as a constitutive model of hydro-mechanical performance assessment of unsaturated buffers. The water characteristic curve of bentonite buffers showed different tendencies according to bentonite type, dry density, temperature, salinity, sample state and hysteresis. Selection of water retention models and determination of model input parameters should consider the effects of these controlling factors so as to improve overall reliability.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.5B
• /
• pp.830-841
• /
• 2000

We extend the sue of the method of least square to develop a recursive algorithm for the design of adaptive transversal filters such that, given the least-square estimate of this vector of the filter at iteration n-1, we may compute the updated estimate of this vector at iteration a upon the arrival of new data. We begin the development of the RLS algorithm by reviewing some basic relations that pertain to the method of least squares. Then, by exploiting a relation in matrix algebra known as the matrix inversion lemma, we develop the RLS algorithm. An important feature of the RLS algorithm is that it utilizes information contained in the input data, extending back to the instant of time when the algorithm is initiated. In this paper, we propose new tap weight updated RLS algorithm in adaptive transversal filter with data-recycling buffer structure. We prove that convergence speed of learning curve of RLS algorithm with data-recycling buffer is faster than it of exiting RL algorithm to mean square error versus iteration number. Also the resulting rate of convergence is typically an order of magnitude faster than the simple LMS algorithm. We show that the number of desired sample is portion to increase to converge the specified value from the three dimension simulation result of mean square error according to the degree of channel amplitude distortion and data-recycle buffer number. This improvement of convergence character in performance, is achieved at the (B+1)times of convergence speed of mean square error increase in data recycle buffer number with new proposed RLS algorithm.

• Journal of Biomedical Engineering Research
• /
• v.12 no.2
• /
• pp.107-112
• /
• 1991

In this paper, we have developed page level input system of the character reading aid for the blind. Input toys)ems arse consisted with 512 pixels line image sensor, optical lento, digital interface for the computer and its control software. Input buffer size of the computer memory that for the single scanning of printed matters Image is 64kB. Image patterns of the reading characters which stored in system memory are converted to tactile character patterns that would be output to the bimorph tactile sensor by software control.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.12
• /
• pp.9-24
• /
• 1995

In this paper, we proposed and analysed two kinds of priority control mechanism to archive the cell loss rate requirement and the delay requirement of each class. The service classes of our concern are the high time priority class(class 1) and the high loss priority class(class 2). Two kinds of priority control mechanism is divided by the method of storing the arriving class 2 cell in buffer on case of buffer full. The first one is the method which discarding the arriving class 2 cell, the second one is the mothod which storing the arriving class 2 cell on behalf of pushing out the class 1 cell in buffer. In the proposed priority schemes, one cell of the class 1 is transmitted whenever the maximum K cells of the class 2 is transmitted on case of transmitting the class 1 cell and the class 2 cell sequentially. In this paper, we analysed the cell loss rate and the mean cell delay for each class of the proposed priority scheme by using the Markov chain. The analytical results show that the characteristic of the mean cell delay becomes better for the class 1 cell and that of the cell loss rate becomes better for the class 2 cell by selecting properly the cell transfer ratio according to the condition of input traffic.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.103-106
• /
• 2002

We prepared $Co_{77}Cr_{20}Ta_{3}$ thin film with Facing Targets Sputtering Apparatus. which can deposit a high quality thin film CoCrTa magnetic layer for Perpendicular magnetic recording media. In order to obtain Good Crystal orientation of CoCrTa thin films. We prepared Thin Films on slide glass substrate. The thickness of Buffer-layer were varied from 10 to 50 nm and Magnetic layer thickness fixed 100[nm]. input current was varied from 0.2[A] to 0.5[A]. Substrate temperature was varied from room temperature to ${250^{\circ}C}$ respectively. The crystal orientation of the CoCrTa film were examined with XRD. Introduce Buffer-layer thin films showed improvement of dispersion angle of c-axis orientation (${\Delta\theta}_{50}$).