• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.4
• /
• pp.158-163
• /
• 2011

$CuInS_2$ thin films were prepared using a sol-gel spin-coating method. That makes large scale substrate coating, simple equipment, easy composition control available. The structural and optical properties of $CuInS_2$ thin films that include less toxic materials (S) instead of Se, tetragonal chalcopyrite structure. Copper acetate monohydrate ($Cu(CH_3COO)_2{\cdot}H2O$) and indium acetate ($In(CH_3COO)_3$) were dissolved into 2-propanol and l-propanol, respectively. The two solutions were mixed into a starting solution. The solution was dropped onto glass substrate, rotated at 3000 rpm, and dried at $300^{\circ}C$ for Cu-In as-grown films. The as-grown films were sulfurized inside a graphite container box and chalcopyrite phase of $CuInS_2$ was observed. To determine the optical properties measured optical transmittance of visible light region (380~770 nm) were less than 30 % in the overall. The XRD pattern shows that main peak was observed at Cu/In ratio 1.0 and its orientation was (112). As annealing temperature increases, the intensity of (112) plane increases. The unit cell constant are a = 5.5032 and c = 11.1064 $\AA$, and this was well matched with JCPDS card. The optical transmittance of visible region was below than 30 %.

• Journal of the Microelectronics and Packaging Society
• /
• v.30 no.2
• /
• pp.71-75
• /
• 2023

In this study, inorganic perovskite films with different compositions were grown by thermal chemical vapor deposition depending on the substrate and their optical properties were compared. Inorganic perovskite crystals were grown on SiO₂/Si and c-Al₂O₃ substrates using CsBr and PbBr₂, respectively, under the same growth conditions. Cs₄PbBr₆-CsPbBr₃ crystallites were grown on the SiO₂ with polycrystalline structure, while a CsPbBr₃ (100) dominant thin film was formed on the c-Al₂O₃ substrate with single crystal structure. From the photoluminescence measurement, CsPbBr₃ showed typical green emission centered at 534 nm with a full width at half maximum (FWHM) of about 91 meV. The Cs₄PbBr₆-CsPbBr₃ mixed structure exhibits blue-shifted emission at 523 nm with a narrow FWHM of 63 meV and a fast decay time of 6.88 ns. These results are expected to be useful for application in photoelectric devices such as displays, solar cells, and light sensors based on inorganic metal perovskites.

• Korean Journal of Soil Science and Fertilizer
• /
• v.33 no.4
• /
• pp.234-241
• /
• 2000

Organic farming (OF) is regarded as alternative farming types against general farming system for sustainable agriculture, recently. However, there is little information on effects of OF on soil properties and watershed condition. In order to determine the effects of OF on soil properties, 36, 10 and 8 sites of organic farming (OF) fields of plastic film houses, paddy and orchard were selected in the national scale, respectively, to evaluate their chemical properties and phosphorus distributing characteristics. The average organic matter (OM) contents in organic farming fields were with $44g\;kg^{-1}$ in plastic film houses, $26g\;kg^{-1}$ in paddies and $39g\;kg^{-1}$ in orchard soils higher than the average OM contents in conventional farming (CF) soils. Available phosphates were accumulated to 986 in plastic film house soils and $754mg\;kg^{-1}$ in orchard soils, respectively, over the optimum range. Furthermore, total P (T-P) reached to $2.973mg\;kg^{-1}$ in plastic film houses and $2303mg\;kg^{-1}$ in orchards in OF soils. It could be attained by applying repeatedly low N/P ratio of manure-based compost. In two types of soils inorganic P was dominant with the ratio of 62~80% of T-P, and then residual and organic Ps followed. However. residual-P was dominant in paddy soils with the rate of 50% of T-P. Fractionation of soil extractable P showed that Ca-P was dominant with about $1,330mg\;kg^{-1}$ in upland soils in OF fields, which is affected by high soil pH of over 6.0. However. Fe-P of extractable P was dominant in paddy soils. Water-soluble P was very high with 65 and $26mg\;kg^{-1}$ in plastic film house and orchard soils in OF. From this results. OF regarded as an environment-friendly farming system may cause serious soil deterioration by accumulated phosphorus and may also cause water pollution.

• Korean Journal of Materials Research
• /
• v.3 no.6
• /
• pp.638-644
• /
• 1993

The degradation of dielectric breakdown field of 8nm-thick gate oxide ($SiO_2$) for Tipolycide MOS(meta1-oxide-semiconductor) capacitor with different annealing conditions and thickness of the polysilicon film on gate oxide was investigated. The degree of degradation in dielectric breakdown strength of the gate oxide for Ti-polycide gate became more severe with increasing annealing temperature and time, especially, for the case that thickness of the polysilicon film remained on the gate oxide after silicidation was reduced. The gate oxide degradation may be occurred by annealing although there is no direct contact of Ti-silicide with gate oxide. From SIMS analysis, it was confirmed that the degration of gate oxide during annealing was due to the diffusion of titanium atoms into the gate oxide film through polysilicon from the titanium silicide film.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.1
• /
• pp.11-14
• /
• 2000

Transparent conducting ITO thin films have been studied and developed for the solar cell substrate or LCD substrate. ITO thin film has been mostly fabricated by high cost sputtering method. In this research, sol-gel method is applied to fabricate ITO thin film at lower cost. The research is focused on the establishment of process condition and development of precursor. Organic sol was made of indium tri-isopropoxide dissolved in ethylene glycol monoethyl ether. The hydrolysis was controled by addition of acetyl acetone. Tin(IV) chloride was added as dopant. Inorganic sol was made of indium acetate dissolve din normal propanol. Spin coating technique was applied to coat ITO on borosilicate glass. The resistivity of ITO thin film was approximately $0.01\Omega{\cdot}cm$ and the transmittance is higher than $90\%$ in a visible range.

• Journal of the Korean Society for Heat Treatment
• /
• v.19 no.4
• /
• pp.200-207
• /
• 2006

In addition to the basic properties of the base and top coating agents, corrosion resistance of non-chrome magni 565 coating and characteristics of coating film when coated to steel substrate were studied. The system had a good wettability at room temperature. Moreover, both the contact angle and surface tension were affected little by the viscosity of coating agent and surface roughness of the steel substrate. And the samples coated with optimal conditions showed a great corrosion resistance in salt spray test with 1500 hours or longer of initial appearance time of rust. The coating film was composed of overlapping layer of zinc and aluminium flakes, and the thickness of base coat increased with an increase of base coat viscosity. Based on the C-F peaks of 1,1-Difluoroethaen homo-polymer, it was thought that the base coat was an inorganic polymer bond layer. Meanwhile, the top coat showed C-F peaks of polytetrafluoroethylene with C-H peaks of phenol in FT-IR analysis. From the lower weight loss of base coat in TG analysis, it was thought that cross linking density of base coat was larger than that of top coat. It was thought that the small exothermic reactions observed in DSC curves were due to the thermosetting resins contained in the coating agents. Compared to the non-coated specimen, the coated sample showed more higher polarization resistance and corrosion potential with lower corrosion current density.

• Journal of the Korean Ceramic Society
• /
• v.48 no.6
• /
• pp.499-503
• /
• 2011

Recently, variety of organic and inorganic hybrid materials have recently investigated as alternative routes to SiOC, $SiO_2$ thin film formation at low temperatures for applications in electronic ceramics. Specially, silicon based polymers, such as polycarbosilane, polysilane and polysilazane derivatives have been studied for use in electronic ceramics and have been applied as dielectric or insulating materials. In this study, Polycarbosilane(PCS), which Si-$CH_2$-Si bonds build up the backbone of the polymer, has been investigated as low-k materials using a solution process. After heat treatment at 350$^{\circ}C$ under $N_2$ atmosphere, chemical composition and dielectric constant of the thin film were $SiO_{0.27}C_{1.94}$ and 1.2, respectively. Mechanical property measured using nanoindentor shows 1.37 GPa.

• Korean Journal of Optics and Photonics
• /
• v.20 no.4
• /
• pp.230-235
• /
• 2009

Photopolymer is evaluated as better material than the others used for hologram storage, due to many advantages, such as high diffraction efficiency, easy processing, and self-developing. In this study, chalcogenide inorganic compound ($SeO_2$) which has optical activity, was added to polyvinyl alcohol/acrylamide photopolymer films. In order to optimize diffraction efficiency of these photopolymer films, we prepared the photopolymer films with various film thicknesses and Eosin Y content. Diffraction efficiency of the photopolymer films were measured using a 532 nm laser at $40^{\circ}$ incident angle. As a result, the phtopolymer film with Eosin Y content of 0.0045 g and thickness of $297{\mu}m$ showed the highest diffraction efficiency (78.70%).

• Journal of the Korean Ceramic Society
• /
• v.39 no.10
• /
• pp.935-942
• /
• 2002

Gallium-doped ZnO (GZO) films were deposited on soda-lime glass substrate without heating using Ne, Ar, or Kr gas. Electrical properties of GZO films deposited at various total gas pressures were investigated for the film positions corresponding to the erosion region (region B) and outside the erosion region (region A) of the target. Region B showed high resistivity, which was attributed to the decrease in carrier density and Hall mobility, compared to region A. GZO films deposited using Ne gas showed the degradation in resistivity and crystallinity, whereas, GZO films deposited using Kr gas showed the improvement in resistivity and crystallinity. This degradation in film properties could be attributed to the film damage caused by the bombardment of high-energy particles. Especially, the energies of recoiled neutral atoms ($Ne^0,\;Ar^0,\;Kr^0$) calculated by Monte Carlo simulation corresponded to experimental results.

• Korean Journal of Food Science and Technology
• /
• v.30 no.5
• /
• pp.1140-1145
• /
• 1998

Low density polyethylene (LDPE) films incorporated with 1% antimicrobial agents of Rheum palmatum extract, Coptis chinensis extract, and Ag-substituted inorganic zirconium matrix, were applied to modified atmosphere packaging of 200 g fresh strawberries. Plain LDPE film package, PVC wrap and perforative pinhole package of the film impregnated with 1% Rheum palmatum extract were also constructed for comparative purpose. All the packages were stored for 13 days at $5^{\circ}C$ and measured in package atmosphere, microbial count and quality attributes of the strawberry fruits. The antimicrobial LDPE films retarded the growth in total aerobic bacteria, lactic acid bacteria and yeast on the fruits, and resulted in significantly lower decay. The degrees of reduced microbial growth and fruit decay in the antimicrobial film packages were more pronounced, when applied by hermetical sealing to produce the modified atmospheres of low $O_2$ (<4.0%) and $CO_2$ concentrations with $6.3{\sim}9.0%$. The hermetically sealed packages of antimicrobial LDPE films also showed better retention of fruit firmness and did not give any negative effect on the physical and chemical qualities of strawberries.