• The Transactions of the Korean Institute of Power Electronics
• /
• v.22 no.5
• /
• pp.423-430
• /
• 2017

This paper proposes a control methodology for a high efficiency operation of an inductive power transfer (IPT) converter by combining full bridge (FB) and half bridge (HB) controls. To apply the proposed control to the IPT converter, the characteristics of each control method are analyzed. By examining the output voltages of the IPT converter and a theoretical loss analysis, the control shifting points between FB and HB controls are evaluated in accordance with the coupling coefficients and the load. Based on the control shifting points, the FB-HB control algorithm is implemented. By applying FB-HB control, high efficiency operation at the light load condition can be achieved.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.22 no.2
• /
• pp.134-139
• /
• 2017

In this study, an inductive power transfer (IPT) charger for electric vehicles is proposed to improve the entire system efficiency and power density by eliminating the DC-DC converter in the secondary side. In the proposed IPT charger, the DC-link voltage is adjusted according to the coupling coefficient through cascade buck-boost converter in the front-end side, and the bridgeless rectifier performs the charging of battery. The control algorithm for the proposed IPT system is theoretically explained, and the validity of the proposed system is verified by informative simulation.

• Proceedings of the KIPE Conference
• /
• 2016.11a
• /
• pp.35-36
• /
• 2016

본 논문에서는 전기자동차 배터리 충전용 자기 유도 방식 무선 전력 전송 (Inductive power transfer, IPT) 컨버터의 풀브릿지-하프브릿지 가변 제어 방법을 제안한다. 제안한 방법을 검증하기 위해 3.3kW IPT 컨버터에 풀브릿지 제어와 하프브릿지 제어를 각각 적용하여 결합계수 및 부하에 따른 이론적인 손실을 분석하고 고효율 운전 방법을 제안한다.

• Proceedings of the KIPE Conference
• /
• 2010.11a
• /
• pp.62-63
• /
• 2010

This paper presents a potential for application of Inductive Power Transfer(IPT) to the light railway vehicle system. IPT system allows for a vehicle fitted with existing or new generation batteries to park over a small charging unit and commence charging immediately. Regular charging will allow for smaller batteries to be used in vehicles. In this paper, IPT system uses a full-bridge LLC resonant converter and is possible for the regenerative braking which is an energy recovery mechanism.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.405-408
• /
• 1998

In this paper, a predictive current control of 12-pulse parallel connected dual converter system with interphase transfromer(IPT) is presented. Firstly, 12-pulse parallel connected dual converter system and the predictive current control of this system is discussed. And the validity of the presented system and the excellence of the predictive current control response is proved through the simyulation and experiment result.

• Journal of Power Electronics
• /
• v.16 no.1
• /
• pp.111-120
• /
• 2016

Generally, a single phase H-bridge converter feeding a single primary track is employed in conventional inductive power transfer systems. However, these systems may not be suitable for some high power applications due to the constraints of the semiconductor switches and the cost. To resolve this problem, a novel dual coupled primary tracks IPT system consisting of two high frequency resonant inverters feeding the tracks is presented in this paper. The primary tracks are wound around an E-shape ferrite core in parallel which enhances the magnetic flux around the tracks. The mutual inductance of the coupled tracks is utilized to achieve adjustable power sharing between the inverters by configuring the additional resonant capacitors. The total transfer power can be continuously regulated by altering the pulse width of the inverters' output voltage with the phase shift control approach. In addition, the system's efficiency and the control strategy are provided to analyze the characteristic of the proposed IPT system. An experimental setup with total power of 1.4kW is employed to verify the proposed system under power ratios of 1:1 and 1:2 with a transfer efficiency up to 88.7%. The results verify the performance of the proposed system.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.4
• /
• pp.332-338
• /
• 2002

High current coil power supply for superconductivity coil of tokamak requires fast dynamics performance of di/dt and smooth change over of current direction. To meet the specification high performance DSP-based controller Is designed for 12-pulse thyristor dual converter with interphase transformer(IPT). Not only the total current of Y and $\Delta$ converter units but also the difference for those should be regulated fast and accurately. Proportional and integral controller is designed for current difference control and the controller output is compensated to $\Delta$ converter. The source voltage phase angle detection and gate pulse generation algorithm are implemented in software for higher reliability of current control. The current error Is reduced by selection of appropriate initial gating angle during the transient of change over of current direction between thyristor converters.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1038-1039
• /
• 2008

This paper proposes a base models of Hybrid railway vehicle power system. A powered system with fuel cell is regarded as a high current and low voltage source. The design parameters of the system should be chosen by taking into account the characteristics of the fuel cell, so the costs of the power system at given operating conditions can be reduced. Currently, no integrated simulation has been approached to analyze interrelated effects. Therefore, the base models of power conversion system with a PEM fuel cell/IPT system for hybrid powered system that includes the PEM fuel cell stack, DC/DC converter are developed. Concept of bidirectional converter for super capacitor charging system is presented.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.1
• /
• pp.333-344
• /
• 2018

This proposed paper aims for the high efficiency contactless power transfer in household dc power distribution. A 300 W five-level diode clamped multi-level converter with 300 Vdc input dc link bus is employed for the power transferring task and the output voltage range is controlled at 48 Vdc. The inner and outer solenoid coils are used for inductive power transfer (IPT) transformer with the 200 kHz switching frequency for designed power density. Therefore, to achieve the converter efficiency above 95%, the LLC series resonant with fundamental harmonic analysis (FHA) and the calculated switching angles are used as an optimized tool for designing the system resonant tank. The validations of this approached topology are illustrated in both MATLAB/Simulink simulation and implementation.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.27 no.3
• /
• pp.237-246
• /
• 2022

This paper proposes a method to adjust the turn ratio of a transformer for the high-efficiency operation of an LLC converter with a wide input range in a wired/wireless integrated charging system for electric vehicles. The characteristics of the inductive power transfer converter in the integrated charging system are analyzed to design the LLC converter, and the DC-link voltage range is derived. The aspect of voltage gain following each parameter of the LLC converter is analyzed, and the resonant network and transformer are designed. Based on the designed parameters, the feasibility of the design and control method is verified by implementing the operation of the LLC converter according to the DC-link and battery voltages.