• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.42-51
• /
• 2003

In this paper, we are going to analyze on relation of an output spectrum along phase distortion of power amplifier in wireless LAN system, and then considered an ACPR characteristic of power amplifier and consideration of an OFDM method for this. Also, we did implementation for OFDM modulation and transmission section of an IEEE 802.11a standard to have transmission speed of the maximum 54Mbps in order to know an OFDM modulation method and relation of non-linear characteristic of power amplifier. The non-linear characteristic of power amplifier did modeling with AM-to-AM and AM-to-PM, and we analyzed an output spectrum characteristic along phase distortion composed input signal supply for power amplifier. When output spectrum analysis results phase distortion increased, and an AM-to-PM characteristic of power amplifier in 5 degrees, the output spectrum was satisfied with a demand spectrum in P1 dB, but 10-20 degrees were able to confirm what cannot be satisfied with a demand spectrum in phase distortion. Also, an output spectrum of power amplifier by frequency re-growth generated by a non-linear characteristic of power amplifier did not satisfied in P1dE. therefore, a back-off value was requested according to an AM-to-PM distortion degree, and smaller back-off value were able to know what demand became in case of modulation section that used OFDM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11A
• /
• pp.1263-1270
• /
• 2004

A low-power 64-point FFT/IFFT processor core is designed, which is an essential block in OFDM-based wireless LAM modems. The radix-2/418 DIF (Decimation-ln-Frequency) FFT algorithm is implemented using R2SDF (Radix-2 Single-path Delay Feedback) structure. Some design techniques for low-power implementation are considered from algorithm level to circuit level. Based on the analysis on infernal data flow, some unnecessary switching activities have been eliminated to minimize power dissipation. In circuit level, constant multipliers and complex-number multiplier in data-path are designed using truncation structure to reduce gate counts and power dissipation. The 64-point FFT/IFFT core designed in Verilog-HDL has about 28,100 gates, and timing simulation results using gate-level netlist with extracted SDF data show that it can safely operate up to 50-MHz＠2.5-V, resulting that a 64-point FFT/IFFT can be computed every 1.3-${\mu}\textrm{s}$. The functionality of the core was fully verified by FPGA implementation using various test vectors. The average SQNR of over 50-dB is achieved, and the average power consumption is about 69.3-mW with 50-MHz＠2.5-V.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.8
• /
• pp.623-631
• /
• 2013

Wireless LAN (WLAN) interface is one of the major sources drastically depleting the battery power of mobile devices such as smartphones and tablets. Most commercial mobile devices employ a power saving technique putting their WLAN interface into a sleep state when there is no network traffic, and thereby, save the battery power. However, since an access point (AP) just transmits the packet(s) received from a server to the corresponding mobile device immediately, it may cause a problem that the mobile device constantly remains in an awake state so that its battery power is rapidly drained. In this paper, we point out this problem and propose a new scheme that can save the mobile device's battery power with an adaptive packet scheduling at the AP side. From the experimental results based on a testbed, we found that the proposed scheme outperforms existing schemes over 50% in terms of power saving.

• Journal of KIISE:Information Networking
• /
• v.33 no.1
• /
• pp.38-48
• /
• 2006

For extending of hot-spot of WLAN, (2) proposes internetworking scheme between wireless LAN (WLAN) and mobile ad-hoc network (MANET), which employ the same layer-2 protocol with different mode. Compared to internetworking schemes between UMTS (Universal Mobile Telecommunications Systems) and WLAN (3-4), the scheme from (2) has relatively low overhead and latencies because WLAN and MANET are physically and logically similar to each other. However, the mode switching algorithm proposed in r2] for internetworking between WLAN and MANET only considers signal strength and determines handoff, and mobile nodes following a zigzag course in pollution area may perform handoff at short intervals. Furthermore, (2) employs mobile IPv6 (MIPv6) at base, which brings still high delay on handoff and overhead due to signal message exchange. In this paper, we present optimized internetworking scheme between WLAN and MANET, modified from (2). To settle ping-pong handoff from (2), we propose adaptive mode switching algorithm. HMIPv6 is employed for IP connectivity and mobility service in WLAN, which solves some shortcomings, such as high handoff overhead and vulnerable security. For routing in MANET, OLSR is employed, which is a proactive Protocol and has optimally reduced signal broadcasting overhead. OLSR operates with current P protocol compatibly with no change or modification. The proposed internetworking scheme based on adaptive mode switching algorithm shows better performance than scheme from (2).