• Journal of Powder Materials
• /
• v.10 no.2
• /
• pp.83-88
• /
• 2003

Nanocrystalline materials of Ni and Ni-Cu alloy have been synthesized by the pulsed wire evaporation (PWE) method and these abnormal magnetic properties in the magnetic ordered state have been characterized using both VSM and SQUID in the range of high and low magnetic fields. Ni and Ni-Cu particles with an average size of 20 to 80 nm were found to influence magnetic hysterisis behavior and the results of powder neutron diffraction patterns and saturation magnetization curves are shown to indicate the absence of the NiO phase. The shifted hysterisis loop and irreversibility of the magnetization curve in the high field region were observed in the magnetic-ordered state of both Ni and Ni-Cu. The virgin magnetization curve for Ni slightly spillover on the limited hysterisis loop ($\pm$20kOe). This irreversibility in the high field of 50 kOe can be explained by non-col-linear behavior and the existence of the metastable states of the magnetization at the surface layer (or core) of the particle in the applied magnetic field. Immiscible alloy of Cu-Ni was also found to show irreversibility having two different magnetic phases.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1996.10a
• /
• pp.202-206
• /
• 1996

An experimental study of the characteristics of the repulsiveytype magnetic bearing using high Tc superconductor is presented. In field cooling superconductor has the position-stability due to a flux pinning effect and the strong damping due to hysterisis, while in zero field cooling it has the only strong repulsive force due to Meissner effect. Lift force in superconducting levitation has a hysterisis characteristics, and it is the dissipation of energy, the mechanism of damping. As the relative linear velocity between a magnet and a superconductor increases, the area of the hysterisis loop becomes smaller. It means the decrease of damping. In field cooling, the static stiffness is very nonlinear in smaller than initial gap, but almost linear in larger than initial gap.

• Proceedings of the KIEE Conference
• /
• 1993.07b
• /
• pp.1134-1136
• /
• 1993

The mean grain size of sample decreases with increasing the addition of $Al_2O_3$ in the basic composition of YIG. It is mean that the addition of $Al_2O_3$ is helpless the development of magnetic properties in YIG garnet, considering the relation of ${\mu}{\propto}D^{1/3}$. To increase addition of $Al_2O_3$ decreased the area of hysterisis loop. It is known that the addition of $Al_2O_3$ is help the development of magnetic properties in YIG garnet, considering the relation of loss component factor and the area of hysterisis loop. As a results, sample with the addition of $Al_2O_3$ 0.5 mol % among the fabricated samples is must effective in the magnetic properties of YIG Garnet.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.350-355
• /
• 2005

This paper presents a new approach for hysteresis modeling of a magnetorheological (MR) fluid. The field-dependent hysteresis of MR fluid is investigated using the Preisach model. The commercial MR Product (MRF-132LD, Lord Corporation) is employed. Its field-dependent shear stress is then obtained using a rheometer (MCR 300, Physica). In order to show the applicability of the Preisach model to the MR fluid, two significant Properties; the minor loop property and the wiping-out property are experimentally examined. Subsequently, the Preisach model for the MR fluid is identified using experimental first order descending (FOD) curves in discrete manner. The effectiveness of the identified hysteresis model is verified in the time domain by comparing the predicted field-dependent shear stress with the measured one. In addition, the hysteresis model proposed in this work is compared to Bingham model.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.20-20
• /
• 2007

Nanowire-based field-effect transistors (FETs) decorated with nanoparticles have been greatly paid attention as nonvolatile memory devices of next generation due to their excellent transportation ability of charge carriers in the channel and outstanding capability of charge trapping in the floating gate. In this work, top-gate single ZnO nanowire-based FETs with and without Au nanoparticles were fabricated and their memory effects were characterized. Using thermal evaporation and rapid thermal annealing processes, Au nanoparticles were formed on an $Al_2O_3$ layer which was semi cylindrically coated on a single ZnO nanowire. The family of $I_{DS}-V_{GS}$ curves for the double sweep of the gate voltage at $V_{DS}$ = 1 V was obtained. The device decorated with nanoparticles shows giant hysterisis loops with ${\Delta}V_{th}$ = 2 V, indicating a significant charge storage effect. Note that the hysterisis loops are clockwise which result from the tunneling of the charge carriers from the nanowire into the nanoparticles. On the other hand, the device without nanoparticles shows a negligible countclockwise hysterisis loop which reveals that the influence of oxide trap charges or mobile ions is negligible. Therefore, the charge storage effect mainly comes from the nanoparticles decorated on the nanowire, which obviously demonstrates that the top-gate single ZnO nanowire-based FETs decorated with Au nanoparticles are the good candidate for the application in the nonvolatile memory devices of next generation.

• Tribology and Lubricants
• /
• v.13 no.2
• /
• pp.52-59
• /
• 1997

An experimental study is presented for the characteristics of the high temperature superconductor as an application of the repulsive type magnetic bearing. A ring shaped YBCO type superconductor and Neodium permanent magnets are employed for the experiment. For the case of field cooling, superconductor shows strong repulsive force, which is due to the Meissner effect, as the gap between the superconductor and the magnet gets closer. The repulsive force variation with respect to the gap change shows hysterisis characteristics. The area of the loop of the hysterisis curve represents the dissipation of energy, which reveals that the magnetic bearing with superconductor has large damping. The effect of the initial gap and the magnetic flux density on the repulsive force is analyzed experimentally and the static stiffness variation is calculated from the measured repulsive force variation. The relative sliding velocity between the superconductor and the magnet has little effect on the repulsive force which is quite different from the usual sliding element bearing. As the initial gap for the field cooling becomes larger, the maximum repulsive force at the minimum gap increases and approaches to the value for the case of zero field cooling.

• Journal of the Korean Ceramic Society
• /
• v.36 no.10
• /
• pp.1035-1039
• /
• 1999

Ferroelectric properties and reliability characteristics of(111) and (100) preferentially oriented tetragonal Pb(Zr0.2Ti0.8)O3 (PZT) thin film capacitors have been investigated as a function of the top electrode thickness. The (111) preferentially oriented film exhibits 180$^{\circ}$domain switching process with better squareness of hysterisis loop and abrupt change of small singal capacitance-voltage comparing to the (100) preferentially oriented film having 90$^{\circ}$ domain switching process. The domain swithcing process of tetragonal phase PZT is different from that of rhobohedral phase. The film with thinner top electrode shows less initial switching polarization due to less compressive stress but it exhibits better endurance characteristics due to enhancing partial switching region.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1988.10a
• /
• pp.86-90
• /
• 1988

In this paper, the compositional and sintering time dependences of dielectric, electrooptic properties for X/55/45([Ca$.$La$.$Nb]/Zr/Ti)CLN-PZT ceramics, where X is ranged from 3.0 to 11.0 mol %, have been investigated. As CLN mol% is increased, density, curie-temperature and dielectric constant are decreased, and also grain size and transmittance are increased, With the increment of CLN mol %. longitudinal mode electromechanical coupling coefficient is decreased and P-E hysterisis loop became slim-loop slowly. The crystal structure of CLN-PZt ceramics is changed from rhombohedral to tetragonal and pseudo-cubic according to the increment of CLN mol%.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.12 no.3
• /
• pp.122-129
• /
• 2004

In plastic working, as working becomes speedy, automatic and working condition deteriorates, the increase of forging working has been remarkable. Therefore, we need the estimation of mold lift in detail, in order to counterplan of effective mold life extension. In this study, on the SKH51, mold steel which is forged by cold working and the KCW1, tool steel of low alloy, we estimated mold life on the base of FEM analysis and investigated mold lift by low cycle fatigue test. Also, this paper suggested a new method of estimation of mold lift.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.717-720
• /
• 2001

Ferroelectric lead ziroconate titanate (PZT) thin film were fabricated on the different bottom electrodes. Both Ru and Ru/RuO$_2$bottom electrodes were deposited by RF-magnetron sputteirng method. The structure phase and surface morphology of the PZT thin film were largely affected by the bottom electrode. It was observerd that used of Ru/RuO$_2$double electrode reduced leakage current and better ferroelectric properties compare with RuO$_2$bottom electrode. From these results, Ru/RuO$_2$hybride bottom electrode is thought to be the available structure for the bottom electrode.