• Journal of the Microelectronics and Packaging Society
• /
• v.31 no.3
• /
• pp.87-90
• /
• 2024

Currently, when oxides are used as insulators in hybrid bonding for 3D integration, they are prone to delamination due to their surface characteristics, and the RC delay value due to the resistance of the metal and the capacitance of the insulator increases as the wiring of the semiconductor chip becomes longer. To solve these problems, we studied the optimization of the conditions of the polymer insulator bonding method for hybrid bonding. To check the possibility of the de-wetting method, we coated a polymer film on the existing micro pillar and conducted hot-press bonding to remove the polymer between the metals. Through this study, it is expected that the introduction of polymers as insulators in hybrid bonding and fine-pitch metal bonding will improve signal transmission speed by reducing RC delay. It is also expected to be commercialized in the future to increase the number of I/O terminals by applying it to hybrid bonding.

• ETRI Journal
• /
• v.18 no.1
• /
• pp.1-14
• /
• 1996

We have experimentally observed and theoretically analyzed the gain dependent optimum repetition rates of a hybrid-type active and passive mode locked laser pulses in an erbium-doped fiber laser of the figure-of-eight geometry by utilizing a nonlinear amplifier loop mirror (NALM) as a saturable absorber and a directional-coupler type electro-optic modulator as an active mode locker. Transform-limited mode-locked pulses of about 10 ps width were obtained at repetition rates which correspond to harmonics of the cavity fundamental frequency and depend on the optical amplifier gain in the NALM.

• ETRI Journal
• /
• v.29 no.2
• /
• pp.162-168
• /
• 2007

A new scheme for bi-directional HDTV/Gigabit Ethernet/CATV transmission over a hybrid dense-wavelength-division-multiplexing passive optical network (DWDM-PON) is proposed and demonstrated. It is based on injection-locked vertical-cavity surface-emitting lasers and distributed-feedback laser diodes as transmitters. Services with 129 HDTV channels, a 1.25 Gbps Gigabit Ethernet connection, and 77 CATV channels are successfully demonstrated over 40 km single-mode fiber links. Good performance of bit error rate, carrier-to-noise ratio, composite second order, and composite triple beat is achieved in our proposed bidirectional DWDM-PON.

• Proceedings of the KIEE Conference
• /
• 2004.11c
• /
• pp.410-413
• /
• 2004

In this paper, a simulator system for Fuel Cell Hybrid Electric Vehicles(FCHEV) is implemented using DSP boards with CAN bus. The subsystems of a FCHEV i.e., the fuel cell system, the battery system, the vehicle dynamics with the transmission mechanism are coded into 3 DSP boards. The power distribution control algorithm and battery SOC control are also coded into a DSP board. The real-time monitoring program is also developed to examine the control performance of power control and SOC control algorithms.

• IEIE Transactions on Smart Processing and Computing
• /
• v.1 no.1
• /
• pp.27-33
• /
• 2012

The Ethernet Passive Optical Network (EPON) has been considered to be one of the most promising solutions for the implementation of the Fiber To The Home (FTTH) technology designed to ameliorate the "last mile" bandwidth bottleneck. In the EPON network, an efficient and fair bandwidth allocation is a very important issue, since multiple optical network units (ONUs) share a common upstream channel for packet transmission. To increase bandwidth utilization, an EPON system must provide a way to adaptively allocate the upstream bandwidth among multiple ONUs in accordance to their bandwidth demands and requirements. We present a new hybrid method that satisfies these requirements. The advantage of our method comes from the consideration of application-specific bandwidth allocation and the minimization of the idle bandwidth. Our simulation results show that our proposed method outperforms existing dynamic bandwidth allocation methods in terms of bandwidth utilization.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.6
• /
• pp.2089-2098
• /
• 2017

Microgrid is a convenient, reliable, and eco-friendly approach for the integration of Distributed Generation (DG) sources into the utility power systems. To date, AC microgrids have been the most common architecture, but DC microgrids are gaining an increasing interest owing to the provision of numerous benefits in comparison with AC ones. These benefits encompass higher reliability, power quality and transmission capacity, non-complex control as well as direct connection to some DG sources, loads and Energy Storage Systems (ESSs). In this paper, main challenges and available approaches for the protection of AC and DC microgrids are discussed. After description, analysis and classification of the existing schemes, some research directions including coordination between AC and DC protective devices as well as development of combined control and protection schemes for the realization of future hybrid AC/DC microgrids are pointed out.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.11
• /
• pp.2457-2462
• /
• 2010

In this paper, We applied CCI canceller to remove multiple access interference in co-channel environment and improved performance of Impulse Radio UWB system. Also, we have evaluated the performance of UWB system with Truncated Type-II Hybrid ARQ scheme for achieving high quality data transmission.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.503-504
• /
• 2011

주파수가 다른 계통을 연계하거나, 장거리 선로 운전시 손실이 낮은 HVDC 송전은 환경문제로 인한 민원으로 새로운 선로건설을 위한 부지확보가 전 세계적으로 어려운 실정이다. 이 문제를 해결할 수 있는 방안으로 기존의 AC선로에 DC를 적용하여 동일철탑에 AC와 DC 선로를 같이 설치하는 하이브리드(Hybird) 선로가 제시되었다. 그러나 AC와 DC가 공존한 상태에서의 전기환경기준이 제시되지 못하고 있는 실정이다. 따라서 본 논문에서는 국내에서 운용중인 345kV 2회선 철탑에 DC선로를 적용한 하이브리드 선로의 축소모델을 제작하였고, DC선로의 도체 구성별 하이브리드 선로의 이온류 특성을 시험하였다.

• Proceedings of the KIPE Conference
• /
• 2000.07a
• /
• pp.739-743
• /
• 2000

With significant development of power electronics technology the proliferation of nonlinear loads such as such as static power converters has deteriorated power quality in power transmission distribution systems. Notably voltage harmonics resulting from current harmonies produced by the nonlinear loads have become a serious problem in many systems Moreover momentary interruptions and voltage sags are responsible for many of the power quality problems found in typical industrial plants. Int his paper proposed 3 phase hybrid series active power filter is not only for harmonic compensation but also for harmonic isolation between supply and load and for voltage regulation and imbalance compensation Through computer simulations we have verified the effectiveness of the proposed system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2A
• /
• pp.187-193
• /
• 2006

Multicarrier systems has major shortcomings due to the large numbers of subcarrier. One of the shortcomings is the high peak-to-average power ratio(PAPR), which causes nonlinearity distortion in the transmitter, and degrades the performance of the system significantly. Partial transmit sequence(PTS) is one of the best approaches that can significantly improve the statistics of the PAPR of an orthogonal frequency division multiplexing(OFDM) signal. Guided scrambling(GS) is an extension of self-synchronizing scrambling. It is also capable of guiding the scrambling process to produce a balanced encoded bit stream. In this paper, we propose a sub-optimal algorithm to optimize the phase factor in PTS. In addition, we integrate GS coding with this method. The proposed Hybrid algorithm can get much more PAPR reduction at the expense of incur a few error extension and do not require transmission of side information.