• 한국안전학회지
• /
• 제10권1호
• /
• pp.3-8
• /
• 1995

The anemometer measurements were obtained from stationary hot-film probe mounted between the forward and rear rotors of a model CRP which rotated the forward and different directions. Data collection was done at several locations between rotors. To establish rotor-rotor interaction flow mechanism that contributes noise increasement of the CRP, methods of simple and the double condition-at sampling have been developed. The former uses to find similarity of the wake the later fixes the forward rotor position in time or space and permits averaging the mean wake at any fixed rotor angular location. The variation of the forward wake Is strongly depending upon the rear rotor location.

• 한국자동차공학회논문집
• /
• 제4권3호
• /
• pp.176-186
• /
• 1996

The phenomena of drag reduction using small quantities of a liner macromolecules has attracted the attention of many experimental investigations. On the other hand drag reduction in two phase flow can be applied to the transport of crude oil, phase change system such as chemical reactor, pool and boiling flow, and to flow with cavitation which occurs pump impellers. But the research on dragreduction in two phase flow is not sufficient. The purpose of the present work is to evaluate the drag reduction by measuring pressure drop, void fraction, mean liquid velocity and turbulent intensity whether polymer additives a horizontal single and two phase system or not. Flow pattern of air-water two phase flow was classified by electrical conductivity probe signal. Velocities and turbulent intensities of signal were measured simultaneously with a Hot-film anemometer.

• 대한의용생체공학회:의공학회지
• /
• 제13권3호
• /
• pp.253-262
• /
• 1992

The wall shear stress in the vicinity of end-to end anastomoses under steady flow condi- tions was measured using a flush-mounted hot-film anemometer(FMHFA) probe. The experi- mental measurements were in good agreement lith numerical results except In flow with low Reynolds numbers. The wall shear stress increased proximal to the anastomosis in flow from the Penrose tubing (simulating an artery) to the PTFE graft. In flow from the PTFE graft to the Penrose tubing, low wall shear stress was observed distal to the anastomosis. Abnormal distributions of wall shear stress in the vicinity of the anastomosis, resulting from the compli- ance mismatch between the graft and the host artery, might be an important factor of ANFH formation and the graft failure. The present study suggests a correlation between regions of the low wall shear stress and the development of anastomotic neointimal fibrous hyperplasia (ANFH) in end-to-end anastomoses.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부 B
• /
• pp.713-716
• /
• 1998

To examine the influence of unsteady wake on the flow and heat transfer characteristics, an experiment has been conducted in a four-vane linear cascade. Flow and heat transfer measurements are made for the inlet Reynolds number of 66000(based on chord length and free-stream velocity). Turbulent intensity and stress were measured using hot wire anemometer, and to measure the convective heat transfer coefficients on the blade surfaces liquid crystal/gold film Intrex technique was used. The disturbance by the unsteady wake is characterized by the unresolved unsteadiness. The unsteady wake enhances the turbulent motion of flow in the cascade passage. It also promotes the boundary layer development and transition. The results show that heat transfer coefficients on the suction surface increase with increasing unresolved unsteadiness.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.393-396
• /
• 1998

To examine the influence of unsteady wake on the flow and heat transfer characteristics, an experiment has been conducted in a four-vane linear cascade. Flow and heat transfer measurements are made for the inlet Reynolds number of 66000(based on chord length and free-stream velocity). Turbulent intensity and stress were measured using hot wire anemometer, and to measure the convective heat transfer coefficients on the blade surfaces liquid crystal/gold film Intrex technique was used. The disturbance by the unsteady wake is characterized by the unresolved unsteadiness. The unsteady wake enhances the turbulent motion of flow in the cascade passage. It also promotes the boundary layer development and transition. The results show that heat transfer coefficients on the suction surface increase with increasing unresolved unsteadiness.

• 대한의용생체공학회:의공학회지
• /
• 제18권2호
• /
• pp.147-156
• /
• 1997

Various prosthetic heart valves have been developed and used clinically, but they have problems, such as thrombogenecity, hemoltsis, high cost and low durability. New types of trileaflet polymer heart valves have been developed in order to use them as inlet and outlet valves in a ventricular assist device. The aim of this study is to determine the hydrodynamic effectiveness of the newly designed trileaflet polymer valves and their feasibility for temporary use in the blood pumps. Trileaflet polymer valves are made of polyurethane, because of its good blood compatibility, high tonsil strength and good resistance to fatigue. An in vitro experimental investigation was perf'ormed in order to ev91ua1e hydrodynamic performance of the trileaflet polymer valves having different design and fabrication tech- niques. The St. Jude Medical valve (SJMV) and floating-type monoleaflet polymer valve (MLPV) were also tested The pressure drop across the valve, leakage volume, and the flow patterns mere investigated for valves. The result of comparative tests showed that the trileaflet polymer valves had a better hydrodynamic performance than the others. TPV which has two stable membrane shape showed the lowest back flow. The pressure hops of TPVs were lower than that of MLPV, but slightly higher than SJMV. The hydrodynamic performance of valves under the pulastile flow showed the similar results as steady flow. The velocity profiles and turbulent intensities were measured at the distal sites of valves using a hot-film anemometer. Central flow was maintained in trileaflet polymer valves, and the maximum turbulent intensities were lower in TPVs comparing to MLPV.

• 대한기계학회논문집B
• /
• 제36권1호
• /
• pp.9-16
• /
• 2012

본 논문은 열전달 유체로서 나노유체의 유용성을 평가하기 위한 장치를 설명한 것이다. 열선센서를 이용한 나노유체 대류성능 평가장치는 몇 가지가 제안되었으나 센서의 작동조건이 불명확한 단점이 있었다. 본 연구에서는 일정한 온도로 유지되는 가는 열선 주위를 흐르는 대류열전달계수를 측정하여 나노유체의 유용성을 평가하였다. 제시된 장치의 동작원리와 실험방법을 자세히 설명하였으며 먼저 순수유체에 대한 실험을 통하여 장치의 타당성을 검증하였다. 그래파이트 나노오일을 이용하여 대류열전달계수에 미치는 농도와 속도 그리고 온도의 영향을 종합적으로 고찰하였다.

• 대한기계학회논문집B
• /
• 제25권2호
• /
• pp.164-170
• /
• 2001

The influence of unsteady wake on the flow and heat transfer characteristics in a four-vane linear cascade was experimentally investigated. The unsteady wake was generated with four rotating rectangular plates located upstream of the cascade. Tested inlet Reynolds number based on chord length was set to 66,000 by controlling free-stream velocity. A hot-wire anemometer system was employed to measure turbulent velocity components. For the convective heat transfer coefficients measurement on turbine blade surface, thermochromic liquid crystal and gold film Intrex were used. It was found that the unsteady wake enhances the turbulent motion in the cascade passage and accordingly promotes the development and transition of boundary layer. It was found that the heat transfer coefficients on the blade surface increase as the plate rotating speed increases. However, the increasing of heat transfer coefficients is not significant in the case that Strouhal number is higher than 0.503.

• 대한기계학회논문집B
• /
• 제23권7호
• /
• pp.864-870
• /
• 1999

An experimental study Is conducted in a four-vane linear cascade in order to examine the influence of the wake behind rectangular bars on the flow and heat transfer characteristics. Flow and heat transfer measurements are made for the inlet Reynolds number of 66000(based on chord length and free-stream velocity). Turbulent intensity and stress are measured using a hot-wire anemometer, and to measure the convective heat transfer coefficients on the blade surface liquid crystal/gold film Intrex technique is used. Each of experimental cases is characterized by the unsteadiness measured at the entrance of the cascade. The wake behind the rectangular bars enhances the turbulent motion of the flow in the cascade passage. It also promotes the boundary layer development and transition. The results show that heat transfer coefficients on the blade surface increase with increasing unsteadiness.

• 해양환경안전학회지
• /
• 제24권1호
• /
• pp.92-100
• /
• 2018

난류경계층이 유지되기 위한 에너지 공급은 경계층 내 구조물인 와류들의 상호작용으로 끊임없이 이루어진다. 이러한 난류 유동은 수송분야의 마찰저항 및 해양구조물의 침식 및 진동을 유발하기 때문에 유동 제어를 위한 연구가 활발히 진행되고 있다. 이러한 제어의 극대화를 위해서는 난류 에너지 전달이 어떻게 이루어지는지에 대한 메카니즘 규명이 필수적이고, 이를 위해서는 층류경계층 내 유동현상으로 파악하는 것이 명확하고 용이하다는 장점이 있다. 따라서, 본 연구에서는 층류경계층 내 평판에 반구를 설치하여 역압력구배을 발생시킴으로써 교란된 유동현상의 상호작용을 분석하였다. 즉, 반구를 둘러싼 목걸이 와류와 반구 표면의 유동 박리에 의한 후류영역에서 머리핀 와류가 생성되어 상호 유기적으로 영향을 주고받는다. 이 과정에서 목걸이 와류는 후류영역으로 높은 운동량의 유체를 유입시켜 머리핀 와류의 발생 주파수를 증가시킨다. 반구 전방에 구멍을 뚫어 국부적인 흡입제어로 목걸이 와류의 와도를 감소시킴으로써 그 영향이 완화되는 과정을 유동 가시화 및 열선유속계로 측정하여 정성 및 정량적으로 분석하였다.