• 한국환경농학회지
• /
• 제25권2호
• /
• pp.109-117
• /
• 2006

Photoinhibition and photoprotection of PSII in the leaves of hot pepper (Capsicum annuum L.) grown in Hoagland solution and Tap water were compared. Though changes in the rates of $O_2$ evolution as a function of photon fluence rate (PFR) were comparable, the rates of respiration in the dark was 3 times higher in the Hoagland solution grown leaves than in the Tap-water grown ones. Compared to Hoagland solution grown plane, PSIIs of Tap water grown pepper leaves were more susceptible to photoinhibitory light treatment. In order to inactivate functional PSII to the same extents, Hoagland solution grown plants required almost 2-fold high light $(1600{\mu}molm^{-2}s^-)$ treatment than those of Tap water $(900{\mu}molm^{-2}s^-)$. Interestingly, the remaining fraction of PSII in Hoagland grown pepper was able to survive under prolonged illumination in the presence of lincomycin, which probably means that the growth condition of plant seemed to have an effect on the recovery of PSII from light stress. When PSII was severly photoinactivated at a chilling temperature, recovery was observed only if the residual functional PSII were not inhibited with DCMU, Nigericin and MV during recovery. In conclusion, PSIIs grown in the Hoagland solution was more resistant to excess light than in the Tap water grown one and the recovery of PSII from photodamage was more efficient in Hoagland grown pepper leaves than Tap water grown one, which means that the increased dark respiration may play a important role in the protection of PSII from photoinhibition by helping repair photosynthetic proteins (in particular, the D1 protein of PSII) degraded by photoinhibition.

• 한국수소및신에너지학회논문집
• /
• 제30권1호
• /
• pp.76-82
• /
• 2019

This study was investigate the characteristics of GHGs ($CO_2$, $CH_4$, and $N_2O$) emissions of diesel medium duty trucks according to their various driving modes. GHGs emissions decreased as vehicle speed increased, and emissions increased after 64.7 km/h. The 4.5 ton trucks show higher values of $CO_2$, $CH_4$, $N_2O$, 35%, 25%, and 57%, respectively, comparing of the 2.5 ton trucks. Also, $CO_2$ emissions under WHVC mode were 20% lower than those under the NEDC mode. In the case of cold start condition, $CO_2$ emissions were 12-13% higher than those for hot start condition. In the future, the result of present study will provide basic data to set up GHGs emission standards for medium and heavy duty vehicles.

• 콘크리트학회논문집
• /
• 제25권2호
• /
• pp.201-207
• /
• 2013

여름철 서중 콘크리트 타설시 높은 온도로 인하여 시멘트 수화반응이 촉진되어 수분의 증발 및 응결이 빨라지게 되며, 이로 인해 컨시스턴시(consistency)가 크게 저하되고, 콜드조인트(cold joint)가 발생한다. 이러한 문제 해결을 위하여 냉각 파이프, 얼음, 액체질소 등을 사용한 냉각 등의 방법이 사용되고 있으나, 사용상의 어려움과 에너지 소비에 따른 경제성 감소 등의 문제점을 가지고 있다. 이 중 지연제의 사용은 경제적이지만 첨가량을 과도하게 사용하면 콘크리트의 경화불량이 발생하기 쉽고, 응결시간 관리가 어려울 수 있다. 또한, 현재 지연제의 인력투입으로 인한 정확한 계량 및 투입이 어렵고 분진발생 등 작업성에 문제가 있다. 따라서 이 연구에서는 분말형 지연제를 의약분야에서 보편적으로 사용하는 정제화 방법을 이용하여 타블렛을 제작하였고, 모르타르의 플로우 테스트 및 응결 시험을 검토한 이 후 콘크리트의 물리적 특성 및 역학적 특성 시험을 실시하여 품질성능에 영향을 미치는지 확인 하였다. 그 결과 리그닌 설폰산염 지연제보다 글루코산염 지연제를 정제화 했을 때 보다 좋은 효과를 발휘 하는 것을 보여 주었다. 또한, 정제화 방법 적용으로 인해 콘크리트의 품질성능을 저하하지 않고 정확한 계량 및 분진발생 등과 같은 관리상의 어려움을 해결할 수 있는 가능성을 보여주었다.

• 한국전기전자재료학회논문지
• /
• 제17권3호
• /
• pp.348-352
• /
• 2004

The mold transformers have been widely used in underground substations in large building and have some advantages in comparison to oil-transformer, that is low fire risk, excellent environmental compatibility, compact size and high reliability. In addition, the application of mold transformer for outdoor is possible due to development of epoxy resin. The mold transformer generally has cooling duct between low voltage coil and high voltage coil. A mold transformer made by one body molding method has been developed for small size and ow loss, but it needs some cooling method because heat radiation between each winding is difficult. The life of transformer is significantly dependent on the thermal behavior in windings. Many transformer designers have calculated temperature distribution and hot spot point by finite element method(FEM) to analyze winding temperature rise. In this paper, The thermal analysis of pole mount mold transformer with one body molding by duct condition is investigated and the test result of temperature rise is compared with simulation data.

• 디지털융복합연구
• /
• 제6권2호
• /
• pp.87-95
• /
• 2008

Information technology is rapidly diffused throughout the world. Unfortunately, as the technology goes on the disabled vocational rehabilitation is more isolated in physically and mentally. A new paradigm, 'Digital practical use Opportunity' is a product of the tremendous technological changes driving the disabled vocational rehabilitation. The employment for the disabled vocational rehabilitation is a hot issue. Because lack of education rehabilitation cause many problems for the employer. Relating program of employment and education for the disabled vocational rehabilitation, they can get a job in a better condition. This study propose a model of good environmental employment for the disabled vocational providing them the way of getting a job so that they can go as a member of highly developed society. It conducted in society could fundamentally advance our knowledge about the structure of the employment of the disabled vocational rehabilitation, cure their feelings, give them a chance to live happier, stronger, healthier.

• 한국의류산업학회지
• /
• 제7권1호
• /
• pp.75-80
• /
• 2005

The purpose of this study was to investigate the effects of silt ventilation system on physiological responses. We measured rectal temperature, local skin temperature, clothing microclimate, blood pressure, heart rate, energy metabolism, body weight loss and subjective sensation during 70 minute, 50 min exercise period and 20 min rest period. The five women subjects randomly wore sportswear without slit ventilation system(NS sportswear) and sportswear with slit ventilation system(S sportswear) under the environmental condition of $25^{\circ}C$, 50%RH. The results of this study are as follows; Rectal temperature, mean skin temperature, clothing microclimate, blood pressure, heart rate, energy metabolism and body weight loss were significantly lower level in 'S sportswear'. In 'S sportswear', subjects replied less hot, less uncomfortable and less wet. Slit ventilation system can be used for bellow effect which is meaningful device of convection during exercise. We could find out that 'S sportswear' has advantage in physiological function.

• 한국안전학회지
• /
• 제21권1호
• /
• pp.6-14
• /
• 2006

The development of automatic production systems have required intelligent diagnostic and monitoring functions to overcome system failure and reduce production loss by the failure. In order to perform accurate operations of the intelligent system, implication about total system failure and fault analysis due to each mechanical component failures are required. Also solutions for repair and maintenance can be suggested from these analysis results. As an essential component of a mechanical system, a bearing system is investigated to define the failure behavior. The bearing failure is caused by lubricant system failure, metallurgical deficiency, mechanical condition(vibration, overloading, misalignment) and environmental effects. This study described slab transfer equipment fault train due to stress variation and metallurgical deficiency from lubricant failure by using FTA.

• 천문학회보
• /
• 제41권1호
• /
• pp.34.2-34.2
• /
• 2016

X-ray cavities are typically detected as surface brightness depression in X-ray diffuse emission from hot gas in high resolution X-ray images (i.e., Chandra and XMM-Newton). Showing the coincidence of location with radio jets, X-ray cavities imply that the radio jets interact with interstellar/intergalactic medium. It is important to understand them since they can be a clue of understanding AGN feedback to their host galaxies. To understand the physics of the AGN feedback, X-ray cavity has been actively studied while there are only a few statistical studies on X-ray cavity based on small or incomplete samples. Hence, a systematic study with a large sample is needed. With the condition of sufficient X-ray photons to detect surface brightness depression, we constructed a large sample of 133 galaxy clusters, galaxy groups, and individual galaxies to investigate X-ray cavities. We detected 201 cavities from 94 objects using two detection methods (i.e., beta-modeling and unsharp masking method), and confirmed the cavity size-distance relation over a large dynamical range. The size-distance relation does not vary for different environments (i.e., galaxy cluster, groups, and individual galaxies), suggesting that there is little environmental effect on the formation of X-ray cavity.

• The Plant Pathology Journal
• /
• 제23권3호
• /
• pp.174-179
• /
• 2007

Seedlot disinfection techniques to control mung bean sprout rot caused by Colletoricum acutatum and C. gloeosporioides were evaluated for commercial production scheme. Soaking seedlots in propolis (100 X) and ethanol (20% for 30 min) appeared promising with control values of 85.5 and 80.8 respectively, but still resulted in up to 20% rot incidence. None of the C. acutatum conidia survived through hot water immersion treatment (HWT) for 10 min at temperatures of 55, 60 and $65^{\circ}C$, whereas the effective range of the dry heat treatment (DHT) was $60-65^{\circ}C$. Tolerance of mung bean seedlot, as estimated by hypocotyl elongation and root growth, was lower for HWT than for DHT. Germination and growth of sprouts were excellent over the range of $55-65^{\circ}C\;at\;5^{\circ}C$ intervals, except for HWT at $65^{\circ}C$ for 5 min. At this marginal condition, heat damage appeared so that approximately 2% of seeds failed to sprout to normal germling and retarded sprouts were less than 5% with coarse wrinkled hypocotyls. These results suggested that DHT would be more feasible to disinfect mung bean seedlots for commercial sprout production. Heat treatment at above ranges was highly effective in eliminating the epiphytic bacterial strains associated with marketed sprout rot samples. HWT of seedlot at 55 and $60^{\circ}C$ for 5 min resulted in successful control of mung bean sprout rot incidence with marketable sprout quality. DHT at 60 and $65^{\circ}C$ for 30 min also gave good results through the small-scale sprouting system. Therefore, we optimized DHT scheme at 60 and $65^{\circ}C$ for 30 min, considering the practical value of seedlot disinfection with high precision and accuracy. This was further proved to be a feasible and reliable method against anthracnose incidence and those bacterial strains associated with marketed sprout rot samples as well, through factory scale mung bean sprout production system.

• 한국환경과학회지
• /
• 제22권11호
• /
• pp.1509-1517
• /
• 2013

So far, most studies associated with soil carbon sequestration have been focused on long term aspect. However, information regarding soil carbon sequestration in short term aspect is limited. This study was conducted to determine changes of soil organic carbon content and stability of carbon in response to compost application rate and tillage management during rice growing season(150 days) in short term aspect. Under pot experiment condition, compost was mixed with an arable soil at rates corresponding to 0, 6, 12, and 24 Mg/ha. To determine effect of tillage on soil carbon sequestration, till and no-till treatments were set up in soils amended with application rate of 12 Mg/ha. Compost application and tillage management did not significantly affect soil organic carbon(SOC) content in soil at harvest time. Bulk density of soil was not changed significantly with compost application and tillage management. These might result from short duration of experiment. While hot water extractable organic carbon(HWEOC) content decreased with compost application, humic substances(HS) increased. Below ground biomass of rice increased with application of compost and till operation. From the above results, continuos application of compost and reduce tillage might improve increase in soil organic carbon content and stability of carbon in long term aspect.