• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.361-362
• /
• 2005

Antimony doped tin oxide(ATO) nano powders have been synthesized by homogeneous precipitation method using $SnCl_4\cdot5H_2O$ for precursor, $SbCl_3$ as doped material and urea. The hydrolysis of urea and conductive mechanism and Heat treatment was performed at the temperature from $500^{\circ}C$ to $700^{\circ}C$ in air. The ATO nano powders are characterized by means of Thermogravimetry differential thermal analyzer (TG-DTA), X-ray diffraction (XRD), Brunauer, Emmett, and Teller adsorption (BET), Scanning electron microscopy (SEM) ATO nano powders with an average size of nm and the highest surface area 129 $m^2g^{-1}$ are obtained.

• Journal of the Korean Ceramic Society
• /
• v.26 no.1
• /
• pp.132-138
• /
• 1989

High purity(99.99%) spherical particles of hydrated Basic Aluminum Salts(BAS) were prepared by a homogeneous precipitation process utilizing the urea decomposition reaction and characterized by XRD, SEM, TG-DTA, IR and PSA methods. Amorphous hydrated BAS was precipitated in the range of pH 4~6. The molar ratio [Al3+]/[SO42-] for the precipitate particles was about 3.7. With increasing the concentration of aluminum sulfate the precipitation of the hydrated BAS occurred slowly and the precipitate particles with a narrow size distribution were fine(1-2${\mu}{\textrm}{m}$ in diameter). At temperatures in the range 400$^{\circ}$to 95$0^{\circ}C$, desulfurization and dehydroxylization resulted in weight loss with 22%. When the precipitate particles were thermally treated, the crystlline ${\gamma}$-Al2O3 was identifited by XRD at 50$0^{\circ}C$ and ${\gamma}$-Al2O3 particles were transformed into $\alpha$-Al2O3 at 100$0^{\circ}C$. A vermicular network was produced by calcining at 125$0^{\circ}C$ for 30min.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.2
• /
• pp.185-193
• /
• 2004

A catalyst with CuO ceramic filter for simultaneous treatment of dust and HAP was prepared and characterized. Catalytic ceramic filter can not only potentially achieve the substantial savings in energy but provide with effective optimization and integration of process for simultaneous removal of SO$_2$, NO$_{x}$ and particulates from flue gases. Catalytic ceramic filters remove simultaneously particulates on exterior surface of filters and reduce NO to $N_2$ and $H_2O$ by SCR (Selective Catalytic Reduction) process. Preparation of catalyst impregnated ceramic filter with disk shape (Ψ 50) follow the processing of alumino-silicate ceramic filter, support impregnation and catalyst impregnation (copper oxide). Preparation routes of alumino-silicate catalyst carrier suitable for production of catalytic filters practically were studied and developed using the sol-gel and colloidal processing, homogeneous precipitation and impregnation method. Characterization of the catalyst, catalyst carrier catalytic filter materials have been performed the using various techniques such as BET, XRD, TGA, SEM. Combination of the sol-gel and colloidal processing and impregnation method is recommended to prepare catalyst carriers economically for catalytic filter applications.s.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.1
• /
• pp.163-166
• /
• 1997

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.12 no.3
• /
• pp.149-156
• /
• 2002

Europium-activated $Ga_2O_3$ phosphor powders were prepared by homogeneous precipitation method. The resulting powders were characterized by means of TG/DTA, XRD, FT-IR and SEM, Two kinds of powders formed were the crystalline GaOOH and the amorphous-like $\gamma$-$Ga_2O_3$ phases. When the urea concentration was below 0,5 M, rod-like micrometer-sized GaOOH powders were formed. They were transformed via $\alpha$-$Ga_2O_3$ to $\beta$-$Ga_2O_3$ phases under heat treatment. On the other hand, the nanometer-sized $\gamma$-$Ga_2O_3$ powders were formed with urea concentrations higher than 1.0 M, and they were directly changed into $\beta$-$Ga_2O_3$.Photoluminescence (PL) spectra were observed at room temperature, and PL intensities of nanometer-sized $Ga_2O_3$ : $Eu^{3+}$ powders around 610 nm were higher than those of micrometer-sized ones.

• Journal of Korea Water Resources Association
• /
• v.38 no.8 s.157
• /
• pp.595-604
• /
• 2005

Precipitation simulation for making the data size larger is an important task for hydrologic analysis. The simulation can be divided into two major categories which are the parametric and nonparametric methods. Also, precipitation simulation depends on time intervals such as daily or hourly rainfall simulations. So far, Markov model is the most favored method for daily precipitation simulation. However, most models are consist of state transition probability by using the homogeneous Markov chain model. In order to make a state vector, the small size of data brings difficulties, and also the assumption of homogeneousness among the state vector in a month causes problems. In other words, the process of daily precipitation mechanism is nonstationary. In order to overcome these problems, this paper focused on the nonparametric method by using uni-variate and multi-variate when simulating a precipitation instead of currently used parametric method.

• Applied Chemistry for Engineering
• /
• v.21 no.4
• /
• pp.440-444
• /
• 2010

$SnO_2$ powders were prepared from the calcination of stannic acids precipitated from the aqueous solution of $SnCl_4$ with ammonium nitrate as a precipitator at $90^{\circ}C$. For the comparison of properties, the stannic acids were prepared from the homogeneous precipitation method using urea as a precipitator at the same temperature. The stannic acid from ammonium nitrate at a thermal gravity analysis showed the weight loss until $700^{\circ}C$ and the percentage of total weight loss was 16.5%. The crystallization of stannic acid into $SnO_2$ finished in the calcination at $600^{\circ}C$ for 2 h. The crystallite size of $SnO_2$ increased with the increase of calcination temperature and initial concentration of $SnCl_4$ solution. In case of the same calcination condition, $SnO_2$ prepared from homogeneous precipitation using urea had a relatively smaller crystallite size rather than $SnO_2$ prepared from ammonium nitrate.

• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.1
• /
• pp.51-63
• /
• 1997

Total suspended particulate matters in the ambient air were analyzed for eight chemical elements (Ca, Co, Cu, Fe, Mn, Pb, Si, and Zn) using an x-ray fluorescence spectrometry (XRF) at the Kyung Hee University - Suwon Campus during 1989 to 1994. To use these data as basis for source identification study, membership of each sample was selected to represent one of the well defined sample groups. The data sets consisting of 83 objects and 8 variables were initially separated into two groups, fine (d$_{p}$<3.3 ${\mu}{\textrm}{m}$) and coarse particle groups (d$_{p}$>3.3 ${\mu}{\textrm}{m}$). A hierarchical clustering method was examined to obtain possible member of homogeneous sample classes for each of the two groups by transforming raw data and by applying various distances. A disjoint principal component analysis was then used to define homogeneous sample classes after deleting outliers. Each of five homogeneous sample classes was determined for the fine and the coarse particle group, respectively. The data were properly classified via an application of logarithmic transformation and Euclidean distance concept. After determining homogeneous classes, correlation coefficients among eight chemical variables within all the homogeneous classes for calculated and meteorological variables (temperature. relative humidity, wind speed, wind direction, and precipitation) were examined as well to intensively interpret environmental factors influencing the characteristics of each class for each group. According to our analysis, we found that each class had its own distinct seasonal pattern that was affected most sensitively by wind direction.ion.

• The Journal of Engineering Geology
• /
• v.18 no.1
• /
• pp.1-6
• /
• 2008

Precipitation and groundwater level data sets from Kum river watershed were analyzed and compared. The correlation between groundwater level and the moving average of precipitation was analyzed. Moving averaging technique is stochastic method and that was used to consider the effect of precipitation events on groundwater level fluctuation. Groundwater level generally follows seasonal precipitation pattern and low level occurs from early December to late April. Relatively high groundwater level is appeared in wet spell (July and August). The correlation between groundwater level and the moving average of precipitation to consider precedent precipitation events was analyzed with minimum two-year data sets. When the precipitation and groundwater level data set pair was selected the precipitation gauge station is closely located to groundwater level gauge station in the upstream direction to minimize the non-homogeneous precipitation distribution effect. The maximum correlation was occurred when the averaging periods were from 10 days to 150 days with Kum river watershed data. The correlation coefficients are influenced by data quality, missing data periods, or snow melt effect, etc. The maximum coefficient was 0.8886 for Kum river watershed data.

• Journal of the Korean Ceramic Society
• /
• v.26 no.3
• /
• pp.423-437
• /
• 1989

Al2O3/ZrO2 composites were prepared by precipitation method using Al2(SO4)3.18H2O, ZrOCl2.8H2O and YCl3.6H2O as starting materials and NH4OH as a precipitation agent. Al2O3/ZrO2 composites(series A) were prepared by mixing Al2O3 powder obtained by single precipitation method with ZrO2(＋3m/o Y2O3) powder obtained by co-predipitation method. Al2O3/ZrO2 composites (series B) were prepared by co-precipitation method using the three starting materials. In all cases, the composition was controlled as Al2O3-15v/o ZrO2(＋3m/o Y2O3). The composites of series A showed higher final relative densities than those of series B and tetagonal ZrO2 in all cases was retained to about 95% at room temperature. ZrO2 particles were coalesced more rapidly in grain boundary of Al2O3 than within Al2O3 grain. ZrO2 particles were located at 3-and 4-grain junction of Al2O3 and limited the grain growth of Al2O3. It was observed that MgO contributed to densification of Al2O3 but limited grain growth of Al2O3 by MgO was not remarkable. In all Al2O3/ZrO2 composites, exaggerated grain growth of Al2O3 was not observed and Al2O3/ZrO2 composites were found to have homogeneous microstructures.