• Journal of the Korean Ceramic Society
• /
• v.41 no.8
• /
• pp.623-627
• /
• 2004

Phase formation and electrical conduction behavior of Ba-doped LaBaGa $O_4$ layered perovskite were studied. Orthorhombic single phase of $K_2$Ni $F_4$-type structure was observed for the composition range of 0$\leq$x$\leq$0.2 in the La$\_$1＋x/Ba$\_$1＋x/Ga $O_4$$\_$4-$\delta$/ system by X-ray analysis. In the dry atmosphere, La$\_$0.8/Ba$\_$1.2/Ga$\_$3.9/ exhibited mixed conduction of oxygen ion and hole (p-type) at high p( $O_2$). However, in water vapor containing atmosphere, it showed proton conduction due to the incorporation of water into oxygen vacancies. As the temperature decreased, the contribution of proton conductivity to the total conduction increased and proton conduction was dominant below 350$^{\circ}C$. The activation energy for proton conduction was calculated as 0.72 eV.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.119-119
• /
• 2011

This study examined the synthesis of large area graphene and the change of its characteristics depending on the ratio of CH4/H2 by using the thermal CVD methods and performed the experiments to control the electron-hole conduction and Dirac-point of graphene by using chemical doping methods. Firstly, with regard to the characteristics of the large area graphene depending on the ratio of CH4/H2, hydrophobic characteristics of the graphene changed to hydrophilic characteristics as the ratio of CH4/H2 reduces. The angle of contact also increased to 78$^{\circ}$ from 58$^{\circ}$. According to the results of Raman spectroscopy showing the degree of defect, the ratio of I(D)/I(G) increases to 0.42% from 0.25% and the surface resistance also increased to 950 ${\Omega}$ from 750 ${\Omega}$/sq. As for the graphene synthesis at the high temperature of 1,000$^{\circ}$ by using CH4/H2 in a Cu-Foil, the possibility of graphene formation was determined as a function of the ratio of H2 included in the fixed quantity of CH4 as per specifications of every equipment. It was observed that the excessive amount of H2 prevented graphene from forming, as extra H-atoms and molecules activated the reaction to C-bond of graphene. Secondly, in the experiment for the electron-hole conduction and the Dirac-point of graphene using the chemical doping method, the shift of Dirac-point and the change in the electron-hole conduction were observed for both the N-type (PEI) and the P-type (Diazonium) dopings. The ID-VG results show that, for the N-type (PEI) doped graphene, Dirac-point shifted to the left (-voltage direction) by 90V at an hour and by 130 V at 2 hours respectively, compared to the pristine graphene. Carrier mobility was also reduced by 1,600 cm2/Vs (1 hour) and 1,100 cm2/Vs (2 hours), compared to the maximum hole mobility of the pristine graphene.

• Journal of Magnetics
• /
• v.10 no.3
• /
• pp.95-98
• /
• 2005

We report hole-induced ferromagnetism in diluted magnetic semiconductor $Zn_{0.99}Mn_{0.01}$ films grown on $SiO_2/Si$ substrates by reactive sputtering. The p-type conduction with hole concentration over $10^{18}\;cm^{-3}$ is achieved by P doping followed by rapid thermal annealing at $800^{\circ}C$ in a $N_2$ atmosphere. The p-type $Zn_{0.99}Mn_{0.01}O:P$ is carefully examined by x-ray diffraction and transmission electron microscopy. The magnetic measurements for $p-Zn_{0.99}Mn_{0.01}O:P$ clearly reveal ferromagnetic characteristics with a Curie temperature above room temperature, whereas those for $n-Zn_{0.99}Mn_{0.01}O:P$ show paramagnetic behavior. The anomalous Hall effect at room temperature is observed for the p-type film. This result strongly supports hole-induced room temperature ferromagnetism in $p-Zn_{0.99}Mn_{0.01}O:P$.

• Journal of Magnetics
• /
• v.12 no.4
• /
• pp.144-148
• /
• 2007

We report on the observation of p-type conductivity and ferromagnetism in diluted magnetic semiconductor $(Zn_{0.97}Mg_{0.01}Mn_{0.02})O:P$ films grown on $SiO_2/Si$ substrates by pulsed laser deposition. The p-type conduction with hole concentration over $10^{18}cm^{-3}$ is obtained by codoping of Mg and P followed by rapid thermal annealing in an $O_2$ atmosphere. Structural and compositional analyses for the p-type $(Zn_{0.97}Mg_{0.01}Mn_{0.02})O:P$ films annealed at $800^{\circ}C$ indicates that highly c-axis oriented homogeneous films were grown without any detectable formation of secondary phases. The films were found to be transparent in the visible range. The magnetic measurements clearly revealed an enhancement of room temperature ferromagnetism by p-type doping.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.87-87
• /
• 2011

Oxide semiconductors are attractive materials for thin-film electronics and optoelectronics due to compatibility with synthesis on large-area, glass and flexible substrate. However, development of thin-film electronics has been hampered by the limited number of semiconducting oxides that are p-type. We report on the effect of the oxygen partial pressure ratio in the gas mixture on the electrical and optical properties of spinel Mg:$ZnCo_2O_4$ thin films deposited at room temperature using RF sputtering, that exhibit p-type conduction. The thin-films are deposited at room temperature in a background of oxygen using a polycrystalline Mg:$ZnCo_2O_4$ ablation target. The p-type conduction is confirmed by positive Seebeck coefficient and positive Hall coefficient. The electrical resistivity and carrier concentration in on dependent Mg:$ZnCo_2O_4$ thin films were found to be dependent on the oxygen partial pressure ratio. As a result, it is revealed that the Mg:$ZnCo_2O_4$ thin-films were greatly influenced on the electrical and optical properties by the oxygen partial pressure condition. The visible region of the spectrum of 36~85%, and hole mobility of 1.1~3.7 $cm^2$/Vs, were obtained.

• Advances in nano research
• /
• v.2 no.1
• /
• pp.1-14
• /
• 2014

Dislocations are basic crystal defects and represent one-dimensional native nanostructures embedded in a perfect crystalline matrix. Their structure is predefined by crystal symmetry. Two-dimensional, self-organized arrays of such nanostructures are realized reproducibly using specific preparation conditions (semiconductor wafer direct bonding). This technique allows separating dislocations up to a few hundred nanometers which enables electrical measurements of only a few, or, in the ideal case, of an individual dislocation. Electrical properties of dislocations in silicon were measured using MOSFETs as test structures. It is shown that an increase of the drain current results for nMOSFETs which is caused by a high concentration of electrons on dislocations in p-type material. The number of electrons on a dislocation is estimated from device simulations. This leads to the conclusion that metallic-like conduction exists along dislocations in this material caused by a one-dimensional carrier confinement. On the other hand, measurements of pMOSFETs prepared in n-type silicon proved the dominant transport of holes along dislocations. The experimentally measured increase of the drain current, however, is here not only caused by an higher hole concentration on these defects but also by an increasing hole mobility along dislocations. All the data proved for the first time the ambipolar behavior of dislocations in silicon. Dislocations in p-type Si form efficient one-dimensional channels for electrons, while dislocations in n-type material cause one-dimensional channels for holes.

• Korean Journal of Materials Research
• /
• v.13 no.8
• /
• pp.519-523
• /
• 2003

We report the synthesis of cubic spinel $ZnCo_2$$O_4$thin films and the tunability of the conduction type by control of the oxygen partial pressure ratio. Zinc cobalt oxide films were grown on$ SiO_2$(200 nm)/Si substrates by reactive magnetron sputtering method using Zn and Co metal targets in a mixed Ar/$O_2$atmosphere. We found from X-ray diffraction measurements that the crystal structure of the zinc cobalt oxide films grown under an oxygen-rich condition (the $O_2$/Ar partial pressure ratio of 9/1) changes from wurtzite-type $Zn_{1-x}$ $Co_{X}$O to spinel-type $ZnCo_2$$O_4$with the increase of the Co/Zn sputtering ratio,$ D_{co}$ $D_{zn}$ . We noted that the above structural change accompanied by the variation of the majority electrical conduction type from n-type (electrons) to p-type (holes). For a fixed $D_{co}$ $D_{zn}$ / of 2.0 yielding homogeneous spinel-type $_2$O$ZnCo_4$films, the type of the majority carriers also varied, depending on the$ O_2$/Ar partial pressure ratio: p-type for an $O_2$-rich and n-type for an Ar-rich atmosphere. The maximum electron and hole concentrations for the Zn $Co_2$ $O_4$films were found to be 1.37${\times}$10$^{20}$ c $m^{-3}$ and 2.41${\times}$10$^{20}$ c $m^{-3}$ , respectively, with a mobility of about 0.2 $\textrm{cm}^2$/Vs and a high conductivity of about 1.8 Ω/$cm^{-1}$ /.

• Korean Journal of Materials Research
• /
• v.18 no.2
• /
• pp.84-91
• /
• 2008

The effects of the deposition and annealing temperature on the structural, electrical and optical properties of Ag doped ZnO (ZnO : Ag) thin films were investigated. All of the films were deposited with a 2wt% $Ag_2O-doped$ ZnO target using an e-beam evaporator. The substrate temperature varied from room temperature (RT) to $250^{\circ}C$. An undoped ZnO thin film was also fabricated at $150^{\circ}C$ as a reference. The as-grown films were annealed in temperatures ranging from 350 to $650^{\circ}C$ for 5 h in air. The Ag content in the film decreased as the deposition and the post-annealing temperature increased due to the evaporation of the Ag in the film. During the annealing process, grain growth occurred, as confirmed from XRD and SEM results. The as-grown film deposited at RT showed n-type conduction; however, the films deposited at higher temperatures showed p-type conduction. The films fabricated at $150^{\circ}C$ revealed the highest hole concentration of $3.98{\times}1019\;cm^{-3}$ and a resistivity of $0.347\;{\Omega}{\cdot}cm$. The RT PL spectra of the as-grown ZnO : Ag films exhibited very weak emission intensity compared to undoped ZnO; moreover, the emission intensities became stronger as the annealing temperature increased with two main emission bands of near band-edge UV and defect-related green luminescence exhibited. The film deposited at $150^{\circ}C$ and annealed at $350^{\circ}C$ exhibited the lowest value of $I_{vis}/I_{uv}$ of 0.05.

• Bulletin of the Korean Chemical Society
• /
• v.13 no.3
• /
• pp.248-252
• /
• 1992

$ZrO_2-dopedYb_2O_3solid$ solutions containing 1, 3, 5, 7 and 9 mol% $ZrO_2were$ synthesized from spectroscopically pure $Yb_2O_3$ and $ZrO_2$ powders and found to be rare earth C-type structure by XRD technique. Electrical conductivities were measured as a function of temperatures from 700 to $1050^{\circ}C$ and oxygen partial pressures from 1${\times}$$10^-5$ to 2${\times}$ $10^-1$atm. The electrical conductivities depend simply on temperature and the activation energies are determined to be 1.56-1.68 $_eV$. The oxygen partial pressure dependence of the electrical conductivity shows that the conductivity increases with increasing oxygen partial pressure, indicating p-type semiconductor. The $PO_2$ dependence of the system is nearly power of 1/4. It is suggested from the linearity of the temperature dependence of electrical conductivity and only one value of 1/n that the solid solutions of the system have single conduction mechanism. From these results, it is concluded that the main defects of the system are negatively doubly charged oxygen interstitial in low. $ZrO_2doping$ level and negatively triply charged cation vacancy in high doping level and the electrical conduction is due to the electronic hole formed by the defect structure.

• Journal of the Korean Chemical Society
• /
• v.28 no.3
• /
• pp.149-154
• /
• 1984

The electrical conductivity of p-type yttrium sesquioxide has been measured as a function of temperature and of oxygen partial pressure at temperatures from 650 to 1050$^{\circ}C$C and oxygen partial pressures from $1 {\times}10^{-5}\;to\;2{\times}10^{-1}$atm. Plots of log conductivity vs. 1/T at constant oxygen partial pressures are found to be linear with low-and high-temperature dependences of conductivity. The high-temperature dependence of conductivity shows two different defect structures. The plots of log conductivity vs. log $Po_2$ are found to be linear at $Po_2$'s of $10^{-5}\;to\;10^{-1}$ atm. The electrical conductivity dependences on $Po_2$ are found to be ${{\sigma}{\propto}Po_2}^{1/6}$at $850{\sim}950^{\circ}C,\;{{\sigma}{\propto}Po_2}^{3/16}$ at $950{\sim}1050^{\circ}C\;and\;{{\sigma}{\propto}Po_2}^{1/7.5}{\sim}{{\sigma}{\propto}Po_2}^{1/8.3}\;at\;650{\sim}800^{\circ}C$, respectively. The defect structures are$O_i{''}$ at $850{\sim}950^{\circ}C$ and $V_M{'''}$ at $950{\sim}1050^{\circ}C$. The electron hole is main carrier type, however, ionic contribution is found at lower temperature portion.