• Journal of Korean Society of Transportation
• /
• v.24 no.3 s.89
• /
• pp.51-61
• /
• 2006

Interchanges are passages for vehicle and pedestrians and a gateway to nearby facilities, and a place to stay of vehicle and Pedestrians. Interchange traffic must be able to navigate well for safety and convenience. Traffic safety and efficiency are influenced by the interchange. In this study, relative delays of vehicles are compared by changing traffic interchanges. the volume of traffic, the number of lanes, the rate of left turns vehicle on the interchanges of urban arterial roads. The object of this study is to compare Grade crossing interchange, Diamond interchange. Roundabout interchange. SPUI(Single Point Urban Interchange), Echelon interchange). Echelon interchange. By VISSIM Simulation, this study drew the relative delay value of every scenario and compared the delay value of each vehicle considering construction expenses. Through this comparison study, ideal interchange is dependent on the volume of traffic, the number of lanes, and the rate of left turns.

• Journal of Korean Society of Transportation
• /
• v.25 no.6
• /
• pp.65-77
• /
• 2007

A two-way left-turn lane is a continuous center left-turn lane that could be used as a deceleration and refuge area for both directions of left-turning vehicles. TWLTL's have been used effectively for access management treatment when applied to a highway that has wide-spread left turning traffic demand and a high-density of side streets. In this study, an effective analysis was carried out using a computer-based simulation tool, VISSIM, in order to evaluate performance and safety effects of TWLTLs and develop a warrant. In conclusion, the results indicated that there was a remarkable decrease of through and left-turning vehicle travel time delay on the main road and improvement of traffic safety.

• International Journal of Highway Engineering
• /
• v.6 no.2 s.20
• /
• pp.37-45
• /
• 2004

The asphalt concrete pavement takes various advantages of better riding quality, serviceability and easier maintenance. At the same time, it addresses a weak point of the premature failures due to rapid increasement of traffic volume, heavy vehicles and high temperature in summer. It increases the expenditure of maintenance and repair. In order to improve the performance of asphalt pavement avoiding this premature failure, the use reinforcements with geosynthetics have been considered. Geosynthetics are known as an effective reinforcement to restrain fatigue and reflective cracks in asphalt pavements. In this study, a comprehensive parametric study is conducted to capture the efficiency of geosynthetic-reinforcements using viscoelastic properties of the asphalt concrete(AC) layer. The investigated parameters were reinforcement location, AC layer thickness, temperature distribution across the AC layer and modulus of AC and base layer. As a result of observations, that reinforced asphalt concrete could be used effectively for improving resistance against fatigue cracks and permanent deformation. Especially, when a geogrid was placed at the interface between the asphaltic base and the subbase, tensile stress in the horizontal direction was significantly reduced.

• International Journal of Highway Engineering
• /
• v.19 no.4
• /
• pp.69-78
• /
• 2017

PURPOSES : In this study, we analyzed the road crossing behavior of older pedestrians on a mid-block signalized crosswalk, and compared it to that of younger pedestrians. In addition, we analyzed the correlation between accidents involving older pedestrians while crossing roads and their behavioral characteristics. Finally, we confirmed the reasons for an increase in accidents involving older pedestrians. METHODS : First, 30 areas with the highest incidence of accidents involving older pedestrians while crossing roads were selected as target areas for analysis. Next, we measured the start-up delay (the time elapsed from the moment the signal turns green to the moment the pedestrian starts walking) and head movement (the number of head turns during crossing a road) of 900 (450 older and 450 younger) pedestrians. The next step was to conduct a survey and confirm the differences in judgment between older and younger pedestrians about approaching vehicles. Finally, we analyzed the correlation between the survey results and traffic accidents. RESULTS : The average start-up delay and head movement of the older pedestrians was 1.58 seconds and 3.15 times, respectively. A definite correlation was obtained between head movement and the frequency of pedestrian traffic accidents. The results of our survey indicate that 17.3% of the older pedestrians and 7.8% of the younger pedestrians have a high crash risk. CONCLUSIONS : Behavioral characteristics of older pedestrians were closely correlated with accidents involving older pedestrians while crossing roads in mid-block signalized crosswalks. Our study indicates that in order to reduce the number of accidents involving older pedestrians, it is necessary to develop an improvement plan including measures such as installation of safety facilities taking the behavioral characteristics of older pedestrians into consideration and their safety education.

• Journal of Korean Society of Transportation
• /
• v.29 no.6
• /
• pp.85-93
• /
• 2011

The width of sidewalk is one of the important factors constructing a pleasant pedestrian environment. The procedure for sidewalk width design based on the Level of Service is suggested in Korea Highway Capacity Manual. However, this manual does not give a difference between the sidewalk on the street with the passage of the subway, therefore, the different flow characteristic of these places is not appropriately reflected. Though the pedestrian flow in the subway encounters a frequent stop and go situation as like the platoon of vehicles, the similar condition is rarely observed at the urban streets. The new measure of LOS for sidewalk is in need. The study reviewed the prominent measure of LOS and carried out the outdoor experiment to evaluate the new measure. Particularity, GPS was used to collect the pedestrian foot path trajectory for the quantitative evaluation and the results from quantitative and qualitative are compared.

• Tunnel and Underground Space
• /
• v.13 no.6
• /
• pp.434-443
• /
• 2003

In this study, it was purposed to develop the new method for the prediction of pollutant concentration in road tunnels. The new method was the use of artificial neural network with the back-propagation algorithm which can model the non-linear system of tunnel environment. This network system was separated into two parts as the visibility and the CO concentration. For this study, data was collected from two highway road tunnels on Yeongdong Expressway. The tunnels have two lanes with one-way direction and adopt the longitudinal ventilation system. The actually measured data from the tunnels was used to develop the neural network system for the prediction of pollutant concentration. The output results from the newly developed neural network system were analysed and compared with the calculated values by PIARC method. Results showed that the prediction accuracy by the neural network system was approximately five times better than the one by PIARC method. In addition, the system predicted much more accurately at the situation where the drivers have to be stayed for a while in tunnels caused by the low velocity of vehicles.

• International Journal of Highway Engineering
• /
• v.20 no.2
• /
• pp.19-25
• /
• 2018

PURPOSES : This purpose of this study is to analyze the effect to autogenous shrinkage of the top-layer material of a two-lift concrete pavement mixing both silica fume and polymer powder. METHODS : The bottom-layer of a two-lift concrete pavement was paved with original portland cement (OPC) with a 20~23 cm thickness. Additionally, the top-layer which is directly exposed to the environment and vehicles was paved with a high-performance concrete (HPC) with a 7~10 cm thickness. These types of pavements can achieve a long service life by reducing joint damage and increasing the abrasion and scaling resistance. In order to integrate the different bottom and top layer materials, autogenous shrinkage tests were performed in this study according to the mixing ratio of silica fume and polymer powder, which are the admixture of the top-layer material. RESULTS : Autogenous shrinkage decreased when polymer powder was used in the mix. Contrary to this, autogenous shrinkage tended to rise with increasing silica fume content. However, the effects were not significant when small amounts of polymer powder were used (3% and 11%). CONCLUSIONS : The durability and compressive strength increase when silica fume is used in the mix. The flexural strength considerably increases and autogenous shrinkage of concrete decreases when polymer powder is used in the mix. As seen from above, the proper use of these materials improves not only durability, but also autogenous shrinkage, leading to better shrinkage crack control in the concrete.

• Journal of Korean Society of Transportation
• /
• v.23 no.5 s.83
• /
• pp.105-112
• /
• 2005

This paper not only tests VIDS(Video Image Detection System) performance by vehicle speed group but also suggests optimal VIDS height considering road and cost condition. The VIDS spreads over freeway and national highway and plays an important role in ITS(Intelligent Transportation Systems). As a result, speed data accuracy drops form 50kph vehicle speed and volume and occupancy data accuracy drop from 30kph. Lowest speed data accuracy is only 88%, but volume and occupancy accuracy are 75% and 77% respectively. The reason VIDS data accuracy drop by vehicle speed is gap distance decrease between vehicles. Therefore, this paper suggests $17m{\sim}21m$ for optimal VIDS height considering road and cost condition.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.3
• /
• pp.96-102
• /
• 2013

In recent years, a variety of ITS services are available such as driving information, road conditions, V2X messages as well as navigation and traffic jams notification. The development of ITS services is accelerating by V2X communication technologies for high-speed vehicles. In this paper, WAVE communication devices based on the IEEE802.11p standard is introduced as a solution of V2X communication technologies. The H/W and S/W structures of the WAVE communication device and the characteristics of RF/antenna are described. The performance is evaluated in the test road by measuring throughput, PER and latency. The implemented WAVE communication device has 6~7 Mbps throughput with 10% PER at 1km coverage. The packet latency is less than 3ms for the whole test road. It is shown that the implemented WAVE technology is satisfactory to provide ITS services and Internet video-streaming services.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.1
• /
• pp.79-88
• /
• 2018

With the increasing popularity of electronic toll collection system using 5.8 GHz dedicated short-range communications (DSRC) technology, DSRC-based travel-time collection systems have been deployed on major urban and rural arterial routes in Korea. However, since probe sample sizes are frequently insufficient in probe-based systems, the gathered travel times from probe vehicles fluctuate significantly compared to those of the population; as a result, the accuracy of the collected travel times could decrease. To mitigate the fluctuations (also known as biases), smoothing techniques need to be applied. In this study, some smoothing techniques-moving average, the Loess, and Savitzky-Golay filtering-were applied to probe travel times. Resultantly, the error in the smoothed travel times at the lowest sampling plan (5%) decreased as much as 45% compared to those in non-smoothed travel times. The results of this study can be practically applied to probe-based travel-time estimation systems for providing reliable travel times along the travel corridor.