• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.222-223
• /
• 2003

The optical gain characteristics of 1550nm traveling-wave semiconductor optical amplifiers are analyzed experimentally and theoretically. The result shows that there is an optimum active layer thickness for high saturation output power.

• Journal of Advanced Navigation Technology
• /
• v.12 no.2
• /
• pp.139-145
• /
• 2008

There has been lots of studies on communication systems using millimeter wave recently in many countries, specially in newly assigned 57GHz ~ 64GHz ISM band. Among those studies, IEEE 802.15.3c standard proposes OFDM (Orthogonal Frequency Division Multiplexing) systems for high data rate transmission support. But OFDM method has the PAPR (peak-to-Average Power Radio) problem The PAPR problem is to decline the performance of the transmission system due to signals distorted severely when passing through nonlinear components such as ADC/DAC and power amplifiers. In order to solve the problem of P APR, this paper suggests SSC (Sine Soft Clipping) and analyzes the PAPR, CCDF, PSD, BER by applying SAW(Surface Acoustic Wave) filter and power amplifiers to IEEE 802.15.3.c OFDM WPAN systems.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.11
• /
• pp.695-700
• /
• 2018

This paper presents the development of compact and lightweight broadband power amplifier module using HMIC (Hybrid Microwave Integrated Circuit) technology that could be high-density integration for many non-packaged microwave components into the small area of a high dielectric constant printed circuit board, such as a ceramic substrate, also using the special design and fabrication schemes for the structure of minimized electromagnetic interference to obtain the homogeneous electrical performance at the wideband frequency. The results confirmed that the small signal gain has a gain flatness of ${\pm}1.5dB$ within the range of 32 to 36 dB. In addition, the output power satisfied more than 30 dBm. The noise figure was measured within 7 dB, and OIP3 (Output Third Order Intercept Point) was more than 39 dBm. The fabricated broadband power amplifier satisfied the target specification required to electrically drive the high power amplifiers of jamming generators for electronic warfare, so the actual applicability to the system was verified. Future studies will be aimed at designing other similar microwave power amplifiers in the future.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.31B no.7
• /
• pp.16-25
• /
• 1994

The major reason that reduces the performance of satellite communication channels is known as the nonlinearities of high power amplifiers(HPA's) which are usually modeled by memoryless nonlinear systems, in the channels. This paper proposes a nonlinear adaptive predistorter,which predistorts the input symbols such that the symbol passing through the nonlinear HPA preserves the desired constellation, and derives the region of convergence for the predistorter. The predistorter has capability of coping adaptively with any time-varying environment such as changes of operating points if HPA since the coefficients of the predistorter which has a form of truncated Tayler series are obtained by recursive optimization procedure utilizing QAM data sequence directely. Simulation results show that the proposed one with 16 QAM input has better performance than the conventional fixed predistorter with the same input.

• Proceedings of the IEEK Conference
• /
• 2000.09a
• /
• pp.573-576
• /
• 2000

현재 사용되고 있는 CDMA 시스템에서는 기지국 내에 사용되는 고출력 증폭기(high power. amplifier)의 비선형 특성으로 인해, 시스템의 송신 신호는 심각한 비선형 왜곡을 겪게되고 이는 결국 시스템의 성능을 크게 악화시키는 요인으로 작용한다. 이러한 고출력 증폭기의 비선형성은 출력 신호 레벨을 선형 영역으로 충분히 backing-off 시킴으로써 감소시킬 수 있으나, 이는 송신 신호의 출력을 과도하게 감소시키게 되어 결국 fade margin을 감소시키는 결과를 가져온다. 본 논문에서는 이러한 고출력 증폭기에서 발생하는 비선형 왜곡을 보상할 수 있는 디지털 사전왜곡기를 하드웨어적으로 직접 구현하여 고출력 증폭기의 특성이 변할 때,LMS 알고리듬을 이용하여 LUT의 값을 갱신함으로써 보다 효과적인 적응 사전왜곡기를 설계하는데 목적이 있다.

• ETRI Journal
• /
• v.43 no.1
• /
• pp.7-16
• /
• 2021

Noncontiguous orthogonal frequency division multiplexing (NC-OFDM)-based cognitive radio (CR) systems achieve highly efficient spectrum utilization by transmitting unlicensed users' data on subcarriers of licensed users' data when they are free. However, there are two disadvantages to the NC-OFDM system: out-of-band power (OBP) and a high peak-to-average power ratio (PAPR). OBP arises due to side lobes of an NC-OFDM signal in the frequency domain, and it interferes with the spectrum for unlicensed users. A high PAPR occurs due to the inverse fast Fourier transform (IFFT) block used in an NC-OFDM system, and it induces nonlinear effects in power amplifiers. In this study, we propose an algorithm called "Alternative Projections onto Convex and Non-Convex Sets" that reduces the OBP and PAPR simultaneously. The alternate projections are performed onto these sets to form an iteration, and it converges to the specified limits of in-band-power, peak amplitude, and OBP. Furthermore, simulations show that the bit error rate performance is not degraded while reducing OBP and PAPR.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.19 no.4
• /
• pp.364-375
• /
• 2014

Parametric array transducers are used for long-range and highly directional communication in an underwater environments. The power amplifiers for parametric array transducers should have sufficient linear output characteristic and high efficiency to avoid communication errors, system heating, and fuel problems. But the conventional power amplifier with fixed source voltage is very low efficient due to large power loss by the big difference between the fixed source voltage and the amplifier output voltage. Thus to solve the problems this paper proposes the high efficiency power amplifier for parametric array transducers. The proposed power amplifier ensures high linearity of output characteristic by utilizing the push-pull class B type amplifier and furthermore gets high efficiency by applying the envelope tracking technique that variable source voltage tracks the envelope of the amplified signal. Also the paper suggests the detailed circuit topology and design guideline of class B push-pull type amplifier and variable output voltage AC/DC converter. Its characteristics are verified by the detailed simulation and experimental results.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.979-982
• /
• 2003

Due to the differential transmission technique and low voltage swing, LVDS has been widely used for high speed transmission with low power consumption. This paper presents the design and implementation of interface circuits for 1.5Gb/s operation in 0.35um CMOS technology. The interface circuit ate fully compatible with the low-voltage differential signaling(LVDS) standard. The LVDS proposed in this paper utilizes a sense amplifiers instead of the conventional differential pre-amplifier, which provides a 1.5Gb/s transmission speed with further reduced driver output voltage. Furthermore, the reduced driver output voltage results in reducing the power consumption.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.2327-2329
• /
• 2005

In this paper, we identify the memory effects of the RF high-power base station amplifiers with Vector Signal Analyzer (VSA). It is found that the model of power- amplifier using Tapped Delayed Neural - Networks with back-propagation algorithm shows very accurate modeling performance. Based on this behavioral modeling, we conducted inverse compensation process which also uses Neural Networks.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.1-11
• /
• 2009

In this paper, a new 1 kW power amplifier with high efficiency and high stability in a RF generator is designed and fabricated for plasma applications. The efficiency of power amplifier is improved by using class-E amplifier that consists of one push-pull MOSFET and high current drive IC instead of class-C amplifier composed of several single ended MOSFET. Switchable damper that allows selecting three different modes of amplifiers for considering efficiency and stability is added into the amplifier for plasma applications. Stable region of an early electronic discharge section is extended to VSWR of 4.5:1 compared to conventional VSWR of 3.8:1 through using switchable damper. The dimension of the amplifier is also reduced to 30 % of conventional amplifier. The 80 % efficiency of power amplifier with switchable damper is obtained the output power of 1 kW in operating frequency of 13.56 MHz. In comparison of conventional power amplifier for plasma applications, 13 % efficiency is improved.