• Journal of Sensor Science and Technology
• /
• v.23 no.6
• /
• pp.392-396
• /
• 2014

The 2-dimensional silicon vertical Hall devices, which are sensitive to X,Y components of the magnetic field parallel to the surface of the chip, are fabricated using a modified bipolar process. It consists of the thin p-layer at Si-$SiO_2$ interface and n-epi layer to improve the sensitivity and influence of interface effect. Experimental samples are a sensor type K with and type J without $p^+$ isolation dam adjacent to the center current electrode. The results for both type show a more high sensitivity than the former's 2-dimensional vertical Hall devices and a good linearity. The measured non-linearity is about 0.8%. The sensitivity of type J and type K are about 66 V/AT and 200 V/AT, respectively. This sensor's behavior can be explained by the similar J-FET model.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.8
• /
• pp.759-765
• /
• 2005

In this paper, developed isolator for gap filler is analyzed and designed using the simulation tool. Using the designed parameters, isolator is fabricated and tested in gap filler band. Temperature characteristics of isolator depend on magnet, YIG ferrite, and conductor etc. These require temperature stability and possible method of compensation for the temperature dependent effects. The temperature stabilization tries to use Ni-alloy. Developed isolator that compare with room temperature and high temperature characteristics has change fewer than 20 MHz. Implemented isolator shows more than 20 dB isolation characteristic at center frequency(2,650 MHz) and has 0.2 dB insertion loss in overall 100 MHz operating bandwidth. Return losses of input and output port are measured below -20 dB.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.43 no.2
• /
• pp.128-133
• /
• 1998

Analyses of now karyotypes using different maize (Zea mays L.) inbred lines have been performed. The accumulation and isolation of high quality and quantity metaphase chromosomes from root tips can be achieved from many kinds of maize lines. The chromosome suspensions were prepared by a simple slicing method from synchronized maize root tips and analyzed with a now cytometry. The variations of experimental now karyotypes were detected among inbred lines in terms of the positions and/or the numbers of chromosome peaks. The 2C DNA amount among 8 inbred lines ranged from 5.09 to 5.52 pg. The variability of DNA content in maize chromosome 1 was 9.1 % ranging from 0.685 to 0.747 pg. The selection of appropriate maize lines is critical for sorting specific single chromosome types. At least five different chromosome types can be discriminated and sorted from five maize lines.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.24 no.5
• /
• pp.695-701
• /
• 1995

The ethanol extract of leaf mustard(Brassica juncea) exhibiting high antimicrobial activities was fractionated in the order of hexane, chloroform, ethylacetate and butanol fractions to test antimicrobial activity. The highest antimicrobial activity for the bacteria tested was found in the ethylacetate fraction, but a lesser extent in the butanol fraction. In contrast to antimicrobial activity for the bacteria, both ethylacetate and butanol fractions showed weak antimicrobial activity for yeasts. Unknown compound A in the ethylacetate fraction which exhibited a strong antimicrobial activity was isolated by silica gel column chromatography and HPLC, and exhibited 9 times more antimicrobial activity than the ethylacetate fraction.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.1
• /
• pp.56-65
• /
• 2011

A new hybrid mount system is proposed for microvibration control in a high-tech factory. The mount consists of an airspring as a passive device and a piezostack actuator as an active device. The two devices are connected in series. Some numerical simulations and experimental tests are carried out to evaluate isolation performance of the mount system comprising of four proposed hybrid mounts. As a control logic, the specific algorithm is adopted for considering multiple target frequencies of excitation based on a Filtered-X LMS algorithm. The results are compared with isolation performance of the passive airspring mount system. It is confirmed that the proposed hybrid mount system has great performance on microvibration.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.11a
• /
• pp.597-602
• /
• 2006

In this paper, a proper support tuning method is established by identifying the dynamic characteristics of the machine, the floor. and the inertia force. Also, the limitation of a passive isolation is presented. To simplify the dynamic analysis and to establish a proper design method for supporting system, each of the machine and the floor is modeled as a single degree of freedom spring-mass-damper system under careful investigation of the dynamic characteristics of each system and appropriate assumptions. Then, the dynamic behavior of a 2DOF system and the effect of the mass and the damping are investigated. Also, the characteristics of motion profiles are investigated. In addition, a quasi-static analysis on the transmitted force through support is performed and related tests are performed.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1593_1594
• /
• 2009

RFID system had used same frequency for transmit and receive signal. RFID recognize range is restrict, because of receive and transmit signal coupled each other. That cause directional coupler is not ideal isolation characteristic and antenna missmatching. So we proposed lambda/8 section directional coupler and design high isolation to use RFID.

• Journal of Photoscience
• /
• v.10 no.1
• /
• pp.165-173
• /
• 2003

m-Phenylene-linked biscarbenes, bisnitrenes and carbenonitrenes can be formed photochemically from appropriate nitrogenous precursors. Generation of such reactive intermediates under matrix-isolation conditions allows for their characterization by spectroscopic techniques such as ESR, UV /vis and IR. The latter method is also useful in characterizing secondary products derived from these reactive intermediates. Computational chemistry methods complement experimental IR data, aiding, thus, in identification of such compounds. In addition electronic structure calculations help in developing qualitative and semi-quantitative models, which can be useful in predicting ground-state multiplicities. The parent systems of m-phenylene-linked carbenes and nitrenes have high-spin ground states, but a switching to lower multiplicity can be achieved by chemical substitution. The ground state and various low-lying excited states of m-phenylenecarbenonitrenes can be reasonably approximated by simple valence-bond depictions. Finally, m-phenylenecarbenonitrenes are photoreactive in the inert matrix isomerizing to cyclopropene derivatives.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.7
• /
• pp.1288-1293
• /
• 2007

In this paper, a compact triplexer has been implemented for Cellular/GPS/USPCS applications. In order to realize the proposed triplexer, we use a low-temperature co-fired ceramic (LTCC) substrate to enable a fully compact integrated module using a multi-layer high-density architecture, and conjugate-match the channels instead of the open matching technique. The three dimensional design capability of LTCC substrates can reduce the overall size of the triplexer, resulting in dimensions on the order of $3.2\;mm\;{\times}\;2.5\;mm\;{\times}\;1\;mm$. The measured result shows that the triplexer has, in Cellular/GPS/USPCS bands, the insertion loss of less than 0.5dB, less than 1.7dB, and less than 0.9dB in order. Also, the triplexer has an isolation of more than 15dB in the cellular and USPCS bands and an isolation of more than 20dB in the GPS band.

• Microbiology and Biotechnology Letters
• /
• v.19 no.6
• /
• pp.588-591
• /
• 1991

S-adenosyl-L-methionine (SAM) is essential substrate for biological methylation reactions. The present work describes a reoptimized procedure of SAM preparation in laboratory scale by the method of yeast fermentation. The fermentation medium enriched with methionine and the culture conditions were reoptimized. The isolation steps consisted of 5 steps including extractions, precipitations, and chromatography. This improved procedure over original method provides relatively high yield of biologically active product within a 4 day-period.