• Journal of Bio-Environment Control
• /
• v.9 no.3
• /
• pp.156-160
• /
• 2000

The Plasma film treated with a high electric voltage was developed to enhance flow down of condensation drops on inside plastic film. Arch type greenhouse framed with iron pipe of 25mm diameter defand 1.5mm thickness were covered with either the developed plasma film or surfactant film(control). Green pepper seedlings raised for 40 days in plug trays were transplanted at a density of 110cm by 30cm in each greenhouse. The mount of condensational water on film surface, generated by 7$0^{\circ}C$ water bath chimney systems and flew down, was collected and measured. The amount of collected water after 150 minutes was 2.56 mL.100c $m^{-2}$ and 0.94mL.100c $m^{-2}$ , respectively, in the plasma film and surfactant film-covered greenhouses. The amount of condensational water drops attached on the cover at 08:20 a.m. at 60 days filter covering was 0.34mL.100c $m^{02}$ and 0.32mL.100c $m^{-2}$ , respectively, in the plasma film- and surfactant film-covered greenhouses. Solar irradiance transmitted into greenhouse was 2.0% higher in the greenhouse covered with the plasma film tan that in the greenhouse covered with the surfactant film. Air temperature in the plasma film-covered greenhouse was higher than the surfactant film-covered greenhouse by 0.5$^{\circ}C$. However, there was no difference in relative humidity between the two greenhouse. Plant height, leaf area, dry weight and early yield showed no significant differences.s.

• Journal of Sensor Science and Technology
• /
• v.8 no.2
• /
• pp.115-123
• /
• 1999

A micro-gas sensor with heater and sensing electrode on the same plane was fabricated on phosphosilicate glass(PSG, 800nm)/$Si_3N_4$ (150nm) dielectric membrane. PSG film was provided by atmospheric pressure chemical vapor deposition(APCVD), and $Si_3N_4$ film by low pressure chemical vapor deposition (LPCVD). Total area of the fabricated device was $3.78{\times}3.78mm^2$. The area of diaphragm was $1.5{\times}1.5mm^2$, and that of the sensing layer was $0.24{\times}0.24mm^2$. Finite-element simulation was employed to estimate temperature distribution for a square-shaped diaphragm. The power consumption of Pt heater was about 85mW at $350^{\circ}C$. Tin thin films were deposited on the silicon substrate by thermal evaporation at room temperature and $232^{\circ}C$, and tin oxide films($SnO_2$) were prepared by thermal oxidation of the metallic tin films at $650^{\circ}C$ for 3 hours in oxygen ambient. The film analyses were carried out by SEM and XRD techniques. Effects of humidity and ambient temperature on the resistance of the sensing layer were found to be negligible. The fabricated micro-gas sensor exhibited high sensitivity to butane gas.

• Journal of Bio-Environment Control
• /
• v.12 no.3
• /
• pp.147-152
• /
• 2003

This study was conducted to analyze the energy balance in closed transplants production system (CTPS) for the production of high quality transplants. Potato (Solanum tuberosum L. cv. Dejima) plug seedlings were grown for 15 days at air temperature of 20$^{\circ}C$, relative humidity of 70%, photoperiod of 16/8 h, and photosynthetic photon flux (PPF) of 200 ${\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ following 5 days of tooting in CTPS. Electric energy consumption was 46% for lighting, 35% for cooling, 16% for heating, 2% for air circulation, and 1% for humidifying. The electric energy utilization efficiency and the short-wave energy utilization efficiency were 0.5% and 5.4%, respectively. These results suggest that CTPS has the feasibility for the commercial production of potato plug seedlings if the electric energy consumption in CTPS is reduced and the electric energy utilization efficiency is increased.

• Atmosphere
• /
• v.21 no.1
• /
• pp.35-44
• /
• 2011

We investigated characteristics of new particle formation and growth events observed at Gosan climate observatory using Scanning Mobility Particle Sizer (SMPS) measurements of particle number size distribution with 54 size ranges from 10 to 487 nm in October 2009. Four days (17~20 October) and five days (22~26 October) were classified into strong new particle formation and growth event ($N_S$) and weak particle formation and growth event ($N_W$), respectively. $N_S$ and $N_W$ divided by increase of aerosol number concentration in nucleation mode and continuity of growth from nucleation to Aitken mode. Particle growth rates of $N_S$ (5.34~$9.19nm\;h^{-1}$) were greater than that of $N_W$ (2.15~$3.53nm\;h^{-1}$). $N_S$ and $N_W$ were analyzed with synoptic pattern over East Asia, meteorological elements, and sulfur dioxide ($SO_2$) measured at Gosan. We found that $N_S$ was characterized by a fast and northwesterly wind accompanied cold and dry airmass, but $N_W$ was affected airmass originated from South China and come through the Korea Peninsula. The events ($N_S$ and $N_W$) occurred at conditions of high solar flux ($&gt;700W\;m^{-2}$) and low relative humidity (< 60%). The $SO_2$ concentration on $N_S$ and $N_W$ was higher than that on case of non observed new particle formation.

• Food Science and Preservation
• /
• v.24 no.2
• /
• pp.181-186
• /
• 2017

This study was conducted to investigate the weight loss, firmness, external color and vitamin C (VC) content of tomatoes (Lycopersicon esculentum) using non-destructive method to measure identical tomato samples during 15 days storage at low temperature and high humidity. Tomatoes were harvested at the light red stage, sorted, box packed and then stored in thermo-hygrostat ($10{\pm}1^{\circ}C$, $90{\pm}10%RH$). The quality changes in weight loss, firmness and external color were measured every 3 day interval. Weight loss was increased by $1.13{\pm}0.15%$, but it may not be considered to affect quality. Surface color of fruit was changed, especially in lightness and hue angle value. The color values were analyzed by analysis of variance (ANOVA), and the results were significant (p<0.001). Firmness of fruit declined during storage, but it did not decrease in direct proportion. On the storage of day 15, firmness was decreased to 40% of initial state. At last, all the experiment data are summarized and the relationship between firmness and weight loss is analyzed to construct a linear regression mathematical model that can predict the weight loss with the firmness value measured by non-destructive method. This research result could be useful in helping tomato exporters and suppliers to get real-time quality factor by using proposed method and regression model.

• Journal of the Korean Wood Science and Technology
• /
• v.43 no.1
• /
• pp.52-59
• /
• 2015

Cross-cut disks from small diameter oak logs were thermally modified and developed to make accessories such as a brooch. However it is known that domestic oaks are refractory and it is hard to dry their cross-cut disks without any drying defects. The cross-cut disks of Quercus variabilis (7 mm long in the longitudinal direction) were forced to dry in air at two different air velocities in summer and fall season, and their drying yields were investigated. Under the same condition, the average final moisture contents (MCs) of the specimens dried in the fall were lower than those dried in the summer. The average final MCs of the small diameter specimens dried at higher air velocity were slightly lower than those at lower air velocity while those of the large diameter specimen were not influenced by the air velocity. The number of the large diameter specimens with cross checkings was higher than that of the small diameter specimen. This discrepancy between two different diameters was twice in the fall, while it was more than four times in the summer. The large diameter specimens dried at low air velocity in Summer were cross-checked most, which was attributed to repeated water condensation and evaporation due to high humidity and low air velocity.

• Journal of Conservation Science
• /
• v.32 no.4
• /
• pp.501-510
• /
• 2016

In this study, we investigated the degradation of adhesives when exposed to ultraviolet light irradiation using samples of lacquer (L), treated lacquer (TL), lacquer mixed with glue (LG), and urushiol mixed with glue (UG). Four types of film specimens were collected under the ultraviolet exposure time, and gloss test, tensile shear strength test, scanning electron microscope analysis, and infrared spectroscopic analysis were conducted for the specimens. LG and UG showed lowering rate of gloss is somewhat later than L. Also, it was observed that with increasing exposure time to ultraviolet irradiation, the surface of L began to show spherical pits and cracks when the polysaccharide layers started to be exposed, whereas the surfaces of LG and UG remained smooth. The Infrared spectra of L and TL showed that the intensity of the overall peak decreased with increasing ultraviolet irradiation time. There was no change in the peak intensity of LG, but for UG, the peaks at $3013cm^{-1}$, $1593cm^{-1}$ and so on disappeared and the overall intensity declined. The tensile shear strength of LG and UG was maintained or increased as compared to the initial test, whereas the tensile shear strength of L decreased sharply after 600 h. LG and UG exhibited fewer changes as a result of high temperature and humidity conditions, and they retained their strength under UV exposure. These results indicate that LG and UG are more durable than L when subjected to environmental change.

• Journal of Conservation Science
• /
• v.34 no.2
• /
• pp.69-76
• /
• 2018

Lead-based pigments (Lead White, Massicot, and Red Lead) are known to cause discoloration easily in indoor air environments. This study was conducted to investigate the effect of representative indoor air environment factors ($O_2$, $CO_2$) on lead-based pigments. As a result of the experiment, almost all of the specimens showed changes of more than ${\Delta}E=5.0$ in their values of chromaticity under $O_2$ (99%, RH 99%) and $CO_2$ (36,000 ppm, RH 99%) environments. Scanning electron microscopy also showed that the pigment particles lose sharpness of the edge. Furthermore, under the degradation, the intensities of the characteristic peaks in the X-ray diffraction patterns were decreased, and Lead White, Massicot, and Red Lead exposed to $CO_2$ (36,000 ppm, RH 99%) were shown to include the new material cerussite ($PbCO_3$). In particular, Plattnerite ($PbO_2$) was identified on Massicot, and for white lead, the characteristic peaks disappeared and those of Cerussite were identified. It was confirmed that chemical change with discoloration can occur when these lead-based pigments are exposed to a high-humidity $CO_2$ environment.

• Korean Journal of Food Science and Technology
• /
• v.33 no.1
• /
• pp.19-23
• /
• 2001

Physicochemical properties including viscosity, temperature and pH stability, color turbidity and moisture retention power of xylooligosaccharide(XO) as food material were investigated to apply to food process. The viscosity of 70 bx XO was 930 cP at $20^{\circ}C$ and 90 cP at $60^{\circ}C$, which was higher than that of sugar but lower than that of other oligosacchrides. XO remained stable after heat treatment for 1hr at $100^{\circ}C$ and pH 2.5 to 8.0 indicating excellent heat and pH stability. The pH of XO was measured $5.0{\pm}0.1$ and the color turbidvity of XO was very low at pH $2.5{\sim}4.0$. The color turbidity of XO increased as pH increased, but it was not high enough to affect food process. When heated with 1% glycine the color turbidity of XO was very low and changed little with pH changes. To measure moisture retention power XO was stored at $25^{\circ}C$ and 75% relative humidity for 71 day. XO retained more than 95% of the original weight; whereas sugar lost 28%. These results suggest that XO has useful physicochemical properties for various food process to improve the functionality of food.

• Journal of Korean Society of Forest Science
• /
• v.98 no.3
• /
• pp.242-246
• /
• 2009

We examined sapflow of two populus tree species (Populus alba ${\times}$ Populus glandulosa and Populus euramericana) grown under Swine wastewater treatment, and measured relationship between sapflow and climate facters. Sapflow of P. euramericana was 1.5 times greater than that of P. alba ${\times}$ P. glandulosa from September to late December 2007. However, sapflow of P. euramericana and P. alba ${\times}$ P. glandulosa was similar after late January. The relationship between the mean temperature and sapflow was relatively high. There was a decrease in sapflow tendency of the two poplar species during the late October when the mean temperature was low. Trends on relationship between the relative humidity and sapflow showed low relationship. However, data showed weak relationship between sapflow and precipitation. During the period of less precipitation, sapflow of P. alba ${\times}$ P. glandulosa has no relationship. Sapflow of two populus species was still active during non-growing season. P. euramericana was considered as a better species than P. alba ${\times}$ P. glandulosa, in terms of phytoremediation.