• Journal of Sensor Science and Technology
• /
• v.5 no.3
• /
• pp.41-48
• /
• 1996

We developed SAW gas sensor for monitoring SOx gas with high sensitivity. It was fabricated as a microsensor for detecting SOx gas by depositing sensing material on SAW device. As a detecting layer material, CdS was selected. Deposition of CdS in the form of thin films was carried out by the ultrasonic spray pyrolysis method using ultrasonic spray nozzle. Thin films with the uniform and large surface area for sensors were deposited. The stable pyrolysis environment provided by uniform and fine droplets formed by spray nozzle made it possible to obtain thin films with excellent quality. The minimum grain size of the CdS thin films was about 50 nm when deposited at $300^{\circ}C$. SAW gas sensors showed reasonable sensitivity and reproducibility. Further studies are required to investigate the interference of other gases to SOx gas detection.

• Progress in Superconductivity
• /
• v.14 no.1
• /
• pp.66-70
• /
• 2012

Superconductor flywheel energy storage system (SFESs) is an electro-mechanical battery with high energy storage density, long life, and good environmental affinity. SFESs have been developed for application to a regenerative power of train, the storage of distributed power sources such as solar and wind power, and a power quality improvement. As superconductor bearing is completely passive, it is not necessary to control a system elaborately but accurate analysis in mechanical properties of the HTS bearing is very important for application to SFESs. Stiffness and damping properties are the main index for evaluation the capacity of HTS bearings and make it possible to adjust rotordynamic properties while operating the rotor-bearing system. The superconductor bearing consists of a stator containing single grain YBCO bulks, a ring-type permanent magnet rotor with a strong magnetic field that can reach the bulk surface, and a bearing support for assembly to SFESs frame. In this study, we investigated the stiffness and damping properties of superconductor bearings in 35 kWh SFESs. Finally, we found that 35 kWh superconductor bearing has uniform stiffness properties depend on the various orientations of rotor vibration. We discovered total damping coefficient of superconductor bearing is affected by not only magnetic damping in superconductor bulk but also external damping in bearing support. From the results, it is confirmed that the conducted evaluation can considerably improve energy storage efficiency of the SFESs, and these results can be used for the optimal capacity of superconductor bearings of the SFESs.

• Journal of Welding and Joining
• /
• v.27 no.6
• /
• pp.68-73
• /
• 2009

Recently, as titanium and titanium alloys are being increasingly used in wide areas, there are on-going researches to obtain high quality weld zone. In particular, growing interest is being drawn to laser welding, which involves low heat input and large aspect ratio in various welding processes and can facilitate shield in atmospheric condition compared with electron beam welding. The first report covered the analysis of embrittlement by the bead color of weld zone through quantitative analysis of oxygen and nitrogen and measurement of hardness as basic experiment to apply laser welding to titanium. Results indicated that the element that affect embrittlement the most was nitrogen, and as embrittlement and oxygenation go on, bead color changed to silver, gold, brown, blue and gray. This study performed butt welding of pure titanium and STS304 by using 1kW CW Nd:YAG laser, and to find out basic physical properties, evaluated welding performance by laser output, welding speed, root gap and misalignment etc, and examined mechanical properties through tensile stress and Erichsen test. The reason particles of pure titanium welded metal and HAZ are greater than STS304 is because they are pure metal and do not include many impure elements that work as nuclei in case of resolidification, thus becoming coarse columnar crystals eventually. In addition, the reason STS304 requires more energy during welding than pure titanium is because the particle size of base metal is smaller.

• Journal of Powder Materials
• /
• v.25 no.6
• /
• pp.487-493
• /
• 2018

The impact of different mixing methods and sintering temperatures on the microstructure and piezoelectric properties of PZNN-PZT ceramics is investigated. To improve the sinterability and piezoelectric properties of these ceramics, the composition of $0.13Pb((Zn_{0.8}Ni_{0.2})_{1/3}Nb_{2/3})O_3-0.87Pb(Zr_{0.5}Ti_{0.5})O_3$ (PZNN-PZT) containing a Pb-based relaxor component is selected. Two methods are used to create the powder for the PZNN-PZT ceramics. The first involves blending all source powders at once, followed by calcination. The second involves the preferential creation of columbite as a precursor, by reacting NiO with $Nb_2O_5$ powder. Subsequently, PZNN-PZT powder can be prepared by mixing the columbite powder, PbO, and other components, followed by an additional calcination step. All the PZNN-PZT powder samples in this study show a nearly-pure perovskite phase. High-density PZNN-PZT ceramics can be fabricated using powders prepared by a two-step calcination process, with the addition of 0.3 wt% MnO2 at even relatively low sintering temperatures from $800^{\circ}C$ to $1000^{\circ}C$. The grain size of the ceramics at sintering temperatures above $900^{\circ}C$ is increased to approximately $3{\mu}m$. The optimized PZNN-PZT piezoelectric ceramics show a piezoelectric constant ($d_{33}$) of 360 pC/N, an electromechanical coupling factor ($k_p$) of 0.61, and a quality factor ($Q_m$) of 275.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.35 no.5
• /
• pp.403-412
• /
• 1990

Soybean grain, the main source of protein and lipid, has been used for various purposes in our food resources. Therefore, to abtain and supply protein in safety, soybean must be considered as more and more important and it must be made many efforts in breeding for good quality and high protein. Contents of seed protein of the recommeded soybean cultivars in Korea were above 40 persents. Soybean seed protein was divided four fractions by solubility differences. Contents of fraction-albumines, globulines, prolamines and glutelines- were 7.59%, 71.43%, 1.32%, and 9.11% to total protein in Jangyeobkong. The major components of amino acids were glutamic acid, aspartic acid and arginine in order, cystein, methionine, and tyrosine were the minor components in soybean seed protein. Soybean seed protein is constituted mostly of 11s and 7s proteins. Contents of methionine and cystein, sulfur containing amino acid, in 11s protein has already identified higher than 7s protein's The yields of soybean curd were positively correlated with the soluble protein contents of the soybean varieties.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2022.10a
• /
• pp.261-261
• /
• 2022

Cowpea [Vigna unguiculata (L.) Walp] is one of the most important grain legumes that enhance soil fertility and is well-adapted to various abiotic stress. Also, it is cultivated worldwide as a tropical annual crop, and the semi-arid regions are known as the main cowpea-produced regions. However, accumulation of soil salinity induced by low rainfall in these regions is reducing crop yields and quality. In general, plants exposed to soil salinity cause an accumulation of high ion chloride, which leads to the degradation of root and leaf proteins. In this study, we identified candidate genes associated with salinity tolerance through an analysis of differentially expressed genes (DEGs) in four cowpea germplasms with contrasting salinity tolerance. A total of 553,776,035 short reads were obtained using the Illumina Novaseq 6000 platform for RNA-Seq, which were subsequently aligned to the reference genome of cowpea Vunguiculata v1.2. A total of9,806 DEGs were identified between NaCl treatment and control of four cowpea germplasms. Among these DEGs, functions related to salt stress such as calcium transporter and cytochrome-450 family were associated with salt stress. In GO analysis and KEGG analysis, these DEGs were enriched in terms such as the "phosphorylation", ''extracellular region", and "ion binding". These RNA-seq results will improve the understanding of the salt tolerance of cowpea and can be used as useful basic data for molecular breeding technology in the future.

• Korean Journal of Materials Research
• /
• v.9 no.12
• /
• pp.1245-1251
• /
• 1999

Phase-change optical disk very rapid recording, high densification of data, resulting in high feedback rate and good C/N(carrier to noise) ratio of a feedback signal. However, repetitive thermal energy may cause the deformation of a disk or the lowering of an eliminability and a cyclability of the recording. The lowering of the cyclability can be reduced by insertion of thin layer of ZnS-$SiO_2$ dielectric thin film in appropriate disk structure between the upper and lower part of the recording film. Using the Taguchi method, optimum conditions satisfying both the optimized quality characteristic values and the scattering values for film formation were found to be the target R.F. power of 200W, the substrate R.F. power of 20W, the Ar pressure of 6mTorr, and the electrode distance of 6cm. From the refractive index data, the existence of the strong interaction between the electrode distance and Ar pressure was confirmed, and so was the large effect of the electrode distance on transmittance. According to the analysis of TEM and XRD, the closer the electrode distance was, the finer was the grain size due to the high deposition rate. However, the closer electrode distance brought the negative effect on the morphology of the film and caused the reduction of transmittance. AFM and SEM analyses showed that the closer the electrode distance was, the worse was the morphology due to the high rate of the deposition. Under optimum condition, the deposited thin film showed a good morphology and dense microstructure with less defects.

• Korean Journal of Breeding Science
• /
• v.49 no.4
• /
• pp.390-395
• /
• 2017

A new small red bean cultivar, 'Geomguseul', was artificially crossed between 'Chilbo' and 'SA8412-3-1-4-3-3-2-3' in 1998, fixed excellent agronomic characters by pedigree breeding method, and selected for the further trials with the name of 'Miryang 10'. It was prominent and showed good result, such as high grain quality, lodging resistance, and high-antioxidant activity in the regional adaptation yield trials (RYT) for three years from 2009 to 2011 and released for the public consumption as the name of 'SA9801-24-4-3-1' in 2011. 'Geomguseul' has a semi-determinate growth habit, yellow flower, green embryonic axis, black seed coat, white hilum, and small spherical seed (12.2 grams per 100 seeds). The average yield of 'Geomguseul' was 2.01 MT/ha in the regional yield trials (RYT) carried out for three years from 2009 to 2011 which was a little higher than that (1.98 MT/ha) of the check variety, 'Chungju'.

• Korean Journal of Breeding Science
• /
• v.43 no.6
• /
• pp.606-610
• /
• 2011

'Jungmo1001' is an early maturing intermediate breeding line developed from a cross between Cheolweon52 and SR14694-57-4-2-1-3-2-2 by the rice breeding team of National Institute of Crop Science, Rural Development Administration (RDA) in 1994. 'Jungmo1001' has about 107 days duration from seeding to heading in mid-northern inland plain, southern alpine area and north-eastern coastal areas. It has about 73 cm in culm length with semi-erect plant type and good canopy architecture. This variety has 13 tillers per hill and 90 spikelets per panicle. Its 1,000 grain-weight of brown rice is 21.2 g which is less than 26.3 g of 'Odaebyeo'. Milled kernels are translucent with non-glutinous endosperm, low amylose content (18.1%) compared with 'Odaebyeo' palatability of cooked rice is very good. This variety shows strong resistance to cold treatment, lodging, premature heading and wilting. This variety shows moderately resistant to blast disease but susceptible to bacterial blight, stripe virus and insect pests. The milled rice yield performance of this variety is about 5.45 MT/ha by ordinary culture in local adaptability test for three years. This variety may be highly adaptable to the mid-northern inland plain, southern alpine area and north-eastern coastal areas of Korea.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.66 no.4
• /
• pp.297-306
• /
• 2021

To select rice (Oryza sativa L.) cultivars suitable for forage-rice double cropping system, the growth and grain quality of four early maturing rice cultivars (Joun, Jopyeong, Haedamssal, and Unkwang), and the chemical properties of soils were investigated under single- (fallow-rice) and forage-rice double-cropping systems in paddy fields in Miryang, southern Korea. The soil where two forage crops [Italian ryegrass (Lolium multiflorum Lam.) and oat (Avena sativa L.)] were cultivated during winter had a slightly lower pH; an increase in total nitrogen (T-N), K, Ca, and Na contents; and a slight decrease in organic matter and available P₂O₅ contents, compared with the soil fallowed during winter. This shows that the chemical properties of paddy soils can be improved by winter forage cropping. At the heading stage, the culm length, panicle length, panicle number, and leaf color of all cultivars, except for Haedamssal, were generally higher under double-cropping than under single-cropping. For Haedamssal, the culm length and leaf color did not differ between the cropping systems, but the panicle length was slightly shortened and its panicle number increased under double-cropping. After harvest, the yield of milled rice decreased for all cultivars except Haedamssal, but increased in Haedamssal under double-cropping. The head rice rate was slightly higher under double cropping, particularly in Jopyeong and Haedamssal, than under single-cropping. The protein content of milled rice under double cropping was higher and its amylose content was similar or slightly lower compared to those of rice under single cropping, resulting in decreased Toyo values for rice under double-cropping. The pasting temperature did not differ significantly between the cropping systems. However, Haedamssal had a low pasting temperature but a high Toyo value under double cropping, compared to the other three cultivars, suggesting that its palatability is relatively high. Furthermore, panicle number increased and milled rice yield did not decrease, even under double cropping. Therefore, Haedamssal seems to be the best cultivar for paddy-based double cropping with forage crops.