• 대한전자공학회논문지TC
• /
• 제45권11호
• /
• pp.32-36
• /
• 2008

본 논문에서는 외부지역에서 낮은 주파수 대역으로 FDD(Frequency Division Duplex)를 사용하고 내부지역에서 TDD(Time Division Duplex)를 사용하는 이중대역 동작을 하는 멀티모드 시나리오에서 내부지역의 CDMA/TDD의 용량을 조사하였다. 특히, 셀 반경, 데이터 전송률, 타임 슬롯 할당과 같은 다양한 시스템 파라미터의 영향을 분석하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.2069-2070
• /
• 2011

In this paper, the fault diagnosis for a gearbox of BLDC motor. The stator of BLDC motor consists of coil winding so it is easy to cool down and it also has a high reliability. In addition, it doesn't have a brush so it is less trouble and good in maintenance. Coupling with the motor which is the power sources, the gear has a high power transfer efficiency and various rotation speed. The gear gets a high driving force through deceleration. Thus it has been widely used. The gearbox fault detection area has not attracted much attention from electrical engineering community. A few papers describe gearbox fault based on vibration. Gearbox fault is diagnosed through FFT analysis of current and voltage. Fault characteristic frequency side band detected by calculating fault frequency. A threshold value is suggested by comparing normal peak value with fault peak value using detected fault characteristic frequency side band. Experimental results demonstrate that motor current and voltage signal analysis are viable tools in detecting these gear faults. Lower side band(LSB) is bigger than upper side band(USB) in current FFT. LSB and USB are similar in voltage FFT. Finally, fault diagnosis system that can easily detect flaws is developted for gearbox of BLDC motor.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2005년도 춘계학술대회논문집
• /
• pp.971-977
• /
• 2005

Power Flow Analysis (PFA) is developed for the effective predictions of frequency-averaged vibrational response in medium-to-high frequency ranges. In PFA, the power coefficients of semi-infinite structure and for-field energy density are used to predict the vibrational responses of structures. Generally, at high frequencies, PFA can predict narrow-band frequency-averaged vibrational responses of built-up structures. However, in low- to medium frequency ranges, the dynamic responses obtained by PFA represent broad-band frequency-averaged vibrational energy densities. For the prediction of vibrational response variance in Power Flow Finite Element Method (PFFEM), the variances of input power and joint element matrix describing structural coupling relationship are derived. Finally, for the validity of developed formulation, numerical examples for two co-planer plates are performed and the vibrational response variance of the structure are compared with the results of classical and PFFEM solutions.

• 반도체디스플레이기술학회지
• /
• 제9권2호
• /
• pp.7-10
• /
• 2010

In this paper, we design a modem SoC (System on Chip) for low power consumption and high speed wireless communications. Among various schemes of high speed communications, an MB-OFDM (Multi Band-Orthogonal Frequency Division Multiplexing) UWB (Ultra-Wide-Band) chip is designed. The MB-OFDM uses wide-band frequency to provide high speed data rate. Additionally, the system imposes no interference to other services. The 90nm CMOS (Complementary Metal-Oxide Semiconductor) technology is used for the SoC design. Especially, power management mode is implemented to reduce the power consumption.

• Journal of electromagnetic engineering and science
• /
• 제14권3호
• /
• pp.306-313
• /
• 2014

A Fabry-Perot resonator cavity antenna for Ku-band application is presented in this paper. The Fabry-Perot cavity is formed by a ground plane and a frequency selective surface (FSS) made of a circular hole array. The cavity resonance is excited by a single-feed microstrip patch located inside the cavity. The measured results show that the proposed antenna has an impedance bandwidth of approximately 13% ($VSWR{\leq}2$) and a 3-dB gain bandwidth of approximately 7%. The antenna produces a maximum gain of 18.5 dBi and good radiation patterns over the entire 3-dB gain bandwidth. The antenna's very thin profile, high directivity, and single excitation feed make it promising for use in wireless and satellite communication applications in a Ku-band frequency.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.1345-1347
• /
• 2008

This paper described a method of determining whether arcing is present in a low-voltage wiring system. We simulated the series arcing that generated in electrical loads and fabricated a arc detection module which can discriminate between normal and arcing state. The module consists of a high-pass filter with a low cut-off frequency of 3 kHz to attenuate power frequency voltage and an active band-pass filter with a frequency of 4 kHz ${\sim}$ 8 kHz to detect series arc signals only. We tested an Incandescent lamp that was controlled by a dimmer and analysed. The module consists of a high-pass filter with a low cut-off frequency of 3 kHz to attenuate power frequency voltage by 80 dB and an active band-pass filter with a frequency of 4 kHz to detect series arc signals only. From the experimental results, we could detect series arc signals without an influence of non-linear loads.

• 말소리와 음성과학
• /
• 제6권1호
• /
• pp.95-101
• /
• 2014

This paper investigated the effects of frequency band limitation on perceptual characteristics of Korean consonants. Monosyllabic speech (144 syllables of CV type, 56 syllables of VC type, 8 syllables of V type) produced by two announcers were low- and high-pass filtered with cutoff frequencies ranging from 300 to 5000 Hz. Six listeners with normal hearing performed perception test by types of filter and cutoff frequencies. We reported phoneme recognition rates and types of perception error of band-limited Korean consonants to examine how frequency distortion in the process of speech transmission affect listener's perception. The results showed that recognition rates varied with the following factors: position in a syllable, manner of articulation, place of articulation, and phonation types. Consonants in the final position were stronger to the frequency band limitation than those in the initial position. Fricatives and Affricates are stronger than stops. Fortis consonants were less stronger than their lenis or aspirated counterparts. Types of perception error also varied depending on such factors as consonant's place of articulation: In case of bilabial stops, they were perceived as alveolar stops with while in cases of alveolar and velar stops, there were changes in phonation types without any change in the place of articulation.

• 한국전자통신학회논문지
• /
• 제13권4호
• /
• pp.685-694
• /
• 2018

본 논문에서는 Ku대역 추적레이더의 핵심부품인 고주파 헤드 내 주파수 믹서(혼합기)의 설계 및 제작 결과에 대해서 다룬다. 단일종단(Single-Ended) 및 단일평형(Single-Balanced) 믹서의 단점을 보완하기 위해서, Fine-Line 구조의 평형(Balanced) 믹서를 설계하여 낮은 변환손실 특성을 가지도록 하였으며, Ku대역 RF신호를 입력받아 L밴드 IF신호를 생성하도록 하였다. 제작된 믹서에 대해서 Ku밴드 5개 샘플주파수를 대상으로 실험한 결과, 최대 잡음지수(Noise Figure Max) 6.823dB, 이득(Gain) 4.159dB ~ 4.676dB, 통과대역(Band Pass) 61MHz의 값을 확인하였다.

• ETRI Journal
• /
• 제42권4호
• /
• pp.549-561
• /
• 2020

We developed a 0.1-㎛ metamorphic high electron mobility transistor and fabricated a W-band monolithic microwave integrated circuit chipset with our in-house technology to verify the performance and usability of the developed technology. The DC characteristics were a drain current density of 747 mA/mm and a maximum transconductance of 1.354 S/mm; the RF characteristics were a cutoff frequency of 210 GHz and a maximum oscillation frequency of 252 GHz. A frequency multiplier was developed to increase the frequency of the input signal. The fabricated multiplier showed high output values (more than 0 dBm) in the 94 GHz-108 GHz band and achieved excellent spurious suppression. A low-noise amplifier (LNA) with a four-stage single-ended architecture using a common-source stage was also developed. This LNA achieved a gain of 20 dB in a band between 83 GHz and 110 GHz and a noise figure lower than 3.8 dB with a frequency of 94 GHz. A W-band image-rejection mixer (IRM) with an external off-chip coupler was also designed. The IRM provided a conversion gain of 13 dB-17 dB for RF frequencies of 80 GHz-110 GHz and image-rejection ratios of 17 dB-19 dB for RF frequencies of 93 GHz-100 GHz.

• Journal of information and communication convergence engineering
• /
• 제6권2호
• /
• pp.192-197
• /
• 2008

High-speed harmonic optical modulation-demodulation schemes are presented and a possibility of the schemes for applying to high-speed light wave transmission system is tested at microwave frequency range. An example of this concept is as follows : Light wave is modulated succeedingly through cascaded optical modulators by a sub-carrier to produce a modulated light wave at harmonic frequency which is higher than the feasible frequency of the individual modulators. For demodulation of the base-band signal, the high frequency optical sub-carrier is down-converted by the same kind of optical modulator with the same concept of harmonic modulation.