• Journal of Korea Society of Industrial Information Systems
• /
• v.25 no.6
• /
• pp.47-54
• /
• 2020

The acupressure is a treatment that applies pressure to certain parts of the body and has been mainly used for pain relief in the field of oriental medicine. However, the treatment effect is often different depending on the practitioner's ability, experience, and physical strength, so standardized acupressure is needed. In this regard, the equipment is being released, but this is mainly a rolling massage method, which reduces energy concentration and poses a risk of injury. Therefore, in this study, a device that provides vertical acupressure based on variable bogie (wheel truck) was implemented. As a result of experimenting with load and body pressure distribution and desirability to validate the device's bearing pressure, the acupressure rod held up to 150kg, the body pressure ratio was measured lower than the body pressure ratio of the comparison item in section 0%

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.4
• /
• pp.44-49
• /
• 2017

There are many battery-based wearable devices for healthcare and medical applications, but there is a user's inconvenience to charge battery frequently due to insufficient power management. In this paper, we propose a tickless-based operating system and power management algorithm that can effectively utilize the power management provided by HW, and propose a cold restart method that consumes the minimum power at the board level. The operating system of the proposed technique has reduced the power consumption from 2 times to 33 times in the four scenarios modeling the wearable device application compared to the existing operating system.

• Journal of Information Technology Applications and Management
• /
• v.12 no.4
• /
• pp.93-104
• /
• 2005

Recently, RFID/USN is one of fundamental technologies in information and communications networks. Low-Rate WPAN, IEEE802.15.4 is a low-cost communication network that allows wireless connectivity in applications with limited Power and relaxed throughput requirements. Its applications are building automation, personal healthcare, industrial control, consumer electronics, and so on. Some applications require location information. Of course location awareness is useful to improve usability of data Low-Rate WPAN Is regarded as a key specification of the sensor network with the characteristics of wireless communication, computing, energy scavenging, self-networking, and etc. Unfortunately ZigBee alliance propose a lot of applications based on location aware technologies, but the specification and low-rate WPAN devices don't support anything about location-based services. RSSI ( Received Signal Strength indication) is for energy detection to associate, channel selection, and etc. RSSI is used to find the location of a potable device in WLAN. In this paper we studied indoor location awareness using vector matching of RSSI in low-Rate wireless PAN. We analyzed the characteristics of RSSI according to distance and experimented location awareness. We implemented sensor nodes with different shapes and configured the sensor network for the location awareness with 4 fixed nodes and a mobile node. We try to contribute developing location awareness method using RSSI in 3-dimension space.

• Journal of Information Technology Applications and Management
• /
• v.27 no.3
• /
• pp.19-36
• /
• 2020

The Internet of things (IoT) is a system of interrelated computed devices, digital machines and any physical objects which are provided with unique identifiers and the potential to transmit data to people or machine (M2M) without requiring human interaction. IoT devices can be used to monitor and control the electrical and electronic systems used in different fields like smart home, smart city, smart healthcare and etc. In this study we introduce four imaginary IoT devices as a learning support assistants according to students' dominant learning styles measured by Honey and Mumford Learning Styles: Activists, Reflectors, Theorists and Pragmatists. This research emphasizes the association between students' strong learning styles and a preference to appropriate IoT devices with specific characteristics. Moreover, different levels of IoT devices' architecture are clearly explained in this study where all the artificial devices are designed based on this structure. Data analysis of experiment were measured by the use of chi square test for association and research results showed the statistical significance of the estimated model and the impacts of each category over the model where we finally got accurate estimates for our research variables. This study revealed the importance of considering the students' dominant learning styles before inventing a new IoT device.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.11 no.3
• /
• pp.21-29
• /
• 2015

The Internet of Things (IoT) is an Infrastructure which allows to connect with each device in physical world through the Internet. Thus IoT enables to provide meahup services or intelligent services to human user using collected data from those devices. Due to these advantages, IoT is used in divers service domains such as traffic, distribution, healthcare, and smart city. However, current IoT provides restricted services because it only supports monitor and control devices according to collected data from the devices. To resolve this problem, we propose a design and implementation of personalized IoT service base on service orchestration. The proposed service allows to discover specific services and then to combine the services according to a user location. To this end, we develop a service ontology to interpret user information according to meanings and smartphone web app to use the IoT service by human user. We also develop a service platform to work with external IoT platform. Finally, to show feasibility, we evaluate the proposed system via study.

• Research in Community and Public Health Nursing
• /
• v.25 no.4
• /
• pp.270-281
• /
• 2014

Purpose: The purpose of the study was to understand low-income elders' experiences of community-based u-Health services. Methods: Qualitative data were collected from 11 participants. All interviews were recorded and transcribed verbatim. The transcribed data were analyzed using qualitative content analysis. Results: Three themes and eight sub-themes emerged as a result of analysis. The three main themes were 'recovered confidence and health condition,' 'trial and error in change,' and 'hope.'The eight sub-themes were 'the burden and efforts to overcome it in using bio-signal device,' 'ambivalence due to changing lifestyle,' 'increase of care time, decrease of pressure', 'conflict under environmental constraints,' 'difficulty in prioritizing health management,' 'discouragement in handling new devices,' 'desire not to be a burden to their children-gradual fulfillment of learning needs,' and 'long for broadening coverage range of services.' Conclusion: The findings of this study demonstrate that low-income elders among the participants have different needs in using u-Health services. Therefore, health professionals need to give personalized education to deal with their conflicts and requirements, especially emotional and environmental support in order for them to successfully accept the u-Health services for self-care.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.2440-2443
• /
• 2005

We propose a new early rehabilitation training system for postural control using a tilting bed and a force plate. The conventional rehabilitation systems for postural control cannot be applied to the patients lying in bed because the rehabilitation training using those systems is possible only when the patient can stand up by himself or herself. Moreover, there has not existed any device that could provide the sense of balance or the sensation of walking to the patients in bed. By using a tilting bed, a visual display, and a force plate, we have developed a new rehabilitation training system for balance control of the patients in bed providing sense of balance and the sensation of walking to the patient. Through the experiments with real people, we verified the effectiveness of the new early rehabilitation training system. The results showed that this system is an effective system for the early rehabilitation training and that our system might be useful as clinical equipment.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.05a
• /
• pp.757-759
• /
• 2011

본 논문에서는 홈 헬스케어에서 건강측정을 위하여 가장 많이 사용되는 개인 건강 기기(personal health device)인 혈당계, 혈압계, 심박측정계(heart rate monitor), 산소포화도 측정계(pulse-oximeter), 심전도 측정계(ECG monitor)의 5가지 홈 헬스케어 의료기기를 구성하고 표준 핵심 기술 요소인 ISO/IEEE 11073, HL7을 준용하는 게이트웨이 플랫폼을 스마트폰에 적용하여 기존의 홈 헬스케어 시스템을 구성하는 단말기 형태의 게이트웨이나 홈 서버 하드웨어 구성을 필요로 하지 않으면서 집안의 고정된 게이트웨이로 인해서 생기는 위치종속성 문제를 해결할 수 있는 PMG(personal mobile gateway) 기반의 홈&모바일 헬스케어 시스템을 개발하고자 한다.

• Proceedings of the IEEK Conference
• /
• 2009.05a
• /
• pp.402-404
• /
• 2009

The development of health information technology enables people to access, view and acquire personal health record. But still, there have been a number of obstacles such as the absence of the standard to realize the ideal Personal Health Record(PHR) system. In this study, we proposed the service model that serves periodic Health Record Summary which is made by a medical specialist to people who are in the busy lives. Healthcare data from EMR in a hospital including people generate themselves at home is sent to a physician to make a medical opinion, and then it is changed into Health Level 7 Continuity of Care Document(CCD) format for interoperability. After a physician writes his opinion about patient's health condition, it will send to people by email. People who receive the health record summary data by email can save them into a USB device to view own PHR and medical comments of a physician through a computer. It will help people managing their own health condition with an opinion of a medical specialist.

• Imaging Science in Dentistry
• /
• v.44 no.2
• /
• pp.155-160
• /
• 2014

Purpose: The purposes of this study were to develop a workstation computer that allowed intraoperative touchless control of diagnostic and surgical images by a surgeon, and to report the preliminary experience with the use of the system in a series of cases in which dental surgery was performed. Materials and Methods: A custom workstation with a new motion sensing input device (Leap Motion) was set up in order to use a natural user interface (NUI) to manipulate the imaging software by hand gestures. The system allowed intraoperative touchless control of the surgical images. Results: For the first time in the literature, an NUI system was used for a pilot study during 11 dental surgery procedures including tooth extractions, dental implant placements, and guided bone regeneration. No complications were reported. The system performed very well and was very useful. Conclusion: The proposed system fulfilled the objective of providing touchless access and control of the system of images and a three-dimensional surgical plan, thus allowing the maintenance of sterile conditions. The interaction between surgical staff, under sterile conditions, and computer equipment has been a key issue. The solution with an NUI with touchless control of the images seems to be closer to an ideal. The cost of the sensor system is quite low; this could facilitate its incorporation into the practice of routine dental surgery. This technology has enormous potential in dental surgery and other healthcare specialties.