• 한국식품영양과학회지
• /
• 제24권2호
• /
• pp.234-241
• /
• 1995

Effect of microwave heating on the oxidative stability of the soybean oil, sesame oil, butter and margarine were investigated by mearsuring fatty acids amout and tocopherol losses. The index for chemical properteis, free fatty acid, peroxide value, anisidine value, carbonyl value, conjugated diene and triene levels were also mearsured in the oil samples for 5, 10, 15 and 20 min of heating in a microwave oven. No significant difference was observed on the fatty acids composition in the fats and oils before and after microwave heating. During microwave treatment, the oxidative degradation of the tocopherols in the samples became greater with increasing heating time. The amount of tocopherols in the soild fats, butter and margarine, dropped drastically after 5 min of heating and reduced to 95% of their original levels after 20min heating ${\gamma}$-tocopherol in butter showed the most unstable states and completely destroyed during microwave treatment for 20min. On the other hand, 80% of tocopherols in the liquid oils were still remained after 5min of heating except $\delta$-tocopherol in sesame oil.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2001년도 추계학술대회논문집 II
• /
• pp.983-988
• /
• 2001

Dynamic behaviors and stability of an optical disk drive coupled with an automatic ball balancer(ABB) are analyzed by a theoretical approach. The feeding system is modeled a rigid body with six degree-of-freedom. Using Lagrange's equation, we derive the nonlinear equations of motion for a non-autonomous system with respect to the rectangular coordinate. To investigate the dynamic stability of the system in the neighborhood of the equilibrium positions, the monodromy matrix technique is applied to the perturbed equations. On the other hand, time responses are computed by the Runge-Kutta method. We also investigate the effects of the damping coefficient and the position of ABB on the dynamic behaviors of the system.

• 소음진동
• /
• 제9권2호
• /
• pp.363-370
• /
• 1999

In this study, we establish a theory for dynamic behaviors of an automatic ball balancer, analyze its dynamic characteristics, and provide its design guide line. Equations of motion are derived by using the polar coordinate system instead of the rectangular coordinate system which was previously used in other researches. After nondimensionalization of the equations, the perturbation method is applied to locate the equilibrium positions and to obtain the linearized equations of motion around the equilibrium positions. The Eigenvalue problem is used to verify the dynamic stability around the equilibrium positions. On the other hand, the time responses are computed from the nonlinear equations of motion by using a time integration method.

• 소음진동
• /
• 제9권2호
• /
• pp.355-362
• /
• 1999

Vibration reduction of an optical disk drive is achieved by an automatic ball balancer and dynamic behaviors of the drive are studied by theoretical approaches. Using Lagrange's equation, we derive nonlinear equations of motion for a non-autonomous system with respect to the rectangular coordinate. To investigate the dynamic stability of the system in the neighborhood of equilibrium positions, the Floquet theory is applied to the perturbed equations. On the other hand, time responses are computed by an explicit time integration method. We also investigate the effects of mass center and the position of the ABB on the dynamic behaviors of the system.

• Structural Engineering and Mechanics
• /
• 제76권5호
• /
• pp.613-618
• /
• 2020

Exhausting oil resources and increasing pollution around the world are forcing researchers to look for new, renewable, biodegradable materials to lead sustainable development. The use of fiber reinforced composites based on natural fibres has increasingly begun as prospective materials for various engineering applications in the automotive, rail, construction and aerospace industries. The natural fiber chosen to make the composite material is plant-based fibre, e.g. jute fibre, and hemp fibre. Thermosetting polymer based Epoxy (LY556) was utilized as matrix material and The composites were produced using hand lay-up technique. The fabricated composites were tested for acoustic testing, thermo-gravimetric analysis (TGA) and flammability testing to asses sound absorption, thermal decomposition and fire resistivity of the structures. Hemp fibre composites have shown improved thermal stability over Jute fibre composites. However, the fire resistance characteristics of jute fibre composites are better as compared to hemp fibre composites. The sound absorption coefficient of composites was found to enhance with the increase of frequency.

• Journal of Electrochemical Science and Technology
• /
• 제12권1호
• /
• pp.159-165
• /
• 2021

YSZ based anode supported solid oxide fuel cells (SOFCs) were prepared, and two cells with different electrolyte thicknesses were connected in series for the simulation of a cell-imbalanced fuel cell stack. Pure YSZ cells in a series connection exhibited a rapid degradation when a thick electrolyte cell was operated under a negative voltage. On the other hand, ceria added-YSZ cells in a series connection were stable under similar operating conditions, and the power density and impedance were about the same as those before tests. The improved stability was due to the reduction of internal partial pressure in the electrolyte by locally increasing the electronic conduction. Thus, we propose a new protection method, i.e., the local addition of ceria in the YSZ electrolyte, to extend the lifetime of a cell-imbalanced SOFC stack.

• Membrane and Water Treatment
• /
• 제14권2호
• /
• pp.55-63
• /
• 2023

In this study, the influence of different IEMs (ion exchange membranes) to performance of the hypochlorite electrolysis unit with Cl₂ recovery stream was investigated. More specifically, Nafion 117-a representative cation exchange membrane (CEM)-and aminated polypheylene oxide (APPO)-an anion exchange membrane (AEM)-were installed in the hypochlorite electrolysis unit, and the performance and the energy efficiency of the units were evaluated and compared. Regardless of whether CEM (Nafion 117) or AEM (APPO) was installed, the rate of hypochlorite generation was increased (by up to 24.3% and 22.2% for Nafion 117 and APPO, respectively) compared with the unit without an IEM. On the other hand, the power efficiency and the optimum operation condition of hypochlorite production units seem to depend on the conductivity and stability of the installed IEM. As the result, between Nafion 117 and APPO, higher performance and efficiency were achieved with Nafion 117, due to excellent conductivity and stability of the membrane.

• 전력전자학회논문지
• /
• 제4권2호
• /
• pp.138-143
• /
• 1999

본 논문에서는 직접 구동용 브러쉬 없는 직류 전동기(BLDD)에 있어서 외란에 강인한 위치 제어를 하기 위한 새로운 제어 방법으로 적응 제어형 외란 관측기를 제시하였다. 정밀 위치 제어를 위해서 Field-orientation 방법을 통해 선형화 하였다. BLDC 전동기는 뒤틈(backlash)이 없는 반면에 높은 가격과 비선형 특성에 의한 복잡한 제어기가 필요하다는 단점이 있다. 또한 외부 외란은 전동기의 축에 직접 영향을 미치고 있다. 이 외란은 영향을 줄이기 위해서 Lyapunov 안정성 이론을 이용하였다. 이 이론을 바탕으로 제안된 시스템의 안정성을 증명하였으며, 관측기에서 취한 값을 순간적으로 등가 전류로 계산하여 정궤환(feedforward)하여 보상하였다.

• 한국공작기계학회논문집
• /
• 제12권2호
• /
• pp.23-30
• /
• 2003

It is very important to detect and evaluate the surface or subsurface flaws because of their influences on mechanical properties of materials. Rayleigh wave and creeping wave are commonly used for the detection of surface and subsurface flaws. These techniques, however, have following problems. Each amplitudes are remarkably affected by the surface condition and evaluation of echo pattern is usually difficult because shear wave mode propagate in the material at the same time. On the other hand, surface SH-wave which is horizontally polarized shear wave traveling along near surface layer is an attractive technique for the surface or subsurface material characterization and this technique is useful to solve the problems mentioned above. In this paper, The stability and transmission coefficient of SH waves through a viscous fluid layer is theoretically studied and simulated. Its results agreed well with the theoretical expectation for the experimental verification. These experimental results show that viscosity of couplants, thickness of couplant and surface roughness are closely related to transfer efficiency in surface SH angle beam method.

• 천문학회보
• /
• 제39권2호
• /
• pp.97.2-97.2
• /
• 2014

In this paper, we study the stability and dynamics of a magnetic field producing the M6.6 class solar flare taking place in NOAA active region (AR) 11158 on 2011 February 13th. Toriumi et. al. (2013) recently suggest that a fine scale magnetic structure on the photosphere gives a major possibility to produce the M6.6 class flare. On the other hand, they don't discuss the torus instability as a plausible mechanism even though Zhao et. al. (2014) and Janvier et. al. (2014) suspect it as the trigger mechanism of X2.2 class flare taking place later in the same AR. We are the first to investigate the stability of a nonlinear force-free field (NLFFF) prior to the M6.6 class flare against the torus instability by using analytical and numerical approaches. Consequently, we found that our NLFFF is quite stable against small perturbation. This result supports that the flare is triggered by the photospheric motion suggested by Toriumi et. al. (2013). We further perform another MHD simulation with an anomalous resistivity using the NLFFF as an initial condition. As a result, we found the eruption of strongly twisted lines. We compare our simulation results with observations and discuss relevant dynamics in detail.