• Journal of the Korea Society of Computer and Information
• /
• v.5 no.2
• /
• pp.115-120
• /
• 2000

This papers describes two low-noise amplifiers that use the Hewlett-Packard ATF-10236 low noise GaAs FET device, The actual measured performance of the amplifiers compares favorably to that predicted by the computer simulation(ADS) the noise figure of the 1575MHz amplifier was measured at 1.78dB which is lower that 2dB as specified. Measurement gam measured 33.0075dB which is within 35dB$\pm$0.5㏈ of the GPS specification. Network Analyzer(HP8510) is used to measure all the s-parameters and Noise Figure meter(HP8970B) is used to measure noise figure. As the result of experiment, gain, input VSWR, output VSWR is within the GPS specification sufficiently.

• ETRI Journal
• /
• v.31 no.6
• /
• pp.795-802
• /
• 2009

This paper presents the design of an advanced terrestrial digital multimedia broadcasting (AT-DMB) baseband receiver SoC. The AT-DMB baseband is incorporated into a hierarchical modulation scheme consisting of high priority (HP) and low priority (LP) stream decoders. The advantages of the hierarchical modulation scheme are backward compatibility and an enhanced data rate. The structure of the HP stream is the same as that of the conventional T-DMB system; therefore, a conventional T-DMB service is possible by decoding multimedia data in an HP stream. An enhanced data rate can be achieved by using both HP and LP streams. In this paper, we also discuss a time deinterleaver that can deinterleave data for a time duration of 384 ms or 768 ms. The interleaving time duration is chosen using the LP symbol mapping scheme. Furthermore, instead of a Viterbi decoder, a turbo decoder is adopted as an inner error correction system to mitigate the performance degradation due to a smaller symbol distance in a hierarchically modulated LP symbol. The AT-DMB baseband receiver SoC is fabricated using 0.13 ${\mu}m$ technology and shows successful operation with a 50 mW power dissipation.

• Journal of Environmental Health Sciences
• /
• v.19 no.1
• /
• pp.66-70
• /
• 1993

Introduction : Methanethiol is a toxicant that is a byproduct in the industrial process (oil refinery), and it is produced in vivo from methionine via transamination in case of its overintake. And it also can be generated by the action of mucosal thiol Smethyltransferase on hydrogen sulfite which is formed by anaerobic bacteria in the intestinal tract. The toxicity of methanethiol has often been suggested as one of endogenous factors involved in the pathogenesis of hepatic encephalopathy. Furthermore, methanethiol could cause the membrane damage and inhibition of some membrane protective enzymes.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.16 no.6
• /
• pp.81-86
• /
• 2017

The high-pressure resin transfer molding (HP-RTM) process has a very effective for the mass production of carbon fiber reinforced plastic (CFRP) for light weight in the automotive industry. In developing robust equipment, new process and fast cure matrix systems reduces significantly the cycle time less than 5 minutes in recent years. This paper describes the cavity pressure, temperature and molding characteristics of the HP-RTM process. The HP-RTM mold was equipped with two cavity pressure sensors and three temperature sensors. The cavity pressure characteristics of the HP-RTM injection, pressurization, and curing processes were studied. This experiment was conducted with selected process parameters such as mold cap size, maximum press force, and injection volume. Consequently, this monitoring method provides correlations between the selected process parameters and final forming characteristics in this work.

• Korean Journal of Plant Resources
• /
• v.27 no.6
• /
• pp.635-641
• /
• 2014

Scutellaria baicalensis $G_{EORGI}$ (Scutellariae Radix) has been used to clear heat and to dry dampness in the stomach or intestines, which manifests as diarrhea or dysenteric disorder. In this study, we investigated the effective preparation of active components in Scutellariae Radix using the methods of solvent extraction and absorption fractionation for the development of new functional food or pharmaceuticals. The marker substances, baicalin, baicalein, wogonoside, and wogonin were directly isolated from the Scutellariae Radix. There chemical structures were elucidated by spectroscopic analysis. The Scutellariae Radix was extracted with hot water. To enhance yield of flavonoids in Scutellariae Radix, the hot water extract was dissolved in ethanol with concentration dependent manner. The precipitates were separated using centrifugal techniques at 10,000 rpm. Supernatant liquid was applied to the HPLC for quantification of major compounds. Separately, the hot water extract was absorbed on Diaion HP-20 resin. And then, the absorbed fraction was eluted with methanol for HPLC. The contents of baicalin, baicalein, wogonoside and wogonin in different treatment methods were analyzed by HPLC. Total amount of four major components were 16.9% in 50% ethanol extract, 21.7% in 70% ethanol extract, 20.5% in 90% ethanol extract, and 39.3% in absorbed fraction of Diaion HP-20 resin. In these results, we found that resin absorption method is suitable for the extraction of enriched flavonoids from Scutellariae Radix.

• Phonetics and Speech Sciences
• /
• v.2 no.4
• /
• pp.3-10
• /
• 2010

The present study aims to investigate neural activations according to the level of code switching in English proficient bilinguals and to find the relationship between the performance of language switching and proficiency level using ERPs (event-related potentials). First, when comparing high-proficient (HP) with low-proficient (LP) bilingual performance in a native language environment, the activation level of N2 was observed to be higher in the HP group than in the LP group, but only under two conditions: 1) the language switching (between-language) condition known as indexing attention of code switching and 2) the inhibition of current language for L1. Another effect of N400 can be shown in both groups only in the language non-switching (within-language) condition. This effect suggests that both groups completed the semantic acceptability task well in their native language environment without the burden of language switching, irrespective of high or low performance. The latencies of N400 are only about 100ms earlier in the HP group than in the LP group. This difference can be interpreted as facilitation of the given task. These results suggest that HP showed the differential activation in inhibitory system for L1 in switching condition of L1-to-L2 to be contrary to inactivation of inhibitory system for the LP group. Despite the absence of an N400 effect at the given task in both groups, differential latencies between the peaks were attributed to the differences of efficiency in semantic processing.

• Journal of the Korean Institute of Gas
• /
• v.8 no.4 s.25
• /
• pp.15-22
• /
• 2004

This study has been carried out to improve the conditions of process operation through the adjustment to the flow rate and outlet pressure of LNG HP pump, one of the main process facilities, in LNG receiving terminal. We have determined optimum flow rate and applied it to the field operation by analyzing the field operating performance for all the HP pumps and the load of natural gas supply in seasonal using the ASPEN PLUS. As a results, we have get the electric cost saving for the HP pump operation and derived contribution to safety operation by reduced the LNG Process pressure.

• Environmental Engineering Research
• /
• v.19 no.3
• /
• pp.197-203
• /
• 2014

This study estimated spatial and seasonal variation of water quality to understand characteristics of Nakdong river basin, Korea. All together 11 parameters (discharge, water temperature, dissolved oxygen, 5-day biochemical oxygen demand, chemical oxygen demand, pH, suspended solids, electrical conductivity, total nitrogen, total phosphorus, and total organic carbon) at 22 different sites for the period of 2003-2011 were analyzed using multivariate statistical techniques (cluster analysis, principal component analysis and factor analysis). Hierarchical cluster analysis grouped whole river basin into three zones, i.e., relatively less polluted (LP), medium polluted (MP) and highly polluted (HP) based on similarity of water quality characteristics. The results of factor analysis/principal component analysis explained up to 83.0%, 81.7% and 82.7% of total variance in water quality data of LP, MP, and HP zones, respectively. The rotated components of PCA obtained from factor analysis indicate that the parameters responsible for water quality variations were mainly related to discharge and total pollution loads (non-point pollution source) in LP, MP and HP areas; organic and nutrient pollution in LP and HP zones; and temperature, DO and TN in LP zone. This study demonstrates the usefulness of multivariate statistical techniques for analysis and interpretation of multi-parameter, multi-location and multi-year data sets.

• Journal of agriculture & life science
• /
• v.45 no.5
• /
• pp.1-8
• /
• 2011

In this study, 160 tea tree (Camellia sinensis L.) lines were classified by caffeine content using colorimetric methods. Among them, caffeine-rich lines (HR-78, HR-137, HR-82 and HR-123) and poor lines (HP-85, HP-88, HP-19, and HP-131) were selected. To know the difference in morphological and genetic characters between caffeine-rich and poor lines, we used leaf/shoot growth and RAPD methods. Cluster pattern of morphological characters (leaf width, leaf length, leaf area and shoot length) showed that shoot length was longer in caffein-rich lines than in -poor lines. In genetic analysis, amplified DNA bands having various sizes were detected in RAPD analysis where 30 random primers were used. However, the discriminated primer set that distinguish caffein-rich tree line from -poor lines was not found. These results can be used as the basic data to determine the morphological and genetic differences among caffein-rich and -poor lines.

• Journal of the Korean Society of Visualization
• /
• v.19 no.1
• /
• pp.62-67
• /
• 2021

Selective catalytic reduction(SCR) is an exhaust gas reduction device to remove nitro oxides (NOx). SCR operation of ship can be controlled through valves for minimizing economic loss from SCR. Valve in SCR-high pressure (HP) system is directly connected to engine exhaust and operates in high temperature and high pressure. Long-term thermal deformation induced by engine heat weakens the sealing of the valve, which can lead to unexpected failures during ship sailing. In order to prevent the unexpected failures due to long-term valve thermal deformation, a failure prediction system using autoregressive integrated moving average (ARIMA) was proposed. Based on the heating experiment, virtual data mimicking temperature range around the SCR-HP valve were produced. By detecting abnormal temperature rise and fall based on the short-term ARIMA prediction, an algorithm determines whether present temperature data is required for failure prediction. The signal processed by the data collection algorithm was interpolated for the failure prediction. By comparing mean average error (MAE) and root mean square error (RMSE), ARIMA model and suitable prediction instant were determined.