• Microbiology and Biotechnology Letters
• /
• v.13 no.4
• /
• pp.397-402
• /
• 1985

The fermentation of various sugars by C. thermosaccharolyticum was examined under pH controlled, anaerobic condition. The kinetic model for Product formation at various sugars was the combination of growth and non-growth associated mode. In the utilization of a single sugar, glucose was the best carbon source for growth. The specific growth rate of glucose, xylose and cellobiose were 0.363 h$^{-1}$, 0.242 h$^{-1}$ and 0.144 h$^{-1}$ respectively. The production of ethanol from glucose showed a negatively growth associated mode, so the higher growth rate decreased the productivity of ethanol. The maximum concentrations of the produced ethanol were 2.42 g/l, 3.76 g/l, and 3.4 g/l on glucose, xylose, and cellobiose. No glucose was detected during cellobiose fermentation. Sequential utilization of sugars was observed in the mixtures of glucose, xylose and cellobiose. It preferred glucose, followed by xylose and then cellobiose. The presence of other sugars had little or no effect on the rate of another sugar utilization. Cell lysis at the end of fermentation occured more slowly in the mixtures of sugars than a single sugar.

• Environmental Engineering Research
• /
• v.23 no.3
• /
• pp.330-338
• /
• 2018

This study investigated the possibility of using potassium titanate oxide ($K_2Ti_4O_9$) and acrylic acid-grafted polypropylene fabric (PP-g-AA) as adsorbents capable of removing strontium from aqueous solutions. $K_2Ti_4O_9$ showed the highest rate of strontium removal in the weak alkaline range, while the PP-g-AA increased strontium removal in the neutral range. Moreover, the adsorption capacity of the $K_2Ti_4O_9$ was not affected by the coexistence of K and Na ions, while the adsorption capacity decreased when Ca and Mg ions were present at the same concentration as that of strontium. When coexisted at the same concentration as strontium, Na, K, Ca, and Mg ions strongly reduced the adsorption capacity of the PP-g-AA. The results also indicated that the adsorption of strontium on $K_2Ti_4O_9$ was consistent with both the Langmuir and Freundlich adsorption isotherms. In contrast, the adsorption of strontium on the PP-g-AA was more consistent with the Langmuir isotherm model. Moreover, the adsorption equilibrium time of $K_2Ti_4O_9$ was generally 12 h, while that of the PP-g-AA was 5 h, indicating that the adsorption rates were consistent with the pseudo-second order kinetics model. $K_2Ti_4O_9$ and the PP-g-AA could be regenerated by simple washing with 0.5 N HCl.

• Progress in Superconductivity
• /
• v.14 no.2
• /
• pp.87-91
• /
• 2012

Metallic magnetic calorimeters (MMCs) are one of the most competitive low temperature detector (LTD) readout sensors. They have the advantages of high time resolution, no heat dissipation, and a wide range of operating temperature. We apply MMCs to our neutrinoless double beta decay ($0v{\beta}{\beta}$) search experiment. A $CaMoO_4$ crystal was employed as both a source of $0v{\beta}{\beta}$ and an energy absorber. The crystal was thermally connected to a MMC sensor. We set a simple thermal model for this detector and measured pulse shapes are compared with a numerical solution of the thermal model.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.17 no.2
• /
• pp.17-20
• /
• 1980

The shearing forces and bending moments acting on the tanker model[1] of $C_B$ 0.82 in regular oblique waves of shallow water are investigated by numerical calculations. The new strip method was adopted. It is concluded that in the shallow water shearing forces and the bending moments acting on the tanker model are higher than those of deep water waves by the present numerical investigations. The wave bending moment at the midship section is roughly twice of deep water value in the shallow of H/T less than 2. in this calculation.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.6
• /
• pp.1-6
• /
• 1998

A leaf spring plays an important role in a passenger bus. Since characteristic of a leaf spring has a hysteresis behaviour, modeling technique for a leaf spring is an important issue for passenger bus analysis. In this paper, modeling technique for a leaf spring is presented. First, non-linear FEM model of a leaf spring is constructed then it is used to make an approximated model to be used in dynamic analysis. The modeling procedure is ex-plained in step by step approach. Then, this model is applied to dynamic analysis of a mini-bus with flexible body and non-linear dynamic force element. The results are compared with test data.

• Transactions of Materials Processing
• /
• v.31 no.4
• /
• pp.194-199
• /
• 2022

In finite element method (FEM) simulations, constitutive models are widely used and developed to represent a wide range of true stress-strain curves using a small number of modeling parameters. Nevertheless, many studies has been conducted to find a suitable constitutive model and optimal modeling parameters to represent experimentally obtained true stress-strain curves. Therefore, in this study, a new constitutive modeling approach using the combined Swift and Voce model is suggested, and confirmed through comparisons of the experimental results with the FEM simulation results.

• Microbiology and Biotechnology Letters
• /
• v.11 no.1
• /
• pp.33-38
• /
• 1983

As flocculent strains are likely to have considerable potential for internal cell recycle, kinetic studies on glucose medium with flocculent Saccharomyces uvarum were carried out in batch and continuous culture. Using a mathematical model, the kinetic parameters at each temperature and pH were estimated in order to establish optimal conditions. It was found that an overall optimum temperature for growth and ethanol production in the range 33-35$^{\circ}C$ was desirable. With regard to the effect of pH, ethanol production by S. uvarum was found to be relatively insensitive to pH value between 4 and 6, with an optimum pH of around 5. At these optimal conditions a maximum ethanol productivity of 12 g/$\ell$/h was determined using semi-batch process together with 5. uvarum.

• Journal of the Korean Chemical Society
• /
• v.55 no.2
• /
• pp.208-217
• /
• 2011

The effects of pH and temperature on the removal of two dyes (neutral red; NR and malachite green oxalates; MG) from aqueous effluents using Maghnia montmorillonite clay in a batch adsorption process were investigated. The results showed the stability of the optical properties of MG in aqueous solution and adsorbed onto clay under wide range of pH 3-9. However, the interaction of NR dye with clay is accompanied by a red shift of the main absorption bands of monomer cations under pH range of 3-5, whereas, those of neutral form remains nearly constant over the pH range of 8-12. The optimal pH for favorable adsorption of the dyes, i.e. ${\geq}$90% has been achieved in aqueous solutions at 6 and 7 for NR and VM respectively. The most suitable adsorption temperatures were 298 and 318 K with maximum adsorption capacities of 465.13mg/g for NR and 459.89 mg/g for MG. The adsorption equilibrium results for both dyes follow Langmuir, Freundlich isotherms. The numerical values of the mean free energy $E_a$ of 4.472-5.559 kj/mol and 2.000-2.886 kj/mol for NR and MG respectively indicated physical adsorption. Various thermodynamic parameters, such as ${\Delta}H^{\circ}$, ${\Delta}S^{\circ}$, ${\Delta}G^{\circ}$ and Ea have been calculated. The data showed that the adsorption process is spontaneous and endothermic. The sticking probability model was further used to assess the potential feasibility of the clay mineral as an alternative adsorbent for organic ion pollutants in aqueous solution.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.10
• /
• pp.1720-1725
• /
• 2004

Absorption characteristics of green tea powder were investigated. The monolayer moisture content determined by GAB equation was 0.024~0.052 g $H_2O$/g dry solid. The absorption enthalpy was calculated with different particle size and various water activities. It showed that the absorption energy was decreased with increasing water activity but no difference was found on particle size increasement. Among models applied for predicting equilibrium moisture content, Halsey model was the best fit model for green tea powders, showing the lowest prediction deviation of 2.1~4.0%. The prediction model equations for the water activity was established as function of relative humidity, time and temperature. The model equation will be helpful for future work on drying and storage of green tea powder.

• Journal of Magnetics
• /
• v.2 no.3
• /
• pp.101-104
• /
• 1997

Vector Moving Preisach model has been applied to the unoriented Co-based alloy thin film media. In the model, the out-of plane easy axis distribution of the particles was derived directly from the texture coefficient phkl obtained from XRD analysis, which corresponds to the fraction of the grains that have the {hkl} plane lying parallel to in-plane direction. The model was validated, by its prediction of a variety of responses, including major loop, minor loop, and the angular dependence of coercivities.