• Journal of Astronomy and Space Sciences
• /
• v.20 no.4
• /
• pp.339-350
• /
• 2003

Engineering qualification model payload for a communications and broadcasting satellite(CBS) was developed by ETRI from May, 2000 to April, 2003. For. the purpose of functional test and verification of the payload, a real-time hardware-in-the-loop(HITL) CBS simulator(CBSSIM) was also developed. We assumed that the spacecraft platform for the CBSSIM is a geostationary communication satellite using momentum bias three-axis stabilization control technique based on Koreasat. The payload hardware is combined with CBSSIM via Power, Command and Telemetry System(PCTS) of Electrical Ground Support Equipment(EGSE). CBSSIM is connected with PCTS by TCP/IP and the payload is combined with PCTS by MIL-STD-1553B protocol and DC harness. This simulator runs under the PC-based simulation environment with Windows 2000 operating system. The satellite commands from the operators are transferred to the payload or bus subsystem models through the real-time process block in the simulator. Design requirements of the CBSSIM are to operate in real-time and generate telemetry. CBSSIM provides various graphic monitoring interfaces and control functions and supports both pre-launch and after-launch of a communication satellite system. In this paper, the HITL simulator system including CBSSIM, communications payload and PCTS as the medium of interface between CBSSIM and communications payload will be described in aspects of the system architecture, spacecraft models, and simulator operation environment.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.5B
• /
• pp.479-486
• /
• 2010

Reliable hydrologic data acquisition is the basic and essential requirement for efficient water management. Especially the acquisition of various stream data in a certain location is very important to construct on alarm system to response an urban flood which occurs frequently due to the effect of climate change. Although the frequency of stream inundation flood occurrence becomes low owing to the consistent stream improvement, the urban flood due to the drainage system problems such as deterioration and bad management occurs continuously. The consistent management and current status understanding of the urban drainage system is essential to reduce the urban flood. The purpose of this study is to develop the urban runoff network flow velocity monitoring system which has the capability of collecting stream data whenever, wherever and to whomever without expert knowledge using Code Division Multiple Access technique and Bluetooth near-distance wireless communication technique. The urban runoff network flow velocity monitoring system consists of three stages. In the first stage, the stream information obtained by using ubiquitous floater is transferred to the server computer. In the second stage, the current state of the urban drainage system is assessed through the server computer. In the last stage, the information is provided to the user through a GUI. As a result of applying, the developed urban runoff network flow velocity monitoring system to Woncheon-Stream in Suwon, the information necessary for urban drainage management can be managed in real time.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.43 no.3 s.309
• /
• pp.76-83
• /
• 2006

A main objective of audio equalizer is for user to tailor acoustic frequency response to increase sound comfort and example applications of audio equalizer includes large-scale audio system to portable audio such as mobile MP3 player. Up to now, all the audio equalizer requires manual setting to equalize frequency bands to create suitable sound quality for each genre of music. In this paper, we propose an intelligent audio graphic equalizer system that automatically classifies the music genre using music content analysis and then the music sound is boosted with the given frequency gains according to the classified musical genre when playback. In order to reproduce comfort sound, the musical genre is determined based on two-step hierarchical algorithm - coarse-level and fine-level classification. It can prevent annoying sound reproduction due to the sudden change of the equalizer gains at the beginning of the music playback. Each stage of the music classification experiments shows at least 80% of success with complete genre classification and equalizer operation within 2 sec. Simple S/W graphical user interface of 3-band automatic equalizer is implemented using visual C on personal computer.

• Proceedings of the KSME Conference
• /
• 2001.06c
• /
• pp.369-375
• /
• 2001

For Optimization technology Was Developed in 1960, the Optimization Technology have grown into a full-featured, robust, highly rated and highly used. And Optimization techniques, having reached a degree of maturity over the past several years, are being used in a wide spectrum of industries, including aerospace, automotive, chemical, electrical, and manufacturing industries. With rapidly advancing computer technology, computers are becoming more powerful, and correspondingly, the size and the complexity of the problems being solved using Optimization techniques are also increasing. But Optimization techniques with analysis solver have many problems. For instance, the difficulties that a particular interface must be coded for each design problem and that the designer should be familiar with the optimization program as well as the analysis program. The purpose of this paper is Optimal Design Framework for Mechanical systems design. This Design Framework has two Optimizers, ADS (local optimizer) and RSM(Response Surface Method), and graphic user interfaces for formulation and optimum design problem and controlling the design process. Current Design Framework tested by two analysis solver, ADAMS and ANSYS. First this paper focused on the core Framework and their conception. In the second of the paper, I cover subjects such as Design Framework Operation. Next, The validity and effectiveness of Design Framework are shown by applying it to many practical design problems and obtaining satisfactory results. Finally, if you are an advanced Operator, you might want to use Response Surface Method, so that cover the result applied by RSM. here.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.6
• /
• pp.2888-2897
• /
• 2011

The performance of a geothermal heat pump system using carbon dioxide was investigated by the steady-state cycle simulation program developed in this study. A parametric study was carried out in order to investigate the effect of various operating conditions on the performance of the basic cycle without an IHX(internal heat exchanger). The simulation program consists of several Fortran subroutines for simulating indoor and outdoor heat exchangers, compressors, and expansion valves and Visual Basic subroutines for the graphic user interface(GUI) consisted with pre-processor for input data and post-processor for the output data. Refprop V6.01 was used for estimating the thermodynamic properties and equilibrium behaviors of carbon dioxide. The simulation results were validated by comparing experimental data through a series of case studies. The cycle simulation program developed in this work would seem to be a useful tool in optimizing and establishing economical and efficient operating conditions in the $CO_2$ geothermal heat pump system.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.1
• /
• pp.75-81
• /
• 2007

This paper dealt with the design and implementation of an expert system to monitor and diagnose the lightning arresters in GIS substations. The expert system consists of a data acquisition module(DAM) based on microprocessor and diagnostic algorithms. The DAM measures and analyzes several parameters necessary for the arrester diagnosis such as system voltages, leakage current components, and temperatures. Also, it includes an intelligent surge counter which can record the date and tin, the polarity, and the amplitude of surge currents. All the data acquired is transmitted to a remote computer by a low rate wireless network specified in IEEE 802.15.4 to avoid electromagnetic intereference under high voltage and large current environments. The decision-making for the arrester diagnosis completes with a Java Expert System Shell(JESS) which is composed of a knowledge base, an inference engine and a graphic user interface(GUI).

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.5
• /
• pp.50-59
• /
• 1997

In this paper, we implement an automatic speech segmentation and labeling system which marks phone boundaries automatically for constructing the Korean speech database. We specify and implement the system based on conventional speech segmentation and labeling techniques, and also develop the graphic user interface(GUI) on Hangul $Motif^{TM}$ environment for the users to examine the automatic alignment boundaries and to refine them easily. The developed system is applied to 16kHz sampled speech, and the labeling unit is composed of 46 phoneme-like units(PLUs) and silence. The system uses both of the phonetic and orthographic transcription as input methods of linguistic information. For pattern-matching method, hidden Markov models(HMM) is employed. Each phoneme model is trained using the manually segmented 445 phonetically balanced word (PBW) database. In order to evaluate the performance of the system, we test it using another database consisting of sentence-type speech. According to our experiment, 74.7% of phoneme boundaries are within 20ms of the true boundary and 92.8% are within 40ms.

• 한국IT서비스학회:학술대회논문집
• /
• 2002.06a
• /
• pp.96-107
• /
• 2002

21세기를 맞이하는 기업은 세계화와 국제화, 정보의 다양화 및 분산화, 제품수명주기의 단축과 수익률의 감소, 고품질의 제품, 지식산업의 등장, 고객 욕구의 증대 등 다양한 내 ${\cdot}$ 외적 환경변화에 대응해야 하고 경쟁우위를 확보하기 위해 끊임없이 기업의 변화능력을 확보해야 한다. 기업은 제품을 생산하여 판매하는 기업의 시스템 전체가 경쟁력을 갖추어 총체적 우위를 확보하고 고객의 기호와 감성에 호소하는 제품을 만들 수 있도록 다양한 정보를 제공하는 시스템을 필요로 하게 되었다. 즉, 시간과 서비스에 뒤진 고객지원체계는 기업의 성장에 절대적인 마이너스 요인이므로 고객 정보의 효율적 관리, 고객 요구에 대한 신속한 대응, 정기적 고객만족도 조사 등 고객이 원하는 것을 재빠르게 얻어낼 수 있는 고객 친밀형 정보시스템의 확립이 요구되는 것이다. 이를 해결해 줄 수 있는 새로운 경영정보시스템이 바로 WebERP인 것이다. WebERP는 기업의 원활한 자재, 구매활동을 위해 제안된 MRP에서 시작되었으며, 생산관리의 개념을 포함하고 있는 MRPII로 확대되었다가 다시 인사나 회계, 재무 등 조직이나 기업의 전업무영역을 수용하는 종합경영정보시스템으로 발전된 것이다. 현재는 전자상거래와 관련하여 WebERP의 필요성이 부각되었고, 모기업과 협력사간의 구매발주 및 납품관리를 확대시켜 소모성자재(MRO: Maintenance, Repair & Operation) 및 기타 공동구매서비스와 유사업종간의 그룹을 형성하여 ASP(Application Service Provider)의 공동 환경을 이용한 WebERP 환경을 이용한 WebERP활용이 현시점으로 적실히 필요한 것이다. 이는 중소기업들의 공동 협업체제를 도모하여 외세를 대비하는 응집력을 확고히 함으로써 집단체제의 e마켓플레이스 확립과 더불어 국제경쟁을 대비한 방안으로서 집단 공동의 웹환경 인프라가 필요한 것이다. 이러한 배경에서 ASP환경을 이용한 WebERP활용방안과 시스템 구축전략을 경남지역의 기계산업정보화사업단이 추진하는 일반기계, 전기기계, 금속기계, 수송기계, 정밀기계의 5개 업종을 4,877개 기업 대상으로 추진하고 있으며, 그 중 WebERP의 모델로서 2003년도까지 50개 기업을 선정하고, 이는 5개 업종 골고루 선정하여 적용과 표준화 모델로 전개해 나가는 것을 정리한 것이다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.3 no.3
• /
• pp.210-215
• /
• 2002

In this study, the computer program called Multi_Cycle, which simulates the steady-state performance (coefficient of performance, capacity, power consumption and etc.) of multi- airconditioning systems using R410A, was developed. In order to validate the simulation program, a series of case studies were carried out. The Multi_Cycle consists of several subroutines for simulating indoor units. outdoor unit, compressor, and expansion devices. and for estimating the thermodynamic and transport properties of the refrigerants and moist air. It would appear to be advantageous to use the Multi_Cycle for a performance analysis when considering various kinds of refrigerants and the complex operating conditions of each unit making up the multi-airconditioner cycle. Moreover, the Multi_Cycle would seem to be useful tool in optimizing a multi-airconditioning system and establishing economical and efficient operating conditions in the multi-airconditioner cycle. In the present study, the Multi_Cycle was programmed with Digital Visual Fortran for the main simulation code and Visual Basic for- the graphic user interface.

• Journal of KIISE:Information Networking
• /
• v.29 no.6
• /
• pp.613-624
• /
• 2002

Within the past decade, TCP/IP network environment has been explosively widespread all over the world. As the internet and the WWW expand their boundaries, the network traffic caused by data transfers over the internet has also increased. In this paper, we present the design and implementation of a WebTraMAS (Web-based Traffic Monitoring and Analysis System) which can resolve the shortcomings of current management approaches, particularly on the network traffic monitoring and analysis. The WebTraMAS presented in this paper performs the network management activities based on the parameters related to the MIB-II of SNMP and the parameters related to the QoS such as network performance and fault. The proposed WebTraMAS, implemented using the WWW technology, is able for the network manager to manage the network easily and platform independently with the performance analysis of internet traffic.