• Nuclear Engineering and Technology
• /
• v.53 no.3
• /
• pp.960-966
• /
• 2021

A technical approach to design and carry out an experiment to determine the uptake of selected radionuclides in site-specific conditions in Kuwait was developed and successfully executed for developing a radioecological decision support system. The radionuclides from soil-to-plant transfer factors have been obtained for leafy and non-leafy vegetables, and root crops cultivated in Kuwait. Two types of vegetated soils were selected and spiked with high concentrations of three relatively short-lived selected radionuclides (⁸⁵Sr, ¹³⁴Cs, and ¹³³Ba). The highest strontium and barium transfer factors were found in the order: leafy vegetables > root crops > non-leafy vegetables. The approximate range of radiocesium transfer factor was found to be low in all plant groups and was comparable to those reported elsewhere in different soil types of temperate and tropical environments. A strong negative correlation between the obtained transfer factors and the distribution coefficient of the radionuclide in soil was found. It is recommended to adopt the newly derived parameters for the sensitive areas in Kuwait and other Gulf countries instead of using the generic parameters, whenever dose calculation codes are used. This will help to more accurately assess and predict the end results of the committed effective dose equivalent through ingestion pathway.

• Journal of Korean Academy of Nursing Administration
• /
• v.13 no.4
• /
• pp.537-545
• /
• 2007

Purpose: The purpose of this study was to compare the role and the certification system for nurses working in HIV/AIDS care among the U.S., the UK, and Japan. Method: The searching for the internet website and literature was used and visiting the institutes and interviewing the key informants were done from August, 2006 to February, 2007. Results: In the U.S., there are two types of nurse specialist in HIV/AIDS care. One is the HIV/AIDS Certified Registered Nurse which is without any academic degree requirement, and the other is the Advanced HIV/AIDS Certified Registered Nurse which requires master level degree and 5 years career. There are three level of nurses' role in HIV/AIDS care in the UK. Also, the National HIV Nurses Association of the UK developed generic competencies and specialist competencies according to this three level of nurse's role. In the case of Japan, the certification system is not formalized yet, but the AIDS coordinator nurses are working as a specialist in the Japan International Medical Center. Conclusion: Based on this result, it is suggested that the comprehensive role of nurses in HIV/AIDS should be developed under the governmental support.

• Tunnel and Underground Space
• /
• v.10 no.4
• /
• pp.553-558
• /
• 2000

Since 1977, KAERI has conducted the fundamental R&D on the permanent disposal of potential HLW repository in Korea. The first ten year project is divided into three short-term phase studies. The first phase study which shall be finished in March of 2000, has the prime target to develop the disposal concept of HLW. Throughout this study the preliminary and generic disposal repository system has been introduced. The potential repository is proposed to be emplaced into crystalline rocks which is the most common rock types in Korea. The proposed depth of the repository is between 300 to 700 meter. The numerical code, MASCOT-K was developed to asserts the long term safety of the proposed repository concept. Based on this conceptual design preliminary safely assessment was performed. Results show that for the given disposal system the potential radioactive release it well below the regulatory limit.

• Asian Pacific Journal of Cancer Prevention
• /
• v.17 no.11
• /
• pp.4951-4957
• /
• 2016

Background: Apart from reducing occupational exposure to cytotoxic hazards, the PhaSeal(R) closed-system transfer device (CSTD) can extend the beyond-use dates (BUDs) of unfinished vials of antineoplastic drugs for up to 168 hours (seven days). In this study, the total material cost incurred by its use in a Malaysian government-funded hospital was calculated. Methods: A list of vial stability following initial needle punctures of 29 commonly-used antineoplastic drugs was compiled. The amount of the materials used, including drugs, infusion bottles, the PhaSeal(R) CSTD and other consumables, was recorded on a daily basis for three months in 2015. The total cost was calculated based on the actual acquisition costs, and was compared with that of a hypothetical scenario, whereby conventional syringe-needle sets were used for the same amounts of preparations. Results: The use of the PhaSeal(R) CSTD incurred a cost of MYR 383,634.52 (USD 92,072.28) in three months, representing an average of MYR 170.5 (USD 40.92) per preparation or an estimated annual cost of MYR 1,534,538.08 (USD 368,289.14). Compared with conventional syringe-needle approach, it is estimated to lead to an additional spending of MYR 148,627.68 (USD 35,670.64) yearly. Conclusion: Although there was a reduction of drug wastage achieved by extending BUDs of unfinished vials using the PhaSeal(R) CSTD, cost saving was not observed, likely attributable to the wide use of lower-priced generic drugs in Malaysia. Future studies should further evaluate the possibility of cost saving, especially in health settings where branded and high-cost antineoplastic drugs are more commonly used.

• Journal of Advanced Navigation Technology
• /
• v.21 no.6
• /
• pp.638-642
• /
• 2017

FOD is a generic term for substances with potential threats that can pose a fatal risk to aircraft. Therefore, FOD should be noted in all areas of the airport. Especially, the method of detecting and collecting FOD in runway and aircraft movements is very low efficiency and economical efficiency of airport operation, so it is essential to develop FOD automatic detection system suitable for domestic environment. As part of the aviation safety technology development project, the development of an automatic detection system for foreign matter in the moving area of the aircraft inside the airport is underway. In this paper, it is confirmed that EO / IR camera is used for detection of foreign objects at Taean Airfield of Hanseo University. EO camera is used during the day and IR camera is used at night.

• Earthquakes and Structures
• /
• v.19 no.5
• /
• pp.347-359
• /
• 2020

The Mega-Sub Controlled Structure System (MSCSS), an innovative vibration passive control system for building structures, is improved by adding lead rubber bearings (LRBs) on top of the substructure. For the new system, a genetic algorithm is used to optimize the dynamic parameters and distributions of dampers and LRBs. The program uses various seismic performance indicators as optimization objectives, and corresponding results are compared. It is found that the optimization procedure for maximizing the energy dissipation ratio yields the best solutions, and optimized models have consistent seismic performances under different earthquakes. Seismic performances of optimized MSCSS models with and without LRBs, as well as the traditional Mega-Sub Structure model, are evaluated and compared under El Centro wave, Taft wave and 20 other artificial waves. In both elastic and plastic analysis, the model with LRBs shows significantly smaller story drift and horizontal acceleration than those of the other two models, and fewer plastic hinges are developed during severe earthquakes. Energy analysis also shows that LRBs installed in proper locations increase the deformation and energy dissipation of dampers, thereby significantly reduce the kinetic, potential, and hysteretic energy in the structure. However, LRBs do not have to be mounted on all the additional columns. It is also demonstrated that LRBs at unfavorable locations can decrease the energy dissipation for dampers. After LRBs are installed, the optimal damping coefficient and the optimal damping exponent of dampers are reduced to produce the best damping effect.

• Journal of the Korean Society for information Management
• /
• v.20 no.1
• /
• pp.417-455
• /
• 2003

Ontologies are formal theories that are suitable for implementing the semantic web. which is a new technology that attempts to achieve effective retrieval, integration, and reuse of web resources. Ontologies provide a way of sharing and reusing knowledge among people and heterogeneous applications systems. The role of ontologies is that of making explicit specified conceptualizations. In this context, domain and generic ontologies can be shared, reused, and integrated in the analysis and design stage of information and knowledge systems. This study aims to design an ontology for international organizations. and build an Internet web retrieval system based on the proposed ontology. and finally conduct an experiment to compare the system performance of the proposed system with that of internet search engines focusing relevance and searching time. This study found that average relevance of ontology-based searching and Internet search engines are 4.53 and 2.51, and average searching time of ontology-based searching and Internet search engines are 1.96 minutes and 4.74 minutes.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.16 no.5
• /
• pp.69-77
• /
• 2017

This paper introduces an optical encoder using the reflection in the slit. The digital optical encoder is a sensor to generate a pulse according to the displacement. An optical encoder is composed of 3 parts: light source, slit plate and light-receiving element. In a conventional encoder, one slit produces one signal. The resolution of the digital optical encoder is determined by the number of slits in the encoder plate. The small slit size is most important among the factors that determine the resolution in a generic-type optical encoder. However, a small slit has low productivity and technical difficulties, so analog optical encoders have emerged as an alternative. Nonetheless, this alternative requires additional circuitry and equipment because of the noise and drafts in the analog signals. A new sensor is presented in this paper with a high resolution and a slit of the same size using the reflection in the slit. Then, the path of the light that passes through the slit ccording to the shape was analyzed, and some paths were expressed in the mathematical expressions. In addition, the optical paths were analyzed in the rectangular, octagonal, and circular encoders, and shown the obtained number of signals per slit by using them. Thus, we confirm that this method has the best performance in circle-shaped slits.

• The Transactions of the Korea Information Processing Society
• /
• v.3 no.3
• /
• pp.631-639
• /
• 1996

In this paper we discuss the elements which must be considered for collaboration- aware application design and their effcets on user interfaces. Collaboration-aware applications have inter-user and user/system interaction features besides generic real-time distribution system features and this restricts the design freedom with the requirement of consistent user interfaces. Programmers, therefore, must provide uniform and logically consistent user interfaces to user and, for this end, they should consider main design features such as concurrency control algorithms, system topology and object replication scheme. Among the design factors concurrency control algorithms have relatively significant impact on user interfaces and we consider the impact of concurrency control agorithms along with that of thesystem to pologyand the objectreplication scheme. Coshed/SAS, a groupeditor, is given as an example of application of the factors.

• Safety and Health at Work
• /
• v.1 no.1
• /
• pp.29-36
• /
• 2010

This article describes a systematic roadmap master plan for advanced industrial safety and health policy in Korea, with an emphasis on. Since Korean industries had first emergence of industrial safety and health policy in 1953, enormous efforts have been made on upgrading the relevant laws in order to reflect real situation of industrial work environment in accordance with rapid changes of Korean and global business over three decades. Nevertheless, current policy has major defects; too much techniques-based articles, diverged contents in less organization, combined enforcement and punishments and finally enforcing regulations full of commands and control. These deficiencies have make it difficult to accommodate changes of social, industrial and employment environment in customized fashion. The approach to the solution must be generic at the level of paradigm-shift rather than local modifications and enhancement. The basic idea is to establish a new system integrated with a risk assessment scheme, which encourages employers to apply to their work environment under comprehensive responsibility. The risk assessment scheme is designed to enable to inspect employers' compliances afterwards. A project comprises four yearly phases based on applying zones; initially designating and operating a specified risk zone, gradually expanding the special zones during a period of 3 years (2010-2012) and the final zone expanded to entire nation. In each phase, the intermediate version of the system is updated through a process of precise and unbiased validation in terms of its operability, feasibility and sustainability with building relevant infrastructures as needed.