• Journal of the Korean Society of Safety
• /
• v.32 no.6
• /
• pp.29-33
• /
• 2017

In order to solve this sort of electrostatic failure in Display and Semiconductor process, Soft X-ray ionizer is mainly used. Soft X-ray Ionizer does not only generate electrical noise and minute particle but also is efficient to remove electrostatic as it has a wide range of ionization. There exist variable factors such as type of tungsten thickness deposited on target, Anode voltage etc., and it takes a lot of time and financial resource to find optimal performance by manufacturing with actual X-ray tube source. Here, MCNPX (Monte Carlo N-Particle Extended) is used for simulation to solve this kind of problem, and optimum efficiency of X-ray generation is anticipated. In this study, X-ray generation efficiency was compared according to target material thickness using MCNPX and actual X-ray tube source under the conditions that tube voltage is 5 keV, 10 keV, 15 keV and the target Material is Tungsten(W). At the result, In Tube voltage 5 keV and distance 100 mm, optimal target thickness is $0.05{\mu}m$ and fastest decay time appears + decay time 0.28 sec. - deacy time 0.30 sec. In Tube voltage 10keV and distance 100 mm, optimal target Thickness is $0.16{\mu}m$ and fastest decay time appears + decay time 0.13 sec. - deacy time 0.12 sec. In the tube voltage 15 keV and distance 100 mm, optimal target Thickness is $0.28{\mu}m$ and fastest decay time appears + decay time 0.04 sec. - deacy time 0.05 sec.

• Journal of Korean Society for Atmospheric Environment
• /
• v.7 no.1
• /
• pp.31-40
• /
• 1991

This study shows the correlation between $NO_x$ emission in the exhaust gas and various operation factors of dual fuel engine for Co-generation system. General tendency was shown that the thermal efficiency was lowered by the change of operation factors. However these were not confirmed on this experiment. Increasing T4 temperature (exhaust gas temperature at turbo-charger inlet) reduces $NO_x$ emission rate. The higher T4 temperature requires lower excess air as the excess air ratio is controlled by T4 temperature on gas mode operation. Another tendency was that $NO_x$ emission rate is reduced in case of increasing boost air temperature, quantity of pilot oil or bypassing flue gas through the exhaust gas boiler. The diameter of the fuel injection nozzle was changed smaller than design value and the injection timing was readjusted. Thus $NO_x$ emission rate could be reduced as retarding injection timing and changing hole diameter of fuel injection nozzle, however maxium engine out-put was decreased by changing fuel nozzle on the diesel mode operation.

• Toxicological Research
• /
• v.23 no.3
• /
• pp.215-221
• /
• 2007

Although sanguinarine, a benzophenanthridine alkaloid, possesses anti-cancer properties against several cancer cell lines, the molecular mechanisms by which it inhibits cell growth and induces apoptosis have not been clearly understood. In order to further explore the critical events leading to apoptosis in sanguinarine-treated MCF-7 human breast carcinoma cells, the following effects of sanguinarine on components of the mitochondrial apoptotic pathway were examined: generation of reactive oxygen species (ROS), alteration of the mitochondrial membrane potential (MMP), and the expression changes of Bcl-2 family proteins. We show that sanguinarine-induced apoptosis is accompanied by the generation of intracellular ROS and disruption of MMP as well as an increase in pro-apoptotic Bax expression and a decrease of anti-apoptotic Bcl-2 and Bcl-xL expression. The quenching of ROS generation with N-acetyl-L-cysteine, the ROS scavenger, protected the sanguinarine-elicited ROS generation, mitochondrial dysfunction, modulation of Bcl-2 family proteins, and apoptosis. Based on these results, we propose that the cellular ROS generation plays a pivotal role in the initiation of sanguinarine-triggered apoptotic death.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.2095-2097
• /
• 2000

Applications of soft X-ray which corresponds to the wavelength of the order of 1 nm and to the photon energy of the order of 1 key respectively, requires intense sources. Only synchrotron sources were available recently. The development of a new laboratory-sized source of soft X-ray radiation is required for wide applications. This paper introduces the generation of soft X-ray using laser-induced plasma.

• The Journal of the Petrological Society of Korea
• /
• v.10 no.3
• /
• pp.212-221
• /
• 2001

This paper introduces the characteristics and generation of the synchrotron radiation (SR). SR has the very high spectral brilliance, broad spectral range, X-ray wavelength tunability, high degree of polarization and collimation, and pulsed time structure. Also describes the technologies to apply in the fields of geology and environmental sciences. These include X-ray tomography, XRF, EXAFS, XANES, DAC, IVP experiments. Further, nuclear power generation and nuclear waste disposal methods are mentioned relating to energy. Using these, analyses of the chemistry, crystal structure and chemical combining states of minerals and rocks can be carried out. Applications in the fields of the economic geology, paleontology and environmental sciences are open too. Informations of the Earth interior materials' behavior under high pressure-temperature can be acquired.

• Proceedings of the KIEE Conference
• /
• 1987.11a
• /
• pp.109-113
• /
• 1987

This paper briefly introduces a strategy of data links between EMS and SCADA systems for the KEPCO's EMS project. For the data links, front end/communication processors are adopted that provide for protocol conversion and communication processing in parallel with EMS/SCADA processing. The data link configuration for a communication channel is point to point links. The EMS - hardware and software - has capability of handling links utilizing both bisync protocol and X.25 (Level 1 and 2)protocol for the data link protocol.

• Journal of Electrical Engineering and Technology
• /
• v.6 no.3
• /
• pp.311-318
• /
• 2011

Small-scale reactors have recently attracted attention as a potential power generation source for the future. The Regional Energy Research Institute for Next Generation is currently developing a small-scale reactor called Regional Energy rX 10 MVA (REX-10). The current paper deals with a power system to be used with small-scale reactors for multi-purpose regional energy systems. This small nuclear system can supply electric and thermal energy like a co-generation system. The electrical model of the REX-10 has been developed as a part of the SCADA system. REX-10's dynamic and electromagnetic performance on the power system is analyzed. Simulations are carried out on a test system based on Ulleung Island's power system to validate REX-10 availability on a power system. RSCAD/RTDS and PSS/E software tools are used for the simulation.

• Journal of Surface Science and Engineering
• /
• v.47 no.3
• /
• pp.104-108
• /
• 2014

To improve emission efficiency of organic light emitting devices (OLEDs), we fabricated the tandem OLED of ITO / 2-TNATA / NPB / SH-1: 3 vol.% BD-2 / Bphen / Liq / Al / $MoO_x$ (X nm) / 2-TNATA / NPB / SH-1: 3 vol.% BD-2 / Bphen / Liq / Al structure. And emission properties of single OLED and tandem OLED with $MoO_x$ thickness as charge generation layer (CGL) were measured. The current emission efficiency and quantum efficiency of tandem OLED with $MoO_x$ of 3 nm thickness were improved compare with single OLED from 7.46 cd/A and 5.39% to 22.57 cd/A and 11.76%, respectively. In case of thicker or thinner than $MoO_x$ of 3~5 nm, the current emission efficiency and quantum efficiency were decreased, because balance of electron and hole in emission layer was not matching. The driving voltage was increased from 8 V of single OLED to 15 V of tandem OLED by thickness increase of OLED. As a result, it was possible to improve the emission efficiency of OLEDs by optimized $MoO_x$ thickness.

• Korean journal of applied entomology
• /
• v.25 no.1 s.66
• /
• pp.1-9
• /
• 1986

Periodical samplings were made in the fields, located Hwasong-Gun, Banwal-Myon, Doondai-Ri, for two years to study the major factors responsible to the population of the overwintered pine needle gall midge, Thecodiplosis japonensis Uchida et Inouye. The population densities of the overwintered larvae reduced greatly at the time of pupation and the changing patterns seemed to be influenced by environmental conditions. The estimated 50% pupation day was about two weeks earlier for the 1980 generation compared with the 1979 generation, and much higher average and the daily maximum temperatures in 1981 affected on the development of the larvae. The relative emergence rates were 14.1% for 1979 and 14.9% for 1980 generation. The relative emergence rates(Y) were affected by the moisture contents of soil ($X_1$) and its variance $(X_2),\;Y=-68.41+4.3206X_1-0.6887X_2$. The relative emergence rates seemed to be decreased with the increased variance of the moisture contents of soil. Percents of needle gall were 49.63% for 1980 and 86.87% for 1981 generation.

• Proceedings of the Optical Society of Korea Conference
• /
• 2009.02a
• /
• pp.361-362
• /
• 2009

High-order harmonics from gaseous atoms driven by an intense femtosecond laser pulse can form an attosecond pulse train. By selecting suitable harmonic generation conditions, the harmonic spectrum can be broad enough to form sub-hundred attoseconds. One serious limitation, however, comes from the inherent attosecond chirp originating from the harmonic generation process. We have proposed to compensate for the positive attosecond chirp by making use of negative group delay dispersion of a metallic x-ray filter or a gaseous medium. We generated 240-as pulses from neon and compressed them to 60 as after propagating through argon, close to the transform-limited duration of 47 as.