• JSTS:Journal of Semiconductor Technology and Science
• /
• 제3권1호
• /
• pp.13-20
• /
• 2003

Both MgO and $Sc_2O_3$ are shown to provide low interface state densities (in the $10^{11}{\;}eV^{-1}{\;}cm{\;}^{-2}$ range)on n-and p-GaN, making them useful for gate dielectrics for metal-oxide semiconductor(MOS) devices and also as surface passivation layers to mitigate current collapse in GaN/AlGaN high electron mobility transistors(HEMTs).Clear evidence of inversion has been demonstrated in gate-controlled MOS p-GaN diodes using both types of oxide. Charge pumping measurements on diodes undergoing a high temperature implant activation anneal show a total surface state density of $~3{\;}{\times}{\;}10^{12}{\;}cm^{-2}$. On HEMT structures, both oxides provide effective passivation of surface states and these devices show improved output power. The MgO/GaN structures are also found to be quite radiation-resistant, making them attractive for satellite and terrestrial communication systems requiring a high tolerance to high energy(40MeV) protons.

• 한국전자파학회논문지
• /
• 제28권9호
• /
• pp.685-697
• /
• 2017

본 논문에서는 탐색 레이다에서 사용되는 C-대역의 고출력전력증폭장치 및 구성품의 설계, 제작과 측정에 대하여 기술하였다. 반도체 소자인 GaN(질화갈륨)을 적용하여 반도체전력증폭조립체를 설계 및 제작하였고, 설계 제작된 도파관 형태의 송신신호결합조립체를 통해 병렬로 구성된 반도체전력증폭조립체의 송신신호 출력을 결합하여 고출력 송신신호 출력을 발생한다. 제작된 고출력전력증폭장치는 C-대역 500 MHz 대역폭, 최대 10.5 % 듀티, 송신펄스폭 $0.0{\sim}000{\mu}s$에서 송신출력 44.98 kW(76.53 dBm) 이상이다.

• 반도체디스플레이기술학회지
• /
• 제21권2호
• /
• pp.101-106
• /
• 2022

In this paper, WBG semiconductor such as SiC and GaN were applied as power switches for LCL circuit that can be applied to satellite power systems and the test results of the LCL circuit are reported. P-channel MOSFET and N-channel MOSFET, which were generally used in the conventional LCL circuit, were applied together to expand the utility of the test results. The design and stability evaluation were performed using a Micro Cap circuit simulation program. For the test circuit, a module using each switch was manufactured, and a total of 5 modules were manufactured and the steady state and transient state characteristics were compared. From the experimental results, the LCL circuit for power supply of the satellite power system constructed in this paper satisfied the constant current and constant voltage conditions under various operating conditions. The P-channel MOSFET showed the lowest efficiency characteristics, and the three N-channel switches of Si, SiC and GaN showed relatively high efficiency characteristics of up to 99.05% or more. In conclusion, it was verified that the on-resistor of the switch had a direct effect on the efficiency and loss characteristics.

• Journal of electromagnetic engineering and science
• /
• 제17권2호
• /
• pp.105-107
• /
• 2017

The self-biasing circuit through a feedback resistor is applied to a gallium nitride (GaN) distributed power amplifier (PA) monolithic microwave circuit (MMIC). The self-biasing circuit is a useful scheme for biasing depletion-mode compound semiconductor devices with a negative gate bias voltage, and is widely used for common source amplifiers. However, the self-biasing circuit is rarely used for PAs, because the large DC power dissipation of the feedback resistor results in the degradation of output power and power efficiency. In this study, the feasibility of applying a self-biasing circuit through a feedback resistor to a GaN PA MMIC is examined by using the high operation voltage of GaN high-electron mobility transistors. The measured results of the proposed GaN PA are the average output power of 41.1 dBm and the average power added efficiency of 12.2% over the 6-16 GHz band.

• 대한전자공학회논문지SD
• /
• 제42권10호
• /
• pp.9-18
• /
• 2005

Si, GaAs, InP 및 $In_{0.53}Ga_{0.47}AS$ 계단형 $p^{+}n$ 접합에서의 항복전압을 위한 해석적 표현식을 유도하였다. 해석적 항복전압을 위해 각 물질에 대한 Marsland의 lucky drift 파라미터를 이용하여 유효이온화계수를 각각 추출하였고, 이의 이온화 적분을 통해 얻은 해석적 항복전압 결과는 $10^{14}cm\;^{-3}\~5\times10\;^{17}cm\;^{-3}$도핑 농도 범위에서 실험 결과와 $10\%$ 오차 범위 이내로 잘 일치하였다.

• 전기전자학회논문지
• /
• 제26권4호
• /
• pp.537-544
• /
• 2022

본 논문은 최근 전자전, 레이더, 기지국 및 위성통신분야에서 각광받고 있는 GaN HEMT(Gallium Nitride High Electron Mobility Transistor) die를 이용한 고출력증폭기의 제작에 사용되는 본드 와이어의 용융단선 현상과 원인을 분석하였다. 고출력증폭기의 주요 성능인 최대 출력전력을 얻기 위해서는 최적의 임피던스 정합이 필요하고 정격전류뿐만 아니라 과도전류에 대한 발열을 고려하여 본드 와이어 소재에 부합하는 직경과 가닥수가 정해져야 한다. 특히, GaN과 같이 에너지 밴드 갭이 넓은 화합물반도체는 설계효율이 낮거나 방열이 부족하면 열 저항 증가로 인해 본드 와이어의 용융단선을 촉발하는 현상을 확인하였다. 본 자료는 발열조건에 대한 모의시험을 수행하고, IR현미경 측정을 통한 검증으로 GaN소자를 이용한 응용분야에 참고자료로 활용이 기대된다.

• Journal of Power Electronics
• /
• 제18권6호
• /
• pp.1912-1919
• /
• 2018

The output capacitance of power semiconductor devices is important in determining the switching losses and in the operation of some resonant converter topologies. Thus, it is important to be able to accurately determine the output capacitance of a particular device operating at elevated power levels so that the contribution of the output capacitance discharge to switch-on losses can be determined under these conditions. Power semiconductor switch manufacturers usually measure device output capacitance using small-signal methods that may be insufficient for power switching applications. This paper shows how first principle methods are applied in a novel way to obtain more relevant large signal output capacitances of Gallium-Nitride (GaN) FETs using the drain-source voltage transient during device switch-off numerically. A non-linear capacitance for an increase in voltage is determined with good correlation. Simulations are verified using experimental results from two different devices. It is shown that the large signal output capacitance as a function of the drain-source voltage is higher than the small signal values published in the data sheets for each of the devices. It can also be seen that the loss contribution of the output capacitance discharging in the channel during switch-on correlates well with other methods proposed in the literature, which confirms that the proposed method has merit.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권9호
• /
• pp.969-977
• /
• 1996

본고에서는 여러가지 Wide Band-gap중에서 특히 최근에 많은 관심을 끌고 있는 GaN와 4H-SiC, 6H0SiC의 전자기적 물성을 소개하고 현재 이들로부터 제작된 prototype소자들의 성능을 비교함으로써 그 발전현황을 알아보기로 한다. 본고에서 관심을 두는 소자분야는 광전소자(optoelectronic devices)라기보다는 고주파 고출력용 전력소자임을 밝힌다. 아울러 GaN로부터 제작된 MESFET(MEtal Semiconductor Field-Effect Transistor)소자의 고주파 대역에서의 Large-Signal특성을 Device/Circuit Model을 통하여 실험치와 비교하여보고 이로부터 최적화된 channel 구조를 갖는 소자구조에서의 RF특성을 조사한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부 C
• /
• pp.726-728
• /
• 1998

Optical and electrical properties of GaSe:$Er^{3+}$ single crystals grown by the Bridgeman technique was been investigated by using optical absorption and Hall-effect measurements. The Hall coefficients were measured by using a high impedance electrometer in the temperature range from 360K to 150K. The temperature dependence of hole concentration shows the characteristic of a partially compensated p-type semiconductor. carrier density($N_H$) of GaSe doped with Erbium was measured about $3.25{\times}10^{16}\;[cm^{-3}}$ at temperature 300K, which was high than undoped specimen. Photon energy gap ($E_{gd}$) was measured about 1.7geV.

• 한국전기전자재료학회논문지
• /
• 제37권4호
• /
• pp.400-406
• /
• 2024

Next-generation wide-bandgap semiconductors such as SiC, GaN, and Ga2O3 are being considered as potential replacements for current silicon-based power devices due to their high mobility, larger size, and production of high-quality wafers at a moderate cost. In this study, we investigate the gradual modulation of chemical composition in multi-stacked metal oxide semiconductor thin films to enhance the performance and bias stability of thin-film transistors (TFTs). It demonstrates that adjusting the Ga ratio in the indium gallium oxide (IGO) semiconductor allows for precise control over the threshold voltage and enhances device stability. Moreover, employing multiple deposition techniques addresses the inherent limitations of solution-processed amorphous oxide semiconductor TFTs by mitigating porosity induced by solvent evaporation. It is anticipated that solution-processed indium gallium oxide (IGO) semiconductors, with a Ga ratio exceeding 50%, can be utilized in the production of oxide semiconductors with wide band gaps. These materials hold promise for power electronic applications necessitating high voltage and current capabilities.