• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.4 no.1
• /
• pp.1-6
• /
• 2005

As an application of the GPS/SDINS integration for its synergistic results, the alignments of the SDINS utilizing GPS carrier phase rate measurements is introduced. A measurement model of GPS carrier phase rate, which does not require integer ambiguity determination process, is newly derived in order to be adopted with the SDINS in-flight alignment process. For in-flight alignment, the performance of the GPS/SDINS integration method suggested in this paper is analyzed using the covariance analysis.

• International Journal of Control, Automation, and Systems
• /
• v.5 no.4
• /
• pp.388-396
• /
• 2007

This paper describes a multipath estimation method for Global Positioning System (GPS) dual frequency carrier phase measurements. Multipath is a major error source in high precision GPS applications, i.e., carrier phase measurements for precise positioning and attitude determinations. In order to estimate and remove multipath at carrier phase measurements, an array GPS antenna system has been used. The known geometry between the antennas is used to estimate multipath parameters. Dual frequency carrier phase measurements increase the redundancy of measurements, so it can reduce the number of antennas. The unscented Kalman filter (UKF) is recently applied to many areas to overcome some of the limitations of the extended Kalman filter (EKF) such as weakness to severe nonlinearity. This paper uses the UKF for estimating multipath parameters. A series of simulations were performed with GPS antenna arrays located on a straight line with one reflector. The geometry information of the antenna array reduces the number of estimated multipath parameters from four to three. Both the EKF and the UKF are used as estimation algorithms and the results of the EKF and the UKF are compared. When the initial parameters are far from true parameters, the UKF shows better performance than the EKF.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2075-2077
• /
• 2001

For precise positioning, GPS carrier measurements are often used. In this case, accurate position having mm${\sim}$cm error can be obtained. For 3D positioning, in CDGPS, more than five carrier phase measurements are required. When GPS signals are blocked or carrier phase measurements are insufficient, it cannot provide positioning solution. By integrating CDGPS with INS, continuity of positioning solution can be guaranteed. However, when a vehicle moves in low speed or in stationary, the CDGPS/INS integrated system is difficult to compensate INS attitude errors because GPS velocity error become relatively lange. In this paper, we used the 3D attitude GPS receiver to compensate the INS attitude error. By field experiments, it is shown that the proposed integration system maintains the navigation performance even when a vehicle is in low speed or GPS signal is blocked for a period of time.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.16 no.2
• /
• pp.195-202
• /
• 1998

In this study, we utilized various type of GPS observation measurements to get a camera projection center of the aerial triangulation and consequently to determine which type is acceptable. For the accuracy and the error analysis, comparison between a projection center from the conventional model adjustment and the result determined by the kinematic DGPS positioning which is fitted to the conventional model adjustment using 3D conformal transformation method has been made. The camera projection center is located within a $\pm{2m}$ for C/A code range measurements, $\pm{14cm}$ for L1 phase measurements and $\pm{10cm}$ for L1/L2 phase measurements with $1\sigma$. In this way, the accuracy of the camera projection center by the bundle block adjustment can be predicted.

• Journal of Mechanical Science and Technology
• /
• v.16 no.11
• /
• pp.1367-1378
• /
• 2002

This paper investigates observability properties of strapdown INS aided by a GPS antenna array. The motivation to consider a GPS antenna array is that the lever-arms between the GPS antennas and IMU play an important role in the estimation of vehicle attitude and biases of IMU. It is shown that time-invariant INS error models are observable with measurements from at least three GPS antennas. It is also shown that time-varying error models are instantaneously observable with measurements from three antennas. Numerical simulation results are given to show the effectiveness of multiple GPS antennas on estimating vehicle attitude and biases of IMU when IMU has considerable magnitude of biases.

• Journal of Astronomy and Space Sciences
• /
• v.28 no.1
• /
• pp.55-62
• /
• 2011

The precise orbit determination (POD) of low earth orbiter (LEO) has complied with its required positioning accuracy by the double-differencing of observations between International GNSS Service (IGS) and LEO to eliminate the common clock error of the global positioning system (GPS) satellites and receiver. Using this method, we also have achieved the 1 m positioning accuracy of Korea Multi-Purpose Satellite (KOMPSAT)-2. However double-differencing POD has huge load of processing the global network of lots of ground stations because LEO turns around the Earth with rapid velocity. And both the centimeter accuracy and the near real time (NRT) processing have been needed in the LEO POD applications--atmospheric sounding or urgent image processing--as well as the surveying. An alternative to differential GPS for high accuracy NRT POD is precise point positioning (PPP) to use measurements from one satellite receiver only, to replace the broadcast navigation message with precise post processed values from IGS, and to have phase measurements of dual frequency GPS receiver. PPP can obtain positioning accuracy comparable to that of differential positioning. KOMPSAT-5 has a precise dual frequency GPS flight receiver (integrated GPS and occultation receiver, IGOR) to satisfy the accuracy requirements of 20 cm positioning accuracy for highly precise synthetic aperture radar image processing and to collect GPS radio occultation measurements for atmospheric sounding. In this paper we obtained about 3-5 cm positioning accuracies using the real GPS data of the Gravity Recover and Climate Experiment (GRACE) satellites loaded the Blackjack receiver, a predecessor of IGOR. And it is important to reduce the latency of orbit determination processing in the NRT POD. This latency is determined as the volume of GPS measurements. Thus changing the sampling intervals, we show their latency to able to reduce without the precision degradation as the assessment of their precision.

• Journal of Advanced Navigation Technology
• /
• v.2 no.2
• /
• pp.75-83
• /
• 1998

This paper presents a low cost and high accuracy integrated Global Positioning System (GPS)/dead reckoning (DR) system. The integrated GPS/DR system is capable of providing highly accurate position data in real-time or in post processing. Based on the analysis of the main error source affecting the DR measurements, an eight-state mathematical model for the integrated system has been developed to represent these errors. This eight-state model has been used to build a nonlinear filter for the estimation of the state vector at every epoch when DR measurements are available. The accuracy of the system has been evaluated using 1Hz DR measurements and 3Hz continuous GPS position estimates. Through numerical simulation the system performance during periods with GPS outage has been investigated by comparing two different noise models. While one model is the position estimation filter containing a single noise model, the other filter includes two-level noise model. The simulation results have shown that the estimation filter containing two-level noise model for computing the position error of the integrated GPS/DR system yields better performance than that the filter including the single-level noise model does.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.186-186
• /
• 2000

In the GPS/DR integrated system, the GPS position(or velocity) is used to compensate the DR output and to calibrate errors in the DR sensor. This synergistic relationship ensures that the calibrated DR accuracy can be maintained even when the GPS signal is blocked. Because of the observability problem, however, the DR sensors are not sufficiently calibrated when the vehicle speed is low. This problem can be solved if we use a multi-antenna GPS receiver for attitude determination instead of conventional one. This paper designs a two-antenna GPS receiver integrated with DR sensors. The proposed integration system has three remarkable features. First, the DR sensor can be calibrated regardless of the vehicle speed with the aid of two-antenna GPS receiver. Secondly, the search space of integer ambiguities in GPS carrier-phase measurements is reduced to a part of the surface of the sphere using DR heading. Thirdly, the detection resolution of cycle-slips in GPS carrier-phase measurements is improved with the aid of DR heading. From the experimental result, it is shown that the search grace is drastically reduced to about 3120 of the non-aided case and the cycle-slips of 1 or half cycle can be detected.

• Wind and Structures
• /
• v.12 no.5
• /
• pp.401-412
• /
• 2009

A method is applied for the estimation of structural damage of tall slender structures using natural frequency and displacements measurements by GPS. The relationship between the variation in the global stiffness matrix (or in the stiffness of each finite element) and the change in the natural frequencies of the structure is given. In engineering practice the number of frequencies which can be derived by GPS measurement of long-period structures will be equal to one, two or three first natural frequencies. This allows us in initial studies to detect damage with frequency changes based on forward methods in which the measured frequencies are compared with the predicted analytical data. This idea, of health monitoring from possible changes to natural frequencies, or from a statement of excessive displacements is applied to the Stuttgart TV Tower.

• International Journal of Aeronautical and Space Sciences
• /
• v.15 no.3
• /
• pp.258-266
• /
• 2014

We present a system for the real-time visual relative navigation of a fixed-wing unmanned aerial vehicle in a GPS-denied environment. An extended Kalman filter is used to construct a vision-aided navigation system by fusing the image processing results with barometer and inertial sensor measurements. Using a mean-shift object tracking algorithm, an onboard vision system provides pixel measurements to the navigation filter. The filter is slightly modified to deal with delayed measurements from the vision system. The image processing algorithm and the navigation filter are verified by flight tests. The results show that the proposed aerial system is able to maintain circling around a target without using GPS data.