• Tribology and Lubricants
• /
• v.35 no.1
• /
• pp.44-51
• /
• 2019

The paper presents the rotordynamic performance measurements and model predictions of a fuel cell electric vehicle (FCEV) air compressor supported on gas foil bearings (GFBs). The rotor has an impeller on one end and a thrust runner on the other end. The front (impeller side) and rear (thrust side) gas foil journal bearings (GFJBs) are located between the impeller and thrust runner to support the radial loads, and a pair of gas foil thrust bearings are located on both sides of the thrust runner to support the axial loads. The test GFJBs have a partial arc shim foil installed between the top foil and bump strip layers to enhance hydrodynamic pressure generation. During the rotordynamic performance tests, two sets of orthogonally installed eddy-current displacement sensors measure the rotor radial motions at the rotor impeller and thrust ends. A series of speed-up and coast-down tests to 100k rpm demonstrates the dominant synchronous (1X) rotor responses to imbalance masses without noticeable subsynchronous motions, which indicates a rotordynamically stable rotor-GFB system. Finite element analysis of the rotor determines the rotor free-free (bending) natural modes and frequencies well beyond the maximum rotating frequency. The predicted damped natural frequencies and damping ratios of the rotor-GFB system reveal rotordynamic stability over the speeds of interest. The imbalance response predictions show that the predicted critical speeds and rotor amplitudes strongly agree with the test measurements, thus validating the developed rotordynamic model.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.33 no.4
• /
• pp.226-232
• /
• 2019

This study was aimed to reveal that the usual cold or heat state was associated with hypertension and could be a risk. We emailed educational personnel in D university to join this study and 182 subjects participated in from March to December in 2016. The usual cold or heat diagnosis was conducted by two experts who had over 10 years expertise. The blood pressure was measured from the subjected after 10 minute rest with Jawon medical device. The hypertension was diagnosed by the guide of the Seventh Report of the Joint National Committee on Prevention, Detection, Evaluation, and Treatment of High Blood Pressure. The frequency analysis was used in general characteristics, Pearson's Correlation Coefficient analysis was conducted in among continuous variables, and chi-square test was also used between hypertension and cold or heat group. Logistic regression was analyzed to generate the odds ratios (ORs) and 95% confidence interval (CI) for hypertension. The cold score was suggested to have negative association with Body mass Index (BMI, -.374, p<.001), systolic blood pressure (-.333, p<.001), and diastolic pressure (-.261, p<.001). The heat score was analyzed to have positive association with Body mass Index (.413, p<.001), systolic blood pressure (.249, p<.001), and diastolic pressure (.156, p<.001). The distribution of the cold group (35.1%) and non-cold group (64.9%) in hypertension was significantly different (p=0.18). The distribution of the heat group (62.2%) and non-heat group (37.8%) was significantly different (p=0.27). The usual cold was associated with decreased ORs (ORs 0.405, 95% CI=0.191-0.857), and usual heat was associated with increased ORs (ORs 2.327, 95% CI=1.108-4.888). However, after adjusting body mass index, sex, and smoking, the association was not significantly different. It is possible that usual cold or heat associate with hypertension. Further study is needed to show that usual heat may be a independent risk factor for hypertension through follow up design.

• Korean Journal of Environmental Agriculture
• /
• v.38 no.3
• /
• pp.205-212
• /
• 2019

BACKGROUND: This survey conducted on agricultural products in Incheon for the past three years from 2016 to 2018 to detect residual pesticides and to monitor the use of pesticides. METHODS AND RESULTS: Residual pesticides were analyzed for a total of 5,937 agricultural products in Samsan wholesale market, traditional market and large retailers in Incheon. Samples were analyzed by multi class pesticide method using GC-MS/MS, LC-MS/MS, GC-ECD/NPD, and UHPLC. In 59 cases (1.0%) residual pesticides were detected improperly and these cases exceeded maximum residue limits (MRLs). CONCLUSION: The ratios of violative agricultural products were similar each year at approximately 1.0% per year, but the residual pesticide detection rates with the limit included in the samples were shown to be gradually decreasing to 17.9%, 12.6%, and 11.2% annually. The frequency of violative residual pesticides was high in order of Diazinon, Chlorpyrifos, Iprodione, etc. Residual pesticide monitoring might be needed in the future continuously, as violations in agricultural products distributed in Incheon are shown at a similar level every year.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.10
• /
• pp.1409-1415
• /
• 2021

The Gysel divider has the advantage of easily setting the resistor in the circuit. If the line impedance in the Gysel divider is set differently, the input signal can be distributed to the two output ports at various distribution ratios. This paper proposes the Gysel divider that can change the power distribution to 1:3 or 3:1 by changing the line impedance. The impedance change of the line can be implemented by placing a floating copper plate on the bottom of the microstrip-line. When the floating copper plate and the ground plane are connected, the line operates as the microstrip-line, and when the floating copper plate and the ground plane are disconnected, the line operates as the coplanar-line. The proposed Gysel divider was fabricated at the center frequency of 1.5GHz. The fabricated 3:1 Gysel divider has a stable value S₁₁ of below -17dB, S₂₁/S₃₁ of 4.8±0.2dB, S₂₁(to high output port) of -1.39±0.12dB and S₃₁(to low output port) of -6.15±0.08dB over 1.3~1.7GHz.

• Journal of the Korean Wood Science and Technology
• /
• v.49 no.4
• /
• pp.315-327
• /
• 2021

Purpose of this study is reviewing the use method for the sawdust (sawmilling by-product) and rice husk (Agriculture by-product) by adding charcoal, an eco-friendly material. Mixed composite boards were manufactured with those materials with each density and mixing ratio, and bending performance was investigated. When the addition ratio of sawdust, rice husk and charcoal is 50:20:20 and the resin addition ratio is 10%, as the density of the prepared mixed board ranges from 0.5 g/cm³ to 0.7 g/cm³, the bending strength was 0.42~3.24 N/mm², dynamic modulus of elasticity was 94.5~888.4 N/mm², and the static modulus of elasticity was in the range of 31.4~220.7 N/mm². As the density increased, the bending performance increased, indicating that the density had a significant effect on the bending performance. In a board prepared by setting the density of 0.6 g/cm³, the addition ratio of sawdust to 50%, and the addition ratio of rice husk and charcoal at different ratios, the bending performance showed a tendency to decrease as the addition ratio of charcoal increased. The relationship between the addition ratio of rice husk and charcoal, bending strength, resonance frequency, and dynamic and static bending modulus showed a rather low correlation with the values of the coefficient of determination (R²) of 0.4562, 0.4310, 0.4589, and 0.5847, respectively. Thus, we found that the effect of the addition ratio on the bending performance was small.

• Journal of The Korean Society of Clinical Toxicology
• /
• v.19 no.1
• /
• pp.1-7
• /
• 2021

Purpose: The purpose of this study was to conduct a systematic review to investigate the socio-economic benefits of the poison control center (PCC) and to assess whether telephone counseling at the poison control center affects the frequency of emergency room visits, hospitalization, and length of stay of patients with acute poisoning. Methods: The authors conducted a medical literature search of the PubMed, EMBASE, and Cochrane Library databases. Two reviewers evaluated the abstracts for eligibility, extracted the data, and assessed the study quality using a standardized tool. Key results such as the cost-benefit ratio, hospital stay days, unnecessary emergency room visits or hospitalizations, and reduced hospital charges were extracted from the studies. When meta-analysis was possible, it was performed using RevMan software (RevMan version 5.4). Results: Among 299 non-duplicated studies, 19 were relevant to the study questions. The cost-benefit ratios of PCC showed a wide range from 0.76 to 36 (average 6.8) according to the level of the medical expense of each country and whether the study included intentional poisoning. PCC reduced unnecessary visits to healthcare facilities. PCC consultation shortened the length of hospital stay by 1.82 (95% CI, 1.07-2.57) days. Conclusion: The systematic review and meta-analysis support the hypothesis that the PCC operation is cost-beneficial. However, when implementing the PCC concept in Korea in the future, it is necessary to prepare an institutional framework to ensure a costeffective model.

• Journal of The Korean Association For Science Education
• /
• v.41 no.2
• /
• pp.71-82
• /
• 2021

Learning efficiency can be maximized by careful matching of text features to expected reader features (i.e., linguistic and cognitive abilities, and background knowledge). The present study aims to explore whether this systematic principle is reflected in the development of science textbooks. The current study examined science textbook texts on 20 measures provided by Auto-Kohesion, a Korean language analysis tool. In addition to surface-level features (basic counts, word-related measures, syntactic complexity measures) which have been commonly used in previous text analysis studies, the present study included cohesion-related features as well (noun overlap ratios, connectives, pronouns). The main findings demonstrate that the surface measures (e.g., word and sentence length, word frequency) overall increased in complexity with grade levels, whereas the majority of the other measures, particularly cohesion-related measures, did not systematically vary across grade levels. The current results suggest that students of lower grades are expected to experience learning difficulties and lowered motivation due to the challenging texts. Textbooks are also not likely to be suitable for students of higher grades to develop the ability to process difficulty level texts required for higher education. The current study suggests that various text-related features including cohesion-related measures need to be carefully considered in the process of textbook development.

• Journal of the Korean Wood Science and Technology
• /
• v.31 no.4
• /
• pp.81-90
• /
• 2003

In this study, we investigated the weathering properties of Korean Rhus lacquers containing tung oil and their potential use as exterior coatings. The finished lacquers were prepared with a raw Korean Rhus lacquer or refined Korean Rhus lacquer content of 10, 20, 30 and 40 wt.% (corresponding to ratios of 10/90, 20/80, 30/70 and 40/60 by weight of Korean Rhus lacquer/tung oil, respectively). The curing temperature of the prepared lacquer increased with increasing the content of the raw Korean Rhus lacquer. This increased curing temperature is related to higher proportion of hydroxyl groups in the prepared lacquer, due to the content of the raw Korean Rhus lacquer. In accelerated weathering testing, the changes in the gloss and contact angle of the prepared lacquers showed a similar trend to that of traditional exterior oil stain. In addition, the prepared lacquers containing tung oil showed greater discoloration than traditional exterior oil stain. However, the discoloration of the prepared lacquer with a raw Korean Rhus lacquer content of 40 wt.%, and that of the prepared lacquer with refined Korean Rhus lacquer contents of 30 wt.% and 40 wt.%, showed a similar trend to that of traditional exterior oil stain. Consequentially, these prepared lacquers showed a potential for being used as exterior coatings.

• Journal of the Korean Electrochemical Society
• /
• v.24 no.4
• /
• pp.106-112
• /
• 2021

Catalyst poisoning by ionomers in membrane electrode assemblies of alkaline membrane fuel cells has been reported recently. We tried to improve the membrane electrode assembly's performance by controlling the solvent's ratio during electrode manufacturing. 4 Different mixing ratios of N-Methyl-2-pyrrolidone (NMP) and ethylene glycol (EG) gave four different cathode electrodes with platinum and Fuma-Tech ionomers. The electrode with higher EG improved polarization performance by about 36% compared to the NMP-based commercial ionomer. The dependence of the ionomer's dispersibility on the solvent seems responsible for the difference, which means that the non-uniform distribution of ionomers improves the performance of the electrode. High-frequency resistance, internal resistance corrected polarization curve, Tafel slope, mass activity, and impedance spectroscopy characterized the electrode. We can find that the existence of poor solvent improves cathode electrode performance. It seems to be the result of reduced poisoning of the catalyst according to the particle size distribution of the ionomer.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.4A
• /
• pp.707-717
• /
• 2006

As an alternative to conventional prestressed concrete (PSC) girders, various types of PSC girders are either under development or have already been applied in bridge structures. Incrementally prestressed concrete girder is one of these newly developed girders. According to the design concept, these new types of PSC girders have the advantages of requiring less self-weight while having the capability of longer spans. However, the dynamic interaction between bridge superstructures and passing trains is one of the critical issues concerning these railway bridges designed with more flexibility. Therefore, it is very important to evaluate modal parameters of newly designed bridges before doing dynamic analyses. In the present paper, a 25 meters long full scale PSC girder was fabricated as a test specimen and modal testing was carried out to evaluate modal parameters including natural frequencies and modal damping ratios at every prestressing stage. During the modal testing, a digitally controlled vibration exciter as well as an impact hammer is applied, in order to obtain precise frequency response functions and the modal parameters are evaluated varying with construction stages. Prestressed force effects on changes of modal parameters are analyzed at every incremental prestressing stage. With the application of reliable properties from modal experiments, estimation of dynamic performances of PSC girder railway bridges can be obtained from various parametric studies on dynamic behavior under the passage of moving train. Dynamic displacements, impact factor, acceleration of the slab, end rotation of the girder, and other important dynamic performance parameters are checked with various speeds of the train.