• 대한조선학회논문집
• /
• 제52권6호
• /
• pp.460-470
• /
• 2015

In general ships and FPSOs, roll damping is very small and consequently roll motion is very large at the roll resonance frequency. Proper evaluation of the roll damping coefficient at the resonance frequency is an important task in the study of roll motion and usually it is done by the analysis of free roll decay tests. The relative decrement method based on energy relation has been used mainly for the evaluation of roll damping coefficient from the roll decay test so far. As another method, the logarithmic decrement method based on equivalent linear decay assumption can be used for the same purpose and it is relatively simple. In this paper, both of the relative decrement method and the logarithmic decrement method are used for the evaluation of roll damping coefficient including quadratic damping from the free roll decay tests, and their results are cross-checked for verifying the obtained damping coefficients. Through applications to a box-type floating body equiped with bilge keels, it is shown that the two methods give almost the same damping coefficients in a practical view point and the cross-check of their results is to be a good tool to prevent a possible error. And also the quantitative effects of the bilge keels on the roll damping of box-type floating body are shown and discussed.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2001년도 추계학술대회 논문집
• /
• pp.169-173
• /
• 2001

This study presents the results of decoupling of free decay roll test data by discrete wavelet transform. Free roll decay test was performed to decide the coefficients of damping terms in equation of motion. During the experiment, a slight yaw motion was found while the model was in the free roll decay motion. Discrete wavelet transform was applied to the signal to extract the pure roll motion. The results were compared to those of the Fourier transform. DWT was able to decouple the two signals efficiently while the Fourier transform was not.

• 한국해양공학회지
• /
• 제19권3호
• /
• pp.25-30
• /
• 2005

To predict rolling performance for a barge-type FPSO, the evaluation of correct nonlinear roll damping is critical. The square section of FPSO causes a considerable viscous damping effect. Free roll decay tests were carried out to estimate nonlinear roll damping for a barge-type FPSO, under three different conditions. The roll motion RAO was deduced from model tests in the wave condition of the wideband spectrum. In numerical calculation, the quadratic damping was considered as equivalent linear damping, using the results of free roll decay test. Tested roll performance in the JONSWAP wave spectrum was compared with numerical results. These two results shaw good agreement, in spite of the proximity of peak wave period and roll natural period.

• 해양환경안전학회지
• /
• 제29권6호
• /
• pp.688-696
• /
• 2023

본 연구에서는 어선의 운동성능을 향상하기 위해 부착되는 부가물의 조합과 파라미터 변경에 따른 어선의 자유 횡 동요 감쇠와 저항 성능을 평가하였다. 성능 평가를 위해 전산유체역학(Computational Fluid Dynamics)을 이용한 수치해석을 수행하였으며, 주요 부가물인 빌지킬과 선저킬의 조합과 치수 변경에 따른 횡 동요 주기와 감쇠 계수의 변화를 확인하였다. 선저킬의 경우 길이가 변화함에 따른 횡 동요 감쇠 계수의 변화가 상대적으로 크지 않음을 확인하였다. 반면 빌지킬의 경우 길이와 각도의 증가에 따라서 횡 동요 감쇠 계수가 증가함을 확인하였다. 4가지 부가물 조합 조건과 나선의 저항 성능을 비교하였으며, 부가물에 의한 어선의 자세와 압력분포의 변화로 인해 저항이 증가함을 확인하였다. 본 연구 결과를 통해 부가물 크기와 배치가 어선의 운동 및 저항 성능에 미치는 영향을 확인할 수 있었으며, 어선 적용 시에 도움이 될 수 있을 것으로 기대한다.

• 한국해양공학회지
• /
• 제33권4호
• /
• pp.322-329
• /
• 2019

The magnitude of the roll motion of a floating structure depends on the roll damping acting on the body. In other words, the roll damping of a floating structure must be accurately obtained in order to precisely evaluate the roll motion. Various methods are used to evaluate the roll damping of a floating structure, such as the linear potential theory, computational fluid dynamics (CFD), and model tests. However, it is difficult to evaluate the roll motion of a floating structure with appendages such as a bilge keel and riser slot due to the limitation of ignoring the viscous effects in the linear potential theory. Among these methods, a model test based on a free decay test and harmonic excited roll motion (HERM) is known to be the most reliable method to estimate the roll damping of the floating structures. In this study, model tests using free decay and HERM techniques were performed in the Ocean Engineering Basin (OEB) of KRISO with various types of midship sections. The roll damping results were estimated based on post-processing methods using both techniques, and the roll damping results were compared.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2004년도 학술대회지
• /
• pp.183-187
• /
• 2004

To predict rolling performance for a barge-type FPSO, the evaluation of correct nonlinear roll damping is critical. The squall section of FPSO causes a fair amount of viscous damping effect. Free roll decoy tests were conducted to estimate nonlinear roll damping for a barge-typ FPSO of three different loading conditions. The roll motion RAO was deduced by model tests in the wave condition of wideband spectrum. In numerical calculation, the quadratic damping was considered as equivalent linear damping using the results of free roll decay test. Tested roll performance in JONSWAP wave spectrum was compared with numerical results. These two results show good agreement, in spite of proximity in peak wave period and roll natural period.

• 대한조선학회논문집
• /
• 제49권1호
• /
• pp.52-59
• /
• 2012

Among many factors to be considered for higher safety level requirements, the hull stability in intact and damaged conditions in seaways is of utmost importance. Since the assessment of a damaged ship is complicated due to the highly non-linear behavior, it is widely acknowledged that computational fluid dynamics (CFD) methods are one of the most feasible approaches. Although many research activities are being reported on the damaged ship stability recently, most of them are not designed for validation of CFD studies. In this study, well-designed model tests were performed to build a CFD validation database, which is essential in developing better CFD methods for the damage stability assessment. The geometry of the damaged compartment and test conditions were determined based on preliminary CFD simulations. Free roll decay tests in calm water with both intact and damaged ships were performed and the roll motion characteristics were compared. The damaged ship showed a larger roll damping coefficient and more rapid decrease of roll amplitude than the intact ship. The primary reason of these efforts can be explained by the movement of the flooded water.

• 한국해양공학회지
• /
• 제33권2호
• /
• pp.131-138
• /
• 2019

This study focused on the roll motion characteristics of a two-dimensional (2D) rectangular floating structure under regular beam sea conditions. An experiment was conducted in a 2D wave tank for a roll free decay test in calm water and the roll motion in a range of regular waves with and without heave motion to investigate the motion response and heave influence on the roll motion. A numerical study was carried out using Reynolds-averaged Navier Stokes (RANS)-based CFD simulations. A grid convergence test was conducted to accurately capture the wave condition on the free surface based on the overset mesh and wave forcing method. It was found in the roll free decay test that the numerical results agreed well with the experimental results for the natural roll period and roll damping coefficient. It was also observed that the heave motion had an impact on the roll motion, and the responses of the heave and roll motion from the CFD simulations were in reasonable agreement with those from the experiment.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제4권2호
• /
• pp.172-181
• /
• 2012

One of the most critical issues in naval architecture these days is the operational safety. Among many factors to be considered for higher safety level requirements, the hull stability in intact and damaged conditions is the first to ensure for both commercial and military vessels. Unlike the intact stability cases, the assessment of the damaged ship stability is very complicated physical phenomena. Therefore it is widely acknowledged that computational fluid dynamics (CFD) methods are one of most feasible approaches. In order to develop better CFD methods for damaged ship stability assessment, it is essential to perform well-designed model tests and to build a database for CFD validation. In the present study, free roll decay tests in calm water with both intact and damaged ships were performed and six degree-of-freedom (6DOF) motion responses of intact ship in regular waves were measured. Through the free roll decay tests, the effects of the flooding water on the roll decay motion of a ship were investigated. Through the model tests in regular waves, the database that provides 6DOF motion responses of intact ship was established.

• 해양환경안전학회지
• /
• 제21권5호
• /
• pp.538-542
• /
• 2015

선체의 횡관성모멘트는 선박의 횡운동 특성을 다루는 경우 제외될 수 없는 요소로서 그 크기의 적정성은 선체 동특성 해석의 결과와 신뢰성에 큰 영향을 미친다. 그러나 선박은 질량분포와 형상이 복잡하므로 이를 직접적인 계산을 통해 값을 구하기에는 과정이 매우 복잡하고 대상 선박의 구체적인 관련 자료를 얻기도 어렵다는 점에서 실용적으로는 선체 질량의 등가적 관성반경을 선체폭의 일정비율로 계산하는 간접적인 방법이 통용되고 있다. 한편, 어느 선체의 자유 횡운동이 나타내는 횡요 주기와 감쇠형태는 관성모멘트에 의해 영향을 받기 마련이고 따라서 이러한 응답의 결과적인 모양으로부터 역으로 해당 선박의 관성모멘트를 구하는 일반식의 도출이 가능할 것으로 유추될 수 있다. 본 연구에서는 관찰에 의한 선체의 횡요 주기는 경사각의 진폭 감쇠비에 의해서도 달라지는 관계를 해석하여 횡요 주기와 경사각 진폭 감쇠비 모두를 함수 인자로 포함하는 일반식에 의해 횡관성모멘트 크기가 구해질 수 있음을 나타내었다. 또한 이러한 일반식에 횡요 관찰 선박의 주요 제원을 적용하였을 때 나타나는 특성 그래프들을 분석한 결과 횡요주기뿐 아니라 진폭감쇠비가 함께 검토될 때 얻어지는 관성모멘트 값이 보다 정확해진다는 것을 확인하였다.