• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.11a
• /
• pp.970-976
• /
• 2003

In this paper, we analyse and present electro-mechanical dynamic characteristics of a micro-machined vibrating silicon ring gyroscope which can measure angular velocities about three orthogonal axes. The ring gyroscope has a ring connected to the gyroscope main body by support-ligaments which are arranged with cyclic symmetry. The natural modes of its vibration can be distinguished into the in-plane motion and the out-of-plane motion which are coupled by the gyro-effect due to the notation of the gyroscope main body. The motions of the ring are electro-statically derived, sensed and balanced by electrodes. The equations of motion are formulated. The scheme of angular velocities sensing by force-to-rebalance method is presented. The dynamic characteristics of a ring gyroscope are calculated and compared.

• Korean Journal of Poultry Science
• /
• v.22 no.1
• /
• pp.43-54
• /
• 1995

Effects of dietary protein sources and their amino acid compositions on the liver and plasma cholesterol levels in growing Single Comb white Leghorn male chicks were studied. A diet containing isolated soy protein (21% cp) was supplemented with 0.5% DL-methionine and 0.3% L-glycine. and another diet containing casein(21% cp) was supplemented with 1.5% L-arginine HCl, 0.4% DL-methionine. and 1.0% L-glycine. Plasma cholesterol level was markedly lower in groups force-fed the diets containing either soy protein or casein supplemented with amino acids compared to those found in birds fed corresponding diets without amino acids supplementation. The cholesterol lowering effect of the casein diet. when balanced with various supplemental amino acids appeared to be due to arginine instead of methionine or glycine. It is likely that amino acid balance rather than the composition of a specific amino acid is one of the major factors determining the effect of dietary protein sources on the blood cholesterol levels in chicks.

• Proceedings of the KIEE Conference
• /
• 2001.04a
• /
• pp.53-56
• /
• 2001

The simple construction and low cost, fault tolerant power electronic drive has made the switched reluctance drive a strong contender for many applications. But the switched reluctance drive does exhibit higher levels of vibration and acoustic noise than most competing drives. The main source of vibration in the switched reluctance drive is generated by rapid change of radial force when phase current is extinguished by commutation action. In this paper, a hybrid excitation method is proposed to reduce vibration and acoustic noise of the switched reluctance drive. The hybrid excitation has 2-phase excitation by long dwell angle as well as conventional 1-phase excitation. The vibration and acoustic noise are reduced because the scheme reduces abrupt change of excitation level by distributed and balanced excitation.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.50 no.9
• /
• pp.438-444
• /
• 2001

The simple motor construction and low cost, fault tolerant power electronic drive has made the switched reluctance drive a strong contender for many applications. But the switched reluctance drive does exhibit higher levels of vibration and acoustic noise than that of most competing drives. The main source of vibration in the switched reluctance drive is generated by rapid change of radial force when phase current is extinguished during commutation action. In this paper, a hybrid excitation method is proposed to reduce vibration and acoustic noise of the switched reluctance drive. The hybrid excitation has 2-phase excitation by long dwell angle as well as conventional 1-phase excitation. The vibration and acoustic noise are reduced because the scheme reduces abrupt change of excitation level by distributed and balanced excitation.

• Proceedings of the KIEE Conference
• /
• 2000.07b
• /
• pp.638-640
• /
• 2000

The main source of vibration in SRM drive is generated by rapid change of radial force when phase current is extinguished by commutation action. In this paper a hybrid excitation method is proposed to reduce vibration and acoustic noise of SRM. The hybrid excitation has 2-phase excitation by long dwell angle as well as conventional 1-phase excitation. The vibration and acoustic noise are reduced because the scheme reduces abrupt change of excitation level by distributed and balanced excitation.

• Proceedings of the KIEE Conference
• /
• 2005.04a
• /
• pp.15-18
• /
• 2005

Switched reluctance drive does exhibit higher levels of vibration and acoustic noise than that of most competing drives. The main source of vibration in the switched reluctance drive is generated by rapid change of radial magnetic force when phase current is extinguished during commutation action. In this paper, some excitation method is proposed to reduce vibration and acoustic noise of the switched reluctance drive. The excitation strategies considered in this research are 1-phase, 2-phase and hybrid excitation method. 1-phase method is a conventional and 2-phase method is excited 2 phases simultaneously. The hybrid excitation has 2-phase excitation by long dwell angle as well as conventional 1-phase excitation. The vibration and acoustic noise are compared and tested. Suggested 2-phase and hybrid strategies reduce acoustic noise because the scheme reduces abrupt change of excitation level by distributed and balanced excitation.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2003.10a
• /
• pp.259-266
• /
• 2003

This paper introduces a relation to determine the span ratio between exterior and interior spans, which is strongly required in the preliminary design stage of bridges constructed by Free Cantilever Method (FCM). A relation for the initial tendon force is derived on the basis of an assumption that no vertical deflection occurs at the far end of a cantilever beam due to the balanced condition between the self-weight and the cantilever tendons. In advance, the span ratio can be determined by using an assumption that the negative maximum moment must be the same with the positive maximum moment along the entire spans to be a rational bridge design. Finally, many rigorous lime-dependent analyses are conducted to establish the validity of the introduced relations. The obtained numerical results show that the rational design of FCM bridges may be achieved when the span length ratio of the exterior span to the interior span ranges about 0.75 to 0.8.

• Journal of Power Electronics
• /
• v.5 no.3
• /
• pp.218-223
• /
• 2005

A simple construction, low cost, and a fault tolerant power electronic drive have made the switched reluctance drive a strong contender for many applications. But the switched reluctance drive exhibits higher levels of vibration and acoustic noise than most competing drives. The main source of vibration in the switched reluctance drive is generated by the rapid change of radial magnetic force when the phase current is extinguished during commutation. In this paper, some excitation methods are proposed to reduce the vibration and acoustic noise of the switched reluctance drive. The excitation strategies considered in this research are 1-phase, 2-phase and hybrid excitation methods. The 1-phase method is the conventional approach, while in the 2-phase method, the two phases are excited simultaneously. The hybrid excitation has 2-phase excitation using a long dwell angle as well as conventional 1-phase excitation. The vibration and acoustic noise are compared and tested. The suggested 2-phase and hybrid strategies reduce acoustic noise because the schemes reduce the abrupt change in excitation level by using distributed and balanced excitation.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.4
• /
• pp.407-412
• /
• 2016

Objective: The aim of this study was to analyze the net joint moment and joint power of the lower extremity during squat in female patients with genu varum. Method: Eight female patients with genu varum were asked to do regular squats, and their net joint moment and joint power were compared to those of another eight female participants with straight legs. Their video recordings and ground reaction force data were analyzed to be used as a theoretical evidence of squatting effectively for female patients with genu varum. Results: Squats had a higher impact on internal knee joint rotation and ankle joint flexion moments in the genu varum group than in the straight leg group due to their weak and short hip joint muscles. Conclusion: There is a need to develop a squat movement that is appropriate for women with genu varum in order to distribute overload efficiently among the hip, knee, and ankle joints and to strengthen the muscles in a balanced way.

• Korea-Australia Rheology Journal
• /
• v.21 no.4
• /
• pp.203-211
• /
• 2009

In flows with deformation rates larger than the inverse Rouse time of the polymer chain, chains are stretched and their confining tubes become increasingly anisotropic. The pressures exerted by a polymer chain on the walls of an anisotropic confinement are anisotropic and limit chain stretch. In the Molecular Stress Function (MSF) model, chain stretch is balanced by an interchain pressure term, which is inverse proportional to the $3^{rd}$ power of the tube diameter and is characterized by a tube diameter relaxation time. We show that the tube diameter relaxation time is equal to 3 times the Rouse time in the limit of small chain stretch. At larger deformations, we argue that chain stretch is balanced by two restoring tensions with weights of 1/3 in the longitudinal direction of the tube (due to a linear spring force) and 2/3 in the lateral direction (due to the nonlinear interchain pressure), both of which are characterized by the Rouse time. This approach is shown to be in quantitative agreement with transient and steady-state elongational viscosity data of two monodisperse polystyrene melts without using any nonlinear parameter, i.e. solely based on the linear-viscoelastic characterization of the melts. The same approach is extended to model experimental data of four styrene-butadiene random copolymer melts in shear flow. Thus for monodisperse linear polymer melts, for the first time a constitutive equation is presented which allows quantitative modeling of nonlinear extension and shear rheology on the basis of linear-viscoelastic data alone.