• 센서학회지
• /
• 제33권3호
• /
• pp.134-138
• /
• 2024

In this study, we propose a ternary D flip-flop using tristate ternary inverters for an energy-efficient ternary circuit design of sequential logic. The tristate ternary inverter is designed by adding the functionality of the transmission gate to a standard ternary inverter without an additional transistor. The proposed flip-flop uses 18.18% fewer transistors than conventional flip-flops do. To verify the advancement of the proposed circuit, we conducted an HSPICE simulation with CMOS 28 nm technology and 0.9 V supply voltage. The simulation results demonstrate that the proposed flip-flop is better than the conventional flip-flop in terms of energy efficiency. The power consumption and worst delay are improved by 11.34% and 28.22%, respectively. The power-delay product improved by 36.35%. The above simulation results show that the proposed design can expand the Pareto frontier of a ternary flip-flop in terms of energy consumption. We expect that the proposed ternary flip-flop will contribute to the development of energy-efficient sensor systems, such as ternary successive approximation register analog-to-digital converters.

• Progress in Superconductivity
• /
• 제4권2호
• /
• pp.127-131
• /
• 2003

We have designed and measured an SFQ(Single Flux Quantum) OR gate for a superconducting ALU (Arithmetic Logic Unit). To optimize the circuit, we used WRspice, XIC and Lmeter for simulations and layouts. The OR gate was consisted of a Confluence Buffer and a D Flip-Flop. When a pulse enters into the OR gate, the pulse does not propagate to the other input port because of the Confluence Buffer. A role of D Flip-Flip is expelling the data when the clock is entered into D Flip-Flop. For the measurement of the OR gate operation, we attached three DC/SFQs, three SFQ/DCs and one RS Flip -Flop to the OR gate. DC/SFQ circuits were used to generate the data pulses and clock pulses. Input frequency of 10kHz and 1MHzwere used to generate the SFQ pulses from DC/SFQ circuits. Output data from OR gate moved to RS flip -Flop to display the output on the oscilloscope. We obtained bias margins of the D Flip -Flop and the Confluence Buffer from the measurements. The measured bias margins $\pm$38.6% and $\pm$23.2% for D Flip-Flop and Confluence Buffer, respectively The circuit was measured at the liquid helium temperature.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제3권2호
• /
• pp.102-106
• /
• 2003

This paper describes novel low-power high-speed flip-flop called dual edge-triggered NAND keeper flip-flop (DETNKFF). The flip-flop achieves substantial power reduction by incorporating dual edge-triggered operation and by eliminating redundant transitions. It also minimizes the data-to-output latency by reducing the height of transistor stack on the critical path. Moreover, DETNKFF allows negative setup time to provide useful attribute of soft clock edge by incorporating the pulse-triggered operation. The proposed flip-flop was designed using a $0.35{\;}\mutextrm{m}$ CMOS technology. The simulation results indicate that, for the typical input switching activity of 0.3, DETNKFF reduces power consumption by as much as 21 %. Latency is also improved by about 6 % as compared to the conventional flip-flop. The improvement of power-delay product is also as much as 25 %.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제6권2호
• /
• pp.74-78
• /
• 2006

This paper presents a high-speed pulse-based flip-flop with pseudo MUX-type scan compatible with the conventional master-slave flip-flop with MUX-type scan. The proposed flip-flop was implemented as the standard cell library using Samsung 130nm HS technology. The data-to-output delay and power-delay-product of the proposed flip-flop are reduced by up to 59% and 49%, respectively. By using this flop-flop, ARM11 softcore has achieved the maximum 1GHz operating speed.

• 전기의세계
• /
• 제13권3호
• /
• pp.21-27
• /
• 1964

A method of triggering a series connected complementary transister flip-flop is described. Also measurements have been made for the operation region with respect to the input pulse variation. This circuit is compared with a Eccles-Jordan flip-flop when it used as a Nixie tube driver of a neon lamp driyer.

• 전자공학회논문지C
• /
• 제35C권1호
• /
• pp.10-14
• /
• 1998

In this paper a double edge triggered (DET) filp-flop is proposed which changes its output state at both the positive and the negative edge transitions of the triggering input. DET filp-flop has advantages in terms of speed and power dissipation over single edge triggered (SET) filp-flop has proposed DET flip-flop needs only 12 MOS transistors and can operate at clock speed of 500 MHz. Also, the power dissipation has decreased about 33% in comparison to SET flip-flop.

• 전기전자학회논문지
• /
• 제8권1호
• /
• pp.47-53
• /
• 2004

본 논문에서는 3치 논리 게이트를 바탕으로 하는 3치 데이터 처리를 위한 3치 flip-flop을 설계하였다. 제안한 flip-flop들은 3치 전압 모드 NMAX, NMIN, INVERTER 게이트를 사용하여 설계하였다. 또한 CMOS 기술을 사용하였고 다른 게이트들 보다 낮은 공급 전압과 낮은 전력소모 특성을 포함하고 있다. 제안한 회로는 0.35um 표준 CMOS 공정에서 설계되었고 3.3v의 공급 전압원을 사용하였다. 제안된 3치 flip-flop 구조는 3치 논리 게이트를 사용하여 VLSI 구현에 적합하고 높은 모듈성의 장점을 갖고 있다.

• 반도체공학회 논문지
• /
• 제1권1호
• /
• pp.14-22
• /
• 2023

본 논문에서는 dual change-sensing 기법을 사용하여 내부 노드 변환을 최소화시킨 저전력 플립플롭 회로를 제안한다. 제안하는 Dual Change-Sensing Flip-Flop(DCSFF)은 데이터 변환이 존재하지 않는 경우, 기존에 존재하던 플립플롭들 중 동적 전력 소모가 가장 낮다. 65nm CMOS 공정을 사용한 측정 결과에 따르면, conventional Transmission Gate Flip-Flop(TGFF)와 비교하여 data activity 가 0% 와 100% 일때, 각각 98%와 32%의 감소된 전력 소모를 보였다. 또한 Change-Sensing Flip-lop(CSFF)과 비교하여 제안하는 DCSFF 는 30% 의 낮은 전력 소모를 보였다.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2000년도 High Temperature Superconductivity Vol.X
• /
• pp.189-192
• /
• 2000

We fabricated rapid single-flux-quantum RS flip-flop circuits with and without Y$_1$Ba$_2$Cu$_3$O$_{7-{\delta}}$(YBCO) ground plane. The circuit consists of SNS-type ramp-edge Josephson junctions that have cobalt-doped YBCO and Sr$_2$AITaO$_6$(SAT) for barrier layer and insulator layer, respectively. The fabricated Josephson junction showed a typical RSJ-like current-voltage(I-V) characteristics above 50K. We sucessfuly demonstrated RS flip-flop at temperatures around 50K. The RS flip-flop fabricated on ground plane showed more definite set and reset state in voltage-flux(V-${\phi}$) modulation curve for read SQUID, which may be attributed to a shielding effect of the YBCO ground plane.

• 대한전자공학회논문지SD
• /
• 제42권8호
• /
• pp.35-42
• /
• 2005

본 논문에서는 전력소모 감소 및 강건성 (robustness) 향상을 위한 새로운 구조의 플립-플롭을 제안한다. 가변 샘플링 윈도우 플립-플롭(Variable sampling window flip-flop, VSWFF)은 입력 데이터에 따라 샘플링 윈도우의 폭을 변화시켜 강인한 데이터-래치 동작을 제공할 뿐 아니라 더욱 짧은 hold time을 갖는다. 또한, 이 플립-플롭은 입력 스위칭 행위(input switching activity)가 큰 경우에 기존의 저전력 플립-플롭보다 내부 전력소모를 감소시킬 수 있다. 클럭 진폭 감쇄형 가변 샘플링 윈도우 플립-플롭(Clock swing-reduced variable sampling window flip-flop, CSR-VSWFF)은 작은 스윙 폭의 클럭을 사용함으로써 클럭분배망(clock distribution network)의 전력소모를 감소시킬 수 있다. 기존의 클럭 진폭 감쇄형 플립-플롭(Reduced clock swing flip-flop, RCSFF)과 달리, 제안된 플립-플롭은 공급전압만으로 동작하므로 고전압의 발생 및 분배로 인한 설계 상의 비용증가를 제거한다. 시뮬레이션 결과, 기존의 플립-플롭과 비교하여 더욱 좁은 샘플링 윈도우에서도 불변의 지연값(latency) 을 유지하고 전력-지연 곱(power-delay product, PDP)이 개선됨을 확인하였다. 제안된 플립-플롭의 성능을 평가하기 위하여 $0.3\mu m$ CMOS 공정기술을 이용하여 테스트 칩을 설계하였으며, 실험 결과, VSWFF는 입력 스위칭 행위가 최대일 때 전력소모가 감소하며 CSR-YSWFF를 이용하여 설계된 동기 카운터는 부가 고전압의 사용 없이 전력소모가 감소됨을 확인하였다.