• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.3-10
• /
• 2014

Direct conversion receiver(DCR) gets noticed for integration and cost reduction of wireless communication systems instead of the heterodyne receiver which uses complex filter. But DCR has several factors in performance degradation. One of them is I/Q imbalance phenomenon, that is amplitude and phase mismatch between real and imaginary part of receiver. Accordingly, researches are being carried to improve the I/Q imbalance problem. However, the tendency of the broaden bandwidth of communication systems, low pass filter(LPF) mismatch problem affects severely in I/Q mismatch phenomenon at the DCR. To study this problem, we generated 10MHz broadband signal and shifted it ${\pm}8MHz$ from the center frequency. The signal is affected by LPF mismatch and it appears as frequency selective distortion. Thus, LPF mismatch model is added to I/Q imbalance model which conventionally dealt with amplitude and phase mismatches. In addition, we proposed the compensation method for each factors of mismatch. As the simulation results, the proposed I/Q mismatch compensator resolves the frequency selective distortion which occurred by the existing LPF mismatch.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.2
• /
• pp.18-26
• /
• 2015

In this paper, we studied the method for analyzing and estimating the parameters that induce I/Q imbalance in the repeater using direct conversion RF. In repeater, amplitude, phase, and filter mismatch are generated in the receiving-end which converts RF signal to baseband signal. And amplitude and phase mismatch are generated in the transmitting-end which converts baseband signal to RF signal. Accordingly, we modeled the parameters that cause I/Q imbalance in the structure of the repeater in order, and proposed a feedback test structure from the transmitting-end to the receiving-end for estimating the corresponding parameters. By comparing the test transmitting signal and received signal, it is possible to estimate the I/Q imbalance parameters which occurred from mixed components of real and imaginary part. And it was confirmed that I/Q imbalance phenomenon has been properly compensated with estimated parameters at the direct conversion RF repeater.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2003.11a
• /
• pp.543-546
• /
• 2003

Kaiman 필터는 통계적 방법에 근거한 필터이므로, 이것을 구성할 때, 추정대상이나 잡음 등의 통계량을 미리 알고 있을 필요가 있다. 일반적으로 이러한 양을 미리 아는 것은 곤란하므로, 필터를 설계할 때에는, 적당한 통계적 모델을 가정하지 않으면 안된다. 그러나, 실제의 통계량이 이러한 값과 다른 경우, 즉, model mismatch가 발생하면, 최적의 추정이 행하여지지 않고 mismatch가 정도가 큰 경우에는, 올바른 추정이 전혀 행하여지지 않을 가능성이 있다. 본 논문에서는 Kalman 필터에 model mismatch가 발생한 경우의 추정값으로의 영향을 2가지의 방법으로 검토한다.

• Proceedings of the KIEE Conference
• /
• 2007.04a
• /
• pp.267-269
• /
• 2007

PLL(Phase Locked Loop) are widely used circuit technique in modern electronic systems. In this paper, We propose the low voltage and high speed PLL. We design the PFD(Phase Frequency Detector) by using TSPC (True Single Phase Clock) circuit to improve the performance and solve the dead-zone problem. We use CP(Charge Pump} and LP(Loop filter) for Negative feedback and current reusing in order to solve current mismatch and switch mismatch problem. The VCO(Voltage controlled Oscillator) with 5-stage differential ring oscillator is used to exact output frequency. The divider is implemented by using D-type flip flops asynchronous dividing. The frequency divider has a constant division ratio 32. The frequency range of VCO has from 200MHz to 1.1GHz and have 1.7GHz/v of voltage gain. The proposed PLL is designed by using 0.18um CMOS processor with 1.8V supply voltage. Oscillator's input frequency is 25MHz, VCO output frequency is 800MHz and lock time is 5us. It is evaluated by using cadence spectra RF tools.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.4
• /
• pp.565-571
• /
• 2021

In this paper, a compensation scheme of frequency selective IQ mismatch for high-performance radar systems based on commercial RFIC's is proposed. Besides, an optimization model and its solution based on the dimension reduction scheme using singular value decomposition are also proposed to design the optimal IQ mismatch compensation digital filter with complex coefficients. The performance of the proposed method had been analyzed through experiments using the IQ mismatch measurement and compensation system implemented on an FPGA board with a target RFIC and compared with the previous method. The experiment result showed a performance improvement of the proposed method over the existing one without noticeable increments in complexities. These performance analysis results showed that the limitation of using commercial RFIC's in high-performance radar systems due to the undesirable maximum SNR cap caused by their IQ mismatches could be overcome by employing the proposed method.

• Journal of Korea Multimedia Society
• /
• v.11 no.10
• /
• pp.1325-1337
• /
• 2008

The difference of environments between training and recognition is the major reason of degradation of speech recognition. To solve this mismatch of environments, various noise processing methods have been studied. Among them, ERN(log-Energy dynamic Range Normalization) and SEN(Silence Energy Normalization) for normalization of log energy features show better performance than others. However, these methods have a problem that they can hardly achieve normalization for the relatively higher values of log energy features and the environmental mismatch caused by this problem becomes bigger especially in low SNR environments. To solve these problems, we propose applying ARMA filter as post-processing for smoothing log energy features by calculating the moving average in auto-regression scheme. From the recognition results conducted on Aurora 2.0 DB, the proposed method shows improved recognition results comparing with conventional methods.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.10
• /
• pp.2380-2386
• /
• 2013

A PLL with an unipolar charge pump and a loop filter consisting of sample-hold capacitor and 2nd-order RC filter has been proposed. The goal of the proposed PLL is the suppression of reference spur which is caused by charge pump mismatch. It also improves phase noise characteristic. It has been designed with a 1.8V $0.18{\mu}m$ CMOS process and proved by HSPICE simulation.

• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 2003.02a
• /
• pp.287-290
• /
• 2003

For microwave device applications, c-axis oriented high temperature superconducting YBa$_2$Cu$_3$O$_{7-{\delta}}$ (HTS-YBCO) epitaxial thin films on the r-cut sapphire substrate(Al$_2$O$_3$) were prepared. In order to reduce the lattice mismatch with a substrate and to enhance the crystallity of HTS thin films, CeO$_2$ buffer layer on the r-cut sapphire substrate was grown by the RF-magnetron sputtering. The YBCO films on the CeO$_2$ buffer layer were deposited using the pulsed-laser deposition (PLD) method. These HTS YBCO /CeO$_2$/Al$_2$O$_3$ multilayer thin films(30 $\times$ 30 mm$^2$) routinely exhibited a critical temperature(T$_{c}$) of 89 K from the R-T measurement. Using HTS YBCO/CeO$_2$ /Al$_2$O$_3$ multilayer thin film. We fabricated and characterized the microwave passive devices (planar type filters) with cryopack-age such as the coupled -line type low-pass filter (LPF) and the open-loop meander type bandpass filter (BPF).filter (BPF).).

• Korean Journal of Optics and Photonics
• /
• v.18 no.1
• /
• pp.1-7
• /
• 2007

Filter colorimeters have a set of spectral bands for which spectral responsivity is the same as the color matching function defined by CIE (Commission Internationale de I'Eclairage). We have designed a set of color matching function filters denoted by $\bar{x}-filter,\;\bar{y}-filter,\;and\;\bar{z}-filter$. Because the $\bar{x}-function$ has two transmission bands, two $\bar{x}-filters$ are designed to cover the $\bar{x}-function$. To design the filters, we developed a nonlinear least square fit program which determines the thickness of the color glasses by minimizing its spectral mismatch value ($f{_1}'$) to below 3 %. The design has been validated by fabrication of the $\bar{y}-bar$ filter, of which $f{_1}'$ was measured to be 2.8 %. Considering a LCD flat panel display as a device under test, we have calculated the systematic error of the colorimetric measurement using the designed filters.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.4
• /
• pp.233-239
• /
• 2009

A mixed CT/DT 2-1 cascaded ${\Sigma\Delta}M$ which includes a first stage CT ${\Sigma\Delta}M$ and a second stage mismatch insensitive two-channel time-interleaved DT ${\Sigma\Delta}M$ is proposed. With this approach, the advantages of both CT and DT ${\Sigma\Delta}Ms$ including high speed operation, inherent anti-aliasing filter, and good coefficient matching can be achieved. The two-channel time-interleaved ${\Sigma\Delta}M$ used in the second stage alleviates the speed constraints of the DT ${\Sigma\Delta}M$, whereas enables better matching between the analog and digital filter coefficients compared to CT ${\Sigma\Delta}Ms$.