• Korean journal of applied entomology
• /
• v.60 no.4
• /
• pp.363-367
• /
• 2021

This study was conducted to investigate the EAG (electroantennogram) response of Spodoptera frugiperda male to sex pheromone compounds and whether or not S. frugiperda male adults would undergo double mating. The EAG response of S. frugiperda male adult to Z9-14:Ac increased in a dose-dependent as the dose increased. Among the 7 sex pheromone components investigated, male EAG recording was the highest to Z9-14:Ac. The EAG response of S. frugiperda male adult to the mixed sex pheromone component was greater than that to the single component. Male adults of S. frugiperda were capable of double mating under laboratory condition, and the secondary mating rate increased to 72.2% compared to the 58.3% of primary mating rate. The EAG response of mated S. frugiperda male adult was not different from that of unmated S. frugiperda male. In the net house test with sex pheromone lure, mated male adults were not captured during the test period. Also, strangely, unmated male adults were not captured even in a trap equipped with virgin female adults, although the antennae of mated male adult were responded to the sex pheromone component in the laboratory. Probably, it is thought that the mated male adults may not have been caught in the trap be due to flight ability which has been decreased after mating. The field attractiveness of S. frugiperda male adults to sex pheromones remains to be further elucidated.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.5
• /
• pp.15-23
• /
• 2021

In this paper, service life for RC(Reinforced Concrete) substructure subjective to carbonation was evaluated through deterministic and probabilistic method considering field investigation data and Design Code(KDS 14 20 40). Furthermore changes in service life with increasing COV(Coefficient of Variation) and equivalent safety index meeting the same service life were studied. From the investigation, the mean and its COV of cover depth were evaluated to 70.0 ~ 90.0 mm and 0.2, respectively. With intended failure probability of 10.0 % and 70 mm of cover depth, service life decreased to 137 years, 123 years, and 91 years with increasing COV of 0.05, 0.1, and 0.2, respectively. In the case of 80 mm of cover depth, it changes to 179 years, 161 years, and 120 years with increasing COV. The equivalent safety index meeting the same service life from deterministic method showed 1.66 ~ 3.43 for 70 mm of cover depth and 1.61 ~ 3.24 for 80 mm of cover depth, respectively. The various design parameters covering local environment and quality condition in deterministic method yields a considerable difference of service life, so that determination of design parameters are required for exposure conditions and parameter variation.

• Korean Journal of Breeding Science
• /
• v.49 no.3
• /
• pp.180-189
• /
• 2017

Genetically modified (GM) crops have been developed worldwide through the recombinant DNA technology and commercialized by global agricultural companies. Until now, GM crops have not been cultivated commercially in Korea. Commercialization of GM crops requires a compulsory assessment of environmental risk associated with the release of GM crops. This study was conducted to evaluate the frequency of pollen mediated gene flow from Bt transgenic rice (Agb0101) to japonica non-GM rice (Nakdongbyeo), indica non-GM rice (IR36), and weedy rice (R55). A total of 729,917, 596,318 and 230,635 seeds were collected from Nakdongbyeo, IR36, and R55, respectively, which were planted around Agb0101. Selection of the hybrids was determined by repeated spraying of herbicide and Cry1Ac1 immunostrip assay. Finally, the hybrids were confirmed by PCR analysis using specific primer. The hybrids were found in all non-GM rice and out-crossing ranged from 0.0005% at IR36 to 0.0027% at Nakdongbyeo. All of hybrids were located within 1.2 m distance from the Agb0101 rice plot. The meteorological elements including rainfall and temperature during rice flowering time were found to be important factors to determine rice out-crossing rate. Consideration should be taken for many factors like the meteorological elements of field and physiological condition of crop to set up the safety management guideline to prevention of GM crops gene flow.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.4
• /
• pp.267-275
• /
• 2018

The dredged sediment management system was developed to have an objective, quantitative and scientific decision for the optimum removal time of dredged sediments behind debris barrier and was set up at the real site. The dredged sediment management system is designed and developed to directly measure the dredged sediments behind debris barrier in the field. This management system is composed of Data Acquisition System (DAS), Solar System and measurement units for measuring the weight of dredge sediments. The weight of dredged sediments, the water level and the rainfall are measured in real time using the monitoring sensors, and their data can be transmitted to the office through a wireless communication method. The monitoring sensors are composed of the rain gauge to measure rainfall, the load cell system to measure the weight of dredged sediments, and water level meter to measure the water level behind debris barrier. The management criteria of dredged sediments behind debris barrier was suggested by using the weight of dredged sediments. At first, the maximum weight of dredged sediments that could be deposited behind debris barrier was estimated. And then when 50%, 70% and 90% of the maximum dredged sediments weight were accumulated behind debris barrier, the management criteria were divided into phases of Outlooks, Watch and Warning, respectively. The weight of dredged sediments can be monitored by using the dredged sediment management system behind debris barrier in real time, and the condition of debris barrier and the removal time of dredged sediments can be decided based on monitoring results.

• Korean journal of applied entomology
• /
• v.58 no.3
• /
• pp.175-182
• /
• 2019

The citrus leafminer, Phyllocnistis citrella (Lepidoptera: Gracillaridae), is an important pest that decreases the productivity of citrus trees by attacking citrus leaves, and especially it causes a severe damage during the young growth stage. In this study, we investigated the distribution of eggs on the leaves of shoots according to the position and the survival rate of this pest in the field condition. The occurrence patterns of P. citrella eggs in citrus orchards were largely affected by the occurrence of shoots. Even if the adults were still being attracted in the pheromone traps, the eggs were not observed on leaves when the growth of shoots was stopped. The density of P. citrella eggs in the citrus shoots peaked at the fifth or sixth leaf from the terminal leaf, and over 90% of the eggs were found in the first to eighth leaves as a whole. In 2015 and 2016, the average survival rate of larvae surviving to pupa was 1.4%, and the rate of survival to adults was 0.2%, indicating that most of them died. Furthermore, we have discussed the management strategy of P. citrella considering the distribution of eggs and the larval survival rate in the citrus shoots.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.22 no.1
• /
• pp.60-71
• /
• 2019

Electrical power supply is needed to operate the radar system in the field. In addition, it should not cause performance deterioration under the environmental factors due to characteristics of military equipment, and should not cause malfunction due to electromagnetic waves generated in radar, and then should not cause malfunction in radar equipment. Therefore, By applying a permanent magnet to the rotor of the generator, light weighting and high efficiency of generator were achieved. As a result, electrical performance test of the generator, the rated output power was 80.8 kW, the maximum output power was 88.1 kW, and the output power efficiency was 98.1 % under the full load condition. When the load capacity of the generator was changed from no load to full load, the maximum voltage variation was 3.6 % and the frequency variation was 0.3 %. As a result of the transient response test for measuring the output power of the generator according to the load characteristics change, the maximum voltage variation of 7.9 %, frequency variation of 0.5 % were confirmed, and the transient response time was 2.1 seconds. Environmental tests were conducted in accordance with MIL-STD-810G and MIL-STD-461F to evaluate the operability of the generator groups. Normal operation of radar system generator group was confirmed under high temperature and low temperature environment conditions. Electromagnetic tests were conducted to check if electromagnetic wave generated from both radar system and generator group in operation caused any performance deterioration to each other. As a result, it was confirmed that the performance deterioration due to electromagnetic wave inflow, radiation, and conduction did not occur. It is expected that it should be possible to provide high efficiency power supply and stable power supply by applying to various military system as well as radar system.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.32 no.1
• /
• pp.32-41
• /
• 2019

Objective : The purpose of this study is to develop a personal health record(PHR) application of atopic dermatitis in Korean Medicine(KM). Methods : We have identified the items necessary to provide an PHR application that helps to record and manage the symptoms of an atopic dermatitis in KM. We also derived the symptom collection process and method and applied it to the application. Results : In this study, the types of symptoms collected for atopic dermatitis were derived. Symptoms include daily check, stool/urine/sleep, daily emotion, meal management, symptom photographs, SCORAD, quality of life, progress check, original symptom, pediatric health check, weakness check, and subjective symptoms. The recording cycle can be divided into the first, daily, weekly, specific day, and subjective. We developed the PHR application of atopic dermatitis in KM by deriving the type of symptoms and symptom recording process. The app organized menus into dashboards, checklists, daily checks, and health records. Conclusions : We developed a PHR application for atopic dermatitis by deriving symptom collection items of atopic dermatitis and developing symptom collection process and collection technique. The app does not make an accurate diagnosis of atopic dermatitis symptoms, but it helps facilitate symptom collection and helps to identify or predict a person's health condition. It can also be used for medical treatment through sharing symptoms with Korean medicine. Patients are able to communicate in both directions on a daily, weekly, self-aware basis, at the request of a doctor, to record their symptoms and use them for medical purposes. If the doctor asks for a progress check to refer to the next examination, it can be written through the system. This manages atopic dermatitis in daily life and can be used in the clinical field.

• Korean Journal of Breeding Science
• /
• v.49 no.4
• /
• pp.414-419
• /
• 2017

Red onion cultivar 'Eumjinara' with mild taste and early maturation was developed in 2013 by the Allium vegetable crop research team, National Institute Crop Science, Rural development Administration (RDA). 'Eumjinara' was originally selected from red onion breeding line, 'IS1115', It was preliminarily selected and designated 'Mon21-31-3' and advanced yield trial was performed from 2008 to 2009. Regional yield trial test was conducted in six regions from 2010 to 2012. Foliage morphology and leaf color were similar to those of a check cultivar, 'Cheonjujeok', but its shape was comparatively broad ovate. Foliage of 'Eumjinara' lodged seven days earlier than check cultivar on May 31 and the average bulb weight ($234{\pm}49.1g/bulb$) was also higher than that of check cultivar. The new cultivar was relatively resistant to clod hardness and downy mildew infection in the field condition. Average yield of 'Eumjinara' in three-year the regional yield trials was 6,999 kg/10a. The total soluble solid contents and quercetin concentrations were $41.43{\mu}g/g$ FW and $556.11{\mu}g/g$ FW, respectively.

• Tunnel and Underground Space
• /
• v.28 no.6
• /
• pp.596-608
• /
• 2018

As urban infrastructure is aging, the possibility of accidents due to the failures or breakdowns of infrastructure increases. Especially, aging underground infrastructures like sewer pipes, waterworks, and subway have a potential to cause an urban ground sink. Urban ground sink is defined just as a local and erratic collapse occurred by underground cavity due to soil erosion or soil loss, which is separated from a sinkhole in soluble bedrock such as limestone. The conventional measurements such as differential settlement gauge, inclinometer or earth pressure gauge have a shortcoming just to provide point measurements with short coverage. Therefore, these methods are not adequate for monitoring of an erratic subsidence caused by underground cavity due to soil erosion or soil loss which occurring at unspecified time and location. Therefore, an alternative technology is required to detect a change of underground physical condition in real time. In this study, the feasibility of a novel magnetic resonance based monitoring method is investigated through laboratory tests, where the changes of path loss (S21) were measured under various testing conditions: media including air, water, and soil, resonant frequency, impedance, and distances between transmitter (TX) and receiver (RX). Theoretically, the transfer characteristic of magnetic field is known to be independent of the density of the medium. However, the results of the test showed the meaningful differences in the path loss (S21) under the different conditions of medium. And it is found that the reflection coefficient showed the more distinct differences over the testing conditions than the path loss. In particular, input reflection coefficient (S11) is more distinguishable than output reflection coefficient (S22).

• Journal of the Korean Society of Radiology
• /
• v.12 no.7
• /
• pp.879-886
• /
• 2018

A 3-dimensional (D) printer is a device capable of outputting a three-dimensional solid object based on data modeled in a computer. These features are utilized in the bone model X - ray phantom production etc using CT data by fusing with the radiation science field. A bone model phantom was made using data obtained by CT scan of an existing Pelvis phantom, using PLA, Wood, XT-CF20, Glow fill, Steel filaments which are materials of Fused Filament Fabrication (FFF) 3D printer.Measure Hounsfield Unit (HU) with images obtained by CT scan of the existing Pelvis phantom and five material phantoms made with 3D printer under the same conditions,SI and SNR were measured using a diagnostic X-ray generator, and each phantom was compared and analyzed.As a result, the X - ray phantom in the X - ray examination condition of the limb was found to be most suitable for the glow fill filament.The characteristics of the filament can be known to the base of this research and the practicality of X - ray phantom fabrication was confirmed.