• Journal of information and communication convergence engineering
• /
• v.1 no.1
• /
• pp.35-38
• /
• 2003

Analyses of performance of wireless broadband communication systems employing fiber-optic link have presented. We have analyzed CNR penalty to evaluate system performance by taking into account, radio link considering rainfall attenuation, and optical link considering several carrier-to-noise ratio versus the optical modulation index.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.4 no.1
• /
• pp.7-13
• /
• 2005

In this paper, we propose the time synchronization module on fiber optic repeater to use optic line delay for obtaining time synchronization between up-link and down-link, in the 2.3 GHz WiBro network using TDD/OFDM (Time Division Duplex/Orthogonal Frequency Division Multiplexing) Generally, when we use fiber optic repeater to remove the shade area, it occurs transmission delay which is caused by optic transmission between RAS (Radio Access Station) and fiber optic repeater and inner delay of fiber optic repeater. Because the WiBro system is adopting a TOO method and there exists the difference of switching time which is caused by these delay between up-link and down-link, it occurs ISI (Inter Symbol Interference), ICI (Inter Carrier Interference). These interference results in the reduction of the coverage. And the inconsistency between Up-Link and Down-Link switching time maybe gives rise to the interruption of communication. In order to prevent these cases, we propose synchronization module using analog optic line delay as the one of synchronizing up-link and down-link. And we propose the consideration factor for the designing time synchronization module and the feature of optic line of analog method. The measurement result of optic line time synchronization module of structure proposed is as follows, the delay error of $0.5{\mu}g$ and the insertion loss value below maximum 4.5dB in range of $0{\sim}40{\mu}s$. These results fully meet the specification of WiBro System.

• ETRI Journal
• /
• v.9 no.2
• /
• pp.24-35
• /
• 1987

A Design and Fabrication of 565 Mbit/s Optical Fiber Transmission Link We calculated the transfer functions of optical channel components and formulated the optimum transfer function of optical receiver for optical transmission to show a design rule of fiber optical link for digital transmission. And we evaluated various causes of sensitivity degradation to determine the receiver specification. Also we fabricated and demonstrated a 565Mbit/s single mode fiber optic link, 27km, to show the practicality of designed fiber optic link. The output power of the transmitter was above -3dBm, and the sensitivity of the optical receiver was -37.8dBm which is the same value we expected. Also the dynamic range was more than 25dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1542-1550
• /
• 2000

Fiber optic link systems based on SCM scheme are widely used as efficient and economic RF signal links between base station and a central station in mobile communication networks. However, its performance can be seriously limited depending on the operational conditions of not only the optical transmission system but also the wireless link in various environments. In this paper, we propose an analytic model for performance analyses of the SCM fiber optic link for CDMA RF signal transmission in various link environments. We present optimal operational conditions taking account of the nonlinear effects of the optical transmission system, and the multiple access interference produced at the wireless link. It has been shown through the BER analyses in this paper that the selection of optical modulation index of the SCM fiber optic links can be found optimally to minimize the fiber optic link noises and intermodulation distortion due to LD.

• Proceedings of the KIEE Conference
• /
• 1987.11a
• /
• pp.143-146
• /
• 1987

Fiber optics provide a solution to the problems at interference, capacity and reliability in communication. Approximately 20 kilometera of a six-fiber, multimode, longwave($1.3{\mu}m$), graded index silica glass fiber optic cable was helically wrapped around a phase conductor at a Korea Electric Power Corporation(KEPCO) 154KV transmission line. This paper presents an economic comparison of several fiber optic cable installation alternative and discusses the characteristics at the helically wrapped fiber cable, as well as the entire installation, including high voltage phase-to-ground (PTG) end termination, and splicing. The fiber link was installed for the field trial and practical use with overhead composite optical fiber cable which installation performed a few years earlier some other location and is intended to accommodate not only telephone but also supervisory Control and Data Acquisition(SCADA), protective relaying, and telemetry functions.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.2
• /
• pp.128-136
• /
• 2001

This paper evaluates the performance of an optic link in a frequency conversion based fiber-radio system. The proposed link structure simplifies a BS(base station) via making the MMW(millimeter wave) optical pilot tone generated in the CS(control station) be used in the uplink as well as in the downlink. To acquire the optical pilot tone, an EOM(electro-optic modulator) in the CS is biased in three different ways, i.e., MAB(maximum bias), MIB(minimum bias), QB(quadrature bias). We, depending on the biasing of the EOM, evaluate the link performances in two cases; one is for constant laser source power and the other for constant received DC optical power at a PD(photo detector). Based on the simulation results on the downlink CNR and the uplink SFDR(spurious free dynamic range), we finally deduce the effective EOM biasing for each case.

• Proceedings of the Optical Society of Korea Conference
• /
• 2006.07a
• /
• pp.363-364
• /
• 2006

We developed 60 GHz analog optical transmitter modules for radio-over-fiber (RoF). They were consisted of an electroabsorption modulator (EAM), impedance matching circuit, and amplifier. The characteristics of fabricated modules were investigated by measuring the signal-to-noise ratio and the noise figure of the 60 GHz RoF link.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.10
• /
• pp.2691-2695
• /
• 2009

Nowadays Fiber optical communication systems have limitless bandwidth and can be used for transmitting various multimedia data with in real time. It is necessary to construct integrated service systems that can be used in our society whole to communicate multimedia data such as text, image, audio and video data in fiber optic communication systems. In this paper, we have designed and constructed the fiber optical link application system for multi-video/audio data transmission using only one core optical cable upgrading previous fiber optical communication systems based on WDM (Wavelength Division Multiplexer). Using the proposed fiber optical link application system enables us to managing fiber optical communication systems with only one core optical cable using WDM (Wavelength Division Multiplexer) and DEWDM/Wavelength splitter.

• ETRI Journal
• /
• v.38 no.2
• /
• pp.227-234
• /
• 2016

Herein, we demonstrate clipping distortion suppression of directly modulated multi-IF-over-fiber links using a simple shunt diode predistorter. The dynamic range of a directly modulated analog fiber optic link is limited by nonlinear distortions caused by laser-diode clipping. We investigate the link performance in the context of carrie-to-noise and distortion ratio (CNDR) and error vector magnitude (EVM) requirements when supporting LTE-A services. We also design an analog predistorter with a shunt-diode structure, and demonstrate experimentally that the predistorter has the ability to suppress clipping-induced third-order intermodulation distortions of the link by at most 14 dB. It also improves the CNDR and EVM of the 4-IF-multiplexed LTE-A carriers by 7 dB and 2.9%, respectively.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1988.10a
• /
• pp.52-58
• /
• 1988