• Fisheries and Aquatic Sciences
• /
• v.1 no.2
• /
• pp.192-200
• /
• 1998

This study was carried out to evaluate the effect of feeding higher protein feeds with lesser amount, but feeding the constant total protein input for all treatments, on water quality and nitrite toxicity in channel catfish ponds. There was no significant difference in survival rate among treatments $(P>0.05)$. Specific growth rate (SGR) for Treatment 1$(28\%\;protein\;and\;100\%\;of\;satiation)$ was significantly higher $(P>0.05)$ than for Treatment 3$(36\%\;protein\;and\;87.5\%\;of\;satiation)$, but not significantly higher than for Treatment 2 $(32\%\;protein\;and\;77.8\%\;of\;satiation)$ at constant digestible energy (DE), 3.08kcal/g (treatments 1, 2 and 3). At constant DE/P (treatments 4, 2 and 5), no significant difference in SGR was observed among treatments. Feed conversion ratio (FCR) slightly improved or improved as dietary protein level increased from $28\%$ to $32\%$ and feed allowance decreased by $12.5\%$, but did not improve as dietary protein level increased from $32\%$ to $36\%$ and feed allowance decreased by $22.2\%$, at constant DE and constant DE/P. There was no significant difference in water quality variables, such as total ammonia nitrogen (TAN), nitrite, chlorophyll a, soluble phosphorous concentrations among treatments, but significant difference in water quality variables over time as amount of feed fed increased $(P<0.0001)$. There was a trend toward increase in TAN and nitrite over time. A strong linear regression was observed between mean total ammonia nitrogen and nitrite for all treatments Y (Nitrite) =$0.04\times (TAN)+0.01$, $R_2=0.89$. Methemoglobin percent in the blood of catifish was not significantly different among treatments. And its mean value was $7.5\%$, which was relatively low, so that it was not serious problem in catfish production pond under these experiment conditions. There was the stronger linear regression between the percentage of Methemoglobin and the molar ratio of nitrite to chloride rather than nitrite alone: $Y\;(Methemoglobin\;\%)\;=\;58.45\;\times\;(NO^{2-}/Cl^-)\;+\;0.41,\;R^2=0.60$. These results indicate that deterioration of water quality has no strong impact on poor weight gain for $36\%$ dietary protein in this study.

• 유체기계공업학회:학술대회논문집
• /
• 2005.12a
• /
• pp.273-277
• /
• 2005

The large particles of suspended matter in raw water can be removed by allowing them to settle out in a presedimentation basin. But there are smaller particles in almost all surface water and some groundwater that will not settle out within a reasonable time without some help to accelerate the process, In the coagulation and flocculation processes, nonsettleable solids are converted into large and heavier settleable solids by physical-chemical changes broght about by adding and mixing coagulant chemicals into the raw water. The object of this research was to improve corrective injection method for low dissolution liquid in the water treatment plant. A sort of chemical feed equipment are diaphram pump, flow control in combined magnetic flowmeter md control valve, roto dipper wheel system and tube pump. Particularly low dissolution liquid (Calcium Hydroxide) put in a bit by feed equipment, tube pump is very useful method for corrective injection method in the water treatment plant.

• Journal of Aquaculture
• /
• v.14 no.2
• /
• pp.67-71
• /
• 2001

Phosphorus is an essential element for growth and metabolism in fish. However high levels of phosphorus in the feed can lead to poor water quality of pond, and can also be a potential source of pollution, when pond water is released to the environment. In this study phosphorus supplemented diets containing 0.0, 0.9 or 1.9% of (dicalcium) phosphate were offered to channel catfish and changes in water quality of ponds and phosphorus levels in fish were measured. Higher level of (1.9%) supplementation of phosphorus in diet resulted in higher concentration of T-P and SRP in pond waters. Also it produced negative effects on fish production by lowering feed coefficient and rate of increment in body weight. Surplus phosphorus can affect fish growth and water quality of pond.

• Journal of environmental and Sanitary engineering
• /
• v.15 no.3
• /
• pp.23-23
• /
• 2000

In this study, to determine the optimum fermentation process for the feed production of food wastes and estimate the practical value of fermented feed using kudzu creeper and sawdust as bulking agent. This study considered initial C/N ratio control as the fermentation process variables. The results are summarized as follows. Minimum water contents of byproducts in the fermentation feed production showed 3994(kudzu), 37%( sawdust) at the C/N ratio 25 and 45%(kudzu, sawdust) at the C/N ratio 35. Temperature variations in the fermentation feed production at the C/n ratio 25 indicated 68'C(kudzu), 70'C (sawdust).Optimum condition of consists of fermentation process of water content, C/N ratio and permeability (porous structure of the mixture). For optimum fermentation of gravitationally, dewatered garbage, the proper mixing ratios of kudzu(moisture contents : 17.3%) and sawdust(moisture contents : 13.2%) were 41% and 39%, respectively Major biological reaction in the aerobic fermentation feed production occurred during 12~14hrs

• Asian-Australasian Journal of Animal Sciences
• /
• v.23 no.5
• /
• pp.556-562
• /
• 2010

The objective of the present study was to compare feed and water intakes, growth performance and carcasscharacteristics of indigenous lamb fed diets containing various levels of halophyte Sporobolus grass hay. Forty male and female lambs were randomly and equally allotted with 5 lambs of each sex per treatment to four dietary treatment groups, which were initially formulated to have 100, 70, 30 or 0.0% Sporobolus grass hay, as a source of forage replacement for conventional Rhodes grass commonly used in the region. The lambs receiving 0.0% Sporobolus grass hay (100% Rhodes grass hay) served as the control. Feed and water were offered ad libitum. Male lambs were slaughtered at the end of the feeding trials. The average daily feed intake was significantly (p<0.05) higher for the animals fed different levels of Sporobolus grass hay than for the control animals. Feed conversion ratio (FCR), i.e., kg feed/kg BW, was similar in all treatment groups. Although lambs fed the diet with 70% Sporobolus grass hay had heavier carcass weights, the differences were not significant. In conclusion, growth performance or carcass characteristics of fattening indigenous lambs were not influenced by the inclusion of different levels of Sporobolus grass hay in the diet. Because of this, Sporobolus grass hay represents an alternative forage resource for sustaining small ruminant production in the saline coastal and subcoastal areas of the world.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.19 no.8
• /
• pp.843-849
• /
• 2009

The reliable operation of a swing check valve in the main feed water system of a power plant is most essential for successful shout-down process. A failure to close the valve at proper time often leads to the instability of the main feed water system, or even to an emergency stop of the power plant. In reality it is a very difficult task to monitor the behavior of a swing check valve. Furthermore it is impossible to see the motion of the valve. In this work two measurements were carried out simultaneously to determine the precise valve closure time. The dynamic pressure measurements were made at the inlet and outlet regions of the swing check valve. The transient vibration of the valve housing in the direction of water flow was also measured, which enabled the measurement of the transient vibration of the valve housing near valve closure. By comparing the results produced from these measurements the precise valve closure time could be determined. By carrying out order tracking technique using the dynamic pressure signals and pump rpm signal, the complicated dynamic problems inside the main feed water system can be more easily dealt with. This measurement scheme might be implemented in a power plant on a real-time basis without much difficulty. If this could be implemented, valuable information essential for shut-down operations can readily be passed on to the main control room. The feasibility of this implementation was demonstrated by this experimental work.

• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.288-293
• /
• 2001

This paper presents the water-hammer effect due to the rapid opening and closing of isolation valve and thruster valve in the spacecraft propulsion system. The single propellant feed system was modeled to investigate the maximum peak pressure due to the water-hammer effect. The test parameters are tank supply pressure, shape and throat length of orifice and line length. Kerosene was used as the inert simulant propellant liquid instead of hydrazine. As downstream line length after isolation valve increased from 1.5 to 2.5m, the maximum line-filling water-hammer peak pressure decreased, but the average time interval between peak pressures increased. The maximum line-filling water-hammer peak pressure with orifice was lower than without orifice, and the maximum line-filling water-hammer peak pressure with orifice at the back of isolation valve was lower than with orifice in front of isolation valve. Without orifice, the maximum water-hammer peak pressure due to the rapid opening and closing of the thruster valve was about 126% of tank supply pressure. With orifice, it decreased. As orifice throat length increased, it decreased. The maximum water-hammer peak pressure due to the rapid closing of the thruster valve with converging-diverging orifice was lower than normal orifice. It was found that the orifice as a means of pressure drop was very effective to reduce the water hammer peak pressure at the thruster valve. The results of this study can be used for the design of spacecraft liquid propulsion feed system.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.13 no.3
• /
• pp.42-48
• /
• 2014

The auxiliary-feed-water pump (AFWP) used to supply water during a station black out situation at nuclear power plants should meet the seismic qualification regulations stipulated in IEEE Std 323 and 344, so as to withstand earthquakes or dangerous situations. Here, we establish a model for the estimation of the structural integrity of this type of pump. If the natural frequency that results from a modal analysis is less than 33 Hz, we adopt a dynamic analysis, instead of a static analysis. A dynamic analysis was carried out taking into consideration seismic conditions such as the floor response spectra (FRS), an operation-base earthquake (OBE), and a safe-shutdown earthquake (SSE). Finally, an analytical estimation of the structural integrity of an AFWP is made through a comparison of calculated values and allowable values. If the result is less than the allowable stress, the pump is deemed to have good structural integrity. In addition, future studies will involve a stability check for rotor accidents that may occur during the operation of the pump.

• Membrane and Water Treatment
• /
• v.7 no.6
• /
• pp.507-520
• /
• 2016

The effect of ZnO on cellulose acetate in the removal of benzophenone-3 (BP-3) was investigated. The benzophenone-3 (BP-3) which is an endocrine disrupting chemical (EDC) was completely removed (100%) from the drinking water using Cellulose Acetate (CA) and zinc oxide (ZnO) composite membranes. The membranes were prepared by DIPS method and the filtration experiments were conducted by dead end filtration unit. The macrostructure of the membrane were studied by ATR-IR and XRD Spectra's. Atomic force microscopy (AFM) and Scanning electron microscopy (SEM) were used to study the micro properties of the membranes. The laboratory experiments such as water uptake study and pure water flux performed to confirm the increasing hydrophilicity. The enhancing hydrophilicity was confirmed with respect to higher the concentration of nanoparticles. Evaluation of BP-3 removal was carried in different experimental conditions, such as, different Trans membrane pressure and different concentration of feed. The membrane with low pressure showed better performance by rejecting 100% of BP-3. However, 1 ppm, 3 ppm and 6 ppm of feed solution was used and among them 3 ppm of feed solution gives 100% rejection. The ZnO nanoparticales enhances the performance of CA membrane by showing maximum rejection.

• Journal of the Korean Solar Energy Society
• /
• v.28 no.6
• /
• pp.48-57
• /
• 2008

The research analyzed the distribution of the indoor temperatures of a radiant floor cooling system through mock-up experiments. It investigated the temperature difference of feed water, the vertical temperature difference of indoor air, the temperature difference of floor surface, and so on. The following is the results of the research. First, the research shows that the difference between indoor temperature and outside temperature was the smallest when the temperature of feed water was set at 16$^{\circ}C$. In addition, the temperature changes according to indoor positions (wall, room, floor, and ceiling) were the most uniform. Thus, the research found that the cold water temperature of 16$^{\circ}C$ is the most proper. In addition, it confirmed that the feed water temperature of 18$^{\circ}C$ is effective because the temperature can lower the temperature of a room to 13.55$^{\circ}C$, which is lower than the temperature of a non-cooling mode. Second, an investigation on the temperature distribution of vertical air in indoor space shows that the temperature distribution had a difference of 0.2 to 1.9$^{\circ}C$ on the average, which satisfies the range of 3.0$^{\circ}C$ in the standard of ISO.