• Membrane and Water Treatment
• /
• v.7 no.4
• /
• pp.277-296
• /
• 2016

The aim of this research was to investigate the ability of nanofiltration (NF) and ultrafiltration (UF) membranes as a filtration unit for groundwater treatment for drinking water resources. Commercial membranes denoted as TS40, TFC-SR3 and GHSP were used to study the performance based on rejections and fluxes. The investigation has been conducted using natural groundwater obtained from a deep tube well with initial concentration of iron (Fe) and manganese (Mn) at 7.15 mg/L and 0.87 mg/L, respectively. Experimental results showed that NF membranes exhibited higher fluxes than UF membrane with pure water permeability at 4.68, 3.99 and $3.15L.m^{-2}.h^{-1}.bar^{-1}$, respectively. For metal rejection, these membranes have performed higher removal on Fe with TS40, TFC-SR3 and GHSP membranes having more than 82%, 92% and 86% respectively. Whereas, removal on Mn only achieved up to 60%, 80% and 30%, for TS40, TFC-SR3 and GHSP membranes respectively. In order to achieve drinking water standard, the membranes were efficient in removing Fe ion at 1 and 2 bar in contrast with Mn ion at 4 and 5 bar. Higher rejection of Fe and Mn were achieved when pH of feed solution was increased to more than 7 as TFC-SR3 membrane was negatively charged in basic solution. This effect could be attributed to the electrostatic effect interaction between membrane material and rejected ions. In conclusion, this study proved that NF membrane especially the TFC-SR3 membrane successfully treated local groundwater sources for public drinking water supply in line with the WHO standard.

• Journal of environmental and Sanitary engineering
• /
• v.24 no.1
• /
• pp.33-39
• /
• 2009

In order to investigate effect of metal ion and antioxidant on rancidity of crude rapeseed oil (CRO), $Fe^{2+}$, $Cu^{2+}$, $Co^{2+}$, $Ni^{2+}$, $Cr^{2+}$, $Sn^{2+}$, $Mn^{2+}$, $Zn^{2+}$, and antioxidants including BHA, Vitamin C, and Tocopherol were used. The specific gravity and refractive index of CRO were $0.92g/cm^3$ and 1.45, respectively. The chromaticities of light, red, and yellow in CRO were 88.6 and 98.7, respectively. Among various fatty acids, Oleic acid (C18:1) concentration was highest, 62.3% and Linoleic acid (C18:2) concentration was 19.16%. In the case of Linolenic acid (C18:3) and Palmitic acid (C16:0), they were 9.88 and 5.2%, respectively. The concentrations of unsaturated fatty acids and saturated fatty acid were 92.2 and 7.8%, respectively. The degree of expediting rancidity of CRO was an order of $Fe^{2+}$> $Cu^{2+}$> $Cr^{2+}$> $Zn^{2+}$> $Ni^{2+}$> $Al^{2+}$> $Mn^{2+}$> $Mn^{2+}$> $Sn^{2+}$> $Co^{2+}$> $Li^{2+}$. Especially, when $Cu^{2+}$ and $Fe^{2+}$ was used, the peroxide value concentration was about 4.0 fold higher than non addition of them. The inhibition effect of rancidity of CRO using antioxidant with $Cu^{2+}$ and $Fe^{2+}$ was an order of BHA> Vitamin C> Tocopherol.

• Journal of Surface Science and Engineering
• /
• v.47 no.1
• /
• pp.13-19
• /
• 2014

The various surface treated conditions of Fe-3.0%Ni-0.7%Cr-1.4%Mn-X steel such as as-received, ion nitriding, DLC coated, DLC coated after nitriding for 3 hrs and 6 hrs were investigated to evaluate the beneficial effect for plastic mold steel. Micro Vickers hardness tester was used to estimate nitriding depth from the hardness profile and to measure hardness on the surface. Elastic modulus and residual stress were measured by a nanoindentator. Scratch test and SP (small ball punch test) were utilized to assess the adhesive strength of DLC coating. The depth of nitriding layer was measured as $50{\mu}m$ for the condition of 3 hrs nitriding and $90{\mu}m$ for that of 6 hrs nitriding. Hardness, elastic modulus, residual stress of DLC coating were 20.37 GPa, 162.78 GPa and -1456 MPa respectively. Residual stress on the surface of DLC coating after nitriding could increase to -3914 MPa by introducing nitriding before DLC coating. During the 'Ball-On-Disc' test ${\gamma}^{\prime}$ particles pulled out from the surface of nitrized layer tend to enhance abrasive wear mode since the fraction of ${\gamma}^{\prime}$ (Fe4N) in ion-nitrized layer is known to increases with nitriding time. Thus the specific wear rate of the nitriding layer increased. Comparing with nitriding the specific wear rate in work piece disc as well as ball decreased prominently in DLC coating due to the remarkable reduction in friction coefficient.

• The Korean Journal of Mycology
• /
• v.15 no.4
• /
• pp.217-223
• /
• 1987

Mitochondria in the L. edodes was purified by linear sucrose density gradient centrifugation. The mitochondrial ATPase activity was investigated by various wavelength illumination for 30 min at dark state. The mitochondrial ATPase activity was stimulated 1.6 fold by 680 nm illumination compared with dark control group. The mitochondrial ATPase activity of different light illumination time at 680 nm was stimulated 2.3 fold at 5 minutes compared with dark control group. Its optimum pH and temperature were found to be 7.5 and $59^{\circ}C$ after illumination for 5 minutes at 680 nm. The mitochondrial ATPase activity was activated by 5 mmol $Fe^{3+}$, 0.1 mmol $Fe^{2+}$, 0.1 mmol $Mg^{2+}$, 0.5 mmol $K^{+}$, and 0.1 mmol $Ca^{2+}$ ion. But, the enzyme was inhibited by 5 mmol $Na^{+}$ ion.

• Journal of the Korean Magnetics Society
• /
• v.19 no.4
• /
• pp.142-146
• /
• 2009

The soft magnetic property for the Corning glass/Ta(5 nm)/[Conetic, Permalloy)/Ta(3 nm) prepared by the ion beam deposition sputtering was investigated. The coercivity and saturation magnetic field of conetic (NiFeCuMo) and permalloy (NiFe) layer with easy and hard direction along to the applying magnetic field during deposition was compared with each other. The surface resistance of conetic film with a thickness of 10 nm was 2 times lower than one of permalloy film. The coercivity and the magnetic susceptibility of conetic film decreased and increased 3 times to one of permalloy film, respectively. These results suggest that a highly sensitive GMR-SV or MTJ using conetic film can be possible to develop the bio-device.

• Journal of the Korean Ceramic Society
• /
• v.44 no.6 s.301
• /
• pp.297-302
• /
• 2007

With aids of square wave voltammetry (SWV) the redox behavior for various combination of polyvalent ions (Sb+Fe, Sb+Zn, Sb+Ce+Ti+Zn) was investigated in alkali-alkaline earth-silica CRT (Cathode Ray Tube) glass melts. The current-potential curve so called voltammogram was produced at temperature range of 1400 to $1000^{\circ}C$ under the scanned potential between 0 and -800 mV at 100 Hz. In the case of the Sb+Fe and Sb+Zn doped melts, peak for $Sb^{3+}/Sb^0$ shown voltammogram was shifted to negative direction comparing to the only Sb doped melts. However, according to voltammogram of Sb+Ce+Ti+Zn doped melt, Ti and Ce except Zn had hardly any influence on the redox reaction of Sb. Based on the temperature dependence of the peak potential, standard enthalpy (${\Delta}H^0$) and standard entropy (${\Delta}S^0$) for the reduction of $Fe^{3+}$ to $Fe^{2+}$, $Sb^{3+}$ to $Sb^0$, $Zn^{2+}$ to $Zn^0$ and $Ti^{2+}$ to $Ti^0$ in each polyvalent ion combination of CRT glass melts were calculated.

• The Korean Journal of Mycology
• /
• v.17 no.4
• /
• pp.169-176
• /
• 1989

Mitochondria in Pleurotus ostreatus was purified by stepped sucrose density gradient centrifugation. The activity of mitochondrial ATPase has been investigated during various times of illumination at each wavelength in the range of 400 nm to 700 nm. The mitochondrial ATPase activity was simulated 1,7 fold by 580 nm illumination compared with the broad wavelength group. The mitochondrial ATPase activity according to various times of illumination was stimulated 2.2 fold for 10 seconds at 580 nm compared with the broad wavelength group. The optimum pH and temperature of the mitochondrial ATPase were 7.4 and $60^{\circ}C$, respectively. The activity of this enzyme was stimulated by 5 mmol $Fe^{3+}$, 5 mmol $Mg^{2+}$, 0.1 mmol $Ca^{2+}$ and 5 mmol $Fe^{2+}$ ion, but inhibited by 5 mmol $Na^{+}$ ion.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2012.05a
• /
• pp.121-122
• /
• 2012

Iron-excess gallium ferrite, $Ga_{0.6}Fe_{1.4}O_3$ (GFO), is known to have room-temperature ferromagnetic phases and potentially exhibit ferroelectricity as well [1]. But, leaky polarization-electric field (PE) hysteresis curves of the GFO thin film are hurdle to prove its spontaneous polarization, in other words, ferroelecticity. One of the reasons that the GFO films have leaky PE hysteresis loop is carrier hopping between $Fe^{2+}$ and $Fe^{3+}$ sites due to oxygen deficiency. We focus on reducing conducting current by substituting divalent cations at $Fe^{2+}$ sites. GFO thin films were grown epitaxially along b-axis normal to $SrRuO_3/SrTiO_3$ (111) substrates by pulsed laser deposition. Current density of the ion-substituted GFO thin films was reduced by $10^3$ or more. Ferroelectric properties of the ion-substituted GFO thin films were measured using macroscopic and microscopic schemes. In particular, local ferroelectric properties of the GFO thin films were exhibited and their remnant polarization and piezoelectric d33 coefficient were obtained.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.5 no.3
• /
• pp.221-227
• /
• 2007

Fenton's reagent is applied to directly decompose the ion-exchange resins, IRN-78 and the mixed resin with IRN-77. The newly applied procedures is to dry the resin first and the catalyst solution is completely absorbed into the resin, then a limited dose of $H_2O_2$ is introduced for an effective reaction between the reagents within the resin. As a characteristic on the decomposition of IRN-78, the resin mixture should be heated to $40^{\circ}C$ to induce the initial reaction and lag time is also needed for about 20 minutes until the main reaction occurs. The effectiveness of the decomposition is investigated using $CuSO_4,\;Cu(NO_3)_2\;and\;FeSO_4$ as a catalyst and the decomposition rate is compared depending on the concentration of each catalyst and the amount of $H_2O_2$. The most effective catalyst was found to be $FeSO_4$ for IRN-78 alone and the mixed resin with IRN-77, and $FeSO_4$ showed a special effect that the reaction was initiated without heating and a lag time. Furthermore, the optimum concentration of the catalyst for each resin and the mixed one is suggested in the view point of the amount of $H_2O_2$ needed and the stability of the decomposition reaction.

• Journal of the Korean Chemical Society
• /
• v.40 no.5
• /
• pp.295-301
• /
• 1996

A series of solid solutions of the $CaGa_1-xFexO_3-y$ system with the compositions of x=0.25, 0.50, 0.75, and 1.00 has been prepared at $1150^{\circ}C$ under an atmospheric air pressure. The structure, nonstoichiometric chemical formula, and the distribution of cations for the solid solutions are determined by X-ray diffraction analysis, Mohr salt titration, Mossbauer spectroscopic analysis. Their physical properties are discussed with electrical conductivity and magnetic measurements. The crystal system of all the compositions is a brownmillerite orthorhombic system from the X-ray diffraction analysis and the reduced lattice volume increases linearly with x value except that of the composition of x=0.25. All the solid solutions do not contain $Fe^{4+}$ ion and the mole number of oxygen vacancies or y value is 0.50 from Mohr salt analysis. The oxidation state of Fe ion, the coordination state, the structure change in the Brownmillerite-type structure, and the distribution of $Ga^{3+}$ and $Fe^{3+}$ ions are discussed with Mossbauer spectroscopic analysis. The electrical conductivity increases and activation energy decreases, as x value increases. The traditional semiconducting property of this system is described in terms of band theory. The compositions of x=0.50∼1.00 show a thermal magnetic hysteresis in the magnetic measurement with the cooling conditions, which is discussed in terms of the space group and Dzyaloshinsky-Moriya interaction.