• Mass Spectrometry Letters
• /
• v.10 no.4
• /
• pp.103-107
• /
• 2019

Low-temperature plasma (LTP) ionization is one of the ambient ionization methods typically used in mass spectrometry (MS) for fast screening of chemicals with minimal or no sample preparation. In spite of various advantages of LTP ionization method, including simple instrumentation and in-situ analysis, more general applications of the method are limited due to poor desorption of analytes with low volatilities and low ionization efficiencies in the negative ion mode. In order to overcome these limitations, an ultrasonic vibrator of a commercial hand-held humidifier was interfaced with an LTP ionization source, which generated microdroplets from sample solutions and assisted with LTP ionization. Ionization behaviors of various chemicals in microdroplet-assisted LTP (MA LTP) were tested and compared with typical LTP ionization from dried samples applied on a surface. MA LTP efficiently ionized small organic, amino, and fatty acids with low volatilities and high polarities, which were hardly ionized using the standard LTP method. Facile interaction of LTP with ultrafine droplets generated by ultrasonic resonator allows efficient ionization of relatively non-volatile and polar analytes both in the positive and negative ion modes.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.2
• /
• pp.601-604
• /
• 2014

Two classes of morpholino-substitued thioacetate have been successfully synthesized and their electrochemical properties of self-assembled monolayers (SAMs) on Au electrode are measured by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The barrier property of the SAMs-modified surfaces is evaluated by using potassium ferro/ferri cyanide. The results suggest that the arenethioacetate forms higher-quality close-packed blocking monolayers in comparison with alkanethioacetate. Furthermore, it has shown that the barrier properties of these monolayers can be significantly improved by mixed SAMs formation with decanethiol. From our experimental results we find that the electron transfer reaction of $[Fe(CN)_6]^{3/4-}$ redox couple occurs predominantly through the pinholes and defects present in the SAM and both SAMs show a good and fast capacity in recognition for $Ag^+$. The morphological and elementary composition have also been examined by scanning electron microscope (SEM) and energy dispersive spectrometer (EDS).

• Bulletin of the Korean Chemical Society
• /
• v.32 no.10
• /
• pp.3592-3596
• /
• 2011

A novel poly(vinylchloride)-based membrane sensor using $N^1$,$N^3$,$N^5$-tris(2-(2,3-dihydroxybenzylamino)-ethyl)cyclohexane-1,3,5-tricarboxamide (CYCOENCAT, L) as ionophore has been prepared and explored as $Fe^{3+}$ selective electrode. The membrane electrode composed of ionophore, poly(vinylchloride) and o-nitropheyloctyl ether in the optimum ratio 4:33:63 gave excellent potentiometric response characteristics, and displayed a linear log[$Fe^{3+}$] versus EMF response over a wide concentration range of $1.0{\times}10^{-5}-1.0{\times}10^{-1}$ M with super nernstian slope of 28.0 mV/decade and the detection limit of $8.0{\times}10^{-6}$ M. The proposed ion selective electrode showed fast response time (< 15 s), wide pH range (3.0-7.0), high non-aqueous tolerance (up to 20%) and adequate long life time (120 days). It also exhibited very good selectivity for $Fe^{3+}$ relative to a wide variety of alkali, alkaline earth, transition and heavy metal ions. Further, the analytical applicability of the sensor was tested as an indicator electrode in the potentiometric titration of $Fe^{3+}$ with EDTA.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.11
• /
• pp.1585-1589
• /
• 2003

A PVC-based membrane electrode for thallium(I) ions based on 1,21,23,25-tetramethyl-2,20: 3,19-dimetheno-[H, 2] H, 23H, 25H-bis-[1,3] dioxocino[5,4-i:5',4'-i] benzo [1,2-d: 5.4-d'] bis [1,3] benzodioxocin(II) has been prepared. The electrode displays a linear dynamic range of $1.0{\times}10^{-1}-1.0{\times}10^{-5}$ M, with a Nernstian slope of $59.8{\pm}0.2\;mV\;{decad^-1}$, and a detection limit $5.0{\times}10^{-6}$ M. It has a very fast response time of<10 s and can be used for at least ten weeks without a considerable divergence in potentials. This electrode revealed comparatively good selectivity with respect to alkali, alkaline earth, and some transition and heavy metal ions and was effective in a pH range of 2.0-10.0. It was used as an indicator electrode in potentiometric titration of thallium ion with sulfide ion.

• Journal of Electrochemical Science and Technology
• /
• v.9 no.1
• /
• pp.20-27
• /
• 2018

We describe a redox-enhanced electric double-layer capacitor (EDLC) that turns the electrolyte in a conventional EDLC into an integral, active component for charge storage-charge is stored both through faradaic reactions with soluble redox-active molecules in the electrolyte, and through the double-layer capacitance in a porous carbon electrode. The mixed-redox electrolyte, composed of vanadium and iodides, was employed to achieve high power density. The electrochemical reaction in a supercapacitor with vanadium and iodide was studied to estimate the charge capacity and energy density of the redox supercapacitor. A redox supercapacitor with a mixed electrolyte composed of 0.75 M NaI and 0.5 M $VOSO_4$ was fabricated and studied. When charged to a potential of 1 V, faradaic charging processes were observed, in addition to the capacitive processes that increased the energy storage capabilities of the supercapacitor. The redox supercapacitor achieved a specific capacity of 13.44 mAh/g and an energy density of 3.81 Wh/kg in a simple Swagelok cell. A control EDLC with 1 M $H_2SO_4$ yielded 7.43 mAh/g and 2.85 Wh/kg. However, the relatively fast self-discharge in the redox-EDLC may be due to the shuttling of the redox couple between the polarized carbon electrodes.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.5
• /
• pp.510-514
• /
• 1991

Second-order rate constants have been determined spectrophotometrically for reactions of S-p-nitrophenyl substituted thiobenzoates with various phenoxide ions and S-aryl substituted thiobenzoates with $HO^-$ ion. Thiol esters have been found to be more reactive than the corresponding oxygen esters toward phenoxide ions. The high reactivity of thiol esters relative to oxygen esters becomes insignificant as the basicity of the nucleophile increases. Furthermore, the highly basic $HO^-$ ion is less reactive toward thiol esters than oxygen esters. The significant dependence of the reactivity of thiol esters on the basicity of nucleophiles has been attributed to the nature of the HSAB principle. The present kinetic study has also revealed that the reactivity of thiol esters compared to oxygen esters is not so pronounced as expected based on the enhanced nucleofugicity of thiol esters. However, the effects of substituents in the nucleophile and in the acyl moiety of the substrate on rate appear to be significant. These kinetic results have led to a conclusion that the present reactions proceed via a rate-determining formation of a tetrahedral intermediate followed by a fast breakdown of it. The magnitude of the ${\beta}$ values shows no tendency either to increase or to decrease with the intrinsic reactivity of the reagents. The constancy of ${\beta}$ values in the present system is suggestive that the RSP should have limited applicability.

• Journal of Hydrogen and New Energy
• /
• v.32 no.6
• /
• pp.592-611
• /
• 2021

In this study a rarely available high-throughput cycling data set of 124 commercial lithium iron phosphate/graphite cells cycled under fast-charging conditions, with widely varying cycle lives ranging from 150 to 2,300 cycles including in-cycle temperature and per-cycle IR measurements. We worked out own Python codes which reproduced the various data plots and machine learning approaches for cycle life prediction using early cycles and more details not presented in the article and the supplementary information. Particularly, we applied regularized ridge, lasso and elastic net linear regression models using features extracted from capacity fade curves, discharge voltage curves, and other data such as internal resistance and cell can temperature. We found that due to the limitation in the quantity and quality of the data from costly and lengthy battery testing a careful hyperparameter tuning may be required and that model features need to be extracted based on the domain knowledge.

• Corrosion Science and Technology
• /
• v.21 no.4
• /
• pp.250-257
• /
• 2022

Transition metal sulfide materials have emerged as a new anode material for Li secondary batteries owing to their high capacity and rate capability facilitated by fast Li-ion transport through the layered structure. Among these materials, niobium disulfide (NbS₂) has attracted much attention with its high electrical conductivity and high theoretical capacity (683 mAh g^-1). In this study, we propose a facile synthesis of Fe_xNbS₂/C composite via simple ball milling and heat treatment. The starting materials of FeS and Nb were reacted in the first milling step and transformed into an Fe-Nb-S composite. In the second milling step, activated carbon was incorporated and the sulfide was crystallized into Fe_xNbS₂ by heat treatment. The prepared materials were characterized by X-ray diffraction, electron spectroscopies, and X-ray photoelectron spectroscopy. The electrochemical test results reveal that the synthesized Fe_xNbS₂/C composite electrode demonstrates a high reversible capacity of more than 600 mAh g^-1, stable cycling stability, and excellent rate performance for Li-ion battery anodes.

• Korean Journal of Community Nutrition
• /
• v.11 no.4
• /
• pp.469-478
• /
• 2006

In order to investigate the adolescent's beverage drinking pattern and its related ecological factors, a questionnaire survey was conducted with the subjects of 920 middle and high-school students,450 boys and 470 girls, residing in 4 cities of the Chungnam area. Of the subjects 65% liked, or liked very much, beverages and only 3.7% did not like beverages. They drank beverages 4.3 $\pm$ 4.0 times a week on average, but 10.4% of them drank beverages more than twice a day. Male students drank more frequently than the females. The intake frequency of carbonated drinks was 1.7 $\pm$ 2.3 a week which was about 40% of the total beverages. However, more students drank mainly ion beverages (33.6%) than carbonated drinks (28.7%). As the students took more balanced food and ate more regularly, their beverage drinking frequency decreased and those taking carbonated drinks also tended to decrease. The more frequent the students took fast food, the more frequent they drank carbonated beverages. The drinking frequencies for beverages or carbonated beverages were also less in students eating cooked rice with sidedishes as breakfast than in students eating others. The drinking frequency for carbonated drinks showed significant correlations with the students' activities such as the time spent using computers and watching TV got longer, the drinking frequency for soft drinks was also higher. When nutritional knowledge was higher, drinking frequency for carbonated drinks got lower. In conclusion, to make the adolescents improve their attitudes toward drinking beverages and to prevent excessive drinking of carbonated drinks, they should be educated not only on the nutritional knowledge and the proper intake of beverages, but also on good dietary habits including balance, regularity, and types of meals. Proper snacking and fast food consumption also should be taught. Since ion beverages were taken more frequently than carbonated drinks among adolescents, further study is recommended on the impact of excessive intake of ion beverages.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.5
• /
• pp.1603-1607
• /
• 2012

The effects of plating process on the surface coverage of the accelerator were investigated in terms of Cu superfilling for device metallization. When a substrate having 500 nm-wide trench patterns on it was immersed in an electrolyte containing poly (ethylene glycol) (PEG)-chloride ion ($Cl^-$)-bis(3-sulfopropyl) disulfide (SPS) additives without applying deposition potential for such a time of about 100s, voids were generated inside of the electrodeposit. In time-evolved electrochemical analyses, it was observed that the process (immersion without applying potential) in the electrolyte led to the build-up of high initial coverage of SPS-Cl on the surface, resulting in the fast saturation of the coverage. Repeated experiments suggested that the fast saturation of SPS-Cl failed in superfilling while a gradual increase in the SPS-Cl coverage through competition with initially adsorbed PEG-Cl enabled it. Consequently, superfilling was achievable only in the case of applying the plating potential as soon as the substrate is dipped in an electrolyte to prevent rapid accumulation of SPS-Cl on the surface.