• Journal of Communications and Networks
• /
• v.8 no.2
• /
• pp.228-233
• /
• 2006

Survivability is a very important requirement for the deployment of broadband networks because out of service links can affect volumes of traffic even if it is a very short time. And the data paths of broadband networks, which are critical for traffic engineering, are always necessary to be well protected. The procedure of protection or restoration for a path is initiated when failure is detected within the working path. In order to minimize the influence on transmission quality caused by the failure of links and to provide a definite time for the recovery from the failure, the protection switching time (PST) should be carefully considered in the path arrangement. Several researches have been devoted to construct the protection and restoration schemes of data paths over dense wavelength division multiplexing (DWDM) networks, however, there was rare research on the design of data paths with guaranteed protection switching time. In this paper, the PST-guaranteed scheme, which is based on the concept of short leap shared protection (SLSP), for the arrangement of data paths in DWDM networks is proposed. The proposed scheme provides an efficient procedure to determine a just-enough PST-guaranteed backup paths for a working path. In addition to selecting the PST-guaranteed path, the network cost is also considered in a heuristic manner. The experimental results demonstrate that the paths arranged by the proposed scheme can fully meet the desired PST and the required cost of the selected path is competitive with which of the shared path scheme.

• Journal of Communications and Networks
• /
• v.9 no.4
• /
• pp.419-427
• /
• 2007

In wavelength-division-multiplexing(WDM) networks a link failure may cause the failure of several high-bit-rate optical channels, thereby leading to large data loss. Recently, various protection and restoration mechanisms have been proposed to efficiently deal with this problem in mesh networks. Among them, dedicated path protection(DPP) is a promising candidate because of its ultra-fast restoration time and robustness. In this work we investigate the issue of planning and optimization of WDM networks with DPP. Integer linear programming(ILP), in particular, is one of the most common exact method to solve the design optimization problem for protected WDM networks. Traditional ILP formalizations to solve this problem rely on the classical flow or route formulation approaches, but both these approaches suffer from a excessively high computational burden. In this paper, we present a variable-aggregation method that has the ability of significantly reducing the complexity of the traditional flow formulation. We compare also the computational burden of flow formulation with variable aggregation both with the classical flow and route formulations. The comparison is carried out by applying the three alternative methods to the optimization of two case-study networks.

• Journal of Internet Computing and Services
• /
• v.4 no.2
• /
• pp.1-9
• /
• 2003

Path restoration, which is needed to increase network survivability in MPLS networks, is a technology of supplying reliable service by delivering the traffics through restoring the paths when links or nodes of a working path are failed. In this paper, we propose a path restoration method using duplication of working paths for link failure as a method of restoring paths for the high priority traffics. The existing path restoration method transmits the traffics to the path restoration uniformly in regardless of the priority while link obstacle. It has a problem to take a long time to restore the connection of the high priority traffics. On the other hand, the suggested restoration method establishes the duplication path for the working path, which transmits the high priority traffics and transmit the traffics through the duplication path. It has a strong point to restore the connection quickly. Also, through simulation we analyze the performance of the restoration system using the duplication path and prove that the proposed restoration method is superior in performance to the existing restoration methods regarding to the high priority traffics.

• Journal of KIISE:Information Networking
• /
• v.31 no.2
• /
• pp.233-241
• /
• 2004

In this paper, we propose a packet-lossless fast rerouting scheme at a link/node fault in MPLS (Multiprotocol Label Switching) network with minimized accumulated buffer delay problem at ingress node. The proposed scheme uses a predefined, alternative LSP (Label Switched Path) In order to restore user traffic. We propose two restoration approaches. In the first approach, an alternative LSP is initially allocated with more bandwidth than the protected working LSP during the failure recovery phase. After the failure recovery, the excessively allocated bandwidth of the alternative LSP is readjusted to the bandwidth of the working LSP. In the second approach, we reduce the length of protected working LSP by using segment-based restoration. The proposed approaches have merits of (ⅰ) no buffer delay problem after failure recovery at ingress node, and (ⅱ) the smaller required buffer size at the ingress node than the previous approach.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9B
• /
• pp.793-805
• /
• 2003

In OBS (Optical Burst Switching) networks which decouple the burst from its header, the fault of a fiber link can lead to the failure of all the light-path that traverses the fiber. Because each light-path is expected to operate at a rate of a few Gbps by using WDM (Wavelength Division Multiplexing) technology, any failure may lead to large data loss. Therefore, an efficient recovery scheme must be provided. In this paper, we analyze network utilization and BCP (Burst Control Packet) loss rate according to each link failure by applying the conventional restoration schemes in OBS networks. And through these simulation results, an ASPR scheme is proposed improve the fault management scheme in terms of recovery time and throughput. Finally, We compare the performance of our proposed scheme with that of the conventional one with respect to burst loss rate, resource utilization and throughput by OPNET simulations.

• The Journal of Advanced Prosthodontics
• /
• v.4 no.2
• /
• pp.76-83
• /
• 2012

PURPOSE. Zirconia has been used in clinical dentistry for approximately a decade, and there have been several reports regarding the clinical performance and survival rates of zirconia-based restorations. The aim of this article was to review the literatures published from 2000 to 2010 regarding the clinical performance and the causes of failure of zirconia fixed partial dentures (FPDs). MATERIALS AND METHODS. An electronic search of English peer-reviewed dental literatures was performed through PubMed to obtain all the clinical studies focused on the performance of the zirconia FPDs. The electronic search was supplemented by manual searching through the references of the selected articles for possible inclusion of some articles. Randomized controlled clinical trials, longitudinal prospective and retrospective cohort studies were the focuses of this review. Articles that did not focus on the restoration of teeth using zirconia-based restorations were excluded from this review. RESULTS. There have been three studies for the study of zirconia single crowns. The clinical outcome was satisfactory (acceptable) according to the CDA evaluation. There have been 14 studies for the study of zirconia FPDs. The survival rates of zirconia anterior and posterior FPDs ranged between 73.9% - 100% after 2 - 5 years. The causes of failure were veneer fracture, ceramic core fracture, abutment tooth fracture, secondary caries, and restoration dislodgment. CONCLUSION. The overall performance of zirconia FPDs was satisfactory according to either USPHS criteria or CDA evaluations. Fracture resistance of core and veneering ceramics, bonding between core and veneering materials, and marginal discrepancy of zirconia-based restorations were discussed as the causes of failure. Because of its repeated occurrence in many studies, future researches are essentially required to clarify this problem and to reduce the fracture incident.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.25 no.3
• /
• pp.389-396
• /
• 2017

Restorations of automotive parts have been done ever since the first vehicle was produced. Because the most expensive parts of a vehicle are in the engine system, there have been various restoration methods developed for engine parts. In the case of commercial diesel engines, the fuel injection device is a key and expensive component. It also has a significant effect on vehicle performance. In particular, reduced engine power and increased exhaust gas emissions may result from mechanical damage due to abrasion of the spill valve in the fuel injection system of a diesel engine. In this paper, restoration techniques for damaged parts are applied to restore the abrasion of a spill valve of fuel injection, also called as the "unit injector", of commercial diesel engines. In order to recover the damage, optimized polishing techniques using hard-metal and coating processes are applied. To evaluate restoration techniques for the spill valve, performance and durability tests are performed on a test bench.

• The Journal of the Korean dental association
• /
• v.56 no.11
• /
• pp.616-621
• /
• 2018

This clinical case highlights the failure of long length implants, and the prosthodontic procedures necessary to rehabilitate the maxillary dentition of a patient with microstomia. The integrated digital technology of intra-oral scanning, computer-aided design, and three-dimensional printing can provide an alternative method to make conventional impressions for patients with microstomia who cannot insert the appropriate tray in their mouths.

• The Journal of the Korean dental association
• /
• v.49 no.2
• /
• pp.85-94
• /
• 2011

In the filed of Dentistry, minimally invasive treatment modalities are new trend for conservation of natural teeth. Of them, laminate veneer and resin bonded fixed partial denture belong to restoration procedures. In this review, survival rates of each modalities and cause of unserviceability are analyzed, and criteria for success are presented. To get successful results of minimally invasive restoration, plenty of enamel layer, thin and strong materials, and high bonding strength are essential under cyclically loaded wet oral condition. Newly tried design of minimally invasive technique nowadays have to be evaluated only on the basis of requirement for long-term success.

• The KIPS Transactions:PartC
• /
• v.12C no.1 s.97
• /
• pp.77-82
• /
• 2005

Protection of user service becomes increasingly important since even very short interruption of service due to link or node failure will cause huge data loss and incur tremendous restoration cost in high speed network environment. Thus fast and efficient protection and restoration is one of the most important issues to be addressed. Protection methods have been proposed to provide efficiency and stability in optical networks. In this paper, an original network is separated into several domains using Hamiltonian cycle. and link protection is performed on the cycles of the domains. We have shown that protection path length can be decreased up to $57{\%}$ with marginal increase of backup capacity. Our proposed method can provide high-speed protection with marginal increase of protection capacity.