• Journal of the Microelectronics and Packaging Society
• /
• v.19 no.4
• /
• pp.45-50
• /
• 2012

A family of multi-die DRAM packages was developed that incorporate the full functionality of an SODIMM into a single package. Using a common ball assignment analogous to the edge connector of an SODIMM, a broad range of memory types and assembly structures are supported in this new package. In particular DDR3U, LPDDR3 and DDR4RS are all supported. The center-bonded DRAM use face-down wirebond assembly, while the peripherybonded LPDDR3 use the face-up configuration. Flip chip assembly as well as TSV stacked memory is also supported in this new technology. For the center-bonded devices (DDR3, DDR4 and LPDDR3 ${\times}16$ die) and for the face up wirebonded ${\times}32$ LPDDR3 devices, a simple manufacturing flow is used: all die are placed on the strip in a single machine insertion and are sourced from a single wafer. Wirebonding is also a single insertion operation: all die on a strip are wirebonded at the same time. Because the locations of the power signals is unchanged for these different types of memories, a single consolidated set of test hardware can be used for testing and burn-in for all three memory types.

• Journal of the Microelectronics and Packaging Society
• /
• v.23 no.2
• /
• pp.79-84
• /
• 2016

A flexible electronic device deformed by external force causes the failure of a semiconductor die. Even without failure, the repeated elastic deformation changes carrier mobility in the channel and increases resistivity in the interconnection, which causes malfunction of the integrated circuits. Therefore it is desirable that a semiconductor die be placed on a neutral line where the mechanical stress is zero. In the present study, we investigated the effects of design factors on the position of neutral line by finite element analysis (FEA), and expected the possible failure behavior in a flexible face-down packaging system assuming flip-chip bonding of a silicon die. The thickness and material of the flexible substrate and the thickness of a silicon die were considered as design factors. The thickness of a flexible substrate was the most important factor for controlling the position of the neutral line. A three-dimensional FEA result showed that the von Mises stress higher than yield stress would be applied to copper bumps between a silicon die and a flexible substrate. Finally, we suggested a designing strategy for reducing the stress of a silicon die and copper bumps of a flexible face-down packaging system.