• Korean Chemical Engineering Research
• /
• v.52 no.1
• /
• pp.88-91
• /
• 2014

In this study, oil as a source of biodiesel from Nannochloropsis oceanica was extracted using organic solvent. The oil extraction yield and efficiency from dry and wet microalgae were investigated. The initial fatty acids content of the N. oceanica was 317.8 mg/g cell showing a high oil content over 30%. The yield from dry microalgae was higher than that from wet microalgae due to the inhibition of water. The yield by chloroform-methanol was the highest and the yield by hexane was the lowest. However, the total fatty acids contents with the chloroform-methanol were 678.7 and 778.2 mg/g oil under dry and wet conditions, respectively. The high oil extraction yield by chloroform-methanol reflected the fact that the extracted oil contained a high level of impurity. The hexane-methanol extraction from dry N. oceanica showed high oil extraction efficiency, 82.6%. The chloroform-methanol extraction under wet condition also showed high efficiency, 88.0%. While the hexane-methanol extraction from dry microalgae is desirable under low drying cost, the chloroform-methanol extraction from wet microalgae is desirable under high drying cost.

• Korean Journal of Veterinary Research
• /
• v.47 no.2
• /
• pp.157-162
• /
• 2007

Lactic acid bacteria (LAB) has been regarded as a useful microorganism and tried to manipulate plasmid DNA for increasing the usefulness. Although several methods have been developed to isolate plasmid DNA from Escherichia coli (E. coli), these methods were not sufficient to apply to LAB with exception of O'Sullivan's lysis method. So, we evaluated plasmid DNA extraction from LAB using general E. coli preparation methods and tried to improve the extraction yield and DNA purity by modifying O'Sullivan's alkaline lysis method. To improve the extraction yield, salt and carrier were added to precipitant and those were incubated at $-70{^{\circ}C}$. Only incubation at $-70{^{\circ}C}$ was the effective method of those modifications. Purity of plasmid DNA was improved by two times of each centrifugation and phenol/chloroform extraction. However, DNA was damaged by twice extraction with phenol/chloroform. Also, exclusion of ethidium bromide showed negative effect to purity. Additionally, it was recommended that improvement of the extraction yield may be due to centrifugation at high speed for more time and to dissolving complete DNA pellet before addition of 7.5 M ammonium acetate. Extraction using this modification produced higher quality of plasmid DNA.

• Elastomers and Composites
• /
• v.34 no.4
• /
• pp.350-359
• /
• 1999

Conversion and oil-yield of a used automotive tire sample in supercritical decomposition and extraction for three solvents such as water, 28% ammoina solution and ammonia, were compared. Supercritical extraction with ammonia gave the highest conversion and oil-yield at the same temperature and pressure. In this paper, supercritical ammonia was used as major solvent and tetralin acting as hydrogen-donor, was used as cosolvent. As the amount of tetralin increased, oil-yield was Increased. When a tire sample was extracted by supercritical ammonia, oil-yield was 48.8% at $280^{\circ}C$, 22.3MPa. But when the weight ratio of tetralin to tire sample (weight of tetralin/weight of tire sample) was 5, oil-yield was 61.2% at $280^{\circ}C$ and 22.3 MPa. These phenomena indicate that as radicals produced in supercritical decomposition become stable, the polymerization and the second decomposition of products may be inhibited. Supercritical extraction of a tire sample swollen by tetralin gave high oil-yield although the amount of tetralin was a little.

• Journal of the Korean Wood Science and Technology
• /
• v.12 no.4
• /
• pp.19-30
• /
• 1984

This experiment was carried out to investigate the effects of autohydrolysis and extraction conditions on the separation of the chemical substances, the extractability of lignin by dioxane, and the yield of reducing sugars from cellulosic substrates by using a commercial cellulase derived from Trichoderma viride. Air-dried wood meals through 0.42mm (40 mesh) screen and retained on 0.25 mm (60 mesh) of Populus alba-glandulosa and Pinus koraiensis were autohydrolyzed with water at $180^{\circ}C$ for 30 and/or 60 minutes in a 6 liter stainless-steel digester with or without 2% 2-naphthol. The hydrothermally-treated wood meals were extracted the lignin with 100%, 90%, 75% and 50% dioxane solutions at $70^{\circ}C$ for 4 hours, respectively. The results obtained were as follows; 1) After autohydrolysis of Populus alba-glandulosa, the yield of wood meals decreased with lengthening the auto hydrolysis time from 30 minutes to 60 minutes and with 2% 2-naphthol addition. In case of Pinus koraiensis, the yield was not affected by 2%, 2-naphthol addition at the autohydrolysis in the digester. 2) After autohydrolysis and lignin extraction of Populus alba-glandulosa, the yield of wood meals decreased with lengthening the autohydrolysis time from 30 minutes to 60 minutes and with 2% 2-naphthol addition. Extraction of 50% dioxane solution was the best solvent for the yield among the solutions of 100%, 90%. 75% and 50% dioxane. In case of Pinus koraiensis, the yield was not affected by 2% 2-naphthol addition and the solution of 90% dioxane was the poorest solvent for the yield. 3) After autohydrolysis and lignin extraction of Populus alba-glandulosa, the Klason lignin content in cellulosic substrates for enzymatic hydrolysis decreased with lengthening the autohydrolysis time from 30 minutes to 60 minutes and with 2% 2-naphthol addition. Klason lignin content was the lowest after extraction by 90% or 75% dioxane solution. The content was also affected by interaction of the three factors-autohydrolysis time, 2% 2-naphthol addition and concentration of dioxane. In case of Pinus koraiensis, the Klason lignin content increased with 2% 2-naphthol addition but was not affected by the concentration of dioxane solution. 4) After autohydrolysis and lignin extraction of Populus alba-glandulosa, the extractable Klason lignin content by extraction increased with lengthening the auto hydrolysis time from 30 minutes to 60 minutes and with 2% 2-naphthol addition. The extractable lignin content was the highest after extraction by 90% or 75% dioxane solution. In case of Pinus koraiensis, the extractable lignin content increased with 2% 2-naphthol addition. Extractions by 100%, 90% and 50% dioxane solutions were more effective for the extraction of Klason lignin than by 75% dioxane solution. 5) After autohydrolysis and lignin extraction of Populus alba-glandulosa, the yield of reducing sugars increased with lengthening the autohydrolysis time from 30 minutes to 60 minutes but was not affected by 2% 2-naphthol addition and the concentration of dioxane. The yield of reducing sugars after enzymatic hydrolysis was slightly higher by extractions with 90%, 75% and 50% dioxane solutions than with 100% dioxane. In case of Pinus koraiensis, the yield of reducing sugars was not affected by 2% 2-naphthol addition but affected by the concentration of dioxane. The yield of reducing sugars was the highest in cellulosic substrates extracted by 100% dioxane solution.

• Herbal Formula Science
• /
• v.22 no.2
• /
• pp.15-24
• /
• 2014

Objectives : Gwakhyangjeonggi-san (GJS) which consists of 13 herbal medicines has been used to treat gastrointestinal disorders caused by common cold. This study was performed to compare GJS decoctions produced using different pressure levels for various extraction times. Methods : Decoctions were prepared by the pressure levels of $0kgf/cm^2$ (non-pressurized) or $1kgf/cm^2$ (pressurized) for 30-180 min. The extraction yield, total soluble solid content (TSSC), and hydrogen ion concentration (pH) were measured, and the contents of the nine marker compounds were determined using high performance liquid chromatography. Results : The higher pressure and longer extraction time significantly increased TSSC value, while decreased the pH value. However, only extraction time affected the extraction yield of pressurized decoction. Variation of the amounts of chemical compounds was shown in pressurized and non-pressurized decoctions during extraction time. The result of regression analysis showed that pressure and extraction time can influence to extraction yield, TSSC, pH, and the content of chemical compounds. Conclusions : This study suggests that the pressure and extraction time can significantly affect the extraction efficiency of components from GJS decoctions.

• Journal of Microbiology
• /
• v.35 no.4
• /
• pp.354-359
• /
• 1997

Methods for the extraction of DNA from water sample were approximated. Four different procedures of DNA extraction were carried out with pellets obtained from centrifugation of 4 liter water samples. The recovery efficiency and purity of DNA extracted by each method from different sources were compared. DNA yield varied with extraction methods, Method I, which involves enzymatic and freeze-thaw lysis steps and phenol and phenol-chloroform purification of extracted nucleic acid, showed a significantly higher yield and purity than the other methods. The use of glass beads in the DNA extraction methods improved the purity of DNA suitable for PCR. Bovine serum albumin in the PCR reaction mixture was useful in reducing inhibitory effects of contaminants. The efficiency of an extraction method was determined by the detection of the aer of Aeromonas hydrophila with PCR. The lower limit of detection of A. hydrophila from seeded tap water was 2 CFU/ml in PCR when method I was used for DNA preparation.

• Journal of Microbiology and Biotechnology
• /
• v.14 no.5
• /
• pp.932-937
• /
• 2004

In situ extraction by organic solvent was studied in order to improve the recovery yield of hydrocarbon from the culture of Botryococcus braunii, a green colonial microalga. When the solvent mixture of octanol as an extractive solvent and n-octane as a biocompatible solvent was added to a two-phase column, the algal growth was seriously inhibited, even at a low concentration of polar octanol. Therefore, a two-stage cell-recycle extraction process was proposed to improve the contact area between the organic phase and the aqueous phase. The hydrocarbon recovery with in situ cell-recycle extraction showed a three-fold increase (57% of cell) in yield over that with two-phase extraction. In addition, over 60% of the hydrocarbon could be recovered without serious cell damage by downstream separation when this process was applied to the culture broth after batch fermentation.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.22 no.6
• /
• pp.771-776
• /
• 1993

Aqueous extraction of sea tangle at the temperature range of 60~10$0^{\circ}C$ was studied for temperature effects on soluble solids and protein yields, amino nitrogen, turbidity and viscosity of extracts. The solids and protein yield were increased as the temperature increased and most of solids and protein were extracted during 1 hour. The supernatant ratio after centrifugation showed significantly low for the extraction at 6$0^{\circ}C$. More temperature effects were found on turbidity and viscosity than yields. A significantly higher total amino nitrogen contents was obtained from higher temperature at initial stage of extraction and then the differences of them became to be narrow as the extraction prolonged further. The low values of 24.1% solids and 13.5% protein yields after 2 hours of extraction at 10$0^{\circ}C$ indicated that most of solids in sea tangle are insouble.

• Plant Resources
• /
• v.6 no.3
• /
• pp.221-226
• /
• 2003

To improve industrial scale extraction method for extraction of icariin from Epimedium koreanum Nakai, the yields under different extracting conditions such as solvent, temperature, duration and solvent to plant material weight ratio were compared. Regarding extracting solution, highest extracts and icariin yield could be achieved when 10% EtOH was used. In case of plant material to extracting solvent ratio, no significant differences could be observed from 1/10 to 1/50, indicating 1/10 was the most efficient. Extracting temperature significantly affected extracts and icariin yields in that 9$0^{\circ}C$ increased the collected extracts and icariin contents up to 29.6% and 0.76%, respectively, compared to 27.2%, 0.33% at 7$0^{\circ}C$. The yield of extracts was less dependent upon extracting temperature compared to icariin yield. Regarding extraction time, 4 hr and 6 hr resulted in high extracts and icariin yield, respectively. We found extracting Epimedium koreanum Nakai in 10 times volume of 10% EtOH for 4 and 6 hr at 9$0^{\circ}C$ seem to be relatively efficient methods for extracts and icariin, respectively.

• Natural Product Sciences
• /
• v.24 no.3
• /
• pp.199-205
• /
• 2018

To determine the optimum extraction conditions that give the highest yield of isoquercitrin and caffeic acid from Aster scaber, the effects of four extraction variables (solvent concentrations, extraction time, number of repeated extraction, and solvent volumes) on isoquercitrin and caffeic acid yield was examined via HPLC-UV. Our results showed that the highest extract and isoquercitrin yield were observed when A. scaber was extracted with 450 mL distilled water for 8 hr repeatedly for three times. In case of caffeic acid, the content was higher in the two repeated extracts. Also, content analysis of isoquercitrin in Aster species was performed in which A. fastigiatus, A. ageratoides, and A. scaber exhibited the highest isoquercitrin content at 6.39, 5.68, and 2.79 mg/g extract, respectively. In case of caffeic acid, the highest content of A. scaber and A. glehni was 0.64 and 0.56 mg/g extract, respectively. This study reports an optimized method for extraction of isoquercitrin and caffeic acid from A. scaber and evaluates potential sources of the compounds.