• Korean Journal of Cognitive Science
• /
• v.14 no.4
• /
• pp.1-7
• /
• 2003

The common features of the behavioral inhibition and the action monitoring that are considered as one of the executive functions were investigated using event-related brain potentials (ERPs) and source localization analysis. The electrophysiological correlates of behavioral inhibition and action monitoring ate analyzed when the subjects performed the Go/NoGo task. Two ERP components of behavioral inhibition termed as N200 and P300 in NoGo condition were differ from those of Go condition, that is the amplitudes of NoGo N200 and P300 are largest on the fronto-central region, which may reflect the inhibitory control of frontal lobe required in NoGo condition. The error-related negativity (ERN) observed on the fronto-central region when the subjects committed error was much larger in amplitude and faster in latency than those of the correct-related negativity (CRN), which may indicate that the signal of action monitoring is much more required for the error response. The correlation analysis for the ERP components of behavioral inhibition and action monitoring revealed the significant negative correlation among the latencies of NoGo N200 and P300 and the amplitude of ERN, which may reflects that the faster subjects inhibit response, the more monitor their own action. The close relationship between behavioral inhibition and action monitoring was also supported by the results of source localization analysis, which showed the common neural sources of NoGo N200 and ERN was anterior cingulate cortex.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.11
• /
• pp.1074-1081
• /
• 2011

As robotics systems are becoming more complex there is the need to promote component based robot development, where systems can be constructed as the composition and integration of reusable building block. One of the most important challenges facing component based robot development is safeguarding against software component failures and malfunctions. The health monitoring of the robot software is most fundamental factors not only to manage system at runtime but also to analysis information of software component in design phase of the robot application. And also as a lot of monitoring events are occurred during the execution of the robot software components, a simple data treatment and efficient memory management method is required. In this paper, we propose an efficient events monitoring and data management method by modeling robot software component and monitoring factors based on robot software framework. The monitoring factors, such as component execution runtime exception, Input/Output data, execution time, checkpoint-rollback are deduced and the detail monitoring events are defined. Furthermore, we define event record and monitor record pool suitable for robot software components and propose a efficient data management method. To verify the effectiveness and usefulness of the proposed approach, a monitoring module and user interface has been implemented using OPRoS robot software framework. The proposed monitoring module can be used as monitoring tool to analysis the software components in robot design phase and plugged into self-healing system to monitor the system health status at runtime in robot systems.

• Wind and Structures
• /
• v.16 no.4
• /
• pp.373-391
• /
• 2013

This is the first of two companion papers that analyse ten years of on-site monitoring data for the Confederation Bridge to determine the validity of the original wind speeds and wind loads predicted in 1994 when the bridge was being designed. The check of the original design values is warranted because the design wind speed at the middle of Northumberland Strait was derived from data collected at shore-based weather stations, and the design wind loads were based on tests of section and full-aeroelastic models in the wind tunnel. This first paper uses wind, tilt, and acceleration monitoring data to determine the static and dynamic responses of the bridge, which are then used in the second paper to derive the static and dynamic wind loads. It is shown that the design ten-minute mean wind speed with a 100-year return period is 1.5% less than the 1994 design value, and that the bridge has been subjected to this design event once on November 7, 2001. The dynamic characteristics of the instrumented spans of the bridge including frequencies, mode shapes and damping are in good agreement with published values reported by others. The on-site monitoring data show bridge response to be that of turbulent buffeting which is consistent with the response predicted at the design stage.

• IE interfaces
• /
• v.19 no.1
• /
• pp.43-52
• /
• 2006

In order to make best use of NC machine tools with minimal labor costs, they need to be in operation 24 hours a day without being attended by human operators except for setup and tool changes. Thus, unattended machining is becoming a dream of every modern machine shop. However, without a proper mechanism for real-time monitoring of the machining processes, unattended machine could lead to a disaster. Investigated in this paper are ways to using PC camera as a real-time monitoring system for unattended NC milling operations. This study defined five machining states READY, NORMAL MACHINING, ABNORMAL MACHINING, COLLISION and END-OF-MACHINING and modeled them with DEVS (discrete event system) formalism. An image change detection algorithm has been developed to detect the table movements and a flame and smoke detection algorithm to detect unstable cutting process. Spindle on/off and cutting status could be successfully detected from the sound signals. Initial experimentation shows that the PC camera could be used as a reliable monitoring system for unattended NC machining.

• Journal of information and communication convergence engineering
• /
• v.9 no.4
• /
• pp.379-384
• /
• 2011

The scope of the problems that could be solved by monitoring and the improvement of the recognition time is directly correlated to the performance of the management function of the business process. However, the current monitoring process of business activities decides whether to apply warnings or not by assuming a fixed environment and showing expressions based on the design rules. Also, warnings are applied by carrying out the measuring process when the event attribute values are inserted at every point. Therefore, there is a limit for distinguishing the range of occurrence and the level of severity in regard to the new external problems occurring in a complicated environment. Such problems cannot be ed. Also, since it is difficult to expand the range of problems which can be possibly evaluated, it is impossible to evaluate any unexpected situation which could occur in the execution period. In this paper, a process-evaluating model based on the goal scenario is suggested to provide constant services through the current monitoring process in regard to the service demands of the new scenario which occurs outside. The new demands based on the outside situation are analyzed according to the goal scenario for the process activities. Also, by using the meta-heuristic algorithm, a similar process model is found and identified by combining similarity and interrelationship. The process can be stopped in advance or adjusted to the wanted direction.

• Environmental Engineering Research
• /
• v.13 no.4
• /
• pp.184-191
• /
• 2008

Long term monitoring was conducted to investigate a surface runoff of pollution from urban highway. The monitoring data was collected for 18 rainfall events and was used to correlate pollution load to various parameters, such as rainfall intensity, antecedent dry days and total discharge flow. Runoff coefficient and seasonal variation were also evaluated. The mean runoff coefficient of the highway was 0.823(range; $0.4687{\sim}0.9884$), and wash-off ratio for $COD_{Mn}$ and SS loads was 72.6% and 64.3%, respectively. For the initial rainfall event, the runoff EMC of $COD_{Mn}$ was high in summer and the EMC of SS was high in autumn season. However the seasonal variation of T-N and T-P was not significant. The discharged $COD_{Mn}$-EMC was $147.6\;mg/L{\sim}9.0\;mg/L$ on the generated $COD_{Mn}$-EMC of $98.8\;mg/L{\sim}8.9\;mg/L$. While the generated EMC of SS was in $285.7\;mg/L{\sim}20.0\;mg/L$ and its discharged EMC was in $190.4\;mg/L{\sim}8.0\;mg/L$. EMC of pollutants was not directly related to the first flush rainfall intensity and the antecedent dry days. But the correlation was relatively high between EMC and cumulative runoff flow volume. The trend of EMC was reduced with the cumulative runoff flow volume.

• Korean Journal of Agricultural Science
• /
• v.41 no.3
• /
• pp.187-191
• /
• 2014

The cultivation area and use of genetically modified (GM) crops have been increased continuously over the world. Concerns about the potential risks of GM crops are also increasing. Safe management for the development and production of GM crops is required according to Living Modified Organism Act in Korea. Planning about the methods, duration, and frequency of environmental monitoring is also required for commercial use of GM crops. GM Zoysia japonica Steud. (event name: JG21) expressing resistance to glufosinate-ammonium has been generated previously. By using gamma ray treatment to JG21 we also developed male sterility and dwarf Z. japonica (event name: JG21-MS). The objective of this study was to establish the monitoring system for environment release of JG21-MS. In this study we extracted RNA from JG21 and JG21-MS and conducted RAPD (random amplified polymorphic DNA) method to distinguish JG21 and JG21-MS.

• Annals of Clinical Neurophysiology
• /
• v.2 no.1
• /
• pp.8-12
• /
• 2000

Purpose : The rapid development and wide popularity of Digital EEG(DEEG) is due to its convenience, accuracy and applicability for quantitative analysis. These advantages of DEEG make one hesitate to use analog EEG(AEEG). To assess the advantage of DEEG system utilizing AEEG(DAEEG) over conventional AEEG and the clinical applicability, a DAEEG system was developed and applied to animal model Methods : Sprague-Dawley rat as status epilepticus model were used for collecting the EEG data. After four epidural electrodes were inserted and connected to 8-channel analog EEG(Nihon-Kohden, Japan), continous. EEG monitoring via computer screen was done from two rats simultaneously. EEG signals through analog amplifier and filters were digitized at digital signal processor and stored in Windows-based pentium personal computer. Digital data were sampled at a rate of 200 Hz and 12 bit of resolution. Acquisition software was able to carry out 'real-time view, sensitivity control and event marking' during continuous EEG monitoring. Digital data were stored on hard disk and hacked-up on CD-ROM for off-line review. Review system consisted of off-line review, saving and printing out interesting segment and annotation function. Results: This DAEEG system could utilize most major functions of DEEG sufficiently while making a use of an AEEG. It was easy to monitor continuously compared to Conventional AEEG and to control sensitivity during ictal period. Marking the event such as a clinical seizure or drug injection was less favorable than AEEG due to slowed processing speed of digital processor and central processing unit. Reviewing EEG data was convenient, but paging speed was slow. Storage and management of data was handy and economical. Conclusion : Relatively simple digital EEG system utilizing AEEG can be set-up at n laboratory level. It may be possible to make an application for clinical purposes.

• Journal of Environmental Health Sciences
• /
• v.43 no.6
• /
• pp.491-498
• /
• 2017

Objective: Bacterial abundance and community compositions have been examined in Asian dust events, clarifying their impacts on public health. This study aims to determine the bacterial community compositions and viable bacteria in Asian dust particles in the Asian dust or non-Asian dust event of March 2016. Methods: The dust samples were collected using the high volume air sampler or high volume cascade impactor, and bacterial 16S rRNA genes were amplified using PCR, followed by pyrosequencing. Bacterial diversity index, richness estimate and community composition in the particles were analyzed from the sequencing data using Mothur software. Results: The results showed that the diversity and richness during Asian dust events were higher than them in non-Asian dust events. The total bacterial community analysis showed that at the phylum Proteobacteria, Actinobacteria and Firmicutes were the most dominant of Asian dust events and non-Asian dust events. In addition, the bacterial colony counts were higher during Asian dust event, comparing with non-Asian dust event. Conclusions: This study showed that bacterial community and richness of Asian dust samples was more complex and higher than non-Asian dust samples in Gyeonggi-do, Korea, which could affect public health and environment. Thus, the continuous monitoring of Asian dust could be an alternative for managing airborne bacteria.

• Journal of Korean Society on Water Environment
• /
• v.29 no.1
• /
• pp.97-106
• /
• 2013

The temporal and spatial variations of water quality in a stratified reservoir are fully dependent on the characteristics of inflow loading from its watershed and the transport regimes of pollutants after entering the reservoir. Because of the meteorological and hydrological conditions in Korea, the pollutants loading to reservoirs are mostly occur during rainfall events. Therefore it is important to understand the characteristics of pollutants loading from upstream rivers and their spatial propagation through the stratified reservoir during the rainfall events. The objectives of this study were to characterize the water quality variations in upstream rivers of Imha Reservoir during a rainfall event, and the transport and spatial variations of pollutants in the reservoir through extensive field monitoring and laboratory analysis. The results showed that the event mean concentration (EMC) of SS, BOD, $COD_{Mn}$, T-N, T-P, $PO_4-P$ are 8.6 ~ 362.1, 2.5 ~ 5.1, 1.5 ~ 5.1, 1.1 ~ 1.9, 8.3 ~ 57.1, 5.6 ~ 25.7 times greater than the mean concentrations of these parameters during non-rainfall period. The turbidity and SS data showed good linear correlations, but the relationships between flow and SS showed large variations because of hysteresis effect during rising and falling periods of the flood. The ratio of POC to TOC were 12.6 ~ 14.7% during the non-rainfall periods, but increased up to 28.2 ~ 41.7% during the flood event. The turbid flood flow formed underflow and interflow after entering the reservoir, and delivered a great amount of non-point pollutants such as labile and refractory organic matters and nutrients to the metalimnion layer of reservoir, which is just above the thermocline. Spatially, the lateral variations of most water quality parameters were marginal but the vertical variations were significant.