• Journal of Korean Society of Forest Science
• /
• v.82 no.4
• /
• pp.328-336
• /
• 1993

This study was conducted to investigate sensitivity of tree seedlings to $SO_2$. Visible injury symptoms and changes of ethylene production were investigated in tree seedlings with the fumigation of $SO_2$ in gas chamber 4 hours a day for six days. The symptoms of visible injury did not appear below 0.5ppm level of $SO_2$ exposure but a change of visible injury with the passage of time appeared at 1.5 and 2.5ppm in all seedlings. With the higher the concentration and/or the longer exposure of $SO_2$ the visible injury symptoms on leaves increased in all seedlings. The sensitivity of seedlings to $SO_2$ was the highest in Liriodendron tulipifera followed by Pinus strobus, Ginkgo biloba, Pinus densiflora and Pinus koraiensis. The amount of ethylene production was more at 1.5 and 2.5ppm of $SO_2$ exposure than at 0.5ppm and the peak time of it came faster at higher levels. The amount of ethylene production was significantly different among tree seedlings. It showed a higher at production of ethylene in Liriodendron tulipifera compared to Ginkgo biloba and the ethylene production of Pinus trees to $SO_2$ were the highest in Pinus strobus followed by Pinus densiflora and Pinus koraiensis. In needle of Pinus strobus the ethylene production increased with the increasing rate of visible injury until the injury rate of 40-50% and than decreased with the increasing rate of visible injury since the rate of 50%.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.1
• /
• pp.79-86
• /
• 2003

In this paper, the effect of oxygen component in fuel on the exhaust emissions has been investigated fur direct injection diesel engine. It was tested to estimate change of engine performance and exhaust emission characteristics for the commercial diesel fuel and oxygenated blended fuel which has seven kinds of mixed ratio. And, the effects of exhaust gas recirculation(EGR) on the characteristics of NOx emission have been investigated. Ethylene glycol mono-n-butyl ether(EGBE) contains oxygen component 27% in itself, and it is a kind of effective oxygenated fuel of mono-ether group that the smoke emission and unburned hydrocarbons of EGBE is reduced remarkably compared with commercial diesel fuel, that is, it can supply oxygen component sufficiently at higher loads and speeds in diesel engine. It was found that simultaneous reduction of smoke and NOx was achieved with oxygenated fuel and cooled EGR method.

• Journal of Environmental Health Sciences
• /
• v.8 no.1
• /
• pp.25-30
• /
• 1982

The incidence of hospital infection has been seriously increased in the general hospital in recent years. This study was performed on hospital air and materials in a General Hospital in Seoul from June to December in 1980. The results were as follows: 1. Air sampling was done in multiple strategic areas by exposing standard petridishes for 5 minutes. There was a significant difference of airborne microbe between places. ($F._{99}$ = 3.2, p < 0.01). 2. The mean colony count was 8.6$\pm$6.2 colonies / plate / 5 minutes. 3. Gram stains of colony in air sampling were Gram (+) cocci 66.5%. Gram (+) rod 18.4%, Gram (-) cocci 1.3%, Gram (-) rod 8.7% Fungus 4.5%. 4. For the evaluation of sterilization of steam sterilizer and ethylene oxide gas sterilizer, biological monitoring were done by commercial spore strip. Positive culture was obtained in 2 out of 41 tests on 3 steam sterilizers, and in 3 out of 13 tests on ethylene oxide gas sterilizer. 5. Product sampling and culture were done for 2 kinds of disinfectants and 30 sets of various operation package or dressing materials. Positive culture was obtained in one disinfectants.

• Textile Coloration and Finishing
• /
• v.2 no.3
• /
• pp.8-13
• /
• 1990

In order to study the modification of wettability, tactility, and bathochromicity of the poly (ethylene Terephthalate) (PET) fabrics, low-temperature plasma$(O_2)$ has been irradiated on the PET fabrics in various conditions. The results obtained from this study were as follows; 1) The weight loss rate of plasma-treated PET fabrics is proportional to irradiation time and internal gas temperature of treating chamber. Also, the effect of weight loss is remarkable at gas pressure ranging from 3 torr to 5 torr. 2) The bathochromic effect of PET fabrics treated with low-temperature plasma$(O_2)$ was improved.

• Horticultural Science & Technology
• /
• v.33 no.5
• /
• pp.675-686
• /
• 2015

Asparagus (Asparagus officinalis L.) needs proper post-harvest treatment to prolong its storage life. This study investigated the effect of 1-methylcyclopropene (1-MCP) on the quality and storage life of asparagus. Fresh-harvested asparagus was treated with 1-MCP ($1mg{\cdot}L^{-1}$), CEPA($10mg{\cdot}L^{-1}$), and 1-MCP($1mg{\cdot}L^{-1}$) + CEPA($10mg{\cdot}L^{-1}$) and compared with an untreated control. The carbon dioxide ($CO_2$) production, ethylene production, and morphological characteristics of the preserved asparagus were observed. The flow-system and the static-type measurement methods for ethylene and $CO_2$ production (respiration rate) were used. Weight loss, respiration rate, degree of freshness, and ethylene production were monitored during storage at $7^{\circ}C$. The results further showed that CEPA (2-chloroethylphosphonic acid) treatment had greater effects on $CO_2$ and ethylene production than using the 1-MCP process. The asparagus treated with CEPA or 1-MCP + CEPA had significantly increased the ethylene production rate compared to the control or using only 1-MCP during storage. There were no evident changes in the respiration rate of asparagus under 1-MCP treatment as compared with the control. Using the flow-system, slight differences in the rates of $CO_2$ and ethylene production were noted as compared to using the static type. Findings showed that in using the flow-system, asparagus manifested clearer results as compared with the static type. Weight loss in asparagus was significantly lower in control and 1-MCP treated samples than in those treated with CEPA. Likewise, the $CO_2$ and ethylene production of the CEPA treated samples significantly increased. The 1-MCP treatment reduced the effects of CEPA on weight loss, soluble solids content, and osmolality. The effect was not observed with exogenous ethylene as CEPA treatment had no visible effect as compared to the untreated group. Thus, 1-MCP treatment of asparagus could slightly reduce damage to the quality of asparagus during its distribution where ethylene gas is produced. Therefore, this study suggests that 1-MCP treatment can reduce the damage induced by ethylene gas on asparagus in poor distribution environments.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.2
• /
• pp.1013-1019
• /
• 2011

In this paper, simulation works for a multi-stage cascade refrigeration cycle using propane, ethylene and methane as refrigerants have been performed for the liquefaction of natural gas using Peng-Robinson equation of state built-in PRO/II with PROVISION release 8.3. The natural gas feed compositions were supplied from Korea Gas Corporation and the flow rate was assumed to be 5.0 million tons per annual. Supply temperature for propane refrigerant was fixed as $-40^{\circ}C$, that for ethylene refrigerant as $-95^{\circ}C$, and that for methane refrigerant as $-155^{\circ}C$. For the multi-stage refrigeration cycle, three-stage refrigeration was assumed for propane refrigeration cycle, two-stage refrigeration for ethylene refrigeration cycle and three-stage refrigeration for methane refrigeration cycle. Natural gas was finally cooled and liquefied to $-162^{\circ}C$ by Joule-Thomson expansion. Conclusively, 91.71% by mole of the natural gas liquefaction ratio was obtained through a cascade refrigeration cycle and Joule-Thomson expansion and 0.433 kW of compression power was consumed for the liquefaction of 1.0 kg/hr of natural gas.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2001.05a
• /
• pp.63-64
• /
• 2001

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.1
• /
• pp.552-558
• /
• 2011

In this paper, simulation works for a cascade refrigeration cycle using propane, ethylene and methane as a refrigerant have been performed for the liquefaction of natural gas using Peng-Robinson equation of state built-in PRO/II with PROVISION release 8.3. The natural gas feed compositions were supplied from Korea Gas Corporation and the flow rate was assumed to be 5.0 million tons per annual. Supply temperature for propane refrigerant was fixed as $-40^{\circ}C$, that for ethylene refrigerant as $-95^{\circ}C$, and that for methane refrigerant as $-155^{\circ}C$. Natural gas was finally cooled and liquefied to $-162^{\circ}C$ by Joule-Thomson expansion. Conclusively, 91.64% by mole of the natural gas liquefaction ratio was obtained through a cascade refrigeration cycle and Joule-Thomson expansion.

• Membrane Journal
• /
• v.20 no.4
• /
• pp.290-296
• /
• 2010

Ethylene vinyl acetate (EVA-28)/Co-Al LDH nanocomposite membranes were prepared by solution intercalation using organically modified LDH. LDH was made organophilic by the intercalation of dodecyl sulfate (DS) anion in the interlayer. The prepared membranes were characterized using XRD, FT-IR and SEM. Gas permeability of EVA/LDH nanocomposite membranes with LDH content of 1, 3, and 5 w% was studied for $O_2$ and $CO_2$ at pressure of 3, 4, and 5 bar. The permeability of $O_2$ and $CO_2$ was minimum for nanocomposite membrane with 1 wt% LDH and increased with increasing LDH content, which is presumably due to aggregation of LDH filler. The selectivity of $CO_2$ for $O_2$ showed the maximum value at 1 wt% of LDH content and decreased thereafter.

• Fibers and Polymers
• /
• v.6 no.2
• /
• pp.121-126
• /
• 2005

Semicrystalline poly(ethylene terephthalate) (cPET)/amorphous poly(ethylene terephthalate) with isophthalic acid (aPET) blends with 100/0, 75/25, 50/50, 25/75, and 0/100 by weight ratios were dissolved in a mixture of trifluoroacetic acid (TFA)/methylene chloride (MC) (50/50, v/v) and electrospun via the electrospinning technique. Solution properties such as solution viscosity, surface tension and electric conductivity were determined. The solution viscosity slightly decreased as aPET content increased, while there was no difference in surface tension with respect to aPET composition. The characteristics of the electro spun cPET/aPET blend nonwovens were investigated in terms of their morphology, pore size and gas permeability. All these measurements were carried out before and after heat treatment for various blend weight ratios. The average diameter of the fibers decreased with increasing aPET composition due to the decrease in viscosity. Also, the morphology of the electrospun cPET/aPET blend nonwovens was changed by heat treatment. The pore size and pore size distribution varied greatly from a few nanometers to a few microns. The gas permeability after heat treatment was lower than that before heat treatment because of the change of the morphology.