• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.40 no.3
• /
• pp.297-307
• /
• 1995

Anatomical and physiological studies of sink tissues are required for better understanding the biological plant growth system and energy metabolism Anatomy of root growth zones of two genotypes of tall fescue (Festuca arundinacea Schreb.) receiving 50 or 200 ppm N were determined, Cross-sectional anatomy and cells responses of root growth zones were observed and examined. Rapid radial root expansion occurred within the first 1.0 mm from root apex, and then increased gradually for both genotypes and N levels. Another increase in diameter occurred at high N after cell elongation slowed near 3.0 mm. Area of the central cylinder cell increased rapidly near the root apex. However, it then decreased again about 1.0 to 1.5 mm from the apex, perhaps because of pressure from the rapid increase of root diameter due largely to an increasing proportion of cortex and epidermis or hypodermis in the distal portion of the root growth zone. Root area from the apical initial to 6.0 mm distal consisted of 10 to 18% epidermis or exodermis, 67 to 79% cortex, and 10 to 22% vascular cylinder cells containing cambium cells (6 to 20%) and xylem cells (0.8 to 2.5%). These data indicate that N application affects root growth radially by increasing mainly cortex cell area, with less effect on epidermis and central cylinder cells.

• Economic and Environmental Geology
• /
• v.22 no.3
• /
• pp.253-266
• /
• 1989

The Cu-Pb-Zn-Ag hydrothermal vein type deposits which comprise the Dongil and Dong-cheogogsan mines occur within the Cretaceous sedimentary rocks in the Euiseong Basin of the southern Korean peninsula. The ore mineralization is contained within three stage(I,II and III) quartz and calcite veins. Ore minerals occur as dominant chalcopyrite, galena, sphalerite, tetrahedrite and Pb, Ag, Sb and Bi-bearing sulfosalts. Stage I ore minerals were deposited between $400^{\circ}C$ and $200^{\circ}C$ from the fluid with moderate salinities(7.0 to 4.5 eq. wt. % NaCl). Evidence of boiling suggests pressure of less than 150 bars during stage I mineralization. This pressure corresponds to maximum depths of 650 m and 1700 m, respectively, assuming lithostatic and hydrostatic loads. The data on mineralogy, temperature and salinity, together with information on the solubility of Cu complex, suggest that Cu deposition is a result of boiling coupled with declining temperature from $350^{\circ}$ to $250^{\circ}C$ or declining log $a_{o_2}$(from -29.8 to -35.9 atm.)and increasing in pH. Pb, Ag, Sb and Bi-bearing sulfosalts were deposited by cooling and dilution at temperature of less than $250^{\circ}C$ from the ore fluid with less than -35.9 atm. of log $a_{o_2}$.

• Applied Microscopy
• /
• v.41 no.2
• /
• pp.139-145
• /
• 2011

Parthenocissus tricuspidata is an epiphyte that lacks a main axial stem, but develops adhesive disks along the stem for climbing support. In this study, scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS) were utilized to examine the brick wall surface and the adhesive disks of P. tricuspidata that attached to the surface successfully. The study was mainly focused the outermost layers of both structures before and after adhesion to find out whether there has been some structural and/or physical interactions between the two. The adhesive disks adhered firmly to the brick wall by secreting adhesive materials that help them for a tight attachment to the surface. The rough wall surface appeared facilitating better attachment of the adhesive disks by infiltrating the materials into those spaces leading to some degree of interactions at the interface. EDS analysis on the outermost layers of the adhesive disks that were separated from the substrates was also consistent with the SEM data on the interaction between the adhesive disks and the substrate surface. EDS analysis of the brick wall surface and the adhesive disks demonstrated similar elements of O, Si, Fe, Al, K, Mg, and Na in their components.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.11 no.5
• /
• pp.38-59
• /
• 2008

This research has a meaning to provide basic data for eco-friendly way of district unit plans and ecological landscape planning by evaluation of biotope preservation value at the level of district unit and designating land development of the site, the whole area of Sinseo-dong (Dong-gu, Daegu metropolitan city) for research site. The summary of analysis result is as follows. As a result of classification of biotope types on the research site, it is divided into 11 biotope groups such as a residential biotope group and 51 specific biotope types which is subordinate to the groups. As a result of the first value assessment on classified biotope types, there are 16 types of natural rivers which is full of vegetation as a I class. Also it is analysed as 9 types of IIclass, 14 of IIIclass, 8 of IVclass, and 4 of Vclass. In particular, in light of a wildlife habitat, EB, in case of broad-leaved tree of mixed forest assessed as a II class, was classified into Iclass which is one-step upgraded as a final class with the analysis as there is a structural characteristic (more than 71% of low density, 50 years of age-class). As a result of second assessment, it is analysed that there are 17 special sites (1a,1b) and 33 special sites (2a, 2b, 2c) respectively for preservation of species and biotope. Particularly, in case of the No. 27 space, it was assessed that it has the value of about medium (IIIclass) level, but its value was upgraded with the on-spot detailed investigation that most of Aristolochia contorta, designated as a rare plant by Ministry of Environment, is growing. It is regarded that the above-mentioned research result on evaluation of biotope preservation value is expected to provide very important basic materials for future district unit plans and smooth integration with landscape ecology plans and eco-friendly space development.

• Journal of Korean Home Economics Education Association
• /
• v.18 no.4 s.42
• /
• pp.207-216
• /
• 2006

The purpose of this study was to investigate the body composition and the nutrient intakes of the physical-education high school male athletics and high school male students in Daegu Kyungpook. The study was performed by 122 physical-education high school male students and 78 high school male students. Statistical data analysis was completed by using the SPSS 12.0 program. They were also analyzed by student's t-test at p<0.05. The results were summarized as follows. (1) Chest circumference in athletic group(AG) was significantly higher than in nonathletic group(NG). Hip circumference in nonathletic group(NG) was significantly higher than in athletic group(AG)(p<0.01). Skinfold thickness of triceps, biceps and subscapular in nonathletic group(NG) were thicker than that of athletic group(AG) significantly(p<0.001). Percent of body fat and body fat mass in nonathletic group(NG) were higher than that of athletic group(AG) significantly(p<0.001). Lean body mass in athletic group(AG) was higher than that of nonathletic group(NG) significantly(p<0.001). (2) Athletic group(AG) was significantly higher than nonathletic group(NG) in energy nutrient intakes and vitamin, mineral and other nutrient intakes except Na, vitamin B6, vitamin E(p<0.001). Athletic group(AG) had more intakes than RDA for all nutrient except calcuim. (3) Nonathletic group(NG) was significantly higher than Athletic group(AG) in total nutrition knowledge scores.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.9 no.1
• /
• pp.9-23
• /
• 1997

A numerical study of a two-layer, stratified flow is investigated, using the implicit finite difference method in one dimension. The results of computational method have been tested and, in case of lock exchange flow, compared with the results of experimental data. The results of model experiments with various interfacial, bottom friction coefficients along with various time weighting factor of numerical scheme and dissipative interface are shown and discussed. Two-layer model experiment has been also carried out to investigate the generation and propagation characteristics of internal tidal wave over the steep bottom topography under stratified condition. The internal wave seems to well radiate through the downstream boundary under the experiments adopting radiation conditions both at two layers and only at upper layer, confirming the applicability of radiational boundary condition in stratified flows. It is also shown that the internal wave through the downstream boundary propagates more actively with increasing thickness of lower layer in the downstream. This implies that the potential tidal energy in the interface will depend upon the thickness of lower layer for the constant thickness of upper layer.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.22 no.1
• /
• pp.25-33
• /
• 2010

The matching condition at a perforated wall with vertical slits involves the permeability parameter, which can be calculated by two different methods. One expresses the permeability parameter in terms of energy dissipation coefficient and jet length at the perforated wall, being advantageous in that all the related variables are known, but it gives wrong result in the limit of long waves. The other expresses the permeability parameter in terms of friction coefficient and inertia coefficient, giving correct result from short to long waves, but the friction coefficient should be determined on the basis of a best fit between measured and predicted values of such hydrodynamic coefficients as reflection and transmission coefficients. In the present study, an empirical formula for the friction coefficient is proposed in terms of known variables, i.e., the porosity and thickness of the perforated wall and the water depth. This enables direct estimation of the friction coefficient without invoking a best fit procedure. To obtain the empirical formula, hydraulic experiments are carried out, the results of which are used along with other researchers' results. The proposed formula is used to predict the reflection and transmission coefficients of a curtain-wall-pile breakwater, the upper part of which is a curtain wall and the lower part consisting of a perforated wall with vertical slits. The concurrence between the experimental data and calculated results is good, verifying the appropriateness of the proposed formula.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.25 no.6
• /
• pp.394-404
• /
• 2013

In the present study, the characteristics of spectral peakedness parameter $Q_p$, bandwidth parameter ${\varepsilon}$, and spectral width parameter ${\nu}$ were analyzed as a first step to define the swell waves quantitatively. For the analysis, the joint probability density function of significant wave heights and peak periods were newly developed. The MCMC(Markov Chain Monte Carlo) simulations have been performed to generate the significant wave heights and peak periods from the developed probability density functions. Applying the simulated significant wave heights and peak periods to the theoretical wave spectrum models, the spectral shapes parameters were obtained and analyzed. Among the spectral shape parameters, only the spectral peakedness parameter $Q_p$, is shown to be independent with the significant wave height and peak wave period. It also best represents the peakedness of the spectral shape, and henceforth $Q_p$ should be used to define the swell waves with a wave period. For the field verification of the results, wave data obtained from Hupo port and Ulleungdo were analyzed and results showed the same trend with the MCMC simulation results.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.32 no.5
• /
• pp.340-350
• /
• 2020

A rapid refresh wave forecasting system has been developed using the sea wind on the Korea Local Analysis and Prediction System. We carried out a numerical experiment for wind-wave interaction as an important parameter in determining the forecasting performance. The simulation results based on the seasons of with typhoon and without typhoon has been compared with the observation of the ocean data buoy to verify the forecasting performance. In case of without typhoon, there was an underestimate of overall forecasting tendency, and it confirmed that an increase in the wind-wave interaction parameter leads to a decrease in the underestimate tendency and root mean square error (RMSE). As a result of typhoon season by applying the experiment condition with minimum RMSE on without typhoon, the forecasting error has increased in comparison with the result without typhoon season. It means that the wave model has considered the influence of the wind forcing on a relatively weak period on without typhoon, therefore, it might be that the wave model has not sufficiently reflected the nonlinear effect and the wave energy dissipation due to the strong wind forcing.

• Applied Chemistry for Engineering
• /
• v.31 no.5
• /
• pp.575-580
• /
• 2020

In this study, we simulated an amine regeneration process with heat-stable salts removal unit. We derived the optimal operating conditions considering the flow rate of waste, the removal rate of heat-stable salts, and the loss rate of MDEA (methyl diethanolamine). In the amine regeneration process that absorbs and removes acid gas, heat-stable salt impairs the absorption efficiency of process equipment and amine solution. An ion exchange resin method is to remove heat-stable salts through neutralization by using a strong base solution such as NaOH. The acid gas removal process was established using the Radfrac model, and the equilibrium constant of the reaction was calculated using Gibbs free energy. The removed amine solution is separated and flows to the heat-stable salts remover which is modeled by using the Rstoic model with neutralization reaction. Actual operation data and simulation results were compared and verified, and also a case study was conducted by adjusting the inflow mass of removal unit followed by suggesting optimal conditions.