• Journal of the Korean Institute of Intelligent Systems
• /
• v.15 no.7
• /
• pp.858-863
• /
• 2005

Sensor network is subject to novel problems and constraints because it is composed of thousands of tiny devices with very limited resources. The large number of motes in a sensor network means that there will be some failing nodes owing to the lack of battery in sensor nodes. Therefore, it is imperative to save the energy as much as possible. In this work, we propose energy efficient routing algorithm which is based on directed diffusion scheme. In the proposed scheme, some overloads required for reinforcing the gradient path can be effectively eliminated. Furthermore, in order to verify the usefulness of the proposed algorithm, several simulations are executed.

• Nuclear Engineering and Technology
• /
• v.20 no.4
• /
• pp.233-240
• /
• 1988

The hafnium shroud is used to control the excess reactivity and power distribution in KMRR. The core analysis is performed by the diffusion code VENTURE using the 5 group macroscopic cross sections homogenized for an assembly. Investigated are the applicability of the diffusion calculation by homogenized cross sections to the analysis of control assembly which features unusual geometry such that hafnium shroud surrounds a multiplying medium inside. Comparative calculation is performed for the excess reactivity and power levels by the transport code TWOTRAN. The results show the acceptability of the diffusion calculation by the homogenized cross sections without significant error.

• Transactions of the Korean hydrogen and new energy society
• /
• v.34 no.3
• /
• pp.283-291
• /
• 2023

The physical properties were analyzed for four gas diffusion layers, and gas diffusion electrodes (GDEs) for the cathode of high-temperature polymer electrolyte membrane fuel cell were fabricated through bar coating with three binder to carbon (B/C) ratios. Among them, The GDE from JNT30-A6P showed a significant change in secondary pore volume at a B/C ratio of 0.31, which had the largest pore volume among all GDEs. In the polarization curve, JNT30-A6P GDE showed the best membrane electrode assembly (MEA) performance with a peak power density of 384 mW/cm² at a a B/C ratio of 0.31. From the distribution of relaxation time analysis, the peak 1 corresponding to mass transfer resistance of oxygen reduction reaction (ORR) was significantly reduced in the JNT30-A6P GDE. This is the result that when the binder content decreased, the volume of the secondary pore increased, and the mass transfer resistance of ORR decreased, which played an essential role in the MEA performance.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.2
• /
• pp.29-38
• /
• 2007

This study was undertaken to investigate the variation of equilibrium moisture content (EMC) in transverse direction and three different directional (longitudinal, radial, and tangential) linear movements, and diffusion coefficients within a tree disc of Korean red pine (pinus densiflora). The EMC gradually increased in heartwood from pith. Therefore, the chemical components might differ even in heartwood and the radial variation in EMC might have a close relationship with the cellulose content within a cross section. The specific gravity increases gradually from pith and the porosity has not direct influence on the variation of EMC within a tree disk. Both the radial and tangential diffusion coefficients exhibited clear trend of increase from pith. The EMC change (${\Delta}EMC$) and tangential diffusion coefficient were close to be axisymmetrical but others were deviated from axisymmetry. The diffusion coefficient decreases with decreasing an activation energy and specific gravity, The diffusion coefficient increased with increasing ${\Delta}EMC$ and hygroscopicity of wood might be inversely proportional to the activation energy, The fJEMC may depend on the chemical constituents of cellulose, hemicellulose and lignin. As the number of sorption sites and sorption capacity of wood increase, therefore, it might be assumed that the hygroscopicity of wood increases while activation energy decreases. Modeling physico-mechanical behavior of wood, the variations should be considered to improve the accuracy.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05b
• /
• pp.160-165
• /
• 1998

Under the heavy irradiation, when the production and the recombination of interstitials and vacancies are included, the diffusion equations become nonlinear. An effort has been made to arrange an appropriated transformation of these nonlinear differential equations to soluble Poisson's equations, so that analytical solutions for simultaneously calculating the concentrations of interstitials and vacancies in the angular dependent Cottrell's potential of the edge dislocation have been derived from the well-known Green's theorem and perturbation theory.

• Journal of Photoscience
• /
• v.12 no.1
• /
• pp.51-54
• /
• 2005

The electronic excitationenergy quenching of 2, 5-diphenyl-1, 3, 4-oxadiazole (PPD) by Carbon tetrachloride ($CCl_4$) in different solvents viz, n-hexane, n-heptane, toluene, benzene, cyclohexane, 1, 4- dioxane has been carried out at room temperature to understand the role of quenching mechanism. The Stern-Volmer plots have been found to be linear. As probability of quenching per encounter 'p' is less than unity, and the activation energy for quenching '$E_a$' is greater than the activation energy of diffusion '$E_d$', it is inferred that the fluorescence quenching mechanism is not due to material diffusion alone.

• Nuclear Engineering and Technology
• /
• v.47 no.5
• /
• pp.608-616
• /
• 2015

The migration of silver (Ag) in silicon carbide (SiC) and $^{110m}Ag$ through SiC of irradiated tristructural isotropic (TRISO) fuel has been studied for the past three to four decades. However, there is no satisfactory explanation for the transport mechanism of Ag in SiC. In this work, the diffusion coefficients of Ag measured and/or estimated in previous studies were reviewed, and then pre-exponential factors and activation energies from the previous experiments were evaluated using Arrhenius equation. The activation energy is $247.4kJ{\cdot}mol^{-1}$ from Ag paste experiments between two SiC layers produced using fluidized-bed chemical vapor deposition (FBCVD), $125.3kJ{\cdot}mol^{-1}$ from integral release experiments (annealing of irradiated TRISO fuel), $121.8kJ{\cdot}mol^{-1}$ from fractional Ag release during irradiation of TRISO fuel in high flux reactor (HFR), and $274.8kJ{\cdot}mol^{-1}$ from Ag ion implantation experiments, respectively. The activation energy from ion implantation experiments is greater than that from Ag paste, fractional release and integral release, and the activation energy from Ag paste experiments is approximately two times greater than that from integral release experiments and fractional Ag release during the irradiation of TRISO fuel in HFR. The pre-exponential factors are also very different depending on the experimental methods and estimation. From a comparison of the pre-exponential factors and activation energies, it can be analogized that the diffusion mechanism of Ag using ion implantation experiment is different from other experiments, such as a Ag paste experiment, integral release experiments, and heating experiments after irradiating TRISO fuel in HFR. However, the results of this work do not support the long held assumption that Ag release from FBCVD-SiC, used for the coating layer in TRISO fuel, is dominated by grain boundary diffusion. In order to understand in detail the transport mechanism of Ag through the coating layer, FBCVD-SiC in TRISO fuel, a microstructural change caused by neutron irradiation during operation has to be fully considered.

• Nuclear Engineering and Technology
• /
• v.40 no.7
• /
• pp.593-606
• /
• 2008

In this study, data on radionuclide migration and retardation processes in the engineered and natural barriers of High-Level Radioactive Waste (HLW) repository have been reviewed and compiled for use in the performance assessment of a HLW disposal system in Korea. The status of the database on radionuclide migration and retardation that is being developed in Korea is investigated and summarized in this study. The solubilities of major actinides such as D, Th, Am, Np, and Pu both in Korean bentonite porewater and in deep Korean groundwater are calculated by using the geochemical code PHREEQC (Ver. 2.0) based on the KAERI-TDB(Korea Atomic Energy Research Institute-Thermochemical Database), which is under development. Databases for the diffusion coefficients ($D^b_e$ values) and distribution coefficients ($K^b_d$ values) of some radionuclides in the compacted Korean Ca-bentonite are developed based upon domestic experimental results. Databases for the rock matrix diffusion coefficients ($D^r_e$ values) and distribution coefficients ($K^r_d$ values) of some radionuclides for Korean granite rock and deep groundwater are also developed based upon domestic experimental results. Finally, data related to colloids such as the characteristics of natural groundwater colloids and the pseudo-colloid formation constants ($K_{pc}$ values) are provided for the consideration of colloid effects in the performance assessment.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05b
• /
• pp.273-278
• /
• 1998

The phase stability of atomized U-10wt. ％Mo powder and the thermal compatibility of dispersed fuel meats at 40$0^{\circ}C$ and 50$0^{\circ}C$ have been characterized. Atomized U-10Mo powder has a good \ulcorner-U phase stability, and excellent thermal compatibility with aluminum matrix in a dispersion fuel. It is thought that the good phase stability is related to th large supersaturation of Mo atoms in the atomized particles. The reasons for the excellent thermal compatibility have been considered to be as follows. Before thermal decomposition of ${\gamma}$-U in particle, supersaturated Mo atoms at ${\gamma}$-U grain boundaries inhibit the diffusion of Al atoms. After thermal decomposition of ${\gamma}$-U into ${\gamma}$-U and U$_2$Mo, the intermetallic compound of U$_2$Mo seems to retard the penetration of Al atoms. The penetration mechanisms of aluminum atoms in the atomized particles are assumed be classified as (a) diffusion through the reacted layer between fuel particles and Al matrix leaving a kernel-like unreacted island and (b) diffusion along grain boundaries showing several unreacted islands and more reacted regions.

• Journal of the Korean housing association
• /
• v.20 no.4
• /
• pp.19-29
• /
• 2009

The purpose of this study is to evaluate the air diffusion performance of a range of indoor units for room airconditioners; the wall-mounted type, floor-standing type, and ceiling-mounted type. These types of units, which have been widely used in housing spaces, will be studied with respect to thermal comfort and the energy performance using CFD analysis. In this study, current air conditioning status and related problems in housing spaces are examined, and a CFD analysis is performed in order to compare and analyze the thermal comfort and energy efficiency across each type of indoor-unit using the PMV, ADPI, EUC and FCEI indexes. The analysis results collectively considering thermal comfort and energy performance indicated that the ceiling-mounted type 4-way indoor unit showed the best diffusion performance in terms of thermal comfort, and had the second best diffusion performance in terms of energy performance after the wall-mounted type under certain conditions.