• 한국산업정보학회:학술대회논문집
• /
• 한국산업정보학회 1997년도 추계학술대회 발표논문집:21세기를 향한 정보통신 기술의 전망
• /
• pp.451-462
• /
• 1997

A 2-dimensional numerical analysis is presented for thermal-electron heat conduction effects upon the electron transport and the drain current-voltage characteristics of submicron GaAs MESFETs, based on the use of a nonstationary hydrodynamic transport model. It is shown that for submicron GaAs MESFETs, electron heat conduction effects are significant on their internal electronic properties and also drain current-voltage characteristics. Due to electron heat conduction effects, the electron energy is greatly one-djmensionalized over the entire device region. Also, the drain current decreases continuously with increasing thermal conductivity in the saturation region of large drain voltages above 1 V. However, the opposite trend is observed in the linear region of small drain voltages below 1 V. Accordingly, for a large thermal conductivity, negative differential resistance drain current characteristics are observed with a pronounced peak of current at the drain voltage of 1 V. On the contrary, for zero thermal conductivity, a Gunn oscillation characteristic is observed at drain voltages above 2 V under a zero gate bias condition.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.307-308
• /
• 2007

This work shows the experimental results obtained from ageing at a temperature of 100 C for 48, 70 and 312 h, although the application of AC electrical tension in samples and the measuring of current leakage are presented. The measurements in samples were carried out with samples prepared from the deformulated commercial materials and respectively reformulated into thin films. The obtained results showed the mechanisms of conduction of samples in low and high electric fields. It was also identified an electric tension transition showing that in low fields it prevails the Ohm's law conduction, and in high electric fields it prevails the conduction of space charge limited current (SCLC). These results can support the natural rubber formulation process having as their main objective the reducing of the mechanisms that occur under high conduction current in high electric fields, which leads the material to a dielectric breakdown. Raw Natural rubber in Brazil is extracted from rubber trees (Hevea brasiliensis) in farms in So Paulo State by using some new plantation technology in smaller spaces, with trees placed a few meters from each other. In the Amazon rain forest the rubber trees are found naturally and their spacing may be of hundreds of meters or even kilometers between them. It is necessary to research this raw material from different internationally standard clones to characterize dielectric and electric properties for industrial applications. Moreover, this natural material has a low commercial price when compared to the synthetic ones.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.259-262
• /
• 2003

The surface electronic state of rutile $TiO_2$, which is an oxide semiconductor and has a wide band gap of 3.1 $\sim$ 3.5 eV, was calculated by DV-$X_{\alpha}$ method, which is a sort of the first principle molecular orbital method and uses Hartre-Fock-Slater approximation. The $[Ti_{15}O_{56}]^{-52}$ cluster model was used for the calculation of bulk state and the $[OTi_{11}O_{34}]^{-24}$ model for the surface state calculation. After calculations, the energy level diagrams and the deformation electron density distribution map were compared in both models. As results, it was identified that the surface energy levels are found between the valence and conduction band of bulk $TiO_2$ on the surface area. The energy values of these surface-induced levels are lower than conduction band of bulk $TiO_2$ by 0.1 $\sim$ 1 eV. From this fact, it is expected that the surface energy levels act as donar levels in n-type semiconductor.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2012년도 춘계학술대회
• /
• pp.709-712
• /
• 2012

본 연구에서는 분석학적 모델을 이용하여 DGMOSFET의 전류-전압을 고찰하고자 한다. 분석학적 모델을 유도하기 위하여 포아송 방정식을 이용하였다. 드레인 전류가 $10^{-7}A$일 때 상단게이트전압을 문턱전압으로 정의하였다. 채널의 길이를 20nm에서 100nm까지 변화시켜 채널길이에 따른 전류-전압특성을 분석하였다. 또한 본 연구에서 제시한 모델을 사용하여 DGMOSFET 설계시 중요한 도핑농도와 채널두께 등의 요소변화에 대한 전류-전압의 변화를 관찰하였다. 구조적 파라미터의 변화에 따라 전도중심의 변화와 전도중심이 전류-전압에 미치는 영향을 분석하였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제40회 동계학술대회 초록집
• /
• pp.63-63
• /
• 2011

비정질 반도체/절연체의 직류와 교류 전도도 스펙트럼은 주파수에 대한 거듭제곱의 법칙 (power-law)을 따르는 보편성이 있음이 확인되었다. 이러한 보편성은 다양한 비정질 반도체/절연체 물질에서 공통적으로 관찰되었으며 현재까지 이 보편성의 물리학적 원인이 정확히 규명되지 않고 있다. 이 보편성을 설명하기 위한 모델로서 비정질 반도체/절연체 내의 전자/정공의 호핑 전도기구 (hopping conduction mechanism)가 제시된 바 있으며 다양한 비정질 시스템의 전도도 스펙트럼 해석에 인용되고 있다. 그러나 직.교류 전도기구 사이의 상이함에 대한 이견이 있으며 현재까지 정확히 규명된 바 없다. 본 연구에서는 비정질 GeSe 반도성 물질의 전도도 스펙트럼을 10 Hz-1 MHz 주파수 대역에서 측정하였으며 이를 위해 백금 상.하부 전극을 갖는 크로스바(crossbar)형의 금속-절연체-금속구조의 2단자 소자를 제작하였다. 측정 스펙트럼으로부터 본 연구의 GeSe 물질이 앞서 언급한 비정질 물질의 보편성에 부합함을 확인하였으며 스펙트럼 내의 직류와 교류 성분을 명확히 분리할 수 있었다. 직.교류 전도도 스펙트럼의 명확한 기구 분리를 위하여 4개의 상이한 면적을 갖는 크로스바에 대한 측정을 실시하였으며 그 결과로 직.교류 전도도의 상이한 면적 의존성을 관찰하였고 이를 근거로 직.교류 전도도가 서로 다른 전도기구에 기인함을 간접적으로 알 수 있었다. GeSe의 전도도 스펙트럼의 온도 의존성 실험을 위해 시편의 온도를 20-300 K 범위에서 변화시키며 전도도 스펙트럼을 측정하였으며 이를 통해 교류 전도도 스펙트럼 내에 상이한 두 개의 전도 기구가 혼재해있음을 규명하였다.

• E2M - 전기 전자와 첨단 소재
• /
• 제11권10호
• /
• pp.60-65
• /
• 1998

Deposition conditions, surface morphology, and electrical properties of polyamic acid alkylamine salts (PAAS) Langmuir-Blodgett(LB) films have been investigated through a study of surface pressure-area $\pi$-A isotherms, AFM (atomic force microscopy), and current-voltage characteristics. To obtain the optimum conditions of film deposition, the $\pi$-A isotherms were examined by varying temperature, barrier moving speed, dipping speed, spreading amount of solution etc. The Z-type LB films were made at the surface pressure of 5 mN m-1 and 25 mN m-1 for the AFM study; the former surface pressure forms the gas phase and the latter one forms the solid phase. The LB film made in the gas phase show domains with a size of about 200 A diameter and 70 A height. However, the LB films made in the solid phase show a very smooth surface with 2 A surface roughness. In the current-voltage characteristics measured along the perpendicular direction of the films, ohmic conduction has been observed below 105 V cm-1 and the calculated electrical conductivity is about 10-13 S cm-1. Nonohmic conduction has been observed above = 10-11 V cm and the conduction mechanism can be explained by the Schottky effect.

• 한국전기전자재료학회논문지
• /
• 제19권9호
• /
• pp.878-882
• /
• 2006

We have fabricated single organic layer devices of the organolanthanide complex, terbium tris-(1-phenyl-3-methyl-4-(tertiarybutyry)pyrazol-5-one)triphenylphosphine oxide [$(tb-PMP)_{3}Tb-(Ph_{3}PO)$] for the investigation of its light emission and electrical conduction properties. The thickness of ($(tb-PMP)_{3}Tb-(Ph_{3}PO)$) layer was varied to 60, 75, 95 nm. Mg and Ca layers were used for the cathode contact. The electrical conduction in the $(tb-PMP)_{3}Tb-(Ph_{3}PO)$ single layer devices was dominated by the injection of electrons into the organic layer from the cathode. A higher current density at much lower voltages can be attained with Ca cathode because of the enhanced electron injection. The device shows very sharp emission at 548 nm. The FWHM of the strongest emission peak was 12 nm.

• 한국전기전자재료학회논문지
• /
• 제14권9호
• /
• pp.757-761
• /
• 2001

We studied emitting properties of organic electroluminescent devices fabricated using the spin-coating and Langmuir-Blodgett(LB) technique. The LB technique has the advantage of precise control of the thickness better than spin-coating method. LB monolayer of poly(3-hexylthiophene)(P3HT) was deposited 27 layers onto the indium-tin-oxide(ITO) substrate as Y-type films by the vertical dipping method. In the absorption spectra, the λ$\_$max/ of P3HT-AA LB films and of spin-coating films showed about at 510, 545 and 590 nm corresponding to 2.43, 2.28, 2.10eV. And we observed that the turn-on voltage of devices deposited by LB method(10V) was higher than that of spin-coating method(8.5V) in voltage-current-luminance characteristic. In the logV-logJ characteristics of ITO/P3HT-AA LB/Al device, we confirmed that El device fabricated by LB method follows three conduction mechanisms: ohmic, space-charge-limited current(SCLC) conduction and trapped-carrier-limited space-charge current(TCLC) conduction.

• 한국전기전자재료학회논문지
• /
• 제11권10호
• /
• pp.820-825
• /
• 1998

We deposited stearic acid LB films by using Langmuir-Blodgett (LB)method and investigated anisotropy electrical conduction characteristics by I-V measurement for horizontal direction and vertical direction. Also, we measured gad response between deposited LB films and organic gas for various temperature(0~8$0^{\circ}C$) by 9MHz At-cut quartz crystal microbalance. The LB films have electrical conduction characteristics such as semiconducting and insulating properties. The is, the conductivity of LB films for the horizontal and vertical direction is about 10\ulcornerS/cm and 10\ulcorners/cm, respectively. the frequency shift of stearic acid LB films for the organic gases depended on the mass change by the surface adsorption and the inner penetration to the sensing films. The resonant frequency shift of the quartz crystal microbalance for temperature properties of LB films is thought to the effect of the rearrangement or the damage pf LB films above the melting point and the mobility increasement of the organic gas by the temperature rising.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.460-463
• /
• 2000

The current-voltage characteristics of the sandwich system at different annealing temperatures and different bias voltages have been studied. In order to prepare the Al/V$O_X$/Al sandwich devices structure, thin films of vanadium oxide(V$O_X$) was deposited by r.f. magnetron sputtering from $V_2$$O_5$ target in 10% gas mixture of argon and oxygen, and annealed during lhour at different temperatures in vacuum. Crystall structure, surface morphology, and thickness of films were characterized through XRD, SEM and I-V characteristics were measured by electrometer. The films prepared below 20$0^{\circ}C$ were amorphous, and those prepared above 300 $^{\circ}C$were polycrystalline. At low fields electron injected to conduction band of vanadium oxide and formed space charge, current was limited by trap. Conduction mechanism at mid fields due to Schottky emission, while at high fields it changed to Fowler-Nordheim tunneling effects.