• Journal of Hydrogen and New Energy
• /
• v.32 no.5
• /
• pp.401-409
• /
• 2021

The combination of different concentrations of ZnSO₄ in acidic solution as electrolyte in Zn-air batteries was investigated by Zn symmetrical cell test, half-cell and full cell tests. Using 1 M ZnSO₄ + 0.05 M H₂SO₄ as electrolyte and MnO₂ as air cathode catalyst with Zn foil anode, this combination had a satisfactory performance with balance of electrochemical activity and stability. Its electrochemical activity was matched to or even better than the PtRu catalyst in different current density. And its cycle life was improved (more than 100 cycles stable) by suppressing the growth of zinc dendrites on anode obviously. This electrolyte overcame the shortcomings of alkaline electrolyte that are easy to react with CO₂ in the air, severely growth of Zn dendrites caused by uneven plating/stripping of Zn.

• Journal of the Korean Chemical Society
• /
• v.33 no.2
• /
• pp.225-231
• /
• 1989

The heterogeneous rate constants for the electrochemical reduction by $trans-[Co(en)_2X_2](ClO_4)_n$(where X is cyanide, nitrite, ammonia, and isothiocyanate) at mercury and glassy carbon electrode were investigated by cyclic voltammetry, DC polarography, and by using rotating disk electrode. The good linear relationship was obtained between the activation energy of reduction and absorption wave number of complexes on glassy carbon electrode. At mercury electrode, $NO_2^-$ ligated complex showed the large deviation from the linear relationship. The difference in the value of rate constants for $NO_2^-$ ligated complex between mercury and glassy carbon electrode was about three order of magnitude which was much larger than the other complexes. It was suggested that $NO_^-$ ligated complex was reduced by inner-sphere mechanism on mercury electrode from the larger value of activation energy and entropy on mercury than carbon electrode.

• Rapid Communication in Photoscience
• /
• v.2 no.2
• /
• pp.42-45
• /
• 2013

Natural photosynthesis utilizes solar energy to convert carbon dioxide and water to energy-rich carbohydrates. Substantial use of sunlight to meet world energy demands requires energy storage in useful fuels via chemical bonds because sunlight is intermittent. Artificial photosynthesis research focuses the fundamental natural process to design solar energy conversion systems. Nicotinamide adenine dinucleotide ($NAD^+$) and $NADP^+$ are ubiquitous as electron transporters in biological systems. Enzymatic, chemical, and electrochemical methods have been reported for NADH regeneration. As photochemical systems, visible light-driven catalytic activity of NADH regeneration was carried out using platinum nanoparticles, molecular rhodium and cobalt complexes in the presence of triethanolamine as a sacrificial electron donor. Pt nanoparticles showed photochemical NADH regeneration activity without additional visible light collector molecules, demonstrating that both photoactivating and catalytic activities exist together in Pt nanoparticles. The NADH regeneration of the Pt nanoparticle system was not interfered with the reduction of $O_2$. Molecular cobalt complexes containing dimethylglyoxime ligands also transfer their hydrides to $NAD^+$ with photoactivation of eosin Y in the presence of TEOA. In this photocatalytic reaction, the $NAD^+$ reduction process competed with a proton reduction.

• Journal of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.689-698
• /
• 1991

Activated oxidation catalysts are generated by the treatment of pentadentate Schiff base cobalt(Ⅱ) complexes with the oxygen saturated DMF solution. Oxidation of 2,6-di-tert-butylphenol by homogeneous oxidation catalysts of superoxo type pentadentate schiff base cobalt(Ⅲ) complexes yields 2,6-di-tert-butylbenzoquinone(BQ) as a major product. And $O_2$/Co mole ratio of homogeneous oxidative catalysts such as [Co(Ⅲ)(sal-DET)]$O_2$ and [Co(Ⅲ)(sal-DPT)]$O_2$by PVT method of the oxygen absorption in DMSO and pyridine solution was 1:1, 1:1.52 in DMF solution and ${\mu}$-peroxo type cobalt(Ⅲ) complexes formed at solid state. The redox reaction processes of superoxo type cobalt(Ⅲ) complexes as homogeneous oxidation catalysts were investigated by cyclic voltammetry and DPP method at a glassy carbon electrode. As a result of electrochemical measurements the reduction processes of oxygen adducted superoxo type cobalt(Ⅲ) complexes occurred to four steps including prewave of $O_2$-in 0.1M TEAP-DMSO and 0.1 M TEAP-Pyridine as supporting electrolyte solution.

• Journal of the Korean Chemical Society
• /
• v.37 no.9
• /
• pp.806-812
• /
• 1993

Complexes of $Cu(I)(hfac)PR_3$(P: phosphine and R: Me, Et and Bu) as Cu(I)(${\beta}$-diketonate) compounds have been synthesized and their electrochemical properties have been investigated using glassy carbon and carbon microelectrode in aprotic solvent. Reduction process of $Cu(I)(hfac)PR_3$ compounds carried out one electron pathway to Cu(0) by cyclic voltammetry in acetonitrile solution. Chronoamperometric curve using carbon microelectrode shows that these complexes are one electron process and diffusion coefficients are $4.5{\sim}6.7{\times}10^{-6}cm^2$/sec.

• Journal of Electrochemical Science and Technology
• /
• v.6 no.3
• /
• pp.95-105
• /
• 2015

In the present work, Carbon supported Pt₁₀₀, Pt₈₀Sn₂₀, Pt₈₀Ni₂₀ and Pt₈₀Sn₁₀Ni₁₀ electrocatalysts with different atomic ratios were prepared by ethylene glycol-reduction method to study the electro-oxidation of ethanol in membraneless fuel cell. The electrocatalysts were characterized in terms of structure, morphology and composition by using XRD, TEM and EDX techniques. Transmission electron microscopy measurements revealed a decrease in the mean particle size of the catalysts for the ternary compositions. The electrocatalytic activities of Pt₁₀₀/C, Pt₈₀Sn₂₀/C, Pt₈₀Ni₂₀/C and Pt₈₀Sn₁₀Ni₁₀/C catalysts for ethanol oxidation in an acid medium were investigated by cyclic voltammetry (CV) and chronoamperometry (CA). The electrochemical results showed that addition of Ni to Pt/C and Pt-Sn/C catalysts significantly shifted the onset of ethanol and CO oxidations toward lower potentials. The single membraneless ethanol fuel cell performances of the Pt₈₀Sn₁₀Ni₁₀/C, Pt₈₀Sn₂₀/C and Pt₈₀Ni₂₀/C anode catalysts were evaluated at room temperature. Among the catalysts investigated, the power density obtained for Pt₈₀Sn₁₀Ni₁₀/C (37.77 mW/cm² ) catalyst was higher than that of Pt₈₀Sn₂₀/C (22.89 mW/cm² ) and Pt₈₀Ni₂₀/C (16.77 mW/ cm² ), using 1.0 M ethanol + 0.5 M H₂SO₄ as anode feed and 0.1 M sodium percarbonate + 0.5 M H₂SO₄ as cathode feed.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.13-16
• /
• 2008

Solid oxide fuel cell(SOFC) is an electrochemical energy conversion system with high efficiency and low-emission of pollution. In order to reduce the operating temperature of SOFC system under $800^{\circ}C$, the thickness reduction of YSZ electrolyte to be as thin as possible, e.g., less than 10 ${\mu}m$ are considered with the microstructure control and optimum design of unit cell. Methods for reducing the thickness of YSZ electrolyte have been investigated in coin cell. Moreover, a large unit cell($8cm{\times}8cm$) for SOFC was fabricated using an anode-supported electrolyte assembly with a thinner electrolyte layer, which was prepared by a tape casting method with a co-sintering technique. we studied the design factors such as active layer, electrolyte thickness, cathode composition, etc,. by the coin type of unit cell ahead of the fabrication process of a large unit cell and also reviewed about the evaluation technique of a large size unit cell such as interconnect design, sealing materials and current collector and so forth. Electrochemical evaluations of the unit cells, including measurements such as power density and impedance, were performed and analyzed. Maximum power density and polarization impedance of coin cell were 0.34W/$cm^2$ and $0.45{\Omega}cm^2$ at $800^{\circ}C$, respectively. However, Maxium power density of a large unit cell($5cm{\times}5cm$) decreased to 0.21W/$cm^2$ at $800^{\circ}C$ due to the increase of ohmic resistance. However, It was found that the potential value of a large unit cell loaded by 0.22A/$cm^2$ showed 0.76V at 100hrs without the degradation of unit cell.

• Journal of Electrochemical Science and Technology
• /
• v.9 no.3
• /
• pp.202-211
• /
• 2018

In this work, Fe-Pd alloy films have been electrodeposited on different substrates using an electrolyte containing $[Pd(NH_3)_4]^{2+}$ (0.02 M) and $[Fe-Citrate]^{2+}$ (0.2 M). The influences of substrate and overpotential on chemical composition, nucleation and growth kinetics as well as the electrodeposited films morphology have been investigated using energy dispersive X-ray spectroscopy (EDS), current-time transients, scanning electron microscopy (SEM), atomic force microscopy (AFM) and X-ray diffraction (XRD) patterns. In all substrates - brass, copper and sputtered fluorine doped tin oxide on glass (FTO/glass) - Fe content of the electrodeposited alloys increases by increasing the overpotential. Also the cathodic current efficiency is low due to high rate of $H_2$ co-reduction. Regarding the chronoamperometry current-time transients, it has been demonstrated that the nucleation mechanism is instantaneous with a typical three dimensional (3D) diffusion-controlled growth in the case of brass and copper substrates; while for FTO, the growth mode changes to 3D progressive. At a constant overpotential, the calculated number of active nucleation sites for metallic substrates is much higher than that of FTO/glass; however by increasing the overpotential, the number of active nucleation sites increases. The SEM micrographs as well as the XRD patterns reveal the formation of Fe-Pd alloy thin films with nanostructure arrangement and ultra-fine grains.

• Journal of Hydrogen and New Energy
• /
• v.20 no.3
• /
• pp.194-201
• /
• 2009

The e1ectrocatalytic properties of heteropolyacids(HPAs) entrapped in covalently cross-linked sulfonated polyetheretherketone(CL-SPEEK/HPA) membranes have been studied for water electrolysis. The HPAs, including tungstophosphoric acid(TPA), molybdophosphoric acid(MoPA), and tungstosilicic acid(TSiA) were used as additives in the composite membranes. The MEA was prepared by a non-equilibrium impregnation-reduction(I-R) method, using reducing agent, sodium borohydride(NaBH4) and tetraamineplatinum(II) chloride(pt(NH$_3$)$_4$Cl$_2$). The electrocatalytic properties of composite membranes such as the cell voltage were in the order of magnitude CL-SPEEKlMoPA40 (wt%) > /TPA30 > /TSiA40. In the optimum cell applications for water electrolysis, the cell voltage of PtlPEM/Pt-Ru MEA with CL-SPEEKlTPA30 membrane was 1.75 V at 80$^{\circ}$C and I A/cm$^2$ and this voltage carried lower than that of 1.81 V of Nafion 117. Consequently, in regards of electrochemical and mechanical characteristics and oxidation durability, the newly developed CL-SPEEKITPA30 composite membrane exhibited a better performance than the others, but CLSPEEKlMoPA40 showed the best electrocatalytic activity (1.71 Vat 80$^{\circ}$C and 1 A/cm$^2$) among the composite membranes.

• Journal of Hydrogen and New Energy
• /
• v.35 no.1
• /
• pp.48-55
• /
• 2024

The electrochemically active site of mixed ionic and electronic conductor (MIEC) as a cathode material is restricted to the triple phase boundary in protonic ceramic fuel cells (PCFCs) due to the insufficient of proton-conducting properties of MIEC. This study primarily focused on expanding the electrochemically active site by La_0.6Sr_0.4Co_0.2Fe_0.8O_3-δ(LSCF6428)-BaZr_0.4Ce_0.4Y_0.1Yb_0.1O_3-δ (BZCYYb4411) composite cathode. The electrochemical properties of the composite cathode were evaluated using anode-supported PCFC single cells. In comparison to the LSCF6428 cathode, the peak power density of the LSCF6428-BZCYYb4411 composite cathode is much enhanced by the reduction in both ohmic and non-ohmic resistance, possibly due to the increased electrochemically active site.