• Journal of the Korean Institute of Gas
• /
• v.12 no.2
• /
• pp.57-62
• /
• 2008

Difference of failure modes was studied by finite element analysis for elbows with local wall thinning area particularly at inner surface of intrados of the elbow. Longitudinal wall thinning length, minimum thickness were kept constant but circumferential wall thinning width was varied to get $90^{\circ}$, $180^{\circ}$ and $360^{\circ}$ thinning width. Elastic-plastic analysis were carried out under the combined loading conditions of internal pressure and in-plane bending moment closing the elbow. Von Mises stress were obtained from the outer surface central surface location in intrados, extrados and crown parts in elbow. The results showed that the plastic deformation and failure started from the crown location when the thinning width small ($90{\sim}180^{\circ}$). However, plastic collapse started from the intrados location when the thinning width is approaching $360^{\circ}C$. This should be reflected to assess structural integrity of elbows after wall thinning measurement is made.

• The Journal of the Acoustical Society of Korea
• /
• v.26 no.6
• /
• pp.293-300
• /
• 2007

Turbulent boundary layer over an underwater vehicle is formed when it moves underwater and wall pressure fluctuation within the turbulent boundary layer generates flow-induced noise by exciting the elastic hull of the underwater vehicle. One of the methods to reduce this flow noise is to attach a compliant layer on the surface of the vehicle. In order to observe the possibility of noise reduction in the water when the compliant layer treatments are applied on the surface, three types of specimens those are a bare steel plate, a steel plate coated with neoprene and a steel plate with polyurethane coating material are tested at various flow speeds in a low noise cavitation tunnel. This paper presents the results of measurements and analysis of wall pressure fluctuations which is a main source of flow noise, within the turbulent boundary layer on three specimens. Its results could be shown that about 10dB reduction of wall fluctuation pressure at high frequencies was achieved due to the dissipation of turbulent energy by the compliant coating while it makes the turbulent boundary layer thicker and changes the behavior of turbulent flow in the layer.

• Journal of Nutrition and Health
• /
• v.30 no.10
• /
• pp.1123-1131
• /
• 1997

This study examined the effect of dietary lipids and guar gum on lipid metabolism in ovariectomized rats. The experimental animals received ovarietomy (OVX). Lipids sources were divided into 3 groups (soybean oil(SB), beef tallow(BT)) and fish oil(FO)) and guar gum was supplemented to each lipid diet (SBG, BTG, FOG). Experimental diets were fed to therats for 16 weeks. Serum triglyceride (TG) levels were higher in the BT group and lower in the FO group as compared to the SB group .Serum total cholesterol (Tc) and HDL-C levels were lower in the FO group as compared to the SB group. Serum LDL-C and phospholipid levels were lower in the FO group as compared to the SB group. Serum lipids levels were lowered by guar gum supplement. Serum SFA(saturated fatty acids) contents were not significantly influenced by dietary lipids and guar gum. Serum MUFA(monounsaturated fatty acids) contents were the lowest in the SB group. Fecal weight was highest in the beef tallow group and lowest in the fish oil group. Fecal weight was increased by guar gum supplement in all lipid groups. Total bile acid content in feces was increased by guar gum supplement in the soybean oil and beef tallow groups. The endothelial cells of the beef tallow group changed from a flat shape to distorted round and enlarged shapes. The subendothelial layer was the thickness the thickest in the beef tallow group ; the interspace between elastic lamina was widened and elastic lamina was straightened and partly disrupted . The fish oil group showed more porminient endothelial cells and subendothelial layer. Internal elastic membrane and elastic lamina exhibited regularly wavy shapes. Guar gum supplement showed positive effects in all lipids groups. Based on the above results , it is suggested that beef tallow increased serum TG levels and injured the wall of the aorta. On the other hand, fish oil , which decreased serum lipid levels, has a positive effect on the walls of the aorta. Guar gum protects the aorta from injury by reducing the serum lipid levels. Therefore, it is suggested that soybean oil and beef tallow consumed with guar gum is beneficial.

• Advances in materials Research
• /
• v.12 no.3
• /
• pp.243-261
• /
• 2023

This study aims to analyze the mechanical buckling behavior of a single-walled carbon nanotube (SWCNT) integrated with a one-parameter elastic medium and modeled as a Kerr-type foundation under a longitudinal magnetic field. The structure is considered homogeneous and therefore modeled utilizing the nonlocal first shear deformation theory (NL-FSDT). This model targets thin and thick structures and considers the effect of the transverse shear deformation and small-scale effect. The Kerr model describes the elastic matrix, which takes into account the transverse shear strain and normal pressure. Using the nonlocal elastic theory and taking into account the Lorentz magnetic force acquired from Maxwell relations, the stability equation for buckling analysis of a simply supported SWCNT under a longitudinal magnetic field is obtained. Moreover, the mechanical buckling load behavior with respect to the impacts of the magnetic field and the elastic medium parameters considering the nonlocal parameter, the rotary inertia, and transverse shear deformation was examined and discussed. This study showed useful results that can be used for the design of nano-transistors that use the buckling properties of single-wall carbon nanotubes(CNTs) due to the creation of the magnetic field effect.

• The Journal of Internal Korean Medicine
• /
• v.19 no.2
• /
• pp.392-410
• /
• 1998

In order to investigate the effect of Alismatis Lhizoma on hyperlipidemia, experimental studies were performed on hyperlipidemia rats. Hyperlipidemia model (controll group) was induced by 1% cholesterol fed-diet for 8 weeks. Sample I group fed with 1% cholesterol and 4% Alismatis Lhizoma diet for 8 weeks. Sample II group fed with 1% cholesterol and 8% Alismatis Lhizoma diet for 8 weeks. The contents of serum total cholesterol, triglyceride, free fatty acid, phospholipid, HDL-cholesterol and LDL-cholesterol were measured, and fat accumulation in liver and the change of elastic and collagenous fiber in aortic wall were observed. The results were summurized as follows ; 1. The content of total cholesterol in the serum compared with control group tended to be decreased in sample group, and then sample I group showed a significant value. 2. The content of triglyceride in the serum compared with control group tended to be decreased in sample group, and then sample I group showed a significant value. 3. The content of free fat acid in the serum compared with control group tended to be decreased in sample group, but did not show a significance. 4. The content of phospholipid in the serum compared with control group tended to be decreased in sample group, and then sample I group showed a significant value. 5. The content of HDL-cholesterol in the serum compared with control group tended to be increased in sample group, and then sample II group showed a significant value. 6. The content of LDL-cholesterol in the serum compared with control group tended to be decreased in sample group, and then sample I group showed a significant value. 7. The lipophagy in liver compared with control group tended to be repressed in sample group. 8. The change of elastic and collagenous fiber lesion in tunica media of aortic wall, compared with control group tended to be repressed in sample group. According to the above results, it is assumed that Alismatis Lhizoma has a valid effect on hyperlipidemia. And yet, it needs to make further researches that sample I group showed more significant value than sample II group.

• The Journal of Internal Korean Medicine
• /
• v.19 no.2
• /
• pp.347-366
• /
• 1998

In order to investigate the effect of Lycii Radicis Cortex on hyperlipidemia, experimental studies were performed on hyperlipidemia rats. Hyperlipidemia model (controll group) was induced by 1% cholesterol fed-diet for 8 weeks. Sample I group fed with 1% cholesterol and 4% Lycii Radicis Cortex diet for 8 weeks. Sample II group fed with 1% cholesterol and 8% Lycii Radicis Cortex diet for 8 weeks. The contents of serum total cholesterol, triglyceride, free fatty acid, phospholipid, HDL-cholesterol and LDL-cholesterol were measured, and fat accumulation in liver and the change of elastic and collagenous fiber in aortic wall were observed. The results were summurized as follows ; 1. The content of total cholesterol in the serum compared with control group tended to be decreased in sample group, but did not show a significance. 2. The content of triglyceride in the serum compared with control group tended to be decreased in sample group, and then sample II group showed a significant value. 3. The content of free fat acid in the serum compared with control group tended to be decreased in sample group, and then sample II group showed a significant value. 4. The content of phospholipid in the serum compared with control group tended to be decreased in sample group, but did not show a significance. 5. The content of HDL-cholesterol in the serum compared with control group tended to be increased in sample group, and then sample I group showed a significant value. 6. The content of LDL-cholesterol in the serum compared with control group tended to be decreased in sample group, and then sample I group showed a significant value. 7. The lipophagy in liver compared with control group tended to be decreased in sample group. 8. The change of elastic and collagenous fiber lesion in tunica media of aortic wall, compared with control group tended to be decreased in sample group. According to the above results, it is assumed that Lycii Radicis Cortex has a valid effect on hyperlipidemia. Therefore, it seems to be applicable to the diseases related to hyperlipidemia.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.10 s.241
• /
• pp.1361-1368
• /
• 2005

The structural and leakage integrity of steam generator tubes should be sustained all postulated loads with appropriate margin even if a crack is present. During the past three decades, for effective integrity evaluation, several limit load solutions have been used world-widely. However, to predict accurately load carrying capacities of specific components under different conditions, the solutions have to be modified by using lots of experimental data. The purpose of this paper is to propose a new burst pressure estimation scheme based on fracture mechanics analyses for steam generator tube with an axial or circumferential through-wall crack. A series of three dimensional elastic-plastic finite element analyses were carried out and, then, closed-form estimation equations with respect to both J-integral and crack opening displacement were derived through reference stress method. The developed engineering equations were utilized for structural integrity evaluation and the resulting data were compared to the corresponding ones fiom experiments as well as limit load solutions. Thereafter, since the effectiveness was proven by promising results, it is believed that the proposed estimation scheme can be used as an efficient tool for integrity evaluation of cracked steam generator tubes.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.16 no.2
• /
• pp.25-33
• /
• 2012

To examine the performance of a thin plate damper attached to coupling beam of bearing wall system, 5 specimens were designed with the variable parameters of the thickness and length of a thin steel plate, which was constructed and tested with a lateral load with up to a 5% drift ratio. The result was that the total amount of the energy dissipation of the specimen with the thin plate damper was greater than that of the standard RC specimen, and the plate buckling and plastic deformation could be seen in steel plate. The shorter the length of the damper, the higher was the lateral resistant force, but there was no apparent increase in the energy dissipation. By comparison of the experiments with the elastic buckling analysis, it was shown that the buckling force from the analysis could properly estimate the maximum value of the linear elastic range.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.5
• /
• pp.59-63
• /
• 2011

Ground dynamic parameter such as shear elastic modulus and damping ratio is a very important variable in design of ground-structure with repeated load and dynamic load. Shear elastic modulus and damping ratio on small strain below linear limit strain is constant regardless of strain. Shear elastic modulus as the maximum shear elastic modulus and damping ratio as the minimum damping ratio were considered. As a lot of experiment related to the maximum shear elastic modulus, which is in dynamic deformation characteristics, have been conducted, many factors including voiding ratio, over consolidation ratio(OCR), confining pressure, geology time, PI, and the number of load cycle affect to dynamic soil characteristic. However, the research of ground dynamic characteristic improved with grout is absent such as underground continuous wall construction, deep mixing method, umbrella arch method. In order to investigate the dynamic soil characteristics improved with grout, in this study, resonant column tests were performed with changing water content(20%, 25%, 30%) and injection ratio of grout(5%, 10%, 15%), cure time(7th day, 28th day) As a result, shear elastic modulus and damping ratio, which are ground dynamic parameter, are affected by the injection ratio of milk grout, cure time and water content.

• Journal of the Korea Concrete Institute
• /
• v.13 no.6
• /
• pp.544-552
• /
• 2001

Korea is classified into low and moderate seismic zone from the view-point of seismic hazard level. Korean seismic provisions has been developed based on UBC and ATC 3-06. Thus, in calculation of design base shear according to Korean provisions response modification factor (R) is included in the formula of design base shear. The major role of this factor is to reduce the elastic design base shear whereby structures can behave in inelastic range during design level earthquake ground motions(mean return period of 475 yrs.). R factor is assigned according to material and structural systems. In this study, R factor for bearing wall system is considered. Most of the walls of apartment buildings in Korea resist gravity and seismic loads simultaneously so that this wall system can be classified into bearing wall system. Structural details of these walls are different from those used in Japan and U.S.. They are all rectangular in sectional shape rather than barbell in shape, and also have special lateral reinforcement details at the boundaries of a wall. In Korean seismic design provisions(1988), two different values(3.0 and 3.5) of R factor are assigned to the bearing wall systems according to the wall details. However, in updated seismic provisions(2000), only one value is assigned to R factor(3.0) irrespective of wall details. In this study, the design base shear values in Korean seismic design provisions(1988, 2000), ATC 3-06, UBC are compared. Also experimental study was carried out to evaluate the seismic performance of structural walls. For this purpose, five test specimens were made which have special details used in apartment bearing wall systems in Korea. Based on the results of this study, response modification factor for bearing wall system is discussed.