• Textile Coloration and Finishing
• /
• v.11 no.3
• /
• pp.49-57
• /
• 1999

The effect of padding solution for the microwave heat dyeing of polyester fabric was studied variously. The dyeing property of polyester fabric varied with the kinds of added chemicals in the padding solution. Polyester fabrics impregnated in aqueous urea solution and aqueous sodium chloride solution for 10 minutes and then dyed for 7 minutes by microwave apparatus(2450 MHz, 700 W) under optimum conditions give good exhaustion. An aqueous solution of urea and a sodium chloride solution was more effective than water as padding solution for microwave heating dyeing. The K/S values of dyed polyester fabric by microwave were significantly affected by the type of solvent added in padding media and its concentration. Added solvents, n-hexane, acetone and dimethyl formamide were also more effective than water as padding media for the microwave heating dyeing. It is assumed that the effect of used solvents on dyeing property of polyester fabrics depends on the solubility parameter difference between solvent and polyester fabric.

• KSBB Journal
• /
• v.9 no.3
• /
• pp.312-318
• /
• 1994

The esterification of Ac-Tyr-OH was carried out in one-phase system containing ethanol by ${\alpha}$-chymotrypsin. The results of the esterification reaction are as follows. Chitin-${\alpha}$-chymotrypsin complex was found to be an effective catalyst for the esterlfication of Ac-Tyr-OH in ethanol organic solvent. The optimal conditions for the esterification were chitn/${\alpha}$-chymotrypsin ratio, 20(w/w); reaction temp., $35^{\circ}C$; reaction pH, 8.0; reaction time, 24 hrs. Also, addition of chitin in water/water-miscible organic solvent was effective for the stability of the enzyme. The esterification yield, Km and Vmax under optimal conditions were 93%, 3.093mM and 1.088mM/mg/hr, respectively.

• Elastomers and Composites
• /
• v.29 no.3
• /
• pp.226-233
• /
• 1994

The properties of the mixed prepolymer-urethane in the range of 10-40 phr were observed. LBR and LCR have same functional group but different in structure of molecular. The viscosity of mixture depending on content of rubber, adhesive strength, thermal property and compatibility with a diluted solvent are as follows: 1. The viscosity of the mixture was influenced by solubility of the diluent for urethane resin and liquid rubber. 2. Adhesive strength showed the highest value at 30phr rubber, decreased gradually at above 30phr rubber. And LBR revealed better physical property than that of LCR. 3. The most effective factors affecting adhesive strength are molecular structure of rubber, the type of solvent, and volatility. 4. Urethane resin containing LBR showed better compatibility for solvent and faster drying velocity. 5. LBR showed more favorable compatibility and dispersion state than those of LCR by analyzing the results of SEM.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.5
• /
• pp.1543-1546
• /
• 2011

N-Bromosaccharin/$Mg(ClO_4)_2$ is an effective and regioselective system for ${\alpha}$-monobromination of 1,3-dicarbonyl compounds. A wide variety of ${\beta}$-keto esters and 1,3-diketones in reaction with this system afforded a regioselectively ${\alpha}$-monobrominated products. The bromination reaction can be conducted at 0-5 $^{\circ}C$ either in solution or under solvent-free conditions.

• Journal of Environmental Science International
• /
• v.10 no.5
• /
• pp.381-386
• /
• 2001

The characteristics of precipitation separation and solvent extraction separation of magnesium from the waste bittern were studied experimentally In the result of precipitation separation, the size of magnesium hydroxide precipitated was not affected on pH, but decreased with increasing the precipitation temperature. The purity of magnesium oxide precipitated was increased with pH beyond pH 11. From the solvent extraction separation, the equilibrium extraction ratio of magnesium was increased with pH and temperature of extraction phase, the concentration of stripping phase, and with decreasing pH of stripping phase. The extractant of Aliquat 336 and Acid 810 mixture was more effective than that of DCH18C6 and $D_2EHPA$ mixture in the extraction separation of magnesium.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.1
• /
• pp.50-56
• /
• 1998

A solvent sublation was studied for the determination of trace Cd, Co, Cu and Ni in water samples. Ammonium pyrrolidine dithiocarbamate (APDC) was used as a complexing agent. Experimental conditions such as pH of solution, amounts of APDC, the type and amount of surfactant, the type of solvent, etc. were optimized for the effective sublation of analytes. After metal-PDC complexes were formed in sample solutions of pH 2.5, the precipitate-type complexes were floated in a flotation cell with an aid of sodium lauryl sulfate as a surfactant and by bubbling with nitrogen gas. The precipitates were dissolved and separated into the surface layer of methyl iso-butyl ketone (MIBK). The analytes preconcentrated were determined by a graphite furnace atomic absorption spectrophotometry (GF-AAS). Extractability of each element was 88% for Cd(Ⅱ), 86% for Co(Ⅱ), 95% for Cu(Ⅱ) and 76% for Ni(Ⅱ), respectively. And this procedure was applied to the analysis of real samples. From the recoveries of more than 92%, it was concluded that this method could be simple and applicable for the determination of trace elements in various water samples of a large volume.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.6
• /
• pp.506-510
• /
• 1996

The syntheses and photoreactions of haloarenes, in which the aryl and haloaryl moieties are tethered by a simple alkyl group, were studied. For 2-benzyl-1-halobenzene, in which two aryl moieties were connected by methylene group, photoreduced product, diphenylmethane, was obtained along with the minor formation of the photocyclized product, fluorene, in acetonitrile solvent. For 1-halo-2-phenethylbenzene, in which two aryl moieties were connected by ethylene group, photocyclized products, 9,10-dihydrophenanthrene and phenanthrene, were obtained along with the minor formation of photoreduced product, bibenzyl, in acetonitrile solvent. The photoreaction selectivities in several solvent systems were studied: In cyclohexane, 2-benzyl-1-chlorobenzene was photoreduced more effective than 2-benzyl-1-bromobenzene; In the presence of NaOH, 1-halo-2-phenethylbenzenes gave 9,10-dihydrophenanthrene and, in the presence of toluene, they gave phenanthrene. A radical reaction mechanism is proposed for the explanation of the reactions. This study shows that the photoreaction of haloarene, in which haloaryl and aryl moieties are tethered by ethylene group, can be used for ring formation of 9,10-dihydrophenanthrene otherwise difficultly accessible.

• Applied Chemistry for Engineering
• /
• v.24 no.1
• /
• pp.82-86
• /
• 2013

Palladium particles were synthesized with 1-buthyl-3-methylimidazolium trifluoromethanesulfonate ([Bmim][$CF_3SO_3$]) as an effective solvent during the synthesis. The morphology of the particles was affected by the concentration of [Bmim][$CF_3SO_3$]. Furthermore, the palladium on carbon powder was prepared with various [Bmim][$CF_3SO_3$] concentrations and calcinations temperatures as a catalyst for hexafluoropropylene hydrogenation. Catalytic activity was varied by both conditions significantly. Under the identical condition, the catalyst prepared by the same mole ratio of [Bmim][$CF_3SO_3$] and palladium, and calcined at $500^{\circ}C$ was the most active in this reaction.

• The Korean Journal of Food And Nutrition
• /
• v.28 no.1
• /
• pp.1-8
• /
• 2015

This study was designed to determine the antioxidant activity of solvent fractions of broccoli sprouts grown by controlling the growing environment at the plant factory system. Fractionation was achieved with chloroform, n-hexane, ethyl acetate, butanol, water by 70% EtOH extract of the broccoli sprouts. Each solvent fraction was put through TLC and HPLC to separate active components. Higher antioxidant activities were observed for the butanol and ethyl acetate layers. Further evaluation of each of the 5 layers (LH1 to LH5) of the butanol fraction showed that the refined LH3 extract had a high antioxidant effect. Components with similar Rf values from TLC had the same retention times and peaks in the HPLC analysis. It was also determined that the sulforaphane content was high at the chloroform and butanol layers and the sulforaphane was responsible for, the high antioxidant activity. Thus, to use for functional materials, the butanol extract/layer of broccoli sprouts is recommended as the most effective.

• Journal of Microbiology
• /
• v.38 no.3
• /
• pp.187-191
• /
• 2000

A validation study was conducted to determine the efficacy of solvent/Detergent (S/D) inactivation and Q-Sepharose column chromatographic removal of the human immunodeficiency virus (HIV) during the manufacturing of a high purity antihemopilic factor VIII (GreenMono) from human plasma. S/D treatment using the organic solvent, tri (n-butyl) phosphate, and the detergent, Trition X-100, was a robust and effective step in eliminating HIV-1. The HIV-1 titer was reduced from an initial titer of 8.3 log10 TCID50 to undetectable levels within one minute of S/D treatment, HIV-1 was effectively partitioned form factor VIII during Q-Sepharose column chromatography with the log reduction factor of 4.1 . These results strongly assure the safety of GreenMono From HIV.