• Title/Summary/Keyword: Eddy Diffusivity

Search Result 38, Processing Time 0.024 seconds

Aerodynamic Resistance and Eddy Diffusivity above the Plug Stand under Artificial Light (인공광하에서 공정묘 개체군상의 공기역학적 저항 및 확산계수)

  • 김용현;고재풍수
    • Journal of Bio-Environment Control
    • /
    • v.5 no.2
    • /
    • pp.152-159
    • /
    • 1996
  • Experiment was performed in a newly developed wind tunnel with light system to determine the aerodynamic resistance and eddy diffusivity above the plug stand under artificial light. Maximum air temperature appeared near the top of the plug stand under artificial light. Since Richardson number was ranged from -0.07 to +0.01, the atmosphere above the plug stand in wind tunnel was in an unstable or near- neutral stability state. The average aerodynamic resistance at rear region of plug stand was 25 % higher than that at middle region. Eddy diffusivity($K_{M}$) linearly increased with the increasing air current speed. $K_{M}$ at air current speed of 0.9 m.$s^{-1}$ was about two times as many as that at air current speed of 0.3 m.$s^{-1}$. And average $K_{M}$ at the rear region was 15% lower than that at the middle region. These results indicated that the diffusion of heat and mass along the direction of air current inside the plug stand was different. It might cause the lack of uniformity in the growth and quality of plug seedlings. The wind tunnel developed in this study would be useful to investigate the effects of air current speed on microclimates and the growth of plug seedlings under artificial light in a semi- closed ecosystem.

  • PDF

Mechanism of a Spray Transport on Intake Manifold Walls (흡기매니폴드내 벽면으로의 연료수송)

  • Lee, G.Y.;Jeon, H.S.;Park, K.S.
    • Journal of ILASS-Korea
    • /
    • v.1 no.1
    • /
    • pp.28-34
    • /
    • 1996
  • Study on the mechanism of droplet transport and the droplet eddy diffusivity in the intake manifold of internal conbustion engine with carburetor has been carried out in this paper The theory and experiments were studied and performed respectively, to elucidate the mechanism and to measure typical rates of deposition, on the walls of a straight type intake manifold, of water droplets suspended in a turbulent air streams. Accordingly, the results are that Mechanism of a spray transport to the walls is caused by the fluctuation component of radial velocity. Deposition rate of a spray on the walls is mainly dependent upon air velocity and mean diameter of spray, and Droplet eddy diffusivity in the intake manifold is around $80\sim105cm^2/sec$.

  • PDF

Application of the E-$\varepsilon$turbulence numerical model to a flow and dispersion around triangular ridge( I ) (E-$\varepsilon$모델을 이용한 삼각 봉우리 주변의 유동과 확산 수치해석(I))

  • 정상진
    • Journal of Korean Society for Atmospheric Environment
    • /
    • v.10 no.2
    • /
    • pp.116-123
    • /
    • 1994
  • The E- $\varepsilon$ turbulence numerical model was applied to a flow around triangular ridge in neutral boundary layer. Scale of cavity region, mean velocity, Reynolds stress and eddy diffusivity were investigated. The height of cavity region was in satifactory agreement with the wind tunnel data while the length of cavity region was underestimated. The man wind velocities outside the cavity region were well Predicted by the model, however in cavity region the mean wind velocities of wind tunnel data were larger than the model results Reynolds stress of cavity region was overestimated by the model. The eddy diffusivity of wake region was strongly modified under the influence of triangular ridge. The local minimum of the eddy diffusivity was occured in the lee of the ridge top.

  • PDF

Analysis of Stratified Lake using an Eddy Diffusion and a Mixed-layer Models

  • Kim, Kyung-sub
    • Korean Journal of Hydrosciences
    • /
    • v.8
    • /
    • pp.111-123
    • /
    • 1997
  • A one-dimensional eddy diffusion model and a mixed-layer model are developed and applied to simulate the vertical temperature profiles in lakes. Also the running result of each method are compared and analyzed. In an eddy diffusion model, molecular diffusivity is neglected and eddy diffusivity which does not need lake-specific fitting parameter and constant lake's level are applied. The heat exchanges at the water surface and the bottom are formulated by the energy balance and zero energy gradient, respectively. In a mixed-layer model, two layers approach which has a constant thickness is adopted. The application of these models which use explicit finite difference and Runge-Kutta methods respectively demonstrates that the models simulate water temperatures efficiently.

  • PDF

A Study on the Eddy Diffusion in a Pulsed Turbulent System (脈動渦流裝置에 있어서의 渦流擴散)

  • Woong Ki Kang;Yung Wook Kim
    • Journal of the Korean Chemical Society
    • /
    • v.7 no.3
    • /
    • pp.203-206
    • /
    • 1963
  • The eddy diffusion in the pulsed wetted wall column, where the spherical balls are consecutively arrayed along the axis of the column and turbulence is caused around the balls by pulsation, has been studied both theoretically and experimentally. A diffusion equation is solved for a longitudinal column where a concentration impulse is given at the top of the column, and the experimental results, which are the impulse response measurements at the half of the total height of the column, have shown a good agreement with the developed theory. A method of measuring the eddy diffusivity, which is based on the slope of concentration vs. time in the particular interval of concentration, is proposed and the measured diffusivity is used as a criterion of comparing the theory and the experiment. The eddy diffusion is remarkably increased as the amplitude and the frequency of the pulsation increase but the increasing rate is decreased as the pulsation increases.

  • PDF

Analysis of Stratified Lake using an Eddy Diffusion and a Mixed-Layer Models (와확산 및 혼합층 모델을 이용한 성층화 호수 해석)

  • 김경섭
    • Water for future
    • /
    • v.29 no.5
    • /
    • pp.235-244
    • /
    • 1996
  • A one-dimensional eddy diffusion model and a mixed-layer model are developed and applied to simulate the vertical temperature profiles in lakes. Also the running results of each method are compared and analyzed. In an eddy diffusion model, molecular diffusivity is neglected and eddy diffusivity which does not need lake-specific fitting parameter and constant lake's level are applied. The heat exchanges at the water surface and the bottom are formulated by the energy balance and zero energy gradient, respectively. In a mixed-layer model, two layers approach which has a constant thickness is adopted. Application of these models which use explicit finite difference an Runge-Kutta methods respectively demonstrates that the models efficiently simulate water temperatures.

  • PDF

직접 접촉방식 열 및 물질교환 장치의 전달현상(II)

  • 김석현
    • Journal of the KSME
    • /
    • v.25 no.5
    • /
    • pp.413-418
    • /
    • 1985
  • 직접 접촉식 교환장치(이하 직접 교환기라 함)에서 액체의 유통형태의 선택은 매우 다양하며 전달계수 역시 개별적인 상황이나 충전물의 종류에 따라서 달라지므로 일률적으로 제시되지 못 하고 있다. 많은 경우 실험을 통하여 열전달 또는 물질전달계수를 측정하게 되나 개수로, 자유 낙하액체막, 액체분류와 같이 이상화가 가능한 경우, 이러한 전달계수를 구하기 위하여 이론적 또는 반실험적인 해석을 수행하기도 한다. 수많은 관련 연구결과들은 층류유동에 관한 것과 난류유동의 경우로 구분되고(예상되듯이 대부분의 직접교환기의 유통영역은 난류쪽이다), 난류 유통의 해석은 다시 표면갱신이론(surface renewal model), 와류확산계수모델(eddy diffusivity model-macroscopic), 미분형와류모델(differential eddy diffusivity model)로 대별된다. 여기서는 수많은 교환기형태의 자료정리보다 상기와 같이 대별된 액체측 유동영역별로 전달현상해석의 방법을 간단히 정리하고자 한다.

  • PDF

An Analytical Model for Predicting Heat Transport due to a Point Source in Coastal Water under a Spring-Neap Modulation of Tidal Currents (조류의 대.소조 변동이 존재하는 연안역에서의 점열원에 의한 열오염의 이동 예측을 위한 해석해 모형)

  • 이호진;김종학
    • Journal of Korean Society of Coastal and Ocean Engineers
    • /
    • v.16 no.2
    • /
    • pp.92-102
    • /
    • 2004
  • In this paper, an analytical solution of calculating the excess temperature field due to a point heat source is presented in the presence of spring-neap modulation of convective alongshore flow. The basic form of the solution is identical to that given by Jung et al. (2003) but the convective term in the exponential kernel function is extended and a spring-neap variation in the horizontal eddy diffusivity is newly introduced. A set of calculations have been performed to examine the sensitivity of the heat build-up to the change in current fields and turbulent dispersion. Results indicate that the excess temperature field is confined within the tidal excursion distance, while the excess temperature field beyond the distance is mainly controlled by the horizontal diffusion. The heat build-up within the distance is considerably affected by the spring-neap variation in the horizontal eddy diffusivity; the relatively high excess temperature more than 1$^{\circ}C$ is extended further when the eddy diffusivity has spring-neap modulation.

On the Large Eddy Simulation of Scalar Transport with Prandtl Number up to 10 Using Dynamic Mixed Model

  • Na Yang
    • Journal of Mechanical Science and Technology
    • /
    • v.19 no.3
    • /
    • pp.913-923
    • /
    • 2005
  • The dynamic mixed model (DMM) combined with a box filter of Zang et. al. (1993) has been generalized for passive scalar transport and applied to large eddy simulation of turbulent channel flows with Prandtl number up to 10. Results from a priori test showed that DMM is capable of predicting both subgrid-scale (SGS) scalar flux and dissipation rather accurately for the Prandtl numbers considered. This would suggest that the favorable feature of DMM, originally developed for the velocity field, works equally well for scalar transport problem. The validity of the DMM has also been tested a posteriori. The results of the large eddy simulation showed that DMM is superior to the dynamic Smagorinsky model in the prediction of scalar field and the model performance of DMM depends to a lesser degree on the ratio of test to grid filter widths, unlike in the a priori test.