• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.441-445
• /
• 2020

A Permanent Magnet Synchronous Motor (PMSM) for an electrical power steering system (EPS) is adopting various dual three-phase type stator windings to get the high fault tolerance capability when the motor runs at the failure condition. In this paper, we analyze the effects of stator winding arrangements on the characteristics such as torque and efficiency of the PMSM with leading and lagging current angle variations using finite element method. As a result, the most valuable design criteria are proposed to select stator winding method. Especially, we suggest the most appropriate winding method in terms of torque and efficiency, extending constant output area and decreasing noise and torque ripples.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.274-278
• /
• 2002

Surface finishing is still indispensable for most rapid prototyping (RP) processes because of the inherent stair-stepped surface and shrinkage of the parts. These problems can be minimized in the $VLM-_ST$ Process, because it uses expandable polystyrene foam sheets, each of which has a thickness of3.9 mm and a linear-interpolated side slope. The use of thick layers, however, limits the process capability of constructing fine details. This study focuses on the design of post-processing tool for fine details of $VLM-_ST$ parts and investigation of thermal characteristics during EPS foam cutting using the post-processing tool. To calculate the heat flux from the tool into the foam sheet, the tool was modeled as a heat source of radiation for finite element analysis. Results of the analysis agreed well with those of the experiment.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.292-305
• /
• 2013

EPCglobal has proposed the EPC Sensor Network to efficiently integrate and interoperate the RFID and WSN technologies based on the international standard EPCglobal Network. However, it can not deal with the sensor data without EPS. Also, it does not provide enough management function for the sensor data only. This study proposes USN management system that can deal with these weaknesses of EPC Sensor Network. Not only that, it is suitable for the medical environment properly. In the medical environment, it is important for the medical information to be integrated and interconnected via the standard for medical data. This proposed USN management system is based on SIP-HL 7 and can send RFID and WSN data based on SIP(Session Initiation Protocol). It can be interconnected with the existing hospital information system and exchange the information. Also it can design and materialize SIP Interface based on HL7 that allows the medical information to be exchanged and sent.

• 전자공학회논문지 IE
• /
• v.46 no.4
• /
• pp.1-7
• /
• 2009

The final goal of ITS and ETC will be to improve the traffic efficiency and mobile safety without new road construction. DSRC system is emerging nowadays as a solution of them. China DSRC standard which was released in May 2007 has low bit rate, short message and simple MAC control. The DSRC system users want a long lifetime over 1 year with just one battery. In this paper, we propose the SoC of very low power consumption architecture. Several digital logic concept and analog power control logics were used for very low power consumption. The SoC operation mode and clock speed, operation voltage range, wakeup signal detector, analog comparator and Internal Voltage Regulator & External Power Switch were designed. We confirmed that the SoC power consumption is under 8.5mA@20Mhz, 0.9mA@1Mhz in active mode, and under 5uA in power down mode, by computer simulation. The design of SoC was finished on Aug. 2008, and fabricated on Nov. 2008 with $0.18{\mu}m$ CMOS process.